Evaluation of thermal reaction for two azo compounds by using 20-L apparatus and calorimetry

Azo compounds are widely involved in the industrial processes of dyes, pigments, initiators, and blowing agents. Unfortunately, these compounds have a bivalent unstable –NN– composition, which can be readily broken when the ambient temperature is elevated. Self-accelerating decomposition might cause a runaway reaction and lead to a fire, explosion, or leakage when the cooling system fails or other events occur. This study investigated the explosion properties, thermal stability parameters, and thermal hazard and mechanism of 2,2′–azobisisobutyronitrile (AIBN) and 2,2′–azobis–2–methylbutyronitrile (AMBN). We used a 20-L apparatus, vent sizing package 2, synchronous thermal analysis, and differential scanning calorimetry under explosive, adiabatic, and dynamic conditions to acquire the explosive curves, thermal curves, and thermodynamic parameters of the substances. Moreover, the differential isoconversional method (Friedman method) and ASTM E698 equation were employed to obtain the apparent activation energy E_a. All the experimental results revealed that AIBN is more dangerous than AMBN. The E_a of AIBN was lower than that of AMBN. The results can be used to construct an azo compound thermal hazard database for use for searches and reference examples by industry and related research areas.     

Co-treatment of fruit and vegetable waste in sludge digesters. An analysis of the relationship among bio-methane generation,process stability and digestate phytotoxicity

The co-digestion of a variable amount of fruit and vegetable waste in a waste mixed sludge digester was investigated using a pilot scale apparatus. The organic loading rate (OLR) was increased from 1.46 kg VS/m³ day to 2.8 kg VS/m³ day. The hydraulic retention time was reduced from 14 days to about 10 days. Specific bio-methane production increased from about 90 NL/kg VS to the maximum value of about 430 NL/kg VS when OLR was increased from 1.46 kg VS/m³ day to 2.1 kg VS/m³ day. A higher OLR caused an excessive reduction in the hydraulic retention time, enhancing microorganism wash out. Process stability evaluated by the total volatile fatty acids concentration (mg/l) to the alkalinity buffer capacity (eq. mg/l CaCO₃) ratio (i.e. FOS/TAC) criterion was <0.1 indicating high stability for OLR <2.46 kg VS/m³ day. For higher OLR, FOS/TAC increased rapidly. Residual phytotoxicty of the digestate evaluated by the germination index (GI) (%) was quite constant for OLR < 2.46 kg VS/m³ day, which is lower than the 60% limit, indicating an acceptable toxicity level for crops. For OLR > 2.46 kg VS/m³ day, GI decreased rapidly. This corresponding trend between FOS/TAC and GI was further investigated by the definition of the GI ratio (GIR) parameter. Comparison between GIR and FOS/TAC suggests that GI could be a suitable criterion for evaluating process stability.     

Development of heat transfer and evaporation model of LNG covered by Hi-Ex foam

Natural gas is a kind of clean, efficient green energy source, which is used widely. Liquefied natural gas (LNG) is produced by cooling natural gas to −161 °C, at which it becomes the liquid. Once LNG was released, fire or explosion would happen when ignition source existed nearby. The high expansion foam (Hi-Ex foam) is believed to quickly blanket on the top of LNG spillage pool and warm the LNG vapor to lower the vapor cloud density at the ground level and raising vapor buoyancy. To identify the physical structure after it contacted with LN₂ and to develop heat transfer model, the small-scale field test with liquid nitrogen (LN₂) was designed. In experiment, three layers including frozen ice layer, frozen Hi-Ex layer and soft layer of Hi-Ex foam were observed at the steady state. By characterizing physical structure of the foam, formulas for calculating the surface of single foam bubble and counting foam film thickness were deduced. The micro heat transfer and evaporation model between cryogenic liquid and Hi-Ex foam was established. Indicating the physical structure of the frozen ice layer, there were a certain number of icicles below it. The heat transfer and evaporation mathematical model between the frozen ice layer and LNG was derived. Combining models above with the heat transfer between LNG, ground and cofferdam, the heat transfer and evaporation mathematical model of LNG covered by Hi-Ex foam was developed eventually. Finally, LN₂ evaporation rate calculated by this model was compared with the measured evaporation rate. The calculated results are 1.2–2.1 times of experimental results, which were acceptable in engineering and proved the model was reliable.     

308 nm光作用下α-Fe2O3表面HNO3的光解

采用紫外可见光谱(UV-Vis)、傅立叶变换红外光谱(FTIR)及离子色谱(IC)技术对HNO3在α-Fe2O3表面暗反应和308nm下光解反应进行了研究.考察了时间、HNO3浓度、相对湿度(RH)等条件对反应的影响.结果表明,随着HNO3浓度、光照时间的增加,HNO3在气相与α-Fe2O3表面光解产物浓度均呈指数增加;HNO3在α-Fe2O3表面光解产生的NO2、NO分别为气相产生的3.27及3.87倍,而无论气相还是表面光解的NO2浓度均约为NO的2倍.随着RH的增加,HNO3光解产生的HONO的浓度随之呈指数增大,其产率从RH 20%时的0.023增加到90%时的0.087.α-Fe2O3的表面效应在HNO3的表面光解反应中起主导作用.     

