稻田土菌群驯化对稻秆两步发酵产甲烷效果的影响

为提高稻秆的降解率及其厌氧发酵甲烷产量,采用高氨氮畜禽废水作为氮源以驯化稻田土壤微生物,优化其降解稻秆的初始pH值,并评估水解产物液体发酵产甲烷性能.结果表明,混合组驯化的微生物产纤维素酶活性及对稻秆木质素的降解率高于其它组及先前文献报道,分别达到4.01 IU和51.96%,且后期水解液中总有机碳（Total organic carbon, TOC）及还原糖含量最高.随着初始pH值的提高,稻秆中纤维素、半纤维素和木质素的降解率显著增加,稻秆水解液中的挥发性脂肪酸（Volatile fatty acids, VFAs）和TOC含量均显著增加,并在第7 d达到最高值.将水解稻秆7 d的水解液进行厌氧发酵显示,在初始pH=9.0条件下累积甲烷产量达到最大,为37.60 mL·mL^-1水解液.本实验结果表明, 驯化的稻田土微生物在碱性条件下可以更有效地降解稻秆,提高水解液中TOC及VFAs含量,从而提高厌氧发酵的甲烷产量.     

产酸脱硫反应器中碳硫比对群落生态特征的影响

通过产酸脱硫反应器处理高浓度含硫酸盐废水的连续流试验,从群落动态的角度研究碳硫比(COD/SO₄^2-)从4.2降低到2.0的过程中,pH值、氧化还原电位(ORP)、碱度(ALK)和末端产物(VFAs)组成、优势种群分布等群落生态特征的变化规律试验证明,在此过程中ORP和ALK提高,而pH值和VFAs中乙酸的分布比例降低,群落类型由高碳硫比稳定型转化为低碳硫比亚稳定型,但仍未改变乙酸型顶极群落的典型特征.     

Recovery of Ni(II) from real electroplating wastewater using fixed-bed resin adsorption and subsequent electrodeposition

Resin adsorption and subsequent electrodeposition were used for nickel recovery. Treated wastewater can meet the Electroplating Pollutant Discharge Standard. The spent resin is completely regenerated by 3 BV of 4% HCl solution. 95.6% of nickel in concentrated eluent was recovered by electrodeposition. Effective recovery of high-value heavy metals from electroplating wastewater is of great significance, but recovering nickel ions from real electroplating wastewater as nickel sheet has not been reported. In this study, the pilot-scale fixed-bed resin adsorption was conducted to recover Ni(II) ions from real nickel plating wastewater, and then the concentrated Ni(II) ions in the regenerated solution were reduced to nickel sheet via electrodeposition. A commercial cation-exchange resin was selected and the optimal resin adsorption and regeneration conditions were investigated. The resin exhibited an adsorption capacity of 63 mg/g for Ni(II) ions, and the average amount of treated water was 84.6 bed volumes (BV) in the pilot-scale experiments. After the adsorption by two ion-exchange resin columns in series and one chelating resin column, the concentrations of Ni(II) in the treated wastewater were below 0.1 mg/L. After the regeneration of the spent resin using 3 BV of 4% (w/w) HCl solution, 1.5 BV of concentrated neutral nickel solution (>30 g/L) was obtained and used in the subsequent electrodeposition process. Using the aeration method, alkali and water required in resin activation process were greatly reduced to 2 BV and 3 BV, respectively. Under the optimal electrodeposition conditions, 95.6% of Ni(II) in desorption eluent could be recovered as the elemental nickel on the cathode. The total treatment cost for the resin adsorption and regeneration as well as the electrodeposition was calculated.     

Comparison of CNT-PVA membrane and commercial polymeric membranes in treatment of emulsified oily wastewater

CNT-PVA membrane was fabricated and compared with polymeric membranes. The separation performance was evaluated by homemade and cutting fluid emulsions. The three membranes show similar oil retention rates. CNT-PVA membranes have higher permeation fluxes compared with polymeric membranes. CNT-PVA membrane shows higher fouling resistance. Membrane separation is an attractive technique for removal of emulsified oily wastewater. However, polymeric membranes which dominate the current market usually suffer from severe membrane fouling. Therefore, membranes with high fouling resistance are imperative to treat emulsified oily wastewater. In this study, carbon nanotube-polyvinyl alcohol (CNT-PVA) membrane was fabricated. And its separation performance for emulsified oily wastewater was compared with two commercial polymeric membranes (PVDF membrane and PES membrane) by filtration of two homemade emulsions and one cutting fluid emulsion. The results show that these membranes have similar oil retention efficiencies for the three emulsions. Whereas, the permeation flux of CNT-PVA membrane is 1.60 to 3.09 times of PVDF membrane and 1.41 to 11.4 times of PES membrane, respectively. Moreover, after five consecutive operation circles of filtration process and back flush, CNT-PVA membrane can recover 62.3% to 72.9% of its initial pure water flux. However, the pure water flux recovery rates are only 24.1% to 35.3% for PVDF membrane and 6.0% to 26.3% for PES membrane, respectively. Therefore, CNT-PVA membrane are more resistant to oil fouling compared with the two polymeric membranes, showing superior potential in treatment of emulsified oily wastewater.     

