氯对模拟管壁生物膜的氧化特性研究

以载片上培养的大肠杆菌生物膜为对象,研究了氯对模拟管壁生物膜中大肠杆菌的灭活效果,同时考察氯氧化生物膜后水中生物可同化有机碳(AOC)、生物可利用磷(MAP)和细菌生长潜能(BRP)的变化情况.结果表明,氯可以有效灭活悬浮态的大肠杆菌,而对生物膜中的大肠杆菌的灭活效率远低于悬浮菌;在相同CT值下,较高浓度的氯对悬浮态和生物膜中大肠杆菌的灭活效果要高于低浓度的氯.氯对生物膜的氧化作用会使生物膜中物质溶出,增加了水中AOC和MAP浓度,如当氯的浓度为1.0 mg/Ｌ(CT值为100 mg·min/L)时,水中AOC由20.78 μg/L增加到120.17 μg/L,MAP含量由0.11 μg/L增加到0.17 μg/L;氯的氧化作用会增加水的细菌生长潜能（BRP）,BRP随着CT值的增加而增加,如当氯投量为1.0 mg/Ｌ(CT值为100　mg·min/L)时,BRP可达到1.10×10⁷ CFU/mL.     

Dynamic contact angle effects on gas-liquid behaviors in the cathode of proton exchange membrane fuel cell with stirred tank reactor design

Liquid water management is still a critical issue in the improvement of proton exchange membrane fuel cell (PEMFC) performance. In this work, for the first time, the liquid water behavior and transport inside the cathode of a PEMFC with a stirred tank reactor (STR) design, rather than the conventional PEMFC flow channel design, are numerically studied. The dynamic contact angle (DCA) is applied to multiple wall boundaries in the numerical model through a user-defined-function (UDF) code, i.e., STR-DCA model. Another numerical model with the static contact angle (SCA) and same operating conditions, i.e., STR-SCA model, is also developed for comparison. The volume of fluid (VOF) method is employed in the simulation to track the gas-liquid interface. The results show that the liquid water distribution and transport are significantly different between these two models, indicating the remarkable effects of DCA on the simulation results. It is also verified the capability of STR-PEMFC to reduce the liquid water flooding, showing the potential of this channel-less type fuel cell in the further development.     

UASB反应器反硝化处理工业废水

采用絮状污泥成功启动升流式厌氧污泥床(UASB)反应器处理含甲酸、苯胺、环已酮、NO3-等的工业废水。UASB反应器以低负荷启动,10天后逐渐提高进水COD,出水COD保持在710~770 mg/L,COD去除率为40%~60%;出水TOC保持在115~314 mg/L,TOC去除率由60.3%逐渐升高至87.2%,最终维持在81%左右;出水中ρ(NO3-)维持在134~176 mg/L,NO3-去除率为90%左右,系统稳定后NO3-去除率几乎为100%。在进水COD容积负荷不超过5.00 kg/(m3·d)的条件下,实际COD容积负荷稳定在2.00 kg/(m3·d)左右,实际TOC容积负荷稳定在1.00 kg/(m3·d)以上。当进水COD容积负荷不大于4.48 kg/(m3·d)时,COD去除率为55%~74%,TOC去除率为63%~87%,NO3-去除率大于95%。     

体积压力板仪试验操作误差分析

体积压力板仪不仅可用于测试非饱和土的脱湿曲线,还能测试其浸湿曲线,对研究土壤与水分之间的物理关系具有重要意义.本文对2bar体积压力板仪的试验操作原理和步骤进行了详细说明,重点对试验操作中可能产生的误差和各种影响因素进行了分析,并以武汉市汉阳黏土土-水特征曲线试验为例,分析了导致试验误差产生的各种影响因素,以为采用体积...     

Evaluation of trajectories calculated from ecmwf data against constant volume balloon flights during etex

This paper validates trajectories calculated from ECMWF analyses against the tracks of constant volume balloons (CVBs) released during the European tracer experiment (ETEX). The altitudes of the calculated trajectories were adjusted to the altitudes of the respective balloons in short intervals to allow direct comparisons. The agreement between the calculated trajectories and the balloon tracks was very good for the first experiment (individual errors from 1 to 26%, average 15%), and excellent (errors from 2 to 11%, average 6%) for the second one. The agreement for the second experiment was probably partly better because the CVBs travelled above the planetary boundary layer, but the small errors also indicate that the ECMWF fields of the horizontal wind were of exceptionally good quality in the second experiment. This is in sharp contrast to the results of the dispersion models which all failed in the prediction of the perfluorocarbon tracer dispersion for the second experiment. A likely explanation for this is that vertical motions, possibly on small scales, were not correctly captured by the ECMWF analyses, but it is not possible to clarify this with the CVB data.     