容积负荷对ABR-MBR工艺反硝化除磷性能的影响

采用连续流ABR-MBR组合工艺处理生活污水,研究不同容积负荷(volume loading rate,VLR)对该工艺反硝化除磷性能的影响,获得最佳工艺参数.试验考察ABR进水容积负荷(以COD计,下同)分别为0.76、1.01、1.51和2.27 kg·(m~3·d)~(-1)时系统去碳脱氮除磷的性能,并在各ABR容积负荷条件下考察MBR容积负荷对MBR反应器硝化性能的影响.结果表明,在ABR进水容积负荷为1.51 kg·(m~3·d)~(-1)的条件下,系统A2隔室COD去除量最大,并在MBR容积负荷为0.462 kg·(m~3·d)~(-1)时,MBR反应器中实现了短程硝化,系统NH_4~+-N和TN去除率分别达到90%和72%以上,厌氧释磷量为7.41 mg·L~(-1),缺氧吸磷量达到15.42 mg·L~(-1),出水PO_4~(3-)-P浓度低于0.5 mg·L~(-1),这表明短程硝化更有利于强化ABR-MBR系统的反硝化除磷性能.     

常规施肥条件下农田不同途径氮素损失的原位研究:以长江中下游地区夏玉米季为例

为了解农田常规施肥条件下的不同途径氮素损失特征,本文通过田间原位试验同步研究了长江中下游地区夏玉米生长季氮肥施用后的农田N2O排放、NH3挥发、氮渗漏和地表径流的变化.结果表明,在复合肥为基肥,尿素为追肥,基追肥氮素水平均为150 kg·hm-2的条件下,整个玉米生长季N2O排放系数为3.3%,NH3挥发损失率为10.2%,氮渗漏和地表径流损失率分别为11.2%和5.1%.此外,基肥施用以氮素渗漏损失为主,而追肥氮素损失以氨挥发和渗漏为主,表明不同途径化肥氮素损失主要受氮肥品种影响,玉米季追肥可改用低氨挥发氮肥品种以减少氮素损失.     

Assessment of the clear-sky bias issue using continuous PM10 data from two AERONET sites in Korea

A bias in clear-sky conditions that will be involved in estimating particulate matter(PM)concentration from aerosol optical depth(AOD) was examined using PM_(10) from two Aerosol Robotic Network sites in Korea. The study periods were between 2004 and 2007 at Anmyon and between 2003 and 2011 at Gosan, when both PM_(10) and AOD were available. Mean PM_(10) when AOD was available(PM AOD) was higher than that from all PM_(10)data(PM all) by 5.1 and9.9 μg/m~3 at Anmyon and Gosan, which accounted for 11% and 26% of PM all, respectively.Because of a difference between mean PM_(10) under daytime clear-sky conditions(PM clear)and PM AOD, the variations in ΔPM_(10), the difference of PM all from PM clear rather than from PM AOD, were investigated. Although monthly variations in ΔPM_(10)at the two sites were different, they were positively correlated to those in ΔT, similarly defined as ΔPM_(10)except for temperature, at both sites. ΔPM_(10)at Anmyon decreased to a negative value in January due to an influence of the Siberian continental high-pressure system while ΔPM_(10)at Gosan was high in winter due to an effect of photochemical production at higher temperatures than at Anmyon.     

港口罢工对周边空气质量的影响

港口污染物的排放浓度极大地影响着周边的空气质量,以2013年3月28日香港国际集装箱码头发生的罢工事件为契机来探究港口运作短暂的瘫痪对周边空气质量的影响。首先,进行污染物之间的相关性分析确定影响本次罢工事件的污染物主要为NO_2、NO_x、SO_2以及O_3。其次,基于罢工前、罢工期间以及罢工后污染物排放的浓度变化,进行横向对比发现罢工期间的污染物确实有一定程度的减少。再次,利用纵向对比排除四季带来的影响探究不同年份同一阶段污染物浓度的变化情况评估罢工期间的空气质量。最后,以NO_2为例建立预测模型对罢工期间的NO_2浓度进行预测,根据实际值与预测值之间的差异来说明罢工影响了NO_2的预测趋势。这项研究主要强调港口空气质量对整个环境的影响,在一定程度上说明政府实施政策的有效性,为政府提供了决策支持,同时也要注重污染物之间的相互转化作用对环境的影响。     

煤制烯烃废水处理与回用技术解析

针对煤制烯烃项目废水的来源及水质特点,从生化处理技术与回用处理技术方面阐述了煤制烯烃废水处理现状及存在问题,展望了煤制烯烃废水处理与回用技术未来发展方向,指出了新型脱氮工艺、膜集成工艺及分质结晶技术在煤制烯烃废水处理中的可行性,为煤化工废水处理与资源化利用提供理论参考。     

餐厨垃圾厌氧消化运行试验研究

采用猪粪厌氧消化的消化污泥为接种物,在中温(37℃)条件下,以连续进料的方式对餐厨垃圾的湿式厌氧消化进行了启动以及运行试验,监测整个实验过程中产气量、pH、VFA、碱度等能够反映厌氧消化的系统指标。结果表明:本实验中系统最佳有机负荷为2.8 kg/(m~3·d)(以VS计),超过此负荷后,依靠系统自身恢复和人工调节,pH很难恢复正常运行状态。正常运行过程中,pH稳定在7.5~8.0,VFA稳定在2 000 mg/L左右,碱度在6 000~9 000 mg/L,氨氮在1 500~2 000 mg/L,底物含水率为96%~98%。系统超负荷运行后,产气量和pH下降,VFA浓度上升,碱度、氨氮、含水率基本保持稳定。