电化学微传感器检测水中痕量铜离子

为改善微电极在阳极溶出伏安法检测重金属离子过程中低电流响应和低电催化能力的缺点,提出了一种在碳纤维微电极表面合成还原氧化石墨烯/纳米金材料制得还原氧化石墨烯纳米金修饰碳纤维微电极（rGO/AuNPs CFMEs）的方法.通过SEM表征,所制备的rGO/AuNPs CFMEs具有比表面积高、吸附能力强和催化活性好的特点,因此改性微电极适合作为方波阳极溶出伏安法（SWASV）测定水中铜离子（Cu²⁺）的工作电极.在构建微传感器测试水中痕量铜离子系统后,对pH值、电导率、富集时间和富集电位等检测条件进行了优化.在pH值为4,电导率为36.1S/m,富集时间为360s,富集电位为-1.2V的最佳条件下,铜的线性范围和检出限分别0~1.0μmol/L和2.4nmol/L.此外,微传感器的可重复性、长期稳定性以及选择性也得到了验证.     

黑色金属材料在长江淡水中的腐蚀行为

通过现场暴露试验,获得了2种碳钢、3种不锈钢及1种不锈钢与碳钢复合板材料在武汉长江淡水中的4年腐蚀试验结果,总结了它们的腐蚀行为。结果表明,Q235和16Mn碳钢在武汉长江中有较高的腐蚀率和明显的点蚀,稳定腐蚀率为0.055 mm/a;暴露4 a,奥氏体不锈钢304和316L没有明显腐蚀,而马氏体不锈钢430有较明显的点蚀和缝隙腐蚀;马氏体不锈钢0Cr13Ni5Mo与Q345C复合钢板在长江淡水中使用4 a后,0Cr13Ni5Mo发生严重的点蚀,说明马氏体不锈钢在淡水中的应用应慎重。     

活性炭负载Co3O4活化过一硫酸盐降解金橙G

通过浸渍煅烧法制备活性炭负载Co的活化剂(Co/AC),采用X射线衍射仪(XRD)、扫描电镜(SEM)及X射线能谱仪(EDS)技术对活化剂进行表征,发现Co主要以Co_3O_4的形式负载于活性炭表面,并利用Co/AC活化过一硫酸盐(PMS)产生硫酸根自由基(SO_4~-·)降解偶氮染料金橙G(OG),研究了活化反应机制及不同因素对OG降解的影响.结果表明,SO_4~-·在OG降解过程中起主要作用,并且随Co/AC用量、PMS浓度、温度的提高,OG降解效率明显增加.反应初始pH对降解OG有较大影响,当p H在4~8范围内,SO_4~-·均能有效降解OG,但在强酸碱条件下,则不利于OG降解.Cl~-对活化降解OG具有双重作用,低浓度时抑制降解,而在高浓度时促进降解.Co/AC在重复使用6次时仍具有较好活化性能.通过紫外可见光谱及气相色谱-质谱(GC/MS)对OG降解过程及中间产物进行了分析.     

不同横截面形状异形纤维捕集颗粒物的数值模拟

基于离散相模型(DPM),模拟研究了不同横截面形状异形纤维在拦截和惯性碰撞2种机制下对颗粒物的捕集效率;考察了颗粒物粒径、入口风速、纤维填充率和纤维放置方式对不同横截面形状异形纤维捕集颗粒物效率的影响。结果表明,当颗粒物粒径为0.5~2.5 μm,入口风速为0.5 m·s⁻¹时,异形纤维对颗粒物的捕集效率随粒径的增加而增加,对粒径为1.5 μm及以上颗粒物的捕集效率明显增加;入口风速为0.2~0.6 m·s⁻¹时,颗粒物粒径为2.5 μm时,异形纤维对颗粒物的捕集效率均随入口风速的增加而增加;当填充率为1.2%~4.0%时,颗粒物粒径为2.5 μm时,异形纤维对颗粒物的捕集效率随填充率的增加而增加,其中横截面为正三角形的纤维对颗粒物的捕集效率均最大。异形纤维的径向异形度相同时,纤维边垂线与来流方向平行的放置方式对颗粒物的捕集效率较高。不同横截面形状异形纤维的径向异形度系数越小,对颗粒物的捕集效率受纤维的放置方式的影响越小。本研究可为新型纤维滤料的开发提供参考。     

Removal of perfluorinated surfactants from wastewater by adsorption and ion exchange——Influence of material properties,sorption mechanism and modeling

Perfluorooctane sulfonate(PFOS) has attracted increasing concern in recent years due to its world-wide distribution, persistence, bioaccumulation and potential toxicity. The influence of sorbent properties on the adsorptive elimination of PFOS from wastewater by activated carbons, polymer adsorbents and anion exchange resins was investigated with regard to their isotherms and kinetics. The batch and column tests were combined with physicochemical characterization methods, e.g., N_2 physisorption, mercury porosimetry, infrared spectroscopy, differential scanning calorimetry, titrations, as well as modeling. Sorption kinetics was successfully modelled applying the linear driving force(LDF) approach for surface diffusion after introducing a load dependency of the mass transfer coefficient βs.The big difference in the initial mass transfer coefficient βs,0, when non-functionalized adsorbents and ion-exchange resins are compared, suggests that the presence of functional groups impedes the intraparticle mass transport. The more functional groups a resin possesses and the longer the alkyl moieties are the bigger is the decrease in sorption rate.But the selectivity for PFOS sorption is increasing when the character of the functional groups becomes more hydrophobic. Accordingly, ion exchange and hydrophobic interaction were found to be involved in the sorption processes on resins, while PFOS is only physisorptively bound to activated carbons and polymer adsorbents. In agreement with the different adsorption mechanisms, resins possess higher total sorption capacities than adsorbents. Hence, the latter ones are rendered more effective in PFOS elimination at concentrations in the low μg/L range, due to a less pronounced convex curvature of the sorption isotherm in this concentration range.     

