混合药物粉尘输运过程静电特性实验研

兽药制药粉尘加工工艺过程中,由于粉尘颗粒之间或颗粒与设备、管壁之间的碰撞、摩擦,导致装置内部静电荷量积聚,激发静电放电,粉尘燃烧或爆炸的事故频发。实验主要通过包括粉尘与管材摩擦的漏电电流测试和静电放电火花对粉尘云点燃敏感性测试两部分。结果表明:单一药物药粉的静电漏电电流随着管材管径的增大,管长的增长,静电漏电电流逐渐变大;随着倾斜角的增大,静电漏电电流先增大后降低;镀锌铁管的漏电电流大于PVC管,电荷逸散速度更快。单一兽药粉的粉尘云放电火花最小点燃能量随质量浓度的变化,呈现二次曲线的变化趋势。混合兽药粉与单一兽药粉的漏电电流和粉尘云放电火花最小点燃能量的测试结果的变化趋势是一致的。     

Validation of the UN test method N.5

Many substances react with water in such a way that flammable gases are formed. For transport issues this reaction may possess a considerable hazard especially if the cargo is wetted by rain or by water from other sources. In the UN Recommendations on the Transport of Dangerous Goods these kinds of problems are addressed. The UN test N.5 “Test method for substances which in contact with water emit flammable gases” corresponds to this hazard. Classification according to the test method is done by measurement of the gas evolution rate of the flammable gas by any suitable procedure. At BAM a gravimetric approach is used to measure the gas evolution rate. In this paper we present the evaluation of the apparatus by means of an absolute calibration routine utilizing a reaction where a known amount of gas is produced as well as the evaluation of important parameters influencing the gas evolution rate using different substances. It can be shown that the apparatus is capable of measuring absolute gas volumes as low as 6 mL with an acceptable error of about 17% as determined from the reaction of Mg with demineralized water.     

轧钢污泥综合利用的技术研究

阐述了一种轧钢污泥的回收处理技术,该技术可把轧钢污泥有效地分离成氧化铁粉和混合油,实现综合利用,减少铁素资源浪费,有良好的经济效益和环境效益.     

大豆蛋白粉喷雾干燥塔尾气余热的回收与利用

针对大豆蛋白粉生产过程中喷雾干燥塔尾气温度较高,有回收利用价值的现实,也针对目前的节能需求,对现有的喷雾干燥塔的尾气排放部分进行改造,设计一个片状空气预热器,以利用高温的尾气与系统的进气做热交换,实现热量再利用,降耗和提高蛋白粉产率的目的,并对投资收益进行了分析。     

从粉煤灰中提取多种微细氧化物的研究

将粉煤灰与Na2CO3按一定的比例混合后焙烧,采用酸碱联合法提取粉煤灰中氧化硅、氧化铝和氧化铁,分析了工艺条件对粉煤灰中氧化物提取率的影响。实验结果表明,从粉煤灰中提取氧化物的最佳条件是:碳酸钠与粉煤灰的比例0.6∶1.0,焙烧温度850℃、盐酸浓度4 mol/L,氢氧化钠浓度2.6 mol/L,浸取时间约6 h。在此条件下得出微细氧化硅、氧化铝、氧化铁的晶体,其平均粒度分别为氧化硅1.107μm,氧化铝1.334μm,氧化铁0.783μm。     

漂白粉用于治理石化企业硫化氢恶臭气体的研究

实验采用填料吸收塔对漂白粉用于石化企业硫化氢恶臭的治理进行了初步研究,系统研究了漂白粉投加量、硫化氢浓度、进气流量、吸收氧化温度、液气比等因素对处理效果的影响。结果表明：室温下,漂白粉投加量为0．2g／100mL,液气比20L／m^3,进气浓度控制在7800mg／m^3以内,调整适宜的进气量,对硫化氢恶臭的去除率可以达到99％以上。漂白粉吸收氧化硫化氢恶臭气体不仅技术可行,而且费用低廉,操作方便,可以进行深入的研究,进行工业化放大。     

Impact of excess and harmful radiation on energy budgets in scleractinian corals

Using dynamic energy budget (DEB) theory, this paper explores the potential of excess and harmful radiation, notably UV, to cause changes in performance and, ultimately, bleaching in scleractinian corals for a range of ambient nitrogen and (beneficial) photosynthetically active radiation levels. Two negative impacts of radiation are considered: a reduction in the capacity of the symbiont to generate energy through photosynthesis (defined in this paper as photoinhibition); an increase in the costs for the symbiont to remain viable due to repair of damage (defined in this paper as photodamage). Model predictions indicate that although both types of impact reduce the growth potential of host and symbiont, photoinhibition predominantly affects host features, except at very low ambient nitrogen levels, under which conditions the severity of nitrogen limitation is so strong that a reduction in photosynthetic rates due to photoinhibition has minimal impact. In steady state, photoinhibition leads to a reduction in host biomass, and an increase in symbiont density, implying that photoinhibition (as defined in this paper) is unlikely to cause bleaching. In contrast, the impact of photodamage is mostly affecting symbiont features, including a decline in symbiont density. Thus, photodamage may contribute to coral bleaching. Furthermore, the model predicts that, with both photoinhibition and photodamage, an increasing ratio of harmful to beneficial radiation accelerates the suppression of growth rates of symbiont and host, implying that coral health deteriorates progressively faster with increasing harmful radiation, such as UVb.     

摩托车防盗器遥控引燃黑火药的实验研究

根据2013型铁将军牌摩托车防盗器工作原理,分析了连接左转向灯、起动继电器及电门锁的5条导线遥控引燃黑火药的方式.利用GOS-620型示波器,测得防盗器在设防、寻车、起动、振动1次、连续振动、解锁时这5根导线两两之间的电压.从60种组合中筛选出10种可能引燃黑火药的方式.通过引燃实验,验证了这10种引燃方式.以左转向灯...     

不同聚合度的聚磷酸铵灭火性能研究*

为考察聚磷酸铵（APP）干粉灭火剂的聚合度对其灭火性能的影响,选用3种不同聚合度的APP,结合其晶体结构、粒度分布及热性能测试,并通过粉体杯式燃烧器进行小尺寸灭火实验,对比3种样品的灭火性能及灭火机理,研究聚合度与其灭火性能的关系。热性能测试结果显示,聚合度的升高会导致APP的热稳定性下降,随着聚合度从80升至1 500,其初始分解温度从326.11 ℃降低至321.54 ℃,失重率从75.21%增加至79.66%。实验结果表明:随着APP聚合度的增加,火焰降温速率升高,最小灭火浓度（MEC）降低,灭火性能增强,当聚合度为1 500时,MEC为118.143 g/m3。聚合度的升高有助于APP在进入火场后更早、更充分地与火焰发生反应,从而使灭火性能得到提升。     

减速机齿轮表面探伤优化选择

采用模糊集的贴近度计算对齿轮表面探伤方法进行了优化选择,表明旋转磁场探伤是齿轮表面探伤的最佳方法,在实用中检测出大量的正在延伸扩展的表面疲劳裂纹.