Isotopic composition (C & N) of the suspended particles and N uptake by phytoplankton in a shallow tropical coastal lagoon

The spatial distribution of the C/N ratios and variations in δ¹³C and δ¹⁵N of suspended particulate matter were used to characterise their source in Asia’s largest brackish water lagoon, Chilika, India. In addition, the significance of re-mineralised nutrients in the primary productivity of the shallow lagoon was also determined through quantification of the subsurface nitrogen uptake conditions at two relatively stable locations in the lagoon. The results indicated that the influence of terrestrial organic matter was the maximum in the northern sector and was relatively limited at the central and southern part of the lagoon. In situ ¹⁵N uptake experiments (daytime) under biogeochemically stable conditions revealed that the N uptake by phytoplankton ranged between 0.24 and 1.01?mM?m^?3?h^?1 during pre-monsoon and post-monsoon seasons. New production and regenerated production in the shallow lagoon was also estimated by calculating f-ratios (ratio of nitrate assimilation by phytoplankton to total nitrogenous nutrient assimilation, have been estimated), which varied from 0.52 in the post-monsoon to 0.38 in the pre-monsoon. Lowering of the f-ratio from post- to pre-monsoon indicated a dominance of mineralisation over the new production.     

Evaluation of Existing and Modified Wetland Equations in the SWAT Model

The ability to accurately simulate flow and nutrient removal in treatment wetlands within an agricultural, watershed‐scale model is needed to develop effective plans for meeting nutrient reduction goals associated with protection of drinking water supplies and reduction of the Gulf of Mexico hypoxic zone. The objectives of this study were to incorporate new equations for wetland hydrology and nutrient removal in Soil and Water Assessment Tool (SWAT), compare model performance using original and improved equations, and evaluate the ramifications of errors in watershed and tile drain simulation on prediction of NO₃‐N dynamics in wetlands. The modified equations produced Nash‐Sutcliffe Efficiency values of 0.88 to 0.99 for daily NO₃‐N load predictions, and percent bias values generally less than 6%. However, statistical improvement over the original equations was marginal and both old and new equations provided accurate simulations. The new equations reduce the model's dependence on detailed monitoring data and hydrologic calibration. Additionally, the modified equations increase SWAT's versatility by incorporating a weir equation and an irreducible nutrient concentration and temperature coefficient. Model improvements enhance the utility of SWAT for simulating flow and nutrients in wetlands and other impoundments, although performance is limited by the accuracy of inflow and NO₃‐N predictions from the contributing watershed. Editor's note : This paper is part of the featured series on SWAT Applications for Emerging Hydrologic and Water Quality Challenges. See the February 2017 issue for the introduction and background to the series.     

城市大气环境治理成本核算及其总量、结构分析——以西安市为例

基于单位成本分析模型对2000—2009年西安市大气环境治理的价值量进行了系统核算,并从总量与结构两方面对核算结果进行了深入和全面的分析。结果表明,从西安市历年大气环境的实际治理成本(除2002、2006、2009年)来看,该市在大气环境治理方面的投资基本上逐年增加,但是增加幅度较小,而大气环境虚拟治理成本在一般年份(除2002、2006、2009年)总体上呈现先增加后减小的变化趋势。可见,西安市为改变环境污染状况,不断增加大气环境治理方面的投资,但在初期治理资金缺口仍在增加,而随着投资的持续增加,许多大气环境治理设施的建立与作用的发挥,大气环境污染状况逐渐减轻,治理资金缺口开始变小;在核算年份中,西安市工业大气环境污染治理的重点主要放在了烟尘方面,城镇生活SO2虚拟治理成本在生活废气总虚拟治理成本中所占比例最高。最后,针对发现问题,对该市今后大气环境治理工作的方向和措施给出了建议。     

阿什河水系枯水期氮污染特征与同位素源解析

在阿什河水系设置20个采样点,采用水质监测技术和稳定氮同位素示踪技术,研究了枯水期阿什河氮污染特征和硝酸盐氮污染来源。结果表明:(1)阿什河枯水期大部分采样点氨氮浓度较低,大部分区域达到或优于《地表水环境质量标准》(GB3838—2002)中Ⅲ类。上游河段硝酸盐氮浓度较低,中游河段较高,到下游河段略有降低。总氮浓度较高,最高达19.4mg/L。(2)阿什河水系采样点15 N的丰度(δ15 N)主要处于0.11%~0.21%、0.42%~0.78%、0.83%~0.88%和1.09%~1.26%。稳定15 N同位素示踪解析阿什河硝酸盐氮污染来源表明,阿什河上游污染源主要为大气沉降、土壤有机氮和人工化肥;中游主要受畜禽养殖污水和生活污水污染;下游主要受城镇生活污水和工业废水影响。     

