Ambient Aerosol and its Carbon Content in Gainesville, a Mid-Scale City in Florida

Ambient aerosols were collected during 2000–2001 in Gainesville, Florida, using a micro-orifice uniform deposit impactor (MOUDI) to study mass size distribution and carbon composition. A bimodal mass distribution was found in every sample with major peaks for aerosols ranging from 0.32 to 0.56 μm, and 3.2 to 5.6 μm in diameter. The two distributions represent the fine mode (<2.5 μm) and the coarse mode (>2.5 μm) of particle size. Averaged over all sites and seasons, coarse particles consisted of 15% carbon while fine particles consisted of 22% carbon. Considerable variation was noted between winter and summer seasons. Smoke from fireplaces in winter appeared to be an important factor for the carbon, especially the elemental carbon contribution. In summer, organic carbon was more abundant. The maximum secondary organic carbon was also found in this season (7.0 μg m⁻³), and the concentration is between those observed in urban areas (15–20 μg m⁻³) and in rural areas (4–5 μg m⁻³). However, unlike in large cities where photochemical activity of anthropogenic emissions are determinants of carbon composition, biogenic sources were likely the key factor in Gainesville. Other critical factors that affect the distribution, shape and concentration were precipitation, brushfire and wind.     

Results of An Indoor Size Fractionated PM School Sampling Program in Libby, Montana

Libby, Montana is the only PM_2.5 nonattainment area in the western United States with the exceptions of parts of southern California. During January through March 2005, a particulate matter (PM) sampling program was conducted within Libby’s elementary and middle schools to establish baseline indoor PM concentrations before a wood stove change-out program is implemented over the next several years. As part of this program, indoor concentrations of PM mass, organic carbon (OC), and elemental carbon (EC) in five different size fractions (>2.5, 1.0–2.5, 0.5–1.0, 0.25–0.5, and <0.25 μm) were measured. Total measured PM mass concentrations were much higher inside the elementary school, with particle size fraction (>2.5, 0.5–1.0, 0.25–0.5, and <0.25 μm) concentrations between 2 and 5 times higher when compared to the middle school. The 1.0–2.5 μm fraction had the largest difference between the two sites, with elementary school concentrations nearly 10 times higher than the middle school values. The carbon component for the schools’ indoor PM was found to be predominantly composed of OC. Measured total OC and EC concentrations, as well as concentrations within individual size fractions, were an average of two to five times higher at the elementary school when compared to the middle school. For the ultrafine fraction (<0.25), EC concentrations were similar between each of the schools. Despite the differences in concentrations between the schools at the various fraction levels, the OC/EC ratio was determined to be similar.     

Concentrations of cadmium and lead heavy metals in Dardanelles seawater

Cadmium and lead were determined simultaneously in seawater by differential pulse stripping voltammetry (DPSV) preceded by adsoptive collection of complexes with 8-hydroxyquinoline (oxine) on to a hanging mercury drop electrode (HMDE). In preliminary experiments the optimal analytical condition for oxine concentration was found to be 2.10⁻⁵ M, at pH 7.7, the accumulation potential was −1.1 V, and the initial scannig potential was −0.8 V. The peak potentials were found −0.652 V for Cd and −0.463 V for Pb At the 60 s accumalation time. The limit of detection (LOD) and limit of quantitatification (LOQ) were found to be by voltammetry as 0.588 and 1.959 μg l⁻¹ (RSD, 5.50%) for Cd and 0.931 and 3.104 μg l⁻¹ (RSD, 4.10%) for Pb at 60 s stirred accumulation time respectively. In these conditions the most of the seawater samples are amenable for direct voltammetric determination of cadmium and lead using a HMDE. An adsorptive stripping mechanism of the electrode reaction was proposed. For the comparison, seawater samples were also analysed by ICP-atomic emission spectrometry method (ICP-AES). The applied voltammetric technique was validated and good recoveries were obtained.     

Competition between phenanthrene, chrysene, and 2,5-dichlorobiphenyl for high-energy adsorption sites in a sediment

We determined the maximum amounts of added phenanthrene, chrysene, and 2,5-dichlorobiphenyl sorbed onto high-energy adsorption sites in a sediment on bi-solute experiments. The bi-solute pairs were phenanthrene/chrysene and phenanthrene/2,5-dichlorobiphenyl. On the bi-solute sorption experiments, one solute was introduced and equilibrated with sediment prior to addition of the second solute. The values for the maximum amounts adsorbed onto high-energy sites revealed that, after equilibration of the first solute, still some high-energy sites could be occupied by the second solute. Phenanthrene, chrysene, and 2,5-dichlorobiphenyl seem to share about 30% of the accessible high-energy adsorption sites in the sediment employed.     

