镍基催化剂对污泥微波热解制生物气效能的影响

为实现污水污泥减量化、无害化及资源化的目标,在微波热解污水污泥基础上,进行了镍基催化剂对制取生物气效能影响的研究。采用元素分析对污泥元素进行检测,气/质联用分析(GC-MS)和气相色谱(GC)对热解生物气的组成和含量进行测定。实验结果表明,镍基催化剂的添加对微波热解污水污泥制取生物气有较大促进作用。5%添加量与800℃热解终温条件下具有最佳催化效果:生物气中H2、CO产量最大,H2产量由29 g/kg增加到35.8 g/kg,提升23.4%,CO产量由302.7 g/kg增加到383.3 g/kg,提升26.6%;同时催化剂还能提高热能利用效率,降低热解终温,即5%添加量在700℃热解终温时可达到空白800℃时的产气效果;镍基催化剂主要在500~600℃时发挥催化作用,加快了H2和CO的释放。微波热解污泥制取的生物气具有产量大、富含H2与CO等优点,可推动污水污泥的资源化进程。     

负载型Mn-Ce/TiO2催化剂的制备及其低温脱硝活性简

以成型TiO₂作为载体,通过浸渍法制备了Mn-Ce/TiO₂低温SCR催化剂,并系统研究了制备方法、煅烧条件、活性组分担载量、Mn含量等参数对催化剂催化还原NO性能的影响。结果表明,煅烧温度的升高会促使活性组分结晶度的提高,从而引起催化活性的降低,在500℃和600℃下所得Mn-Ce/TiO₂催化剂活性组分为无定型态,表现出较高的脱硝活性。活性组分担载量的增加有利于催化活性的提高。Mn含量对Mn-Ce/TiO₂催化剂的活性有较大影响,当Mn/（Mn+Ce）摩尔比为40%和85%时,催化剂活性最高。     

含氨氮催化剂生产废水的处理

采用加入淀粉的短程硝化-反硝化一体化技术处理低碳含NH3-N催化剂废水。通过中试确定了适宜的工艺参数,并在工业化装置上进行了验证。试验结果表明：在DO为0.5 mg/L左右、淀粉加入量为0.25 kg/ m3、HRT=30 h的条件下,短程硝化-反硝化一体化技术具有较好的处理效果,NH3-N去除率大于97%,且具有较强的抗冲击负荷的能力; 出水的COD<100 mg/L,ρ（NH3-N）<10 mg/L,达到GB 8978—1996《污水综合排放标准》的一级排放标准。工业化装置的运行费用以NH3-N计为2.3 元/kg、以废水计为4.6 元/t。该法适用于中低浓度（ρ（NH3-N）<300 mg/L）废水的处理。     

Using multivariate regression modeling for sampling and predicting chemical characteristics of mixed waste in old landfills

Municipal solid waste landfills pose a threat on environment and human health, especially old landfills which lack facilities for collection and treatment of landfill gas and leachate. Consequently, missing information about emission flows prevent site-specific environmental risk assessments. To overcome this gap, the combination of waste sampling and analysis with statistical modeling is one option for estimating present and future emission potentials. Optimizing the tradeoff between investigation costs and reliable results requires knowledge about both: the number of samples to be taken and variables to be analyzed.This article aims to identify the optimized number of waste samples and variables in order to predict a larger set of variables. Therefore, we introduce a multivariate linear regression model and tested the applicability by usage of two case studies. Landfill A was used to set up and calibrate the model based on 50 waste samples and twelve variables. The calibrated model was applied to Landfill B including 36 waste samples and twelve variables with four predictor variables.The case study results are twofold: first, the reliable and accurate prediction of the twelve variables can be achieved with the knowledge of four predictor variables (Loi, EC, pH and Cl). For the second Landfill B, only ten full measurements would be needed for a reliable prediction of most response variables. The four predictor variables would exhibit comparably low analytical costs in comparison to the full set of measurements. This cost reduction could be used to increase the number of samples yielding an improved understanding of the spatial waste heterogeneity in landfills.Concluding, the future application of the developed model potentially improves the reliability of predicted emission potentials. The model could become a standard screening tool for old landfills if its applicability and reliability would be tested in additional case studies.     

