Supercritical water oxidation of polyvinyl alcohol and desizing wastewater：Influence of NaOH on the organic decomposition

Polyvinyl alcohol is a refractory compound widely used in industry. Here we report supercritical water oxidation of polyvinyl alcohol solution and desizing wastewater with and without sodium hydroxide addition. However, it is difficult to implement complete degradation of organics even though polyvinyl alcohol can readily crack under supercritical water treatment. Sodium hydroxide had a significant catalytic effect during the supercritical water oxidation of polyvinyl alcohol. It appears that the OH ion participated in the C-C bond cleavage of polyvinyl alcohol molecules, the CO2-capture reaction and the neutralization of intermediate organic acids, promoting the overall reactions moving in the forward direction. Acetaldehyde was a typical intermediate product during reaction. For supercritical water oxidation of desizing wastewater, a high destruction rate (98.25%) based on total organic carbon was achieved. In addition, cases where initial wastewater was alkaline were favorable for supercritical water oxidation treatment, but salt precipitation and blockage issues arising during the process need to be taken into account seriously.     

Formic acid as an alternative reducing agent for the catalytic nitrate reduction in aqueous media

Formic acid was used for the nitrate reduction as a reductant in the presence of Pd:Cu/γ-alumina catalysts. The surface characteristics of the bimetallic catalyst synthesized by wet impregnation were investigated by SEM, TEM-EDS. The metals were not distributed homogeneously on the surface of catalyst, although the total contents of both metals in particles agreed well with the theoretical values. Formic acid decomposition on the catalyst surface, its influence on solution pH and nitrate removal efficacy was investigated. The best removal of nitrate (50 ppm) was obtained under the condition of 0.75 g/L catalyst with Pd:Cu ratio (4:1) and two fold excess of formic acid. Formic acid decay patterns resembled those of nitrate removal, showing a linear relationship between kf (formic acid decay) and k (nitrate removal). Negligible amount of ammonia was detected, and no nitrite was detected, possibly due to buffering effect of bicarbonate that is in situ produced by the decomposition of formic acid, and due to the sustained release of H2 gas.     

OMS-2负载Pt催化剂的制备及其催化氧化性能研究

采用前掺杂法、沉积-沉淀法和浸渍法制备了氧化锰八面体分子筛(OMS-2)负载Pt催化剂(Pt/OMS-2),对所制催化剂进行了结构和织构表征。并研究了不同制备方法和沉积-沉淀法中不同制备(Pt负载量和溶液的pH值)对Pt/OMS-2催化氧化CO性能的影响。结果表明,沉积-沉淀法制备的Pt/OMS-2-DP催化剂活性最好(T100=100℃)。这与Pt/OMS-2-DP催化剂中Pt颗粒大小及OMS-2载体与Pt之间存在强相互作用有关。Pt负载量明显影响Pt/OMS-2-DP催化剂的催化活性,3Pt/OMS-2-DP催化剂(Pt=3.0 wt%)催化活性最高,这是由于适当Pt负载量,Pt颗粒较小,并与载体OMS-2的相互作用较强,能较好地活化OMS-2晶格氧。pH值对Pt/OMS-2-DP催化剂催化性能影响较大,这与OMS-2的等电点和Pt在不同溶液中存在不同Pt配位体形式有关。     

Fenton氧化技术在废水处理方面的应用

Fenton氧化技术是高级氧化技术的一种,是处理难降解的废水是常用的技术之一。本文对Fenton氧化技术原理和影响因素进行分析,并对Fenton氧化技术在电镀废水、染料废水、造纸废水中的应用进行了研究。     

生态工程组合工艺应用于城市污水处理厂尾水深度处理

针对城市污水处理厂尾水的特点,采用生态氧化池／垂直流人工湿地／自然湿地生态工程组合工艺对其进行深度处理,重点分析了运行效果和去除机理。数据结果表明,该工艺运行稳定,系统出水COD,BOD5,NH3-N和TP平均分别为14．4,3．4,0．84,0．19mg／L,平均去除率均在65％以上,出水水质达到《地表水环境质量标准》（GB3838-2002）中Ⅳ类标准。     

非均相类Fenton试剂的制备及其在焦化废水处理中的应用研究

利用浸渍法,将Fe3＋负载在经酸碱改性后的粉状活性炭上,当浸渍液浓度为2．5％,固化温度为270℃时,制成的催化剂催化活性较高。用自制的非均相类benton试剂降解焦化废水,通过正交试验和极差分析得出,影响因素的主次顺序为催化剂用量〉初始pH值〉反应时间〉H：0：投加量。结果表明,在100ml水样中。室温条件下,初始pH值为4．0,催化剂使用量为1．5g,H20：投加量为5ml（分两次投加）,反应时间为90min时,COD去除率可达99％。采用混凝＋化学沉淀＋非均相类Fenton试剂法处理焦化废水,各主要出水水质指标为：色度lO倍;COD浓度38．5mg／L;氨氮浓度8．4mg／L,达到国家一级排放标准。     

氧气热处理的TiO2纳米管阵列光电催化降解亚甲基蓝的研究

采用原位阳极氧化法在Ti基底上制备了高度有序的TiO2纳米管阵列薄膜,SEM图像表明TiO2纳米管定向排列整齐,分布均匀,其管径范围在70～100 nm.XRD结果证明,阳极氧化法制备的TiO2纳米管为无定型晶型,经退火后为具有良好光催化活性的锐钛矿型.以亚甲基蓝（methylene blue）为目标物研究了TiO2纳米管光电催化性能及影响因素,结果表明,以0.1 mol/L NaCl为电解质,在氧气热处理气氛下,外加偏压为0.5 V、pH=3.25、光照强度为1 000μW/cm2、纳米管薄膜表面积为2 cm×2 cm且MB初始浓度为10 mg/L的条件下,TiO2纳米管阵列薄膜光电催化降解MB的降解效率可达99.56%.电化学阻抗谱分析显示,光电催化降解过程的速控步骤均为表面反应步骤,外加偏压减小了界面电荷转移阻抗,提高了光生载流子的分离效率.     

芬顿氧化试验中残余双氧水对CODcr测定的影响研究

在采用Fenton高级氧化技术对垃圾压滤液进行处理时,作为氧化剂的双氧水经常不能完全消耗。而使用重铬酸钾法进行CODcr测定时,待测水体中残余的双氧水会表现出还原性而消耗重铬酸钾,对最终CODcr测定结果产生影响。本文分析了在垃圾压滤液中不同浓度双氧水对CODcr测定的影响大小,得出双氧水浓度对CODcr影响曲线,同时为消除双氧水对CODcr测定结果影响,在试验中投加过量硫酸亚铁与双氧水反应,当投加量达到理论反应量的1.0～1.2倍时,对双氧水去除效果最好,使后续的CODcr测定试验更加准确。     

T型氧化沟工艺处理低碳源生活污水的效果研究

详细介绍了T型氧化沟工艺的特征,并考察研究了该工艺处理低碳源生活污水的长期运行效果。研究结果表明,工艺出水COD、BOD5、NH3-N、TN和TP年平均浓度分别为13.9、3.8、0.91、18.80和1.67 mg/L,去除率分别为88.99%、94.37%、96.74%、37.57%和41.58%,均能达到相应的排放标准。由于T型氧化沟中以好氧环境为主,缺乏厌氧和缺氧环境以及进水的BOD5/TN值低,工艺对有机物及NH3-N的去除效果较好,但TN和TP去除效果较低。提出了加强工艺脱氮除磷的措施,为同类型污水处理厂改造提供参考。