石油降解菌Pseudomonas stutzeri TH-31的分离与降解条件优化

使用稀释富集法,从大港油田采油废水处理站生化池中定向快速的分离出多株高效石油降解菌株。对分离获得的1株优势菌株进行生理生化和分子生物学鉴定,显示属于Pseudomonas stutzeri的1个新菌株,命名为Pseudomonas stutzeri TH-31。通过批次实验,对菌株TH-31的生长条件和石油降解条件进行了优化,经过条件优化,P.stutzeri TH-31在初始pH 7,原油投加量为300 mg/L,35℃培养5 d后,获得最高石油烃降解率92.7%。     

硫酸盐还原菌污泥固定化特性

采用玉米芯为碳源,聚乙烯醇(PVA)为包埋载体,饱和硼酸(H3BO3)为交联剂,研究了硫酸盐还原菌污泥(SRBS)、铁屑、麦饭石共固处理合成煤矿酸性废水的最优配比与机理,并分析了固定化过程中小球稳定性及活性的变化规律。实验结果表明,SRBS投加量是影响处理效果的最显著因子,当投加30%SRBS、2%铁屑、3%麦饭石时SO42-、Mn2+去除率分别为94.13%和84.39%,溶液pH为7.03,未检测出Fe2+;随着交联时间的延长,小球膨胀率及SO42-还原率分别呈线性与指数下降,从保持小球稳定性与活性角度考虑,可将交联时间设定为4~8 h;该法可为市政污泥的处置以及生物法处理煤矿酸性废水的工程应用提供技术参考。     

一株中度嗜盐硫酸盐还原菌的分离及生理特性研究

本文从四川自贡盐厂卤水污泥中，分离出一株中度嗜盐硫酸盐还原菌。菌体为短杆状，０．９－１．１×２．０－２．５μｍ，革兰氏染色阴性，形成芽孢，不含脱硫孤菌素。固体培养基上无Ｆｅ２＋时，菌落为半透明状；有Ｆｅ２＋时菌落为黑色，直径为１－３ｍｍ。利用乳酸盐作为碳源，利用乙酸盐时必须添加生长因子。能在５％－２５％（Ｗ／Ｖ）Ｎａｃｌ浓度范围内生长，最适生长浓度为９％－１３％（Ｗ／Ｖ）。最适生长温度为３５℃。最适生长ｐＨ值为７．０．根据形态和生理生化特征，该菌为脱硫肠状菌属，但与该属已报导的硫酸盐还原菌在嗜盐、碳源利用、最适生长温度以及其它一些特征上均有不同，因此可能是个新种。该菌是目前已报道的嗜盐浓度最高的硫酸盐还原菌。     

厌氧条件下微生物对芳香族化合物分解的研究进展

本文总结了国内外芳香族化合物厌氧微生物分解的代谢类型和途径,指出厌氧条件下微生物对芳香族化合物的分解,包括光和代谢作用、硝酸盐还原作用、发酵作用、硫酸盐还原作用和产甲烷作用五种类型.厌氧条件下芳环的生物裂解包括还原性和非还原性两种类型,讨论了参与芳环裂解过程的一些酶类.     

硫酸盐生物还原过程中涉硫组分代谢特性

通过硫酸盐生化代谢过程中涉硫组分（SO42-、SO32-、H2S、S2-、S2O32-、微生物含硫）等代谢特性模式研究,揭示了代谢过程中的主要限速步骤及过程代谢产物演替规律。SRB还原过程中限速步骤主要为亚硫酸根转化为硫化氢的过程,利用氮气吹脱硫化氢后,反应终点时各涉硫组分占总硫的51.38%,硫离子的量增加了2.09倍,硫酸根的去除率从83.5%提高到91.24%,亚硫酸根浓度呈现出降低的趋势;pH明显上升,并最终达到8.31,而无吹脱硫化氢的反应器最终pH为6.87。反应器中脱硫弧菌为优势菌,硫化氢被吹脱后,微生物在目、科、属水平上优势菌得到提高,硫化氢的存在抑制了优势菌的增殖。     

