浸渍液pH值对V-Mo/Ti脱硝催化剂性能的影响研究

为提升V-Mo/Ti催化剂的脱硝性能,在催化剂制备过程中调节浸渍工艺参数,制备了一系列不同浸渍液pH值的催化剂,采用XRD、N2-吸附脱附、拉曼光谱、UV-Vis、H2-TPR、NH3-TPD等手段对催化剂进行表征,考察了pH值的变化对催化剂物理化学性能的影响,采用固定床微型反应器对催化剂的脱硝性能进行评价。结果表明,降低浸渍液pH值,可以抑制催化剂上VOx物种的聚合,提升催化剂的还原性能,有利于提升催化剂的脱硝效率,降低脱硝反应过程中N2O生成量。同时,浸渍液pH值的变化,也会影响催化剂的酸性性能。当浸渍液pH值低于3.64时,催化剂酸性性能显著降低,造成催化剂脱硝性能降低;当浸渍液pH值控制在3.64时,催化剂的还原性能和酸性性能匹配较好,从而显示了较高的脱硝性能。     

Bi/Fe_3O_4催化NaBH_4还原水中对硝基苯酚

以磁性Fe_3O_4为载体负载Bi(NO_3)_3,再用NaBH_4还原Bi~(3+)制备了Bi/Fe_3O_4催化剂。采用XRD和紫外-可见光谱对催化剂进行表征。考察了Bi负载量、NaBH_4加入量和Bi/Fe_3O_4加入量对Bi/Fe_3O_4催化NaBH_4还原对硝基苯酚(4-NP)效果的影响。表征结果显示:当催化剂中Bi含量较少时,Bi分散良好;当Bi含量较多时,会形成纳米颗粒。实验结果表明:当反应温度为25℃,初始4-NP浓度为4.0 mmol/L时,在Bi负载量为5%(w)、Bi/Fe_3O_4催化剂加入量为500 mg/L,NaBH_4加入量为6.0 g/L的条件下,反应速率常数为0.581 min~(-1),4-NP的去除率为99.7%;Bi/Fe_3O_4催化剂稳定性好,重复使用15次后,活性基本不变。     

SO2和H2O对Mn-Ce/TiO2催化剂低温SCR活性的影响

采用溶胶凝胶法制备Mn-Ce/TiO_2低温SCR催化剂并考察其活性,研究了SO_2和H_2O对Mn-Ce/TiO_2低温脱硝催化剂的影响,并运用XRD、BET、SEM和FT-IR对中毒前后的催化剂进行表征。结果表明,催化剂在无SO_2和H_2O条件下具有良好的脱硝性能,在140℃时NO_x去除率达到84%。但若向模拟烟气中加入SO_2和H_2O,则随其体积分数增大对催化剂活性产生明显抑制作用。当H_2O的体积分数为5%、SO_2为700×10-6时,反应4 h后,NO_x去除率降为53%。H_2O对催化剂的抑制作用随H_2O的除去而消除,H_2O主要通过与NO_x的竞争吸附来抑制催化剂的活性。低浓度的SO_2对催化剂活性影响较小,SO_2体积分数为100×10~(-6)时,稳定后NO_x去除率仍能维持在80%以上,但较高体积分数的SO_2引起的催化剂失活不可自行恢复。SO_2毒化作用主要是引起了硫酸铵盐覆盖催化剂的表面活性位,以及造成活性组分MnO_x的晶化,并破坏了MnO_x与TiO_2间的强相互作用。H_2O和SO_2共同存在时,H_2O可以弱化SO_2对催化剂的毒化作用,主要因为H_2O与SO_2的竞争吸附作用而使SO_2对催化剂活性的影响减弱。     

Two-step fast microwave-assisted pyrolysis of biomass for bio-oil production using microwave absorbent and HZSM-5 catalyst

A novel technology of two-step fast microwave-assisted pyrolysis(f MAP) of corn stover for bio-oil production was investigated in the presence of microwave absorbent(Si C) and HZSM-5catalyst. Effects of f MAP temperature and catalyst-to-biomass ratio on bio-oil yield and chemical components were examined. The results showed that this technology, employing microwave, microwave absorbent and HZSM-5 catalyst, was effective and promising for biomass fast pyrolysis. The f MAP temperature of 500°C was considered the optimum condition for maximum yield and best quality of bio-oil. Besides, the bio-oil yield decreased linearly and the chemical components in bio-oil were improved sequentially with the increase of catalyst-to-biomass ratio from 1:100 to 1:20. The elemental compositions of bio-char were also determined. Additionally, compared to one-step f MAP process, two-step f MAP could promote the bio-oil quality with a smaller catalyst-to-biomass ratio.     

