空白值校正法无汞快速测定地表水化学需氧量

探讨了K2Cr2O7在不同酸度的硫酸介质中的化学行为,确定9 mol/L H2SO4为K2Cr2O7法测定地表水COD的合理酸度。多种有机物消解试验及半年多地表水样跟踪检测,将消解回流时间从2小时缩短到30分钟之内是可行的。氯离子(Cl-)干扰可用生成AgCl沉淀和空白值校正的办法消除。此方法的检出下限是11mg/L,样品测定的加标回收率在96%～101%。此方法不仅缩短了回流时间、减少了汞带来的二次污染,从而实现无汞快速测定地表水COD。     

研究单位压边力值对板料成形性能的影响

主要介绍板料在拉深成形过程中单位压边力值对板料成形性能的影响。研究方法采用仿真技术 ,指出板料在成形过程中如按最初设定的单位压边力值进行成形 ,那么 ,板料成形过程中单位压边力值将逐渐增大 ,严重影响板料成形极限。如果采用控制板料在成形过程中压边圈下坯料的单位压边力值 ,将提高板料成形极限。其结论为生产现场提高板料成形性能和表面质量提供了一种可实施的方法。     

用亚椭圆形毛料提高盒形件成形的研究

在盒形件拉伸成形过程中,毛料展开是冲压工作的重要课题。此文根据数学理论,用亚椭圆方法建立数学模型来摸拟盒形件毛料尺寸展开外形,是提高一次成形、减少压延次数的有效方法。     

降低总氮空白吸光值的因素探讨

为了有效控制总氮的空白吸光值,本文从容器的洗涤、实验用水、试剂纯度、样品的消解、后处理阶段等环节进行分析,通过科学实验,探讨了其影响因素,找到最佳条件：用1：3的硫酸清洗容器消除有机物的干扰,GR级的过硫酸钾和AR级的氢氧化钠分别进行溶解作为消解剂,控制消解的时间超过30分钟,最后用1：9的盐酸消除干扰,总氮的空白值可以控制在0.020之内。     

总氮测定中的注意事项

碱性过硫酸钾消解紫外分光光度法测定总氮中，对空白值偏高的影响因素进行了实验和分析，提出了几点建议及改进措施。     

影响分析空白值的因素及控制措施

化学实验中,经常会出现空白值异常的情况。文中从可能对空白值产生影响的各个因素逐一进行分析,并在此基础上提出了控制空白值的手段和措施。     

Synthesis and characterization of agricultural controllable humic acid superabsorbent

Humic acid superabsorbent polymer (P(AA/AM-HA)) and superabsorbent polymer (P(AA/AM)) were synthesized by aqueous solution polymerization method using acrylic acid (AA), acrylamide (AM) and humic acid (HA) as raw material. The effects of N,N'-methylenebisacrylamide (MBA) crosslinking agent, potassium peroxydisulfate (KPS) initiator, reaction temperature, HA content, ratio of AA to AM, concentration of monomer and neutralization of AA on water absorption were investigated. Absorption and desorption ratios of nitrogen fertilizer and phosphate fertilizer were also investigated by determination of absorption and desorption ratio of NH₄⁺, PO₄^3- on P(AA/AM-HA) and P(AA/AM). The P(AA/AM-HA) and P(AA/AM) were characterized by Fourier translation infrared spectroscopy, biological photomicroscope and scanning electron microscopy (SEM). The optimal conditions obtained were as follows: the weight ratio of MBA to AA and AM was 0.003; the weight ratio of KPS to AA and AM was 0.008; the weight ratio of HA to AA was 0.1; the mole ratio of AM to AA is 0.1; the mole ratio of NaOH to AA is 0.9; the reaction temperature was 60℃. P(AA/AMHA) synthesized under optimal conditions, has a good saline tolerance, its water absorbency in distilled water and 0.9 wt.% saline solution is 1180 g/g and 110 g/g, respectively. P(AA/AM-HA) achieves half saturation in 6.5 min. P(AA/AM-HA) is superior to P(AA/AM) on absorption of NH₄⁺, PO₄^3-. The SEM micrograph of P(AA/AM-HA) shows a fine alveolate structure. The biological optical microscope micrograph of P(AA/AM-HA) shows a network structure. Graft polymerization between P(AA/AM) and HA was demonstrated by infrared spectrum. The P(AA/AM-HA) superabsorbent has better absorbing ability of water and fertilizer, electrolytic tolerance and fewer cost than P(AA/AM) superabsorbent.     

水中总氮空白的影响因素的探讨

本研究以水中总氮空白值为研究对象,不同厂家的过硫酸钾和不同试验用水条件下的总氮空白的变化规律。研究结果表明：无氨水和二次水蒸出来的总氮空白明显低于一次水蒸出来的总氮空白;这跟蒸馏水纯度有关系,一次水含有氨,所以消解时蒸馏水中的氨会被氧化,从而导致空白值偏高。同样有的厂家的过硫酸钾纯度不高,所以导致空白值高。     

高锰酸盐指数一酸性法空白质量控制研究

常规监测高锰酸盐指数-酸性法,通过对高锰酸盐指数空白测试与检测限、空白质控图、空白加标回收率进行测试研究,可以得到理想的监测结果。     

挥发酚空白的质量控制

挥发酚空白的质量控制应采取以下措施：实验用水应为无酚水、提纯4-氨基安替比林试剂、确定检测限及空白实验的质控图。