分子筛催化剂生产废水的生物处理

采用氨化—硝化—反硝化三段联合生物工艺处理分子筛催化剂生产过程中产生的含有机胺废水。实验结果表明：在氨化过程中,当进水COD稳定为1 200~1 600 mg/L时,出水COD低于300 mg/L,COD去除率稳定在80%左右,当进水ρ（有机氮）为100~160 mg/L时,出水ρ（有机氮）均低于30 mg/L,有机氮去除率大于80%,在整个氨化过程中,出水ρ（氨氮）较进水ρ（氨氮）提高了35~200 mg/L;硝化过程中,当进水ρ（氨氮）小于等于300 mg/L时,出水ρ（氨氮）最终稳定在15 mg/L以内,氨氮去除率大于90%;在反硝化过程中,亚硝酸盐氮去除率基本稳定在98%以上,最终出水COD低于80 mg/L,出水ρ（总氮）低于25 mg/L。     

拜耳法赤泥粒径分级预处理的研究

赤泥是从铝土矿中提取氧化铝的过程中产生的工业废渣.分析了拜耳法赤泥的粒径分布,以及主要化学组成和矿物组成在不同粒径赤泥中的变化规律.在此基础上,提出先将赤泥粒径分级预处理,然后根据粗细粒径赤泥的差异分别进行回收利用的思路.研究结果表明,赤泥中粒径大于0.075 mm的粗颗粒以铁、硅、钙为主,实践证明可以通过磁选或重选工...     

脱硝催化剂孔结构及其脱硝特性的研究

选择性催化还原脱硝技术(SCR)所采用的催化剂多数为多孔介质,其内部孔隙有助于提高催化剂的反应活性。文中采用浸渍负载法,通过改变制备温度制备出不同孔结构的催化剂样品,采用N2吸附法对其孔结构进行测定和分析,并对不同孔结构的催化剂样品进行了脱硝实验。研究表明:煅烧及干燥温度对催化剂孔结构有很大的影响,比表面积越大,其催化剂内的孔分布宽度越窄,平均孔径越小;在活性温度范围(360～390℃)内,脱硝过程中主要是属于化学反应过程控制,脱硝效果随着比表面积的增大而增强;在非活性温度范围内,脱硝过程同时受到气体扩散过程及化学反应过程控制。     

Ozone facilitated degradation of caffeine using Ce-TiO2 catalyst

The ozone initiated oxidation of 1,3,7-trimethylxanthine (caffeine), commonly found in wastewaters as model compound is reported using cerium (Ce)/titanium dioxide (TiO₂) as catalyst. The effect of pH and loading of ceria on titania were investigated. Effect of reaction conditions on degradation of caffeine based on their pseudo first-order rate constants were compared. The combination of catalyst Ce-TiO₂ and ozone aeration significantly enhanced the degradation of caffeine compared to uncatalysed ozonation. The oxidation of caffeine ensued via the free radical mechanism, through enhanced ozone decomposition into OH radicals. Ce/TiO₂(0.5?wt%) showed good activity in degradation of caffeine at pH 6, in both natural stream and river water samples showing about 60% total organic carbon removal in 2?h ozonation period. Using liquid chromatography-mass spectroscopy, degradation products were analysed. A reaction intermediate and one final product were positively identified. Nano-catalysts with different loadings of Ce on TiO₂ synthesized by sol-gel route were characterized by scanning electron microscope, transmission electron microscopy, BET and powder X-ray diffraction spectrum techniques. The results showed that the material retained a highly ordered mesoporous structure and possessed large surface area.     

CePO4-TiO2固溶体的NH3-SCR活性

采用共沉淀法合成了不同Ce与Ti摩尔比的CePO₄-TiO₂复合材料,利用XRD、TEM、NH₃-TPD和H₂-TPR技术对其物理化学性质进行了表征,并对其NH₃-SCR活性进行了评价。实验结果表明：随着CePO₄含量的增加,催化剂的活性提高;当Ce与Ti的摩尔比为8:2时催化剂的活性最高,230 ℃的NO转化率达到100%,且具有更广的温度窗口,优于纯CePO₄。表征结果显示,CePO₄与TiO₂形成固溶体后,颗粒尺寸较为均匀,强酸位的数量增多,氧化还原性能提升,从而提高了催化剂的SCR反应活性,同时改善了其抗水抗硫性能。     

氮掺杂氧化钛的简易制备及可见光催化活性的研究

为开发对可见光响应的催化剂,以尿素为氮掺杂剂,采用简易溶胶-凝胶法制备氮掺杂氧化钛,并以2,4-DCP的降解检验其光催化活性。XRD、BET、XPS和UV-Vis漫反射光谱分析表明,随着氮/钛原子比（N/Ti)的增大,各催化剂晶粒尺寸减小,比表面积增大,锐钛矿相向金红石相的转变得到抑制,除0#样品出现金红石相外,其他催化剂均只出现锐钛矿相;掺入催化剂的N位于晶格O位点和晶格间隙,替代N和间隙N掺杂使催化剂的光吸收发生明显的红移。荧光光谱分析表明,当N/Ti在0～6范围内增加时,反应体系中·OH自由基的产生速率增加,当N/Ti增大至8时,速率则下降。相似的规律也表现在氮掺杂量对光催化活性的影响。适量氮掺杂能增强氧化钛的可见光催化活性,该改性催化剂可用于有机污染物的太阳光激催化降解。