Enhanced catalytic complete oxidation of 1,2-dichloroethane over mesoporous transition metal-doped γ-Al2O3

High-surface-area mesoprous powders of γ-Al₂O₃ doped with Cu^2 +, Cr^3 +, and V^3 + ions were prepared via a modified sol–gel method and were investigated as catalysts for the oxidation of chlorinated organic compounds. The composites retained high surface areas and pore volumes comparable with those of undoped γ-Al₂O₃ and the presence of the transition metal ions enhanced their surface acidic properties. The catalytic activity of the prepared catalysts in the oxidation of 1,2-dichloroethane (DCE) was studied in the temperature range of 250–400°C. The catalytic activity and product selectivity were strongly dependent on the presence and the type of dopant ion. While Cu^2 +- and Cr^3 +-containing catalysts showed 100% conversion at 300°C and 350°C, V^3 +-containing catalyst showed considerably lower conversion. Furthermore, while the major products of the reactions over γ-alumina were vinyl chloride (C₂H₃Cl) and hydrogen chloride (HCl) at all temperatures, Cu- and Cr-doped catalysts showed significantly stronger capability for deep oxidation to CO₂.     

Apportioning aldehydes: Quantifying industrial sources of carbonyls

<正>In their recent Journal of Environmental Sciences publication,Wang and colleagues provide field evidence that industrial activities can contribute substantially to atmospheric carbonyl concentrations(Wang et al.,2015).These results may helpto explain underestimations of carbonyl emissions in currently available emission inventories,and highlight the need for an improved understanding of industrial sources of this class of compounds.In the atmosphere,carbonyl compounds photolyze to yield     

Cu–Mn–Ce ternary mixed-oxide catalysts for catalytic combustion of toluene

Cu–Mn, Cu–Mn–Ce, and Cu–Ce mixed-oxide catalysts were prepared by a citric acid sol–gel method and then characterized by XRD, BET, H₂-TPR and XPS analyses. Their catalytic properties were investigated in the toluene combustion reaction. Results showed that the Cu–Mn–Ce ternary mixed-oxide catalyst with 1:2:4 mole ratios had the highest catalytic activity, and 99% toluene conversion was achieved at temperatures below 220°C. In the Cu–Mn–Ce catalyst, a portion of Cu and Mn species entered into the CeO₂ fluorite lattice, which led to the formation of a ceria-based solid solution. Excess Cu and Mn oxides existed on the surface of the ceria-based solid solution. The coexistence of Cu–Mn mixed oxides and the ceria-based solid solution resulted in a better synergetic interaction than the Cu–Mn and Cu–Ce catalysts, which promoted catalyst reducibility, increased oxygen mobility, and enhanced the formation of abundant active oxygen species.     

桂林市公共场所空气污染的检测与分析

采用甲醛检测仪、有机气体检测仪等测试分析了桂林市宾馆、商场、候车室、家具城、文化娱乐场等公共场所的甲醛和TVOC浓度。结果显示:候车室和文化娱乐场所的甲醛、TVOC合格率均为100%;宾馆、商场、家具城的TVOC合格率分别为98.7%、98.9%、95.0%,甲醛合格率分别为78.8%、91.1%、85.0%;皮革制品、家具板材等为主要的甲醛和TVOC污染源。     

城市安全供水综合指数研究-以太原为例

采集太原市不同区住户的自来水和12种瓶装水,分析了水中无机离子和挥发性有机物( VOCs)成分.结果表明,无机离子和VOCs的总浓度范围分别为1.08~354.18 mg/L和0.43~13.98 μg/L;自来水中的无机离子与VOCs 含量最高,约是瓶装水中浓度的三倍.加热与过滤处理措施均可改善自来水水质,对水中无机离子和VOCs的去除效果均可达19%~100%,其中过滤可能会引发VOCs的二次污染 .根据饮用水标准,使用饮用水水质指数( DWQI)模型对水质评价结果显示,太原市饮用水水质总体较好.     

