温度与pH对生物合成施氏矿物在酸性环境中溶解行为及对Cu2+吸附效果的影响

探析施氏矿物在不同温度、pH下的溶解行为,对其在酸性煤矿废水(ACMD)重金属去除领域的应用具有重要的工程指导意义.本研究通过摇瓶实验,在0.16mol·L-1FeSO4·7H2O,初始pH为2.5的酸性体系中,采用氧化亚铁硫杆菌A.ferrooxidans催化合成施氏矿物.考察了15℃与30℃,pH为2.0$6.0环境条件下矿物的溶解行为,及生物合成施氏矿物对酸性体系Cu2+的吸附去除效果.研究结果表明,经过24h反应,施氏矿物合成体系pH从原始2.50降低至2.18,体系Fe2+氧化完全,27.3%的铁离子参与矿物的合成,矿物分子式可表示为Fe8O8(OH)4.22(SO4)1.89.生物合成施氏矿物在温度为15℃,pH分别为3.2、3.0、2.8、2.6、2.4、2.2与2.0液态体系中振荡72h,矿物溶解率分别为1.92%、3.34%、5.90%、13.09%、28.74%、44.53%与61.46%.在温度为30℃的上述酸度体系中,矿物溶解率在相应时间却达到2.04%、3.98%、8.34%、20.53%、43.50%、96.74%与99.92%.在pH≥3.5的不同温度液态体系中该矿物无溶解迹象.在15℃,pH为6.0、5.0、4.5、4.0与3.5,Cu2+浓度为40mg·g-1的液态体系中,生物合成施氏矿物对Cu2+的吸附量为(50.9±2.2)、(47.3±13.3)、(40.5±4.7)、(31.1±5.0)及(16.9±6.5)mg·g-1.体系酸度一定,施氏矿物在15℃与30℃条件下对Cu2+的吸附效果无显著差异.本研究结果对生物合成施氏矿物在ACMD重金属去除工程应用提供必要的参数支撑.     

北京城乡结合地空气中挥发性有机物健康风险评价

采用低温固体吸附采样,热脱附-气相色谱-质谱方法对北京城乡结合地空气中挥发性有机物（VOCs）进行了观测分析,并利用国际公认的健康风险评价四步法评价模型,对北京城乡结合地空气中挥发性有机物的健康风险进行了初步评价.结果表明,芳香族类的非致癌风险值在10-4～10-1数量级,卤代烃的非致癌风险值在10-4～10-5数量级,挥发性有机污染物的非致癌风险系数〈1,不会对暴露人群健康造成明显的非致癌危害.但苯的致癌指数较高（2.21×10-5）,超过了USEPA的建议值（1×10-6）,可能对人体健康造成潜在危害.在一年四季的健康风险中,冬季VOCs的健康风险最高,秋季次之,夏季最低.     

Reversibly enhanced aqueous solubilization of volatile organic compounds using a redox-reversible surfactant

Surfactant-enhanced remediation (SER) is an effective method for the removal of volatile organic compounds (VOCs) from contaminated soils and groundwater. To reuse the surfactant the VOCs must be separated from the surfactant solutions. The water solubility of VOCs can be enhanced using reversible surfactants with a redox-acive group, (ferrocenylmethyl)dodecyldimethylammonium bromide (Fcl2) and (ferrocenylmethyl)tetradecanedimethylammonium bromide (Fcl4), above and below their critical micelle concentrations (CMC) under reducing (I⁺) and oxidative (I²⁺) conditions. The CMC values of Fcl2 and Fcl4 in I⁺ are 0.94 and 0.56 mmol/L and the solubilization of toluene by Fcl2 and Fcl4 in I⁺ for toluene is higher than the solubilization achieved with sodium dodecyl sulfate, cetyltrimethylammonium bromide and Trition X-114. The solubilization capacity of the ferrocenyl surfactants for each tested VOCs ranked as follows: ethylbenzene > toluene > benzene. The solubilities of VOCs by reversible surfactant in I⁺ were 30% higher than those in I²⁺ at comparable surfactant concentrations. The effects of Fcl4 concentrations on VOCs removal efficiency were as follows: benzene > toluene > ethylbenzene. However, an improved removal efficiency was achieved at low ferrocenyl surfactant concentrations. Furthermore, the reversible surfactant could be recycled through chemical approaches to remove organic pollutants, which could significantly reduce the operating costs of SER technology.     

