Direct methanol fuel cell bubble removal mechanism using magnetic actuation

This article develops a direct methanol fuel cell (DMFC) with a magnet-actuated bubble removal mechanism. A micro-DC motor is used to control the bubble removal mechanism. The lower magnetic device is operated to extrude a Polydimethylsiloxane (PDMS) runner to compress the liquid fuel in the anode flow channel, forcing the CO₂ bubbles in the runner to flow toward the outlet end. The bubble retention in the anode flow channel is thereby improved, enhancing the cell performance. The proposed mechanism stability and performance and Polymethylmethacrylate (PMMA) runner are also discussed.     

快腐剂对畜禽粪便堆肥过程中腐熟度的影响

以牛粪、菌糠和鸡粪等为材料按照两种比例调配为混合基质,在添加或不添加快腐剂的条件下在发酵桶中进行为期38 d的堆肥发酵实验,通过对发酵产物的温度、p H值、总有机碳、C/N、硝铵态氮含量和种子发芽指数等指标变化的研究,揭示了快腐剂对发酵过程的影响。结果表明,虽然快腐剂对有机物料的温度、C/N比无显著的影响,但可以促进铵态氮向硝态氮的转化,在16 d时使发酵产物NH+4-N/NO-3-N比值降为0.15,达到腐熟标准(0.16);提升种子发芽指数,在腐解29 d时使种子发芽指数达到82.76%,达到完全腐熟指标(0.8),比不添加快腐剂的处理提前了4 d左右。快腐剂的作用效果受腐解物料配比的影响。     

生物阴极式碳纸隔膜微生物燃料电池的反硝化和产电性能

为了探讨生物阴极式廉价隔膜微生物燃料电池(microbial fuel cell,MFC)的基本性能,首先以生物反硝化作用为基础构建了生物阴极MFC,并进一步以涂布聚四氟乙烯(PTFE)的廉价碳纸代替昂贵的质子交换膜(PEM)构建碳纸隔膜生物阴极式MFC。研究结果显示,对于生物阴极式MFC,阴极室中最适宜反硝化细菌生长的NO-3-N浓度为99.2 mg/L,此时输出电压最高可达0.11 V,1 h内NO-3-N的去除率达到80.0%,COD去除率为62.8%;以涂PTFE的碳纸代替PEM的生物阴极式MFC与有PEM的MFC最高输出电压基本一致(均达到0.22 V,外阻500Ω),但碳纸隔膜MFC的产电更稳定。结果验证了廉价隔膜生物阴极式MFC的可行性,并为其应用于污水脱氮奠定基础。     

不同酶强化污泥为燃料微生物燃料电池特性对比分析

采用单室无膜悬浮阴极微生物燃料电池(MFC),对比分析了蛋白酶和淀粉酶强化剩余污泥为燃料的MFC(ESMFC)产电特性、酶特性和污泥减量化效果。研究表明,投加蛋白酶的ESMFC最大功率密度比对照组增加106.2%,投加淀粉酶时ESMFC最大功率密度比对照组增加48%。蛋白酶作用主要体现在投加后的前12小时,而淀粉酶作用时间则较长,为投加后的前144小时,但在运行前期,由于高温作用,导致系统内的酶活性较强,投加的淀粉酶作用则不明显。投加蛋白酶的系统内TCOD、TSS和VSS去除率分别为82%、65%和85%,而投加淀粉酶的系统内TCOD、TSS和VSS去除率分别达到86%、67%和88%。此研究对于ESMFC中外加酶的选择具有一定意义。     

Telomere length in workers was effected by omethoate exposure and interaction between smoking and p21 polymorphisms

Abstract

Omethoate is an organophosphorus pesticide that poses a major health hazard, especially DNA damage. The purpose of this study was to investigate the factors affecting telomere length in workers exposed to omethoate by analyzing the interaction between cell cycle gene polymorphism and environmental factors. The exposure group consisted of 118 workers exposed to omethoate for 8–10?years, the control group comprised 115 healthy people without occupational toxicant exposure history. The telomere length of genomic DNA from peripheral blood leucocyte was determined with real-time PCR. Polymerase chain reaction and restriction fragment length polymorphism was used to detect the polymorphisms in p53, p21 and MDM2 gene. The telomere length in the (CA?+?AA) genotypes for p21 rs1801270 polymorphism was longer than that in the CC genotype in control group (P?=?0.015). The generalized linear model analysis indicated the interaction of the p21 rs1801270 polymorphic (CA?+?AA) genotypes and smoking has a significant effect on telomere length (β = ?0.258, P?=?0.085). The prolongation of telomere length in omethoate-exposed workers was associated with genotypes (CA?+?AA) of p21 rs1801270, and interactions of (CA?+?AA) genotypes and smoking factor.     

阴极液及底物浓度对AFB-MFC同步废水处理及产电性能影响

为了提高厌氧流化床微生物燃料电池（AFB-MFC）的性能,并为双室MFC寻找价廉、易得、无污染的阴极液,在曝气量16～24 L/h、温度（35±2）℃、回流量10.2 L/h、阴极底边距阴极室内底部17.3 cm、外电阻250 Ω、水力停留时间（HRT）14.0～14.9 h以及进水pH 7.81～8.37下,研究了阴极液及底物浓度对系统产电及废水处理性能的影响。结果表明,使用缓冲溶液、阳极室出水和自来水作阴极液时,自来水的产电性能最佳,阴极液种类不影响系统有机基质的去除。以自来水为阴极液时,阴极液pH及电导率随运行时间增加而增加,COD去除率为80.11%～89.29%,输出电压及功率密度开始随运行时间增加而增加,之后稳定在440～452 mV和48.40～51.08 mW/m²之间。增加底物浓度对COD去除率影响不大,而输出电压及功率密度随底物浓度增加而下降;底物COD浓度由3 307.09 mg/L增至9 520 mg/L时,COD去除率在85.77%～94.44%之间,输出电压及功率密度则分别由449 mV和50.40 mW/m²下降至406 mV和41.21 mW/m²。自来水作阴极液可避免二次污染及阴极液对阳极室微生物的影响,并得到高的产电能力。     