Spectroscopic Distribution of Dissolved Organic Matter in a Dam Reservoir Impacted by Turbid Storm Runoff

Spectroscopic characteristics of dissolved organic matter (DOM) in a large dam reservoir were determined using ultraviolet absorbance and fluorescence spectroscopy to investigate spatial distribution of DOM composition after turbid storm runoff. Water samples were collected along a longitudinal axis of the reservoir at three to four depths after a severe storm runoff. Vertical profiles of turbidity data showed that a turbid water layer was located at a middle depth of the entire reservoir. The spectroscopic characteristics of DOM samples in the turbid water layer were similar to those of terrestrial DOM, as demonstrated by the higher specific UV absorbance (SUVA) and the lower fluorescence emission intensity ratio (F ₄₅₀/F ₅₀₀) compared to other surrounding DOM samples in the reservoir. Synchronous fluorescence spectroscopy revealed that higher content of humic-like DOM composition was contained in the turbid water. Fluorescence excitation–emission matrix (EEM) showed that lower content of protein-like aromatic amino acids was present in the turbid water DOM. The highest protein-like fluorescence was typically observed at a bottom layer of each sampling location. The bottom water DOM exhibited extremely high protein-like florescence near the dam site. The particular observation was attributed to the low water temperature and the isolation of the local bottom water due to the upper location of the withdrawal outlet near the dam. Our results suggest that the distribution of DOM composition in a dam reservoir is strongly influenced by the outflow operation, such as selective withdrawal, as well as terrestrial-origin DOM inputs from storm runoff.     

NOx分解还原催化研究进展

介绍和评价了ＮＯ_ｘ分解还原的３类催化剂：贵金属催化剂、氧化物催化剂、金属离子置换的分子筛。在ＮＯ_ｘ的碳氢化合物选择性催化还原反应（ＨＣ－ＳＣＲ反应）中,同样有３类催化剂,即金属氧化物、贵金属和分子筛。由于Ｃｕ－ＺＳＭ－５是目前最有希望投入实际使用的一种,故本文重点介绍了它对ＮＯ_ｘ的ＨＣ－ＳＣＲ反应的催化机理,以及温度、Ｏ_２含量、Ｃｕ~（２＋）的置换度、不同种类ＨＣ及ＨＣ含量等各种因素对Ｃｕ－ＺＳＭ－５的影响,并对其工作台试验进行了评价,指出了其存在的问题及当前的研究热点。     

北京首都机场绿色滑行时间估算

采用北京首都机场2014年实际CDM地面放行数据确定航空器的污染物排放量与离场排队飞机数量和落地滑入飞机数量的强关联性,构建包含这两个解释变量为影响因素的多元线性回归模型,用以估算几种常见机型在首都机场地面运行时的最小污染物排放量和绿色滑行时间。对比实际污染物排放量与最小污染物排放量,得出首都机场离场地面污染物排放量远远超过最小污染物排放量。     

上海城区交通干道黑碳污染调查

采用设置在上海市中心城区交通主干道旁空气质量自动监测站2018年1—12月的观测数据,分析黑碳气溶胶(BC)污染特征及其与PM_(2.5)、SO_2、NO_x、CO、O_3、苯、甲苯、乙苯、二甲苯和气象参数的相关性。结果表明,观测期间内,BC小时均值为(3 038±22) ng/m~3,ρ(BC)在ρ(PM_(2. 5))中占比为(11. 48±0. 12)%。日内ρ(BC)变化呈双峰型,各月份之间ρ(BC)变化不大。ρ(BC)与风速呈负相关,与PM_(2. 5)、NO_x、CO、苯、甲苯、乙苯和二甲苯呈正相关。     

A study on the factor market distortion and the carbon emission scale effect of two-way FDI

Based on the data of 30 Chinese provinces for the period from 2004 to 2015, this paper expounds the carbon emissions effect of two-way foreign direct investment (FDI) from the perspective of scale effect and factor market distortions. This study uses Kaya identity to decompose carbon emission and construct simultaneous equations model to empirically examine the factor market distortion and the carbon emission scale effect of two-way FDI. The results show that the inward foreign direct investment (IFDI) increase regional carbon emission through scale effect and also exacerbates factor market distortion in China, whereas the outward FDI trends reduce carbon emission and reduces factor market distortions in China. The study also shows that human capital, research and development (R&D), trade openness, and capital accumulation are important determinants of two-way FDI. Therefore, the study proposes that IFDI policies should focus on acquiring green technologies. In addition, the domestic enterprises should be encouraged to participate in global business.     

An analysis of end-of-life terminology in the carbon fiber reinforced plastic industry

While many studies and reviews into the practices conducted by industry and academia to recycle and remanufacture carbon fibre-reinforced plastic (CFRP) exist, to date no investigation exists which regards the correctness of the use of the terms recycling and remanufacturing. As such, this paper seeks to analyse the CFRP reuse industry’s attempt to recycle and remanufacture manufacturing waste CFRP and end-of-life (EOL) CFRP with an emphasis on the terminology used to describe these practices. Firstly, this paper presents a justification of the importance of using EOL terminology correctly; outlining the benefits and problems associated with using the correct and incorrect terminology. This paper finds that in the case of CFRP remanufacturing, terminology is being applied incorrectly and in the case of CFRP recycling, particular care should be taken when applying the term recycled to CFRP or stating that CFRP has been recycled. Further, this paper proposes new terminology (in keeping with EU directives) which could be adopted by industry and academia working in this area. This paper also finds that in the case of remanufacture, CFRP is incapable of being remanufactured.