全文获取类型
收费全文 | 604篇 |
免费 | 108篇 |
国内免费 | 402篇 |
专业分类
安全科学 | 52篇 |
废物处理 | 151篇 |
环保管理 | 68篇 |
综合类 | 557篇 |
基础理论 | 121篇 |
污染及防治 | 153篇 |
评价与监测 | 10篇 |
社会与环境 | 2篇 |
出版年
2024年 | 5篇 |
2023年 | 13篇 |
2022年 | 28篇 |
2021年 | 35篇 |
2020年 | 41篇 |
2019年 | 30篇 |
2018年 | 46篇 |
2017年 | 35篇 |
2016年 | 46篇 |
2015年 | 62篇 |
2014年 | 74篇 |
2013年 | 69篇 |
2012年 | 69篇 |
2011年 | 56篇 |
2010年 | 35篇 |
2009年 | 37篇 |
2008年 | 39篇 |
2007年 | 48篇 |
2006年 | 52篇 |
2005年 | 35篇 |
2004年 | 40篇 |
2003年 | 28篇 |
2002年 | 27篇 |
2001年 | 24篇 |
2000年 | 20篇 |
1999年 | 24篇 |
1998年 | 21篇 |
1997年 | 9篇 |
1996年 | 15篇 |
1995年 | 11篇 |
1994年 | 11篇 |
1993年 | 10篇 |
1992年 | 8篇 |
1991年 | 3篇 |
1990年 | 1篇 |
1989年 | 3篇 |
1988年 | 2篇 |
1987年 | 1篇 |
1977年 | 1篇 |
排序方式: 共有1114条查询结果,搜索用时 140 毫秒
221.
以磷酸硅铝分子筛SAPO-5、SAPO~(-1)1和SAPO-34为载体,采用乙醇分散法制备了用于低温氨选择性还原(NH_3-SCR)NO_x的分子筛负载MnO_x催化剂.活性测试结果显示,3种分子筛催化剂均展现出优良的NH_3-SCR活性,但三者在低温区间的SCR活性存在较明显差异,其SCR活性顺序如下:MnO_x/SAPO-34MnO_x/SAPO-5MnO_x/SAPO~(-1)1.借助XRD、N2吸附-脱附、XPS、H2-TPR、NH_3-TPD、NH_3FT-IR等技术对催化剂的表面活性物种及表面酸性等进行表征分析,结果表明,MnO_x主要以无定型状态分散于载体上,负载后载体的比表面积和孔体积均有所下降.XPS和H2-TPR分析证实,不同分子筛载体上MnO_x的表面浓度与氧化态明显不同.NH_3-TPD和NH_3FT-IR分析揭示了催化剂表面均存在Bronsted酸位和Lewis酸位,其中,Lewis酸性位对低温SCR反应起着关键作用.研究表明,催化剂的催化性能会因载体不同而存在差异,高Mn4+表面浓度和丰富的Lewis酸性位对催化剂在低温区间实现优良的催化活性尤为重要. 相似文献
222.
223.
224.
聚丙烯塑料-锯末干混合制备高介孔率柱状活性炭 总被引:2,自引:1,他引:2
以聚丙烯塑料和梧桐锯末为原材料,无水K2CO3为活化剂,采用干混合法制备高介孔率柱状活性炭.通过单因素实验,探究了塑料含量、盐料比、活化温度及活化时间对活性炭吸附亚甲基蓝(MB)性能的影响.结果表明:当塑料含量为20%、盐料比为2.5、活化温度为950℃、活化时间为80 min时,所制备的活性炭具有较高的MB吸附量(322.9 mg·g-1).所制备的活性炭具有发达的微观孔隙结构,其比表面积达到1461.99m2·g-1,平均孔径为3.23 nm,总孔容为1.04 cm3·g-1,其中,介孔孔容为0.80 cm3·g-1,介孔率超过70%,充分说明该方法可制备优质高介孔率柱状活性炭. 相似文献
225.
