Composting of waste algae: A review

Although composting has been successfully used at pilot scale to manage waste algae removed from eutrophied water environments and the compost product applied as a fertiliser, clear guidelines are not available for full scale algae composting. The review reports on the application of composting to stabilize waste algae, which to date has mainly been macro-algae, and identifies the peculiarities of algae as a composting feedstock, these being: relatively low carbon to nitrogen (C/N) ratio, which can result in nitrogen loss as NH₃ and even N₂O; high moisture content and low porosity, which together make aeration challenging; potentially high salinity, which can have adverse consequence for composting; and potentially have high metals and toxin content, which can affect application of the product as a fertiliser. To overcome the challenges that these peculiarities impose co-compost materials can be employed.     

臭氧联用技术深度处理腈纶废水的效果对比

将臭氧分别与超声波、H2O2、紫外光等联用,深度处理干法腈纶生产厂生化池出水,对各种联用技术的处理效果进行了研究。实验结果表明：在进水流量2 L/min、反应时间30 min、臭氧加入量3.5 g/（L?h）的条件下,当超声功率为300 W时,臭氧-超声联用技术的COD去除率为30.0%;当H2O2加入量为0.4 mL/L时,臭氧-H2O2联用技术的COD去除率为50.7%;当紫外灯功率为40 W时,臭氧-紫外光联用技术的COD去除率为49.9%;在各种联用技术中,臭氧-H2O2联用技术的运行成本最低（为7.5 元/t）,且处理后出水COD为143 mg/L,达到《<污水综合排放标准>（GB8978—1996）中石化工业COD标准值修改单》中的一级排放标准。综合考虑,臭氧-H2O2联用技术是深度处理干法腈纶废水的最优工艺。     

含氨氮催化剂生产废水的处理

采用加入淀粉的短程硝化-反硝化一体化技术处理低碳含NH3-N催化剂废水。通过中试确定了适宜的工艺参数,并在工业化装置上进行了验证。试验结果表明：在DO为0.5 mg/L左右、淀粉加入量为0.25 kg/ m3、HRT=30 h的条件下,短程硝化-反硝化一体化技术具有较好的处理效果,NH3-N去除率大于97%,且具有较强的抗冲击负荷的能力; 出水的COD<100 mg/L,ρ（NH3-N）<10 mg/L,达到GB 8978—1996《污水综合排放标准》的一级排放标准。工业化装置的运行费用以NH3-N计为2.3 元/kg、以废水计为4.6 元/t。该法适用于中低浓度（ρ（NH3-N）<300 mg/L）废水的处理。     

柴油低温临界吸收法回收装车挥发油气

研究了采用柴油低温临界吸收法回收装车挥发油气的效果。实验结果表明：按装车挥发油气中的总烃体积分数为20.88%、装车挥发油气流量为280 m³/h、年运行时间为2 668 h计,装置年回收油气量为291 t,装置年最大运行功率为206.770 MW,装置投资回收期为3 a;处理后净化气中的总烃体积分数为1.24%,排放质量浓度低于25 g/m³,油气回收率达95%。处理后净化气满足GB 20950—2007《储油库大气污染物排放标准》,取得了较好的环保效益和经济效益。     

宝钢焦化废水处理脱氮研究与实践

针对上海提高新排放标准中总氮(TN)≤35 mg/L的要求,对焦化废水进行了脱氮研究。选取现场缺氧-好氧-好氧(A-O-O)工艺中前两段的A-O生化沉淀池1出水,在SBR内进行反硝化脱氮实验,考察葡萄糖、葡萄糖+乙酸钠、甲醇和甲醇+乙酸钠单一或复合碳源及投加反硝化菌种对脱氮的影响,确定最佳碳源为甲醇+乙酸钠,最佳反硝化水力停留时间为16 h。当反硝化菌液投加浓度为1 mg/L时,SBR出水TN满足达标排放要求。结合实验结果对宝钢焦化废水原有AO-O工艺改造升级为A-O-A-O二段脱氮工艺,并对生化出水实施进一步的物化混凝处理。改造后,工艺长期运行稳定,最终出水完全达到上海市污水综合排放标准(DB 31/199-2009)TN≤35 mg/L的要求,并满足氰化物、氟化物以及COD的排放要求。     