废水除磷技术的研究与发展

目前 ,人们越来越重视污水除磷技术。本文介绍与评述了化学和生物两种除磷方式及其除磷机理和工艺 ,并着重介绍了生物除磷的现状、发展和研究动向     

无机超滤技术和生化处理技术在宝钢冷轧含油废水处理中的应用

冷轧废水处理是轧钢工艺中的难点之一。宝钢 2 0 30冷轧废水处理改造工程 ,首次将生化处理技术引入到冷轧含油废水处理工艺 ,并在工程中采用了无机陶瓷超滤技术 ,从而实现了冷轧废水处理的国产化及国内技术总成     

Trace Organic Matter in the Ria Formosa,Portugal

The Ria Formosa lagoon, Portugal, receives organic matter from many natural and anthropogenic sources. This paper presents an overview of the contribution these sources made through the use of lipid biomarkers. Sixty-one surface sediment samples were collected and analysed for a range of lipids. Sewage materials were confined to regions within 2 km of discharge points; phytoplankton biomarkers (sterols and fatty acids) suggest production was greatest in the inner parts of the lagoon that also have greatest inorganic nutrient enrichment; terrestrial organic matter was present in relatively low concentrations as shown by both sterol and fatty alcohols; bacteria were widespread although the Sulphate Reducing Bacteria (SRBs, shown by the presence of 3-OH fatty acids) were located near but not adjacent to sewage discharge points.     

Application of rotating cylinder method for ecotoxicological evaluation of antifouling paints

The environmental impact of two biocide-free antifouling paints, fluoropolymer and silicone types, painted on a test cylinder was assessed using a battery of ecotoxicity test and chemical analyses for organic micro-pollutants such as perfluoroalkyl substances (PFAS). A biocide paint containing zinc pyrithione (ZnPT₂) and cuprous oxide was assessed as a positive control. A standardized laboratory rotating-cylinder method using each test cylinder with artificial seawater was performed for 45 days. After 1?h rotation, the leaked seawater was subjected for bioassay and chemical analyses twice weekly. The seawater extracts from the biocide paint showed adverse effects on bacteria, algae, and crustaceans, but those from the biocide-free paints did not. The leakage seawater from biocide-free paints, after 7-day continuous rotation, contained the same concentration levels of PFAS as blank seawater used to conduct the tests. Thus, no significant toxicities of the biocide-free paints were found under the conditions of this study. Simultaneous analysis of ZnPT₂ and copper pyrithione (CuPT₂) was developed using an HPLC with a polymeric resin column, showing that ZnPT₂ was converted to CuPT₂ by trans-chelation in the leakage seawater from the positive control paint. The experimental results using a laboratory rotating-cylinder method demonstrated that biocide-free paints did not markedly affect three species tested and no PFAS was detected. In contrast, biocide paint was significantly toxic to test species and toxicity of the extract on bacteria was partly responsible for CuPT₂ produced in leakage seawater. Thus, a laboratory rotating-cylinder method may be applied for ecotoxicological assessment of antifouling paints.     

Screening for plants and rhizospheral fungi with bioremediation potency of petroleum-polluted soils in a Tehran oil refinery area

The contamination of soils by toxic and/or hazardous organic pollutants, especially with crude oil, is a widespread problem. This study was conducted in a petroleum-contaminated area in a Tehran oil refinery to find petroleum-resistant plants and their rhizospheral fungal strains with bioremediation potency. The plants growing in the oil-polluted area were collected and determined taxonomically. Root samples of the plant species were collected from a polluted area and fungal strains determined by laboratory methods and taxonomical keys. The growth ability of the isolated fungal strains was studied in media containing 1%–15% crude oil. Results showed that seven plant species were of the highest density in the contaminated area: Alhagi persarum, Hordeum marinum, Peganum harmala, Phragmites australis, Prosopis farcta, Salsola kali, and Senecio glaucus. The root-associated fungi were isolated and showed that the fungal variation in the oil-polluted area is higher than that in a non-polluted area. The growth assay of isolated fungal strains showed that all studied fungal strains were able to form colonies at the applied concentrations but Alternaria sp. and Rhizopus sp. were the most resistant ones. Some plants were resistant to oil pollution, which also had positive effects on the fungal strains.