利用土著微生物处理焚烧飞灰及资源化初探

利用从自然界花坛土壤中筛选的土著脲酶微生物开展了微生物诱导碳酸盐沉淀作用(MICP)处理垃圾焚烧飞灰试验,通过颗粒级配、无侧限抗压强度、重金属浸出毒性测试对固化/稳定化效果进行了评价.结果表明,在土著微生物附著剑菌(Ensifer adhaerens)的MICP作用及飞灰火山灰性的共同作用下,飞灰固化、稳定化效果明显;在较优工况下,无侧限抗压强度可达205.2kPa,弹性模量可达200MPa,主要重金属元素Cd、Cr、Pb、Zn、Cu的浸出浓度满足《地表水环境质量标准》Ⅲ类要求.在此基础上,利用有限元软件ABAQUS分析了将固化飞灰用作道路路面和路基之间填料后,对沥青路面性能的影响.结果表明:在路面碎石基层与路基之间设置固化飞灰层,可有效降低沥青路面底部拉应变,延长疲劳寿命,有效减轻车辙损伤,可作为大量消纳飞灰的处理途径之一.     

微波消解-原子荧光光谱法测定垃圾焚烧飞灰中铅

采用微波消解-原子荧光光谱法测定了垃圾焚烧飞灰中铅的含量。重点研究了铁氰化钾的用量以及加入盐酸羟胺对测定结果的影响。试验结果表明:加入铁氰化钾可以促进铅烷生成,盐酸羟胺可起到抑制干扰的作用。方法的检出限为0.39μg/L,回收率为83.6%～101.3%。     

Synthesis of mesoporous silica materials from municipal solid waste incinerator bottom ash

Incinerator bottom ash contains a large amount of silica and can hence be used as a silica source for the synthesis of mesoporous silica materials. In this study, the conditions for alkaline fusion to extract silica from incinerator bottom ash were investigated, and the resulting supernatant solution was used as the silica source for synthesizing mesoporous silica materials. The physical and chemical characteristics of the mesoporous silica materials were analyzed using BET, XRD, FTIR, SEM, and solid-state NMR. The results indicated that the BET surface area and pore size distribution of the synthesized silica materials were 992 m²/g and 2–3.8 nm, respectively. The XRD patterns showed that the synthesized materials exhibited a hexagonal pore structure with a smaller order. The NMR spectra of the synthesized materials exhibited three peaks, corresponding to Q² [Si(OSi)₂(OH)₂], Q³ [Si(OSi)₃(OH)], and Q⁴ [Si(OSi)₄]. The FTIR spectra confirmed the existence of a surface hydroxyl group and the occurrence of symmetric Si–O stretching. Thus, mesoporous silica was successfully synthesized from incinerator bottom ash. Finally, the effectiveness of the synthesized silica in removing heavy metals (Pb²⁺, Cu²⁺, Cd²⁺, and Cr²⁺) from aqueous solutions was also determined. The results showed that the silica materials synthesized from incinerator bottom ash have potential for use as an adsorbent for the removal of heavy metals from aqueous solutions.     

一种烟气脱硝预除尘装置

提出了一种新型的用于脱硝反应前的高效除尘装置；该装置包含与烟气进口相连接的烟气管道和与烟气管道输出口连接的脱硝反应器，在烟气管道靠近烟气进口位置设有两级预除尘器。一级预除尘器为设置在竖直烟道最底部的锥形灰斗，二级预除尘器包括设置在水平烟道扩径处的角形挡板和平形挡板。经预除尘装置后使烟气的烟尘含量大大减少，可显著提高脱硝效果。     

草木灰对亚甲基蓝的吸附研究

本实验目的是研究草木灰对吸附亚甲基蓝的去除效果,探讨了亚甲基蓝初始量、吸附时间、pH值等对吸附效果的影响,并运用伪一级、伪二级反应动力学模型和Laugmuir、Freundlich等温线模型进行拟合。结果表明,草木灰对亚甲基蓝溶液的吸附在5 min~30 min速率比较快,约在65 min内达到吸附平衡,pH越大越有利于吸附,浓度在5mg/L时草木灰对亚甲基蓝的吸附最佳。与伪二级动力学曲线模型拟合效果较好,由Laugmuir等温线模型计算得出理论最大吸附容量Qm为2.275 mg/g,吸附性能优异。     

