高级氧化技术降解环烷酸的研究进展

针对原油及油砂洗脱废水中的环烷酸所具有的酸性、毒性、腐蚀性等特点,介绍了多种降解环烷酸的高级氧化技术,包括Fenton氧化法、臭氧氧化法、光催化氧化法、超临界氧化法、微波辐照法等。评述了高级氧化技术降解环烷酸的最新进展和发现,分析了各种技术的处理效果,并总结了各种技术的优缺点。最后,提出了处理石油行业环烷酸废水的一些思路,为现阶段石油行业环烷酸废水的处理提供了参考。     

Supercritical water oxidation of polyvinyl alcohol and desizing wastewater：Influence of NaOH on the organic decomposition

Polyvinyl alcohol is a refractory compound widely used in industry. Here we report supercritical water oxidation of polyvinyl alcohol solution and desizing wastewater with and without sodium hydroxide addition. However, it is difficult to implement complete degradation of organics even though polyvinyl alcohol can readily crack under supercritical water treatment. Sodium hydroxide had a significant catalytic effect during the supercritical water oxidation of polyvinyl alcohol. It appears that the OH ion participated in the C-C bond cleavage of polyvinyl alcohol molecules, the CO2-capture reaction and the neutralization of intermediate organic acids, promoting the overall reactions moving in the forward direction. Acetaldehyde was a typical intermediate product during reaction. For supercritical water oxidation of desizing wastewater, a high destruction rate (98.25%) based on total organic carbon was achieved. In addition, cases where initial wastewater was alkaline were favorable for supercritical water oxidation treatment, but salt precipitation and blockage issues arising during the process need to be taken into account seriously.     

自组装纳米金修饰玻碳电极检测亚硝酸根

将N-［3-(三甲氧硅基)丙基］-乙二胺与金溶胶通过自组装制备亚硝酸根的电化学传感器.原子力显微镜图(AFM) 显示纳米金自组装在氨基硅烷修饰的玻碳电极表面.由于质子化的氨基硅烷与带负电的亚硝酸根间的相互作用以及纳米金对亚硝酸根具有较好的催化作用,亚硝酸根在该修饰电极上的氧化电位与在玻碳电极上的氧化电位相比负移了140 mV.利用微分脉冲伏安法和微分脉冲安培法研究了亚硝酸根电流响应信号与浓度间的关系.在最优实验条件下,亚硝酸根的氧化峰电流与其浓度在5.0×10^-7～1.0×10^-3 mol·L^-1的浓度范围内呈良好的线性关系, 检测限可达到2.0×10^-7 mol·L^-1(信噪比为3). 用分光光度法及本研究提出的方法对实际样品中亚硝酸根的测定进行了比较,测定结果的差异很小.本研究所提出的测定亚硝酸根的方法具有较高的灵敏度和较好的重现性.     

ZnOOH/O3催化臭氧化体系去除水中痕量对氯硝基苯

以实验室制备的羟基化锌（ZnOOH）为催化剂,考察了其催化臭氧化去除水中痕量对氯硝基苯（ppCNB能力.本实验条件下,蒸馏水中反应20　min时,催化臭氧化比单独臭氧化对pCNB的去除率提高了51 .3个百分点;催化过程遵循自由基反应机理,催化剂表面结合的羟基基团有利于催化反应;pCNB的去除效果随催化剂投量的增加而更佳,催化剂重复使用3次后,催化效果基本没有变化,水中的重碳酸盐以及缓冲溶液中的磷酸盐可以明显降低催化活性,中性条件下,催化作用最佳.     

含硝基苯类化合物废水处理技术研究进展

综述了近年来处理含硝基苯类化合物废水的物理法（包括吸附法和溶剂萃取法）、化学法（包括电化学法、铁碳微电解法、超声波氧化法和臭氧氧化法及复合技术）和生物法的研究进展。指出将现有的处理技术高效整合并降低成本是今后处理含硝基苯类化合物废水的研究方向和重点。     

Reduction and characterization of bioaerosols in a wastewater treatment station via ventilation