厌氧折流板式微生物燃料电池堆影响因素研究

微生物燃料电池(MFC)中输出电压/电流的提升,以及反应器体积的扩展放大是其工程化应用的关键。本文构建了一个总体积为6.4 L的新型厌氧折流板式微生物燃料电池堆(ABSMFC)。以葡萄糖作为底物,探讨了阳极材料、液面高程差和水力停留时间(HRT)等因素对ABSMFC性能的影响。结果表明,碳纤维毡作为阳极时,电池单体外电路平均分压(R_(ex)=1 000Ω)为210 mV,填充石墨颗粒后增加到319.8 mV。格室间存在液面高程差时,电池单体、串联和并联的功率密度分别为207.1、181.1和215.7 mW/m~2,当无液面高程差(即水力相连)时为205.8、69.5和151.5 mW/m~2。4个电池单体串联和并联连接时,HRT对ABSMFC的产电稳定性无影响,溶解性COD的去除率和库仑效率均随HRT的增加而升高,且并联效果优于串联。     

厌氧氨氧化ASBR中亚硝氮和氨氮降解规律研究

采用生物膜ASBR反应器,研究了厌氧氨氧化反应过程中亚硝氮与氨氮降解速度的变化规律。结果表明,降解过程主要分为2个阶段:速度上升期(0~30 min)和速度下降期(30~150 min)。一阶指数衰减模型的模拟结果表明,20 min以后亚硝氮、氨氮降解速度逐渐减少,亚硝氮降解速度始终高于氨氮降解速度,但是两者差值随时间逐渐减少。     

Metabolism of the Nonylphenol Isomer [Ring-U-14c]-4-(3′,5′-Dimethyl-3′-Heptyl)-Phenol by Cell Suspension Cultures of Agrostemma githago and Soybean

Abstract

The biotransformation of the nonylphenol isomer [ring-U-¹⁴C]-4-(3′,5′-dimethyl-3′-heptyl)-phenol (4-353-NP, consisting of two diastereomers) was studied in soybean and Agrostemma githago cell suspension cultures. With the A. githago cells, a batch two-liquid-phase system (medium/n-hexadecane 200:1, v/v) was used, in order to produce higher concentrations and amounts of 4-353-NP metabolites for their identification; 4-353-NP was applied via the n-hexadecane phase. Initial concentrations of [¹⁴C]-4-353-NP were 1 mg L^?1 (soybean), and 5 and 10 mg L^?1 (A. githago). After 2 (soybean) and 7 days (A. githago) of incubation, the applied 4-353-NP was transformed almost completely by both plant species to four types of products: glycosides of parent 4-353-NP, glycosides of primary 4-353-NP metabolites, nonextractable residues and unknown, possibly polymeric materials detected in the media. The latter two products emerged especially in soybean cultures. Portions of primary metabolites amounted to 19–22% (soybean) and 21–42% of applied ¹⁴C (A. githago). After liberation from their glycosides, the primary 4-353-NP metabolites formed by A. githago were isolated by HPLC and examined by GC-EIMS as trimethylsilyl derivatives. In the chromatograms, eight peaks were detected which due to their mass spectra, could be traced back to 4-353-NP. Seven of the compounds were side-chain monohydroxylated 4-353-NP metabolites, while the remaining was a (side-chain) carboxylic acid derivative. Unequivocal identification of the sites of hydroxylation/oxidation of all transformation products was not possible. The main primary metabolites produced by A. githago were supposed to be four diastereomers of 6′-hydroxy-4-353-NP (about 80% of all products identified). It was concluded that plants contribute to the environmental degradation of the xenoestrogen nonylphenol; the toxicological properties of side-chain hydroxylated nonylphenols remain to be examined.     

Toxicological characterization of the landfill leachate prior/after chemical and electrochemical treatment: A study on human and plant cells

In this research, toxicological safety of two newly developed methods for the treatment of landfill leachate from the Piškornica (Croatia) sanitary landfill was investigated. Chemical treatment procedure combined chemical precipitation with CaO followed by coagulation with ferric chloride and final adsorption by clinoptilolite. Electrochemical treatment approach included pretreatment with ozone followed by electrooxidation/electrocoagulation and final polishing by microwave irradiation. Cell viability of untreated/treated landfill leachate was examined using fluorescence microscopy. Cytotoxic effect of the original leachate was obtained for both exposure periods (4 and 24 h) while treated samples showed no cytotoxic effect even after prolonged exposure time. The potential DNA damage of the untreated/treated landfill leachate was evaluated by the comet assay and cytokinesis-block micronucleus (CBMN) assay using either human or plant cells. The original leachate exhibited significantly higher comet assay parameters compared to negative control after 24 h exposure. On the contrary, there was no significant difference between negative control and chemically/electrochemically treated leachate for any of the parameters tested. There was also no significant increase in either CBMN assay parameter compared to the negative control following the exposure of the lymphocytes to the chemically or electrochemically treated landfill leachate for both exposure periods while the original sample showed significantly higher number of micronuclei, nucleoplasmic bridges and nuclear buds for both exposure times. Results suggest that both methods are suitable for the treatment of such complex waste effluent due to high removal efficiency of all measured parameters and toxicological safety of the treated effluent.