钱塘江引水降氮示范工程的构建和运行研究

针对杭州西湖钱塘江引水低碳高氮的特点,提出以改性水草塘—复合垂直流人工湿地(IVCW)相耦合的生物—生态工艺进行引水处理,对该引水降氮示范工程的构建和运行效果进行了跟踪研究。结果表明,整个稳定运行期间(2012年7月19日至11月19日),耦合工艺对COD、TN、硝酸盐氮、TP的平均去除率分别为52.27%、52.49%、53.69%、52.79%,系统出水满足《地表水环境质量标准》(GB 3838—2002)Ⅳ标准;改性水草塘和IVCW单元作为耦合工艺的两个重要组成部分,在脱氮、除磷方面优势互补,从而共同保证出水水质的稳定;在改性水草塘单元,温度与COD的去除效果呈负相关关系,进水C/N与TN去除效果呈正相关关系;而在IVCW单元,温度与COD、TN的去除效果均呈线性正相关关系,进水C/N与两者的去除效果也呈正相关关系,且对COD的影响要大于对TN的影响。     

3种运行模式下CAST工艺脱氮性能

以模拟城市污水为处理对象,采用循环式活性污泥法（CAST）反应器,对3种运行模式（M1：常规模式,M2：缺氧好氧模式、M3：缺氧好氧交替模式）下系统的脱氮性能进行了研究,比较了各模式下CAST反应器的氨氮和总氮的去除效率,并对各模式下典型周期内氮基质浓度变化进行了考察,以确定系统的脱氮模式。结果表明,在氨氮去除不成为限制条件（去除率〉90％）的条件下,3种运行模式下系统总氮的平均去除率分别为67．3％、70．6％和82．4％,以缺氧好氧交替模式下的最高;M1、M2和M3均可实现亚硝酸型硝化,但随着温度的升高,亚硝酸型硝化逐渐消失。静态实验分析表明,3种模式下系统的氨氧化速率大小次序为：vN：M1〉vN：M2〉vN：M3,反硝化速率大小次序为：vDN,M2〉vDN,M3〉vDN,M1。     

竹制填料生物接触氧化工艺处理污染河水简

针对受污染的湖溪河水质特征,以传统弹性塑料填料做对比,研究以竹球和竹丝为填料的生物接触氧化工艺,考察填料的挂膜时间、生物量和污水处理效果;确定连续曝气和间歇曝气时反应器的最优运行工况：连续曝气时为HRT=7.5 h,DO=3 mg/L;间歇曝气时为厌氧1.2 h、好氧6.3 h交替运行。实验结果表明,与弹性塑料填料相比,竹制填料挂膜速度快,竹球填料的水处理效果最好;连续曝气最优工况下竹球填料反应器中COD、TN、NH₃-N和TP的平均去除率分别为66.7%、47.9%、57.1%和30.6%;间歇曝气最优工况下竹球填料反应器中COD、TN、NH₃-N和TP的平均去除率分别64.08%、39.95%、60.7%和54.68%;竹制填料可替代传统的塑料填料作为生物接触氧化工艺的载体填料。     

湖库型水体总氮总量控制目标的区域分配研究

基于层次分析法原理,以资源禀赋、社会经济、农业生产生活、污染治理水平为主要考虑因素设计指标体系和层次结构,建立了湖库型水体总氮总量控制目标分配方法,并在石头口门水库流域进行了应用,为湖库型水体总氮总量控制目标分配及石头口门水库流域总氮总量控制提供借鉴。     

含氨氮催化剂生产废水的处理

采用加入淀粉的短程硝化-反硝化一体化技术处理低碳含NH3-N催化剂废水。通过中试确定了适宜的工艺参数,并在工业化装置上进行了验证。试验结果表明：在DO为0.5 mg/L左右、淀粉加入量为0.25 kg/ m3、HRT=30 h的条件下,短程硝化-反硝化一体化技术具有较好的处理效果,NH3-N去除率大于97%,且具有较强的抗冲击负荷的能力; 出水的COD<100 mg/L,ρ（NH3-N）<10 mg/L,达到GB 8978—1996《污水综合排放标准》的一级排放标准。工业化装置的运行费用以NH3-N计为2.3 元/kg、以废水计为4.6 元/t。该法适用于中低浓度（ρ（NH3-N）<300 mg/L）废水的处理。     

Using multivariate regression modeling for sampling and predicting chemical characteristics of mixed waste in old landfills

Municipal solid waste landfills pose a threat on environment and human health, especially old landfills which lack facilities for collection and treatment of landfill gas and leachate. Consequently, missing information about emission flows prevent site-specific environmental risk assessments. To overcome this gap, the combination of waste sampling and analysis with statistical modeling is one option for estimating present and future emission potentials. Optimizing the tradeoff between investigation costs and reliable results requires knowledge about both: the number of samples to be taken and variables to be analyzed.This article aims to identify the optimized number of waste samples and variables in order to predict a larger set of variables. Therefore, we introduce a multivariate linear regression model and tested the applicability by usage of two case studies. Landfill A was used to set up and calibrate the model based on 50 waste samples and twelve variables. The calibrated model was applied to Landfill B including 36 waste samples and twelve variables with four predictor variables.The case study results are twofold: first, the reliable and accurate prediction of the twelve variables can be achieved with the knowledge of four predictor variables (Loi, EC, pH and Cl). For the second Landfill B, only ten full measurements would be needed for a reliable prediction of most response variables. The four predictor variables would exhibit comparably low analytical costs in comparison to the full set of measurements. This cost reduction could be used to increase the number of samples yielding an improved understanding of the spatial waste heterogeneity in landfills.Concluding, the future application of the developed model potentially improves the reliability of predicted emission potentials. The model could become a standard screening tool for old landfills if its applicability and reliability would be tested in additional case studies.