应用加载磁混凝处理微污染河水

实验对比考察了常规混凝和加载磁混凝工艺对微污染河水中COD、浊度和TP等污染物的去除效果,系统研究了混凝剂用量、磁种加载量、搅拌条件和药剂投加顺序等因素对加载磁混凝效果的影响。实验结果表明,加载磁种后沉淀颗粒的体积平均粒径为从常规混凝工艺的50.1μm显著增加到68.6μm;污染物去除效果明显优于常规混凝工艺,尤其对浊度和总磷的去除效果得到了显著的提升;在实验最优条件下COD、浊度和TP的去除率分别达到54.17%、99.28%和75.82%;并且加载磁种后可减少50%以上的混凝剂投加量,同时大大缩短沉淀时间。     

Fenton法处理垃圾渗滤液的参数优化及反应动力学模型

采用Fenton法处理垃圾渗滤液,研究反应时间、初始浓度、pH、Fenton试剂用量对垃圾渗滤液TOC去除率的影响。研究结果表明,最优反应条件是反应时间30 min,初始pH为3.0,初始[H2O2]0=7 310 mg/L,最佳[H2O2]/[Fe2+]摩尔比为5,反应温度为室温,此时渗滤液的TOC去除率达到70.3%。渗滤液矿化过程符合一级反应动力学,并建立了符合该渗滤液的反应动力学模型。     

发酵类抗生素废水处理工艺及运行效果

介绍了内蒙古某抗生素废水处理厂的处理工艺流程、处理单元类型及其详细设计参数,通过对该污水处理厂半年内运行效果的调研,分析评价该污水处理系统的处理效果及出水指标;该水厂工艺流程对COD、TOC、氨氮、总氮、总磷、BOD和急性毒性的平均去除率分别为96.52%、95.83%、50.24%、55.20%、62.05%、98.52%和99.14%,COD、氨氮、总氮、总磷出水水质分别为477、438、556.7和7.69 mg/L,达到排放到城区下水道要求,园区内所有废水汇集到园区污水处理厂进行集中深度处理达标后排放水体。通过对该水厂工艺的介绍和水质分析,为我国抗生素生产企业面临的废水处理工艺类型选择及工程改造升级提供一定参考。     

Comparison of Fenton and Photo-Fenton Processes for Livestock Wastewater Treatment

In this study, the photochemical degradation of livestock wastewater was carried out by the Fenton and Photo-Fenton processes. The effects of pH, reaction time, the molar ratio of Fe^{2 +}/H₂O₂, and the Fe^{2 +} dose were studied. The optimal conditions for the Fenton and Photo-Fenton processes were found to be at a pH of 4 and 5, an Fe^{2 +} dose of 0.066 M and 0.01 M, a concentration of hydrogen peroxide of 0.2 M and 0.1 M, and a molar ratio (Fe^{2 +}/H₂O₂) of 0.33 and 0.1, respectively. The optimal reaction times in the Fenton and Photo-Fenton processes were 60 min and 80 min, respectively. Under the optimal conditions of the Fenton and Photo-Fenton processes, the chemical oxygen demand (COD), color, and fecal coliform removal efficiencies were approximately 70–79, 70–85 and 96.0–99.4%, respectively.     

Treating solid dairy manure using microwave-enhanced advanced oxidation process

The microwave enhanced advanced oxidation process (MW/H₂O₂-AOP) was used to treat separated solid dairy manure for nutrient release and solids reduction. The MW/H₂O₂-AOP was conducted at a microwave temperature of 120°C for 10 minutes, and at three pH conditions of 3.5, 7.3 and 12. The hydrogen peroxide dosage at approximately 2 mL per 1% TS for a 30 mL sample was used in this study, reflecting a range of 0.53–0.75 g H₂O₂/g dry sludge. The results indicated that substantial quantities of nutrients could be released into the solution at pH of 3.5. However, at neutral and basic conditions only volatile fatty acids and soluble chemical oxygen demand could be released. The analyses on orthophosphate, soluble chemical oxygen demands and volatile fatty acids were re-examined for dairy manure. It was found that the orthophosphate concentration for untreated samples at a higher % total solids (TS) was suppressed and lesser than actual. To overcome this difficulty, the initial orthophosphate concentration had to be measured at 0.5% TS.