低温等离子体-催化协同降解挥发性有机废气

低温等离子体-催化协同技术适合于各类挥发性有机物的治理,特别是大气量低浓度的有机废气的处理.高效催化剂的加入可 以显著提高等离子体反应中有机废气的降解效率,减少有害副产物的生成以及提高反应器的能量利用率.从反应器、催化剂以及背景气体等方面探讨了该技术实现产业化需要解决的问题,结合低温等离子体与催化剂的相互作用、等离子体...     

Effects of metal and acidic sites on the reaction by-products of butyl acetate oxidation over palladium-based catalysts

Catalytic oxidation is widely used in pollution control technology to remove volatile organic compounds. In this study, Pd/ZSM-5 catalysts with different Pd contents and acidic sites were prepared via the impregnation method. All the catalysts were characterized by means of N2 adsorption- desorption, X-ray fluorescence （XRF）, HE temperature programmed reduction （H2-TPR）, and NH3 temperature programmed desorption （NH3-TPD）. Their catalytic performance was investigated in the oxidation of butyl acetate experiments. The by-products of the reaction were collected in thermal desorption tubes and identified by gas chromatography/mass spectrometry. It was found that the increase of Pd content slightly changed the catalytic activity of butyl acetate oxidation according to the yield of CO2 achieved at 90%, but decreased the cracking by-products, whereas the enhancement of strong acidity over Pd-based catalysts enriched the by-product species. The butyl acetate oxidation process involves a series of reaction steps including protolysis, dehydrogenation, dehydration, cracking, and isomerization. Generally, butyl acetate was cracked to acetic acid and 2- methylpropene and the latter was an intermediate of the other by-products, and the oxidation routes of typical by-products were proposed. Trace amounts of 3-methylpentane, hexane, 2-methylpentane, pentane, and 2-methylbutane originated from iso4merization and protolysis reactions.     

Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.     

化学合成类制药行业工艺废气VOCs排放特征与危害评估分析

以浙江台州6家典型化学合成类制药企业为代表,对其排放工艺废气中的18项挥发性有机物(VOCs)特征污染物(如甲苯、甲醛、二氯甲烷等)进行监测和分析,并采用臭氧产生潜力(OFP)和健康风险评价指标对VOCs所产生的环境与健康危害进行初步的评价.结果表明,化学合成类制药企业排放的总VOCs浓度为14.9~308.6 mg·m-3,其产生环境危害的OFP值为3.1~315.1 mg·m-3,主要贡献物质为甲苯、四氢呋喃、乙酸乙酯等6种物质,存在较大的潜在环境危害.另外,健康危害中的非致癌风险指数和总致癌风险指数介于9.48×10-7~4.98×10-4a-1和3.17×10-5~6.33×10-3之间,主要是苯、甲醛和二氯甲烷这3种致癌物.     

大连星海地区环境空气中挥发性有机物的臭氧生成潜势研究

以该实验的观测资料为基础,通过数据分析表明,对大连星海地区OH自由基消耗的主要环境VOCs组分是烯烃类物质,对O3生成潜势贡献最高的环境VOCs组分是芳香烃类物质;综合LiOH及OFP值评价,识别影响大连星海地区O3生成的关键环境VOCs反应活性物种为丙烯、甲苯、间对二甲苯等物质。     

基于VOCs有机废气处理技术研究进展

随着经济的不断发展,环境污染因素的种类越来越多,而且危害性也在逐渐提升。其中有机废气在人类社会不断发展的背景下产生量排放量都越来越高,如果不进行处理将对环境和人体都造成极其严重的影响。本文主要对基于VOCs有机废气处理技术的相关研究作了分析,希望对有机废气的处理有一定促进作用。     

长江河口硅和磷生源要素质量浓度的变化特征

根据近年来长江河口区域内大通水文站的记录和近期在长江入海河口区上海段多个采样点的生源要素质量浓度实测数据,比较水中可溶性硅酸盐和磷酸盐的质量浓度,分析在长江入海河口区水中硅和磷元素含量的主要变化特征.结果表明,长江水中的硅酸盐和磷酸盐从长江入海河口进入大海的过程中,其质量浓度有降低的趋势,它们在长江入海河口的多年的质量浓度变化趋势是相反的.长江入海河口区域上游的磷酸盐质量浓度升高幅度较大,而硅酸盐变化不大,硅酸盐、磷酸盐质量浓度在长江河口区进入海洋的过程中迅速降低.