Development of a hybrid microbial fuel cell (MFC) and fuel cell (FC) system for improved cathodic efficiency and sustainability: the M2FC reactor

In an effort to improve the efficiency and sustainability of microbial fuel cell (MFC) technology, a novel MFC reactor, the M2FC, was constructed by combining a ferric-based MFC with a ferrous-based fuel cell (FC). In this M2FC reactor, ferric ion, the catholyte in the MFC component, is regenerated by the FC system with the generation of additional electricity. When the MFC component was operated separately, the electricity generation was maintained for only 98 h due to the depletion of ferric ion in the catholyte. In combination with the fuel cell, however, the production of power was sustained because ferric ion was continually replenished from ferrous ion in the FC component. Moreover, the regeneration process of ferric ion by the FC produced additional energy. The M2FC reactor yielded a power density of up to 2 W m⁻² (or time-averaged value of approximately 650 mW m⁻²), density up to 20 times (or approximately six times based on time-averaged value) higher than the corresponding MFC system.     

Novel mesoporous microspheres of Al and Ni doped LMO spinels and their performance as cathodes in secondary lithium ion batteries

A facile, scalable, and solution-based technique is used to fabricate Al and Ni-doped (LiAl_0.1Mn_1.9O₄ and LiAl_0.1Ni_0.1Mn_1.8O₄) microspheres of lithium manganese oxide (LMO) spinels for use as reversible cathode materials for lithium ion batteries (LIBs). The spheres of the two samples exhibit different porosities. Cells with these LMO-based cathodes are then cycled between 4.5 V and 2 V to study their stabilities while simultaneously being subjected to the undesirable Jahn-Teller distortion that occurs around the ~3 V regime. The LiAl_0.1Mn_1.9O₄ (LAMO) and the LiAl_0.1Ni_0.1Mn_1.8O₄ (LANMO) cells exhibit comparable open circuit voltages (OCV) of 2.94 V and 2.97 V, respectively. During cell cycling, the LAMO cell exhibits a maximum specific capacity of 122.51 mAh g^?1 with a capacity fade of 65.35% after 75 cycles. The LiAl_0.1Ni_0.1Mn_1.8O₄ (LAMO) sample fares better and exhibits a maximum of 140.49 mAh g^?1 and a capacity drop of 52.59%. Detailed structural studies indicate that Ni doping and the greater degree of porosity of the LANMO sample to be a stabilizing factor. This is further confirmed by cyclic voltammetry (CV) and AC impedance spectra analysis.     

碱激发胶凝材料及其固化Pb^2＋的试验研究

对碱激胶凝材料（碱-偏高岭土、碱-矿渣和碱-粉煤灰）与水-水泥体系固化Ph^2＋进行了试验研究,其中水-水泥体系为对比样。结果表明：对于相同稠度的碱激发胶凝材料,即使Pb^2＋含量达到2．4％,除了碱-粉煤灰的抗压强度略低外,其他都达到30MPa以上,满足填埋或做建筑基材的使用要求;与水泥相比,碱激发胶凝材料能显著降低重金属离子（Ph^2＋）浸出浓度,其规律性与其NH4交换容量大小的规律性一致,与其固化体的抗压强度的大小没有相关性。     

Changes in negative air ions concentration under different light intensities and development of a model to relate light intensity to directional change

The purpose of this research was to determine changes in negative air ion (NAI) concentrations produced by plants grown under different light intensities. NAI concentrations were observed and analyzed in an outdoor green space with five plant species (Aloe arborescens, Clivia miniata, Chlorophytum comosum, Opuntia brunnescens, Crassula portulacea) and A. arborescens was then grown under controlled-light conditions in an enclosed space for the subsequent light intensity experiment.     

改性高岭土处理含酸性媒介染料的印染废水

用十六烷基三甲基溴化铵(CTMAB)改性的高岭土处理以水溶性酸性媒介染料为主的印染废水.实验结果表明,当CTMAB-高岭土加入量为0.6 g/L、用石灰乳控制废水pH为9.5～10.0、聚丙烯酰胺的加入量为2.0 mg/L时,废水的处理效果最佳,废水色度和COD去除率分别达到98.0%和92.0%以上,出水色度和COD达到了GB4287-92<纺织染整工业水污染物排放标准>一级排放标准.     

无汞开管法快速测定工业废水中的COD

文章对化学需氧量的几种测定方法进行对比,研究了无汞开管法快速测定方法的实验条件与干扰因素,并与标准方法进行对照,总结出炼油废水应用无汞开管法监测COD的适用范围与注意事项,可供同类企业应用该方法时借鉴。     

川西气田地层水回注选井选层研究

根据川西气田的实际情况,对致密砂岩层回注选井选层技术进行研究,初步建立了致密砂岩层回注选井选层技术,优选出川西气田1、2、3号等5个回注井区。目前,注水规模300m3/d,累计注水量达75 698.8m3,节约生产成本约200万元,且有效缓解了高浓度氯离子地层水外排带来的环保压力。现场回注试验表明:致密砂岩层回注高浓度氯离子地层水是可行的,回注选井选层技术具有现场推广应用价值。     

稠油污水回用锅炉处理工艺的应用

新疆油田公司稠油污水处理普遍采用成熟的离子调整旋流反应水处理技术,污水处理后达到回用锅炉水质标准SY/T 0097-2000《稠油油田采出水用于蒸汽发生器给水处理设计规范》,供给油田专用高压注汽锅炉用水。采用相同技术建成的采油一厂稠油处理站污水回用锅炉处理工艺投用后,处理后污水回用锅炉,减少了含油污水的外排,充分利用了稠油污水的热能,取得了良好的经济和社会效益。     

单标多点校正组合英蓝超滤测定地表水中多种阴离子

建立了利用组合单标多点校正和英蓝超滤单元的离子色谱法测定地表水中F-、C1-、NO3-、S0424—4-种离子的方法,方法操作简便,灵敏度高,线性范围广,抗干扰能力强,可同时快速测定不同数量级浓度的离子,降低了配置标准品和样品前处理的复杂性,减少了因前处理带来的干扰。     

Structural and optical characterization of dissolved organic matter from the lower Athabasca River, Canada

Dissolved organic matter (DOM) is a ubiquitous constituent of natural waters and is comprised of a variety of chemically heterogeneous molecular structures and functional groups. DOM is often considered to be a major ligand for metals in most natural waters and its reactivity is thought to be strongly dependent on its chemical composition and structure. In this study, a combination of UV/visible, emission excitation matrix fluorescence (EEM) and ¹H NMR spectroscopies were used to characterize DOM from the Athabasca River (Alberta, Canada). The chemical characterization of river DOM showed that the most upstream samples located in agricultural areas were blue-shifted and less aromatic and contained more hydrogens connected with oxygen functional groups than those in the wetland dominated area in the Athabasca oil sand deposit region. The presence of paramagnetic ions (Fe and Al) was not found to significantly affect the structural composition of DOM as revealed by ¹H NMR. Such change in the quality of DOM may have a profound impact on metal binding in the Athabasca River watershed.