榆林市某园区兰炭企业存在问题及解决对策

兰炭是榆林市的重要产业之一,但由于兰炭"粗放"的生产方式,对区域环境产生一定影响。为推进兰炭绿色健康发展,本文针对榆林市某园区内兰炭企业进行调研,了解该企业存在的主要问题,并提出相关建议。     

金属负载活性炭催化氧化法处理ZPT生产废水

研究了金属负载活性炭催化剂在常温常压下催化氧化处理吡啶硫酮锌(ZPT)废水的技术，在探讨影响催化氧化效果诸因素的基础上，确定出中和预处理、后接两级催化氧化处理该废水的工艺流程，该流程的COD的去除率最高可达92％，处理出水达到国家污水综合排放标准二级指标。     

酿酒废水培养钝顶螺旋藻(S.platensis)与营养物质去除的研究

经前处理后的酿酒厂废水用清水稀释用来培养钝顶螺旋藻 ,可以获得高生物量的钝顶螺旋藻。同时 ,废水中的营养物质也可以被去除。在连续培养条件下 ,使用改进的开放式通道装置培养获得螺旋藻的蛋白质、水分、灰化成份分别为 6 2 .7%、6 .2 1 %和 5 .2 6 % ,重金属含量也符合标准 (GB 1 991 9-1 997)。T -N ,NH4 + -N ,T -P和PO4 3 --P的去除效率分别可达到 72 %、97.9%、4 1 .3%、4 3.1 %。     

施肥对不同农田土壤微生物活性的影响

采用室内恒温培养研究了施肥对不同农田土壤微生物活性的影响。结果表明，在红壤、水稻土和潮土中，土壤微生物量、土壤酶活性大小顺序均为有机肥配施无机肥处理＞单施有机肥处理＞单施无机肥处理，但对脲酶来说，其活性大小顺序为有机肥配施无机肥处理＞单施无机肥处理＞单施有机肥处理。从土壤类型来看，土壤微生物量碳、氮和土壤酶活性大小以水稻土最大，潮土次之，红壤最小。３种土壤的微生物量、土壤酶活性在培养的４５～６０ｄ之间分别达到最大值，以后逐渐下降。部分单施无机肥处理的土壤微生物量、土壤酶活性最大值比单施有机肥处理、有机肥配施无机肥处理提前１５ｄ。相关分析表明，有机肥配施无机肥处理及单施有机肥处理，３种土壤的土壤微生物量碳、氮与土壤过氧化氢酶、转化酶、蛋白酶、脲酶及速效养分呈显著或极显著的相关性；单施无机肥处理中，土壤微生物量碳、氮与土壤过氧化氢酶、蔗糖转化酶、蛋白酶、脲酶显著或极显著相关，与部分速效养分相关不显著。     

紫外-Fenton试剂的作用机理及在废水处理中的应用

本文研究了紫外光、铁离子对过氧化氢的催化分解作用.证实了紫外光和铁离子对过氧化氢的催化分解存在协同效应,并通过研究三价铁离子与紫外光的相互作用,探讨了协同效应产生的机理.UV-Fenton试剂对硝基苯、十二烷基苯磺酸钠(DBS)模拟废水的处理结果表明:将紫外光引入Fenton试剂可大大提高Fen-ton试剂的氧化性能,对生物难降解或难化学氧化的有机污染物具有良好的处理效果.     

生物质燃烧释放N2O的测定及其分布

本文报导了实验室规模的生物质封闭燃烧系统及稻草、玉米秸、麦杆燃烧过程中Ｎ２Ｏ排放因子的测定结果，测定结果表明：稻草、麦杆及玉米秸燃烧排气中Ｎ２Ｏ的排放因子分析是８４．４ｇ／ｔ，２７．３ｇ／ｔ，１３２ｇ／ｔ。用Ｎ２Ｏ－Ｎ占生物全氮的百分含量表示，稻草及玉米秸分别上０．５９％，０．８７％。用实验得到的Ｎ２Ｏ的排放因子计算出了生物质燃烧产生Ｎ２Ｏ在全国各省、直辖市、县的年排放量，并作出了全国年排放的分布