人为干扰对小兴安岭森林湿地土壤碳组分和酶活性的影响

以小兴安岭落叶林沼泽湿地为研究对象,对比研究皆伐地、火烧地和落叶松湿地土壤碳组分和酶活性.结果表明:(1)3种湿地类型土壤SOC含量表现为对照地显著高于皆伐地和火烧地(p0.05),在0~10 cm土层中皆伐地与对照地相比降低了58.38%,火烧地与对照地相比降低了61.96%.皆伐地与火烧地在不同土层的土壤中SOC含量差异不显著(p0.05);DOC含量对照地显著高于皆伐地和火烧地(p0.05).在0~10cm土层中火烧地DOC含量是皆伐地的1.99倍,两者差异不显著(p0.05);不同干扰方式对土壤MBC含量影响的差异主要表现在0~10 cm的土层土壤,对照地分别比皆伐地和火烧地高23.13%和95.79%(p0.05).在不同的土层中皆伐地MBC含量均大于火烧地,与SOC含量的变化趋势一致.(2)与对照地相比,皆伐地与火烧地0~10 cm土层的土壤蔗糖酶活性分别降低了45.59%和36.76%,脲酶活性显著降低了18.22%和55.69%(p0.05),蛋白酶活性降低了19.65%和17.34%,淀粉酶活性降低了6.29%和10.69%.土壤碳组分和酶活性在垂直方向上均表现为随着土层深度增加而减小.皆伐和火烧造成森林湿地土壤碳组分和酶活性降低.     

Ti/SnO_2-Sb阳极-空气阴极电催化降解染料废水

为解决电化学法处理高盐染料废水存在的能耗大、成本高等问题,分别采用溶胶-凝胶法和辊压法制备Ti/SnO_2-Sb阳极和空气阴极,构建了Ti/SnO_2-Sb阳极-空气阴极双极体系(TSSA-ADC)。甲基橙(MO)作为高盐染料废水的典型污染物,考察了电流强度、MO浓度、电解液浓度和初始p H对TSSA-ADC体系和TSSA单阳极体系降解MO的影响。结果表明:与TSSA单阳极体系相比,TSSA-ADC体系具有更好的抗有机负荷冲击、抗盐分冲击、抗酸碱波动能力,能够维护酸碱平衡防止硬度离子结垢。最佳反应条件为电流强度为0.030 A,电解液浓度为3%,MO浓度为100 mg/L,初始pH=6。以MO去除率达到98%为基准,TSSA-ADC体系比TSSA体系可节能74.26%。     

污泥基生物炭对垃圾渗滤液的吸附性能研究

以城镇污水处理厂剩余污泥为原料制备生物炭,研究了其对垃圾渗滤液中污染物吸附性能,旨在探索市政污泥综合利用方法和"以废治废"的治理技术途径。结果表明:当生物炭投加量为20 g/L时,垃圾渗滤液的COD和TP去除效果最佳,去除率分别为36.76%和78.36%,NH_4~+-N去除率随生物炭投加量增加而增加;上述三者不同污染物去除的最佳反应接触时间分别为50 min、30 min和≥2 h;生物炭对重金属离子的吸附机理主要表现为离子交换作用。     

我国城镇化进程中碳排放影响因素的实证研究

利用1980—2013年间的城镇人口与碳排放数据,选取城镇化进程中影响碳排放的城镇化水平、城镇建设用地面积、第三产业增加值、人均可支配收入、城镇人均绿化面积等因素,实证分析了城镇化对我国碳排放的影响程度,并利用格兰杰夫因果关系与误差修正模型分析了二者的因果关系与时间效应。最后,从降低工业碳排放、加快低碳城镇化试点建设、推进低碳社区发展,促进新能源发展等方面提出了相关建议。     

Mesoporous carbon nanomaterials induced pulmonary surfactant inhibition, cytotoxicity, inflammation and lung fibrosis

Environmental exposure and health risk upon engineered nanomaterials are increasingly concerned. The family of mesoporous carbon nanomaterials(MCNs) is a rising star in nanotechnology for multidisciplinary research with versatile applications in electronics,energy and gas storage, and biomedicine. Meanwhile, there is mounting concern on their environmental health risks due to the growing production and usage of MCNs. The lung is the primary site for particle invasion under environmental exposure to nanomaterials. Here, we studied the comprehensive toxicological profile of MCNs in the lung under the scenario of moderate environmental exposure. It was found that at a low concentration of 10 μg/mL MCNs induced biophysical inhibition of natural pulmonary surfactant. Moreover, MCNs at similar concentrations reduced viability of J774 A.1 macrophages and lung epithelial A549 cells.Incubating with nature pulmonary surfactant effectively reduced the cytotoxicity of MCNs.Regarding the pro-inflammatory responses, MCNs activated macrophages in vitro, and stimulated lung inflammation in mice after inhalation exposure, associated with lung fibrosis.Moreover, we found that the size of MCNs played a significant role in regulating cytotoxicity and pro-inflammatory potential of this nanomaterial. In general, larger MCNs induced more pronounced cytotoxic and pro-inflammatory effects than their smaller counterparts. Our results provided valuable information on the toxicological profile and environmental health risks of MCNs, and suggested that fine-tuning the size of MCNs could be a practical precautionary design strategy to increase safety and biocompatibility of this nanomaterial.