Simulating mesoscale transport and diffusion of radioactive noble gases using the Lagrangian particle dispersion model

In order to simulate the impact of mesoscale wind fields and to assess potential capability of atmospheric Lagrangian particle dispersion model (LPDM) as an emergency response model for the decision supports, two different simulations of LPDM with the mesoscale prognostic model MM5 (Mesoscale Model ver. 5) were driven. The first simulation of radioactive noble gas ((85)Kr exponent) emitted during JCO accident occurred from 30 September to 3 October 1999 at Tokai, Japan showed that the first arriving short pulse was found in Tsukuba located at 60km away from the accidental area. However, the released radioactive noble gas was transported back to the origin site about 2 days later due to the mesoscale meteorological wind circulation, enhancing the levels of (85)Kr with the secondary peak in Tsukuba. The second simulation of atmospheric dilution factors (the ratio of concentration to the emission rate, chi/Q), during the underground nuclear test (UNT) performed by North Korea showed that high chi/Q moved to the eastward and extended toward southward in accordance with the mesoscale atmospheric circulations generated by mesoscale prognostic model MM5. In comparison with the measurements, the simulated horizontal distribution patterns of (85)Kr during the JCO are well accord with that of observation in Tsukuba such as the existence of secondary peak which is associated with the mesoscale circulations. However, the simulated level of (85)Kr anomaly was found to be significantly lower than the observations, and some interpretations on these discrepancies were described. Applications of LPDM to two mesoscale emergency response dispersion cases suggest the potential capability of LPDM to be used as a decision support model provided accurate emission rate of accident in case of a large accident.     

Evaporating liquid flow in a channel (An integral model based on shallow water flow approximation)

Liquefied Natural Gas (LNG) storage facilities generally include channels to convey potential spills of the liquid to an impoundment. There is increasing concern that dispersion of vapors generated by flow of LNG in a channel may lead to higher than limit vapor concentrations for safety at site boundary from channels that may be close to the dike walls. This issue is of recent concern to regulatory agencies, because the calculation of vapor hazard distance(s) from LNG flow in a channel is not required under existing LNG facility siting standards or regulations.An important parameter that directly affects the calculated LNG vapor dispersion distance is the source strength (i.e., the rate of vaporization of LNG flow from the wetted channel surfaces, as a function of spatial position and time). In this paper a model is presented which considers the variation of the depth of the flowing LNG with spatial location and time, and calculates the spatial and temporal dependence of the mass rate of vapor generation. Self similar profiles for the spatial variation of the thermal boundary layer in the liquid wetted wall and liquid depth variation are assumed. The variation with time of the location of the liquid spread front and the evaporation rate are calculated for the case of a constant LNG spill rate into a rectangular channel. The effects of two different channel slopes are evaluated. Details of the results and their impact on dispersion distances are discussed.     

Dispersion of the vapour cloud in the Buncefield Incident

Dispersion of the flammable vapour cloud in the 2005 Buncefield Incident is examined. Footage from security cameras around the site is analysed and the results from Computational Fluid Dynamics (CFD) simulations of the vapour dispersion are presented. It is shown that the shape of the terrain and the presence of obstacles significantly affected the dispersion of vapour from the overflowing tank. The CFD model is shown to produce similar qualitative behaviour to that observed in the incident, both in terms of the arrival time of the vapour cloud and its final depth.     

危险化学品泄漏扩散模型的研究现状分析与比较

为了对危险化学品港口装卸过程中泄漏危险度进行量化评定,基于泄漏扩散模型提高港口的应急处理技术,对危险化学品泄漏扩散模型的研究现状从理论研究、试验研究、应用研究3方面进行深入分析。着重对高斯模型(Gaussian model),BM模型,Sutton模型,FEM3模型,箱及相似模型,P-G模型等模型从理论描述方法、适用对象和范围、计算精度和难易、参数选取等方面进行优缺点的对比研究,认为:由于危险化学品泄漏和扩散行为的复杂性,影响因素的多样性,使各类模型在具备一定的理论价值和现实意义的同时,还存在着参数选取不确定性、试验模拟差异性以及实际应用局限性的问题和不足,运用计算机技术完善试验结果数据库、改进数学仿真模型是其进一步研究发展的趋势。     

西安市秋冬季市区与山区微生物气溶胶组成特征及来源

为探究城市市区与山区微生物气溶胶组成特征及来源,在西安市市区(城区和郊区)及南郊山区设立3个采样点,采集细颗粒物、土壤及叶片样本.通过高通量测序法,解析不同采样点真菌与细菌群落结构,考察其时空变化特征;使用Source Track源解析技术对空气中微生物进行来源分析.结果表明,不同采样点真菌、细菌菌属差异较大,说明地理位置对空气中微生物的群落结构影响显著;冬季市区检测出较多的潜在真菌致病菌和细菌致病菌,且具有较高的相对丰度和多样性.通过源解析技术发现,在局部源叶片和土壤中,叶片表面微生物是空气中微生物的主要潜在源,且秋季叶片对空气中微生物的贡献率高于冬季.本研究不仅为空气中生物气溶胶的溯源研究提供了一定基础,也为深入了解大气中微生物污染特性和为我国空气环境质量评价与疾病预防提供一定的科学依据.     