Experimental investigation of adsorption capacity of anthill in the removal of heavy metals from aqueous solution

In the present work, the adsorption capacity of anthill was investigated as a low‐cost adsorbent to remove the heavy metal ions, lead (II) ion (Pb²⁺), and zinc (II) ion (Zn²⁺) from an aqueous solution. The equilibrium adsorption isotherms of the heavy metal ions were investigated under batch process. For the study we examined the effect of the solution's pH and the initial cations concentrations on the adsorption process under a fixed contact time and temperature. The anthill sample was characterized using a scanning electron microscope (SEM), X‐ray fluorescence (XRF), and Fourier transform infrared (FTIR) techniques. From the SEM analysis, structural change in the adsorbent was a result of heavy metals adsorption. Based on the XRF analysis, the main composition of the anthill sample was silica (SiO₂), alumina (Al₂O₃), and zirconia (ZrO₂). The change in the peaks of the spectra before and after adsorption indicated that there was active participation of surface functional groups during the adsorption process. The experimental data obtained were analyzed using 2‐ and 3‐parameter isotherm models. The isotherm data fitted very well to the 3‐parameter Radke–Prausnitz model. It was noted that Pb²⁺ and Zn²⁺ can be effectively removed from aqueous solution using anthill as an adsorbent.     

Bi2O3-TiO2复合光催化剂协同处理铬-邻苯二甲酸酯复合污染

以硝酸铋和钛酸丁酯为前驱体,采用水热法制备了Bi_2O_3-TiO_2复合半导体材料,并利用X射线衍射(XRD)、紫外-可见吸收光谱(UVVis)、能谱分析(EDS)、X射线光电子能谱(XPS)等手段对复合材料的结构进行了表征.同时,考察了Bi_2O_3-TiO_2复合材料对重金属Cr(Ⅵ)和难降解邻苯二甲酸二丁酯(DBP)复合污染的处理性能,并探讨了复合催化剂协同处理复合污染的作用机制.结果表明:该复合催化剂在可见光下能同时降低重金属Cr(Ⅵ)和有机物DBP的浓度,抑制电子和空穴复合,表现出比对单一Cr(Ⅵ)及DBP污染物更高的处理效率.当Bi_2O_3含量为4%时,复合催化剂表现出最佳的光催化活性.     

浸入式短流程超滤膜生产工艺过程膜污染的形成与控制

以江苏芦泾水厂膜技术改造工程为对象,从水质、膜工艺特征结合生产运行过程以及污染膜的清洗进行了分析,目的是了解膜污染的组分构成,评价不同清洗剂的清洗效果,获取较优的清洗顺序.结果表明,原水以憎水酸(HOA)和亲水组分(HIM)为主体,质量分数各占40.34%和28.48%.溶解性有机物(DOM)则以芳香性蛋白质Ⅱ类物质为...     

改性Y沸石催化降解聚苯乙烯的研究

用热重分析方法研究了HY沸石与改性Y沸石(UHY)作为催化降解聚苯乙烯的催化剂对聚苯乙烯催化降解的作用及影响,对聚苯乙烯的催化降解与热降解反应产物进行了比较。结果表明,催化剂的存在能显著地降低聚苯乙烯的降解温度,催化剂的酸量和孔结构对聚苯乙烯的降解温度、活化能、积炭的生成量及裂解产物有很大的影响。     

用脉冲电旋风除尘器处理催化剂厂分子筛尾气

介绍了脉冲电旋风除尘器的工作原理及用其处理催化剂分子筛尾气的试验情况。试验结果表明,分子筛尾气很适合脉冲电旋风除尘处理,除尘效果较好,在进气含尘质量浓度为1324．9mg／m^3时,除尘效率达89．4％左右,粉尘驱进速度达0．15～0．17m／s,比常规电除尘技术提高1倍左右。     

废水中氨氮湿式空气氧化和超临界水氧化研究进展

湿式空气氧化法(WAO)和超临界水氧化法（SCWO)废水处理技术近年已有广泛研究。当催化剂存在于氧化体系时,不仅能降低反应温度、压力,而且可提高废水中有害物质的降解效率。介绍了氨的湿式空气氧化和超临界水氧化催化剂应用的研究进展、各种催化剂在超临界水中的稳定性能及氨的催化超临界水氧化情况。