Bioaerosols from wastewater treatment processes are a significant subgroup of atmospheric aerosols. In the present study,airborne microorganisms generated from a wastewater treatment station(WWTS) that uses an oxidation ditch process were diminished by ventilation.Conventional sampling and detection methods combined with cloning/sequencing techniques were applied to determine the groups,concentrations,size distributions,and species diversity of airborne microorganisms before and after ventilation. There were 3021 ± 537 CFU/m3 of airborne bacteria and 926 ± 132 CFU/m3 of airborne fungi present in the WWTS bioaerosol.Results showed that the ventilation reduced airborne microorganisms significantly compared to the air in the WWTS. Over 60% of airborne bacteria and airborne fungi could be reduced after4 hr of air exchange. The highest removal(92.1% for airborne bacteria and 89.1% for fungi) was achieved for 0.65–1.1 μm sized particles. The bioaerosol particles over 4.7 μm were also reduced effectively. Large particles tended to be lost by gravitational settling and small particles were generally carried away,which led to the relatively easy reduction of bioaerosol particles0.65–1.1 μm and over 4.7 μm in size. An obvious variation occurred in the structure of the bacterial communities when ventilation was applied to control the airborne microorganisms in enclosed spaces.     

Al2O3催化臭氧化处理邻苯二甲酸二甲酯

'Al₂O₃催化剂对邻苯二甲酸二甲酯(DMP)溶液臭氧化过程的影响结果表明:Al₂O₃可以显著提高臭氧氧化的效果,反应120min后,TOC的去除率从单独臭氧氧化的23.9%提高到55.1%.实验中还考察了制备条件对Al₂O₃催化剂活性的影响并确定了反应的最佳工艺条件.在实验考察的范围内:焙烧温度600℃,Al₂O₃粒径为0.5～1.0mm时催化活性最高;最佳反应工艺条件为:催化剂投加量20g/L,混和气体流速200mL/min,反应温度15℃.通过单独臭氧氧化,单独臭氧氧化后再进行催化剂吸附,催化臭氧化的对比实验证明了Al₂O₃催化剂对体系TOC的去除主要是基于催化作用.     

亚铁活化过硫酸钠氧化预处理电镀废水

针对电镀生产过程产生的难降解、高浓度的有机废水,采用Fe~(2+)活化过硫酸钠产生硫酸根自由基的高级氧化技术对其进行预处理。重点探讨了S_2O_8~(2-)投加量、n(Fe~(2+))∶n(S_2O_8~(2-))、废水pH等因素对有机物去除及废水可生化性的影响。实验结果表明,常温下,在S_2O_8~(2-)投加量为4.0 g/L、n(Fe~(2+))∶n(S_2O_8~(2-))为1.00、废水pH为7.0的条件下,废水的处理效果最佳,反应20 min后COD去除率可达70%,BOD_5/COD从原水的0.21升至0.40,废水的可生化性大幅提高,能够满足深度生化处理的要求。     

利用钢铁盐酸酸洗废液在填料塔中制备FeCl3

以钢铁盐酸酸洗废液为原料,亚硝酸钠为催化剂,氧气为氧化剂,在填料塔中催化氧化制备三氯化铁。考察了反应温度、催化剂加入量和添加方式、循环流量等对制备三氯化铁的影响。实验结果表明,在优化的工艺条件为料液预热温度为60 ℃、催化剂加入量为钢铁盐酸酸洗废液总质量的0.30%、料液循环流量6.0 m³/h的条件下,反应80~120 min,酸洗废液中的Fe²⁺完全氧化为Fe³⁺。     

Al2O3为载体的催化剂净化贫燃汽车尾气研究

在富氧条件下,考察了C₃H₆和C₂H₅OH在Ag/Al₂O₃、In/Al₂O₃、Sn/Al₂O₃、Co/Al₂O₃、Pt/Al₂O₃和Ag/Al₂O₃+Pt/Al₂O₃组合催化剂上选择性还原NO的性能.结果表明,Ag/Al₂O₃具有最高的NO还原活性.在负载型过渡金属氧化物催化剂上,会生成显著量的CO,其HC和CO氧化转化温度也远远高于Pt/Al₂O₃催化剂.串联组合Ag/Al₂O₃+Pt/Al₂O₃催化剂可显著拓宽活性温度范围,促进HC和CO氧化,降低N₂O和CH₃CHO生成量.