废弃电器电子产品POPs/PTS减排环境管理实践研究

全球环境基金(GEF)"通过环境无害化管理减少电器电子产品的生命周期内持久性有机污染物和持久性有毒化学品(POPs/PTS)的排放全额示范项目"湖北省作为项目示范省之一.三家废弃电器电子产品拆解企业,分别开展了废弃电器电子产品拆解技术示范、湿法废弃印刷电路板处置BAT/BEP技术示范、利用再生铅连续熔炼炉协同处置阴极射线管含铅锥玻璃项目技术示范.电子废弃物全自动化分类与拆解生产线,为电子废弃物绿色循环与资源化提供了示范模式.     

邀山阁游客流量控制研究

邀山阁是一座4层砖石结构楼阁,目前西北角墙体倾斜严重且墙体、石柱存在竖向裂缝。基于保护邀山阁的需要,应用等效体积单元(RVE)进行墙体的有限元分析,通过调整弹性模量和优化有限元模型来模拟砌体带裂缝时的工作状态;在应力值及其变化值比较大的关键部位选取了26个控制点,进行应力包络分析;在合理的安全系数和游客荷载最不利工况下,得到了邀山阁游客的合理控制数量。本研究将有益于古建筑的长期保护和合理开发利用。     

排烟方式对大空间建筑火灾空气升温的影响

为了考察烟气排放对大空间建筑火灾温度场的影响,利用FDS程序仿真模拟了火灾场景,系统分析了不同排烟系统对温度场的影响。结果表明:烟气排放对温度的影响较大,最大降温幅度可达原最高温度的50%左右;降温幅度与建筑高度有密切联系;当建筑高度小于12m时,按规范设计的自然排烟系统下的火场温度低于机械排烟的火场温度;当建筑高度达到或超过12m时,自然排烟系统下的火场温度将接近或高于机械排烟的火场温度。     

古夫河着生藻类优势种体积与水质因子的相关性研究

通过研究长江三峡库区古夫河着生藻类优势种体积的变化,探索影响其体积的主要水质因子,为河流水质评价提供依据.于2010年12月至2012年2月,对古夫河着生藻类和地表水采样11次,共鉴定着生藻类197种,检测水质指标10项.选取Mcnaughton优势度指数(Y)>0.02的着生藻类(共30种)作为优势种并计算体积;利用主成分分析(PCA)分析优势种藻类在不同月份的体积变化.结果显示,硅藻门对冷暖季的变化较为敏感.将水质因子与优势种藻类体积进行典范对应分析(CCA),结果显示水质因子与藻类体积相关性大小为:溶解氧>氨氮>叶绿素a>酸碱度>硝态氮>总磷>水温>总氮>总有机碳>化学需氧量.Monte Carlo显著性检验结果为溶解氧和氨氮对着生藻类体积的影响最大,其次为叶绿素a、酸碱度和硝态氮.硅藻门藻类体积的变化可以判断古夫河水体中溶解氧、氨氮、叶绿素a、酸碱度、硝态氮的含量与变化.     

重庆渝北地区土壤重金属形态特征及其有效性评价

结合渝北地区土壤重金属全量及形态分析,对区内主要土壤类型(紫色土、石灰土、黄壤、水稻土)中的As、Cd、Cr、Pb形态构成特征、影响因素及有效性进行研究. 结果表明:不同土壤类型重金属形态构成差异明显,Cr、Pb在各土壤类型中均以残渣态为主;Cd在黄壤、紫色土中以离子态、残渣态为主,其中离子态平均构成在2类土中分别高达37.44%、29.97%. w(可利用态As)和w(可利用态Cr)在紫色土中的平均值分别为0.04和0.96mg/kg,w(可利用态Cd)在水稻土和紫色土中的平均值分别为0.13和0.09mg/kg,w(可利用态Pb)在黄壤中的平均值为1.94mg/kg,表现出较高生物有效性;石灰土中各重金属可利用态总体较低. w(可利用态As)、w(可利用态Cd)分别与As全量(以w计,下同)、Cd全量呈显著正相关;w(可利用态Cd)和w(可利用态Pb)与pH,w(可利用态Cr)与w(有机质)均呈显著负相关. 紫色土中w(可利用态Cd)、w(可利用态Cr)和w(可利用态Pb)与各重金属全量、pH和w(有机质)三者显著服从多元非线性对数回归,通过该回归可对研究区紫色土这3个元素的可利用态含量进行预测.