4种动物养殖场空气中抗生素耐药菌的生物多样性及群落结构

动物集约化养殖场可向空气环境释放大量微生物,包括抗生素耐药菌甚至是耐药致病菌,危害动物和工人健康并污染周边空气环境.针对以上问题,本研究以四环素和红霉素耐药菌为例,对动物养殖场空气颗粒物负载抗生素耐药菌的生物多样性以及群落结构展开研究.基于高通量测序技术,对比分析动物舍内与舍外颗粒物,以及粪便样品中抗生素耐药菌的生物学差异,并研究驱动以上差异的关键菌属.结果表明,整体上养殖场空气颗粒物负载红霉素耐药菌的生物多样性高于四环素耐药菌,舍内空气颗粒物负载生物的多样性高于粪便样品.细颗粒物和粗颗粒物负载抗生素耐药菌的生物多样性和群落结构均无显著差异.Actinobacteria是导致红霉素耐药菌和其他细菌群落差异的关键菌门之一,Staphylococcus是四环素耐药菌群区别于红霉素耐药菌和全部细菌菌群的关键菌属之一.群落结构研究结果显示,四环素和红霉素耐药菌的优势菌群和群落结构没有显著差异.但粪便和空气颗粒物负载生物的群落结构在属水平上差异显著,优势菌门也有所不同.本研究结果将为准确评估动物养殖场空气环境中抗生素耐药菌污染现状及其生态风险提供基础数据.     

Large eddy simulation of plume dispersion behind an aircraft in the take-off phase

The aim of this paper is to provide an investigation, using large eddy simulation, into plume dispersion behind an aircraft in co-flowing take-off conditions. Validation studies of the computational model were presented by Aloysius and Wrobel (Environ Model Softw 24:929–937, 2009) and a study of the flow and dispersion properties of a double-engine aircraft jet was presented by Aloysius et al. (EEC/SEE/2007/001, EUROCONTROL Experimental Centre, ), in which only the engine was modelled. In this paper, the complete geometry of a Boeing 737 is modelled and investigated. The current work represents a contribution towards a better understanding of the source dynamics behind an airplane jet engine during the take-off and landing phases. The information provided from these simulations will be useful for future improvements of existing dispersion models.     

Cr/γ-Al_2O_3对乙酸乙酯的催化燃烧

使用浸渍法制备不同负载量的Cr/γ-Al_2O_3催化剂,研究乙酸乙酯的催化燃烧.BET,XRD结果表明,Cr在γ-Al_2O_3上负载存在分散阈值效应,负载量在阈值以下时呈单层分散形式,在超过阈值时Cr形成结晶,实验测得单层分散阈值与理论计算一致.Raman结果表明Cr在单层分散时为Cr~(6+),而在非单层分散时为Cr_2O_3.催化乙酸乙酯燃烧的活性研究显示,阈值效应对催化活性有显著影响:催化活性在单层分散阈值时最好,此时活化能最高,指前因子最大.     

Analytical solutions of three-dimensional contaminant transport in uniform flow field in porous media: A library

The purpose of this study is to present a library of analytical solutions for the three-dimensional contaminant transport in uniform flow field in porous media with the first-order decay, linear sorption, and zero-order production. The library is constructed using Green’s function method (GFM) in combination with available solutions. The library covers a wide range of solutions for various conditions. The aquifer can be vertically finite, semi-infinitive or infinitive, and laterally semi-infinitive or infinitive. The geometry of the sources can be of point, line, plane or volumetric body; and the source release can be continuous, instantaneous, or by following a given function over time. Dimensionless forms of the solutions are also proposed. A computer code FlowCAS is developed to calculate the solutions. Calculated results demonstrate the correctness of the presented solutions. The library is widely applicable to solve contaminant transport problems of one- or multiple- dimensions in uniform flow fields.     

Validation of modeling approach to evaluate congener-specific concentrations of polychlorinated dibenzo-p-dioxins and dibenzofurans in air and soil near a solid waste incinerator.

A concise modeling approach using long-term averaged meteorological data was developed to estimate site-specific concentrations of congeners of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) near a solid waste incinerator. This approach consists of calculation of atmospheric dispersion, dry and wet deposition of gaseous and particle-bound congeners, and non-steady-state concentrations in soil. The predictability of this approach was evaluated by comparison of calculated concentrations of congeners in soil with those measured at eight locations near a municipal solid waste incinerator (MSWI). The variation of these concentrations due to variability of meteorological parameters is small. A considerable number of mean values show good agreement with measured concentrations within a factor of three. The reasonable agreement between calculated and measured concentrations indicates that algorithms for the calculation of vapor-phase deposition and non-steady-state concentrations in soil must be included in the modeling approach for an accurate estimation of the concentrations of congeners of PCDD/Fs emitted from MSWIs to the atmosphere. For a detailed estimation of site-specific concentrations, it is important to specify the bulk density of soil in the evaluated area, together with meteorological parameters.