生活垃圾焚烧发电厂设计新思路探讨

以兴义市生活垃圾焚烧发电厂工程为例,介绍了该项目设计的主要内容;总结了项目设计中节省投资和改善环境的新思路,以助于推进生活垃圾焚烧处理技术的应用。     

Coupling magnetic particles with flocculants to enhance demulsification and separation of waste cutting emulsion for engineering applications

Magnetic particles were coupled with a flocculant to enhance the demulsification and separation of waste cutting emulsions. The optimal magnetic particle size and critical magnetic field conditions were investigated to achieve large-scale engineering application of magnetic demulsification separation for waste cutting emulsion treatment. The micro-scale magnetic particles were found to show comparable effects to nano-scale magnetic particles on enhancing the demulsification and separation of cutting emulsions, which are beneficial for broadening the selectivity of low-cost magnetic particles. The critical magnetic separation region was determined to be an area 40 mm from the magnetic field source. Compared to the flocculant demulsification, the magnetic demulsification separation exhibited a significant advantage in accelerating flocs–water separation by decreasing the separation time of flocs from 180–240 min to less than 15 min, compressing the flocs by reducing the floc volume ratio from 60%–90% to lower than 20%, and showing excellent adaptability to the variable properties of waste cutting emulsions. Coupled with the design of the magnetic disk separator, continuous demulsification separation of the waste cutting emulsion was achieved at 1.0 t/hr for at least 10 hr to obtain clear effluent with 81% chemical oxygen demand removal and 89% turbidity reduction. This study demonstrates the feasibility of applying magnetic demulsification separation to large-scale continuous treatment of waste emulsion. Moreover, it addresses the flocs–water separation problems that occur in practical flocculant demulsification engineering applications.     

餐厨废油捕收剂浮选高炭粉煤灰

通过对餐厨废油进行处理,制备餐厨废油捕收剂用以处理高炭粉煤灰.分别采用机械活化试验确定高炭粉煤灰原灰的最佳机械活化时间,通过不同温度工况的浮选试验获得餐厨废油捕收剂的脱炭性能规律并同常规捕收剂煤油对比,通过FTIR、SEM、TG等技术对餐厨废油捕收剂和脱炭产物进行系统分析.结果表明：最佳机械活化时间为30min,最佳温度工况下,浮选炭热值可达到中高热值燃料要求,产物脱炭粉煤灰矿物成分可达到Ⅰ级粉煤灰标准.真正实现了"以废治废"和"变废为宝",对环境保护、节能减排和资源的综合利用有着重要意义.     

垃圾焚烧飞灰热处理过程中Zn的挥发机理研究

试验在650~1350℃条件下探讨了温度和时间对飞灰中Zn的挥发率的影响,采用XAFs对飞灰及二次飞灰中Zn的赋存形态进行分析,运用吉布斯自由能理论推导了Zn的氯化反应途径,并开展了验证试验.结果表明：温度是影响Zn挥发的主要因素,其挥发趋势随温度先增加而后降低,在1000℃时挥发率达到最高,而时间对其挥发效果影响较小;Zn主要以氯化物形态挥发,从假设反应途径的吉布斯自由能理论计算及验证试验得出,热处理过程中Zn的氯化反应分两步进行,首先飞灰中氯化物与SiO₂反应生成Cl₂,而后与ZnO反应生成ZnCl₂,而小部分Cl₂可能与水蒸气反应形成HCl,再与ZnO反应生成ZnCl₂.     

污泥焚烧残渣水热合成NaPl型沸石和水钙沸石的性质研究

本文以污泥焚烧残渣为原料,以传统水热合成方法制得NaPl型沸石和水钙沸石,并对其相关指标进行表征．经x射线衍射、扫描电镜和红外光谱测定表明,制得的产物为无其它杂晶生成的NaPl型沸石和水钙沸石,且具有放射束片状晶体形貌和沸石骨架结构．与原污泥焚烧残渣相比,合成沸石的比表面积和阳离子交换容量提高了47倍、17倍,分别达到...