化学混凝-催化氧化法处理钻井污水

由于钻井污水经混凝处理后仍存在ＣＯＤ、色度超标问题,因此需采用其他方法深度处理污水。故采用混凝－催化氧化法工艺处理钻井污水,混凝剂为硫酸铁或聚合硫酸铁,混凝剂加量一般为２０００ｍｇ／Ｌ,初始ｐＨ值为３．０～５．０,氧化时间为３ｈ等。通过实验结果可知：该方法完全能满足钻井污水处理的要求,处理后出水可达标外排。化学混凝－催化氧化处理工艺是解决高浓度钻井污水处理ＣＯＤ、色度超标的重要途径,在技术经济上是可行的,具有广阔的应用前景     

催化剂生产废水铵离子选择交换处理工艺

用铵离子选择交换工艺对催化剂生产过程排出的含氨氮废水进行处理。考察了再生液中NH3－N浓度、进水NH3－N浓度、进水悬浮物浓度、进水pH、再生液用量等因素对处理效果的影响；探讨了铵离子选择交换床液体空速与出水NH3－N浓度的关系、铵离子交换床总交换容量与进水NH3－N负荷之比与出水NH3－N浓度的关系。     

INTEGRATING LANDSCAPE ASSESSMENT AND HYDROLOGIC MODELING FOR LAND COVER CHANGE ANALYSIS1

ABSTRACT: Significant land cover changes have occurred in the watersheds that contribute runoff to the upper San Pedro River in Sonora, Mexico, and southeast Arizona. These changes, observed using a series of remotely sensed images taken in the 1970s, 1980s, and 1990s, have been implicated in the alteration of the basin hydrologic response. The Cannonsville subwatershed, located in the Catskill/Delaware watershed complex that delivers water to New York City, provides a contrast in land cover change. In this region, the Cannonsville watershed condition has improved over a comparable time period. A landscape assessment tool using a geographic information system (GIS) has been developed that automates the parameterization of the Soil and Water Assessment Tool (SWAT) and KINEmatic Runoff and EROSion (KINEROS) hydrologic models. The Automated Geospatial Watershed Assessment (AGWA) tool was used to prepare parameter input files for the Upper San Pedro Basin, a subwatershed within the San Pedro undergoing significant changes, and the Cannonsville watershed using historical land cover data. Runoff and sediment yield were simulated using these models. In the Cannonsville watershed, land cover change had a beneficial impact on modeled watershed response due to the transition from agriculture to forest land cover. Simulation results for the San Pedro indicate that increasing urban and agricultural areas and the simultaneous invasion of woody plants and decline of grasslands resulted in increased annual and event runoff volumes, flashier flood response, and decreased water quality due to sediment loading. These results demonstrate the usefulness of integrating remote sensing and distributed hydrologic models through the use of GIS for assessing watershed condition and the relative impacts of land cover transitions on hydrologic response.     

Preparation and characterization of mixed hydroxy-Fe-Al pillared montmorillonite with large basal spacing

IntroductionMontmorilloniteisaclaymineralwithsubstantialisomorphicsubstitution .Mesoporouspillaredmontmorillonitecanbepreparedbyintroducinggallerytemplates ,suchasquaternaryammoniumcationandlongchainamine .Thusformedorgano montmorilloniteshaveimprovedcapa…     

Kinetics study on catalytic wet air oxidation of phenol by several metal oxide catalysts

Four metal oxide catalysts composed of copper (Cu), stannum (Sn), copper-stannum (Cu-Sn) and copper-cerium(Cu-Ce) respectively were prepared by the co-impregnation method, and γ-alumina(γ-Al2O3 ) is selected as support. A first-order kinetics model was established to study the catalytic wet air oxidation of phenol at different temperature when these catalysts were used. The model simulations are good agreement with present experimental data. Results showed that the reaction rate constants can be significantly increased when catalysts were used, and the catalyst of 6% Cu-10% Ce/γ-Al2 O3 showed the best catalytic activity. This is consistent witht he result of catalytic wet air oxidation of phenol and the COD removal can be arrived at 98.2% at temperature 210℃, oxygen partial pressure 3 MPa and reaction time 30 rain. The activation energies of each reaction with different catalysts are nearly equal, which is found to be about 42 kJ/mol and the reaction in this study is proved to be kinetics control.     

低温等离子体催化氧化甲烷的实验研究

采用电容耦合等离子体和催化剂协同作用对干空气中的甲烷进行了氧化实验,并和没有放置催化剂时进行了对比,结果表明,放置催化剂后甲烷的分解效率明显提高,反应产物中CO2的选择性增加,副产物NO和NO2的浓度减少,反应所需的能耗降低.甲烷的最终氧化产物为CO、CO2和H2O.     

水体溶解性有机物的化学分级表征:原理与方法

综述了水体溶解性有机物(DOM)的化学分级表征法即树脂吸附分级法(RA)的研究与进展,同时基于该方法存在的一些问题结合我国典型水质体系,从树脂的选择、净化、分级的定义、水样过柱流速、水样树脂体积比的确定等方面进行了研究探讨,给出了完整的实验参数和操作方法.     

工业废渣制备生物质裂解用催化剂载体及其性能

以赤泥和粉煤灰为原料,无水碳酸钠为造孔剂,制备了用于生物质裂解的催化剂载体。探讨了载体的焙烧工艺、最佳配方及其最高焙烧温度,并对按最佳工艺条件所制备的载体进行了性能测试。     

用废镍铝合金粉制备镍催化剂

研究了以废镍铝合金粉（废镍渣）为原料、H2SO4为浸出剂、尿素为沉淀剂制备镍催化剂的方法;考察了Ni浸出条件对其浸出率的影响,并通过催化加氢实验对镍催化剂的活性进行了评价。Ni的浸出条件：w（H2SO4）25％、酸浸时间3h、n（废镍渣）：n（H2SO4）=1．0：1．4。在该条件下,Ni的浸出率为92．85％。Ni的回收率在90％以上。催化加氢实验结果表明,在温度120～125℃、压力大于或等于1．2MPa、催化剂用量1％（质量分数）的条件下,可将异丙叉丙酮经一步液相催化加氢反应制备成甲基异丁基甲醇（MBC）,异丙叉丙酮转化率为100％,MIBC的收率达99．3％。     

化学需氧量半微量烘箱测定方法的研究

介绍了污水和工业废水中化学需氧量(COD)的半微量烘箱测定方法。该法与经典回流法比较,具有节省水电、省时、省药品等特点。用Ag2SO4-MnSO4作催化剂,HgSO4用量少,减少了汞盐的二次污染。具有较好的精密度和准确度,适用于大批量的水样的测定,有良好的推广价值。