A novel silica catalyst was synthesized by evaporation-induced self-assembly (EISA) method and tested for the catalytic selective hydrolysis of cellulose to glucose. This silica catalyst exhibited a higher catalytic activity than other oxides prepared by the same method, such as ZrO2, TiO2, and Al2O3. Using silica as a catalyst, cellulose was selectively hydrolyzed into glucose with a glucose yield as high as 50% under hydrothermal conditions without hydrogen gas. The silica catalyst was characterized by Brunauer-Emmett-Teller (BET), X-ray diffraction (XRD) and transmission electron microscopy (TEM). The results of temperature-programmed desorption of ammonia (NH3-TPD) and textural properties indicated that the synergistic effect between strong acidity and a suitable pore diameter of the silica catalyst may be responsible for its high activity. In addition, the catalyst was recyclable and showed excellent stability during the recycle catalytic runs. 相似文献
226.
227.
挥发性有机物(VOCs)大量排放已成为日益严重的环境问题,为了实现VOCs的高效去除,本文采用自蔓延燃烧合成法制备了一系列锰铈复合氧化物催化剂,将稳恒直流电场引入典型VOCs气体苯的催化氧化过程,并基于不同电场条件下催化剂的理化性质表征结果进行机理分析.实验结果表明,MnxCey催化剂对含苯废气的去除有良好的效果,稳恒直流电场显著促进了催化剂的活性,其中Mn1Ce3的催化性能最佳,电流为5 mA时,Mn1Ce3催化剂在155℃可达到50%的苯转化率,在202.4℃可达到90%的苯转化率,对应的转化温度T50和T90比传统方法分别降低了62.4℃和48.3℃,且电场中的反应活化能由52.32 kJ·mol-1降低至32.31 kJ·mol-1.根据实验现象及表征结果,发现协同效应与活性位点的快速持续再生及活性氧物种的转化有关,由此提出苯在MnxCey催化剂上的氧化机理及电场协同催化的反应模型. 相似文献
228.
Decomposition mass loss and pyrolysis products analyses of particles sampled at various locations along the tailpipe of a Euro-IV diesel engine were performed using a thermogravimetry in conjunction with Fourier transformation infrared spectrometry-mass spectrum. Diesel particles were collected at the same location with and without diesel oxidation catalyst (DOC) mounted on the test engine separately. The three poles in thermal gravity-differential thermal gravity images suggested that the decomposition process of diesel particles could be divided into three stages which correspond to the decompositions of lower boiling substances, higher boiling substances and soot respectively. It is noticed that no matter whether DOC was mounted or not, the further the particles were sampled away from the engine block, the lower the peak temperatures and the heavier the mass losses within the first two stages, which indicated that the soluble organic fraction in the particle samples increased and therefore lowering the activation energy of thermal decomposition. Hydroxyl, ammonia, CxHy fragments, benzene, toluene, and phenol were found to be the primary products of particle decomposition, which didn't change with the location of particle sample point. The employment of DOC increased the activation energy for particle oxidation and resulted in a higher peak temperature and lower mass loss within the first-stage. Moreover, the CO stretching bands of aldehyde and ketone at 1771 cm?1 was only detected without a DOC, while the NO2 peak at 1634 cm?1 was solely noticed with the presence of DOC. Compared to the first-stage pyrolysis products, more polycyclic aromatic hydrocarbons and less CxHy fragments were seen in the second-stage. 相似文献
229.
镍铜氧化物对吐氏酸废水臭氧氧化的催化作用 总被引:10,自引:0,他引:10
染料中间体废水等难生物降解废水是目前水处理研究的焦点。用浸渍法和附着沉淀法制备了以γ-Al2O3为载体的负载型镍、铜氧化物催化剂,并以催化吐氏酸废水的臭氧氧化。研究结果表明,镍、铜单组分和双组分氧化物催化剂能不同程度地提高臭氧的利用效率,其中附着沉淀法制备的Ni-Cu-Urea-1催化剂活性最高,当臭氧投加量为0.82g/L时,其臭氧化指数为1.1;助剂钾对催化剂活性的影响与制备方法有关,当用浸渍法制备时,助剂钾能提高催化剂活性,而附着沉淀法时则不利。 相似文献
230.