典型印染废水处理过程中芳香烃化合物的污染特征及污泥生态风险评价

采用GC-MS测定了典型综合印染废水处理厂废水和污泥中芳香烃化合物的含量.结果表明,原水中苯系物总量为203.96±15.18μg·L-1,其中二甲苯占62.7%,尾水中苯系物总量为0.2±0.029μg·L-1,整个处理工艺对苯系物的去除效率为99%.原水中多环芳烃(PAHs)总浓度达1349.51±35.77 ng·L-1,以3—6环为主,主要富集在颗粒物上.整个工艺对PAHs的去除效率为95%,尾水中PAHs总浓度为65.81±20.99ng·L-1,以2—3环为主.干污泥中PAHs含量高达2996.10±151.0 ng·g-1,污泥吸附为水相中PAHs去除的主要机理之一.印染污泥直接填埋或农用会引起潜在的生态危害.     

固定化多酚氧化酶对水中苯酚和氯酚的去除

以壳聚糖/蒙脱土插层复合物为载体,吸附法制备固定化多酚氧化酶,并以此催化氧化去除水中的苯酚、4-氯苯酚和2,4-二氯苯酚.考察了固定化多酚氧化酶的制备条件,对酚类化合物的催化氧化条件、动力学特性以及固定化酶的重复使用性能.结果表明,固定化多酚氧化酶的最佳制备条件为p H 5.0,酶与载体质量比20 mg·g-1,固定化6 h,所得固定化酶的载酶量为12.12 mg·g-1,每克单位载体酶活为12.76×103U·g-1.固定化多酚氧化酶对酚类化合物的最佳去除条件为:苯酚溶液p H 7.0,温度30℃;4-氯苯酚溶液p H 5.0,温度20℃;2,4-二氯苯酚溶液p H 5.0,温度30℃.在最佳反应条件下,酶与底物质量比为20 mg·mg-1时,固定化多酚氧化酶对苯酚、4-氯苯酚和2,4-二氯苯酚溶液去除率分别为63.6%、85.8%和87.8%.苯酚、4-氯苯酚和2,4-二氯苯酚的米氏常数Km值依次减小,最大反应速率Vmax依次增大,表明固定化酶对2,4-二氯苯酚的亲和力最强,催化速度最快.固定化酶循环使用6次(24 h)后对苯酚、4-氯苯酚和2,4-二氯苯酚的去除率分别为15.7%、24.2%和27.8%.     

基于放射性碳分析的多环芳烃源解析:技术进展和准确性评估

化石燃料燃烧和生物质燃烧是污染物多环芳烃(polycyclic aromatic hydrocarbon,PAHs)的两大来源.放射性碳(14C)分析近年用于评估这两类源对环境中PAHs的相对贡献.此方法基于化石燃料和生物质的14C含量差异,即化石燃料不含14C,而生物质的14C浓度有一个较稳定值.14C的自然丰度极低(约10-12),因此检测PAHs这样的痕量污染物的14C含量一度极具挑战.1990年代中期,加速器质谱的技术突破使得对环境样品PAHs的14C分析具有实用价值.要准确测出PAHs的14C含量,须先从化学成分复杂的环境样品中分离出高纯度的PAHs.制备气相色谱因其出色的分离能力而成为目前环境样品PAHs14C分析必备的工具.本文意在简介基于14C分析的PAHs源解析的基本原理、技术进展,以及评估该方法获得的PAHs源解析结果的准确性.     

长江重庆段表层水体中多环芳烃的分布及来源分析

采集了长江重庆段干流以及重要支流共7个断面的表层水样,采用液相色谱法分析15种优先控制的多环芳烃(PAHs).结果表明,水体中总PAHs浓度范围为6.44—109.39 ng·L-1,平均值为41.83 ng·L-1.在5个断面水体中检出苯并(a)芘,浓度为0.05—1.32 ng·L-1,低于我国地表水标准限值(2.8 ng·L-1).长江重庆段的PAHs浓度水平低于大部分国内其他河流,与国外一些河流的浓度水平相当.PAHs组成以中低环PAHs(3环和4环)为主,平均比例分别为55.7%和38.8%,高环PAHs(5环和6环)含量较低,分别占3.6%和1.9%.示踪PAHs比值法结果显示长江重庆段表层水体PAHs主要来源于石化产品的泄漏污染.