生活污水对蝌蚪红细胞微核及核异常的诱导

利用青蛙蝌蚪红细胞微核试验,检测了城市生活污水处理厂各级处理工艺出水的诱变活性。在l6d生话污水处理的实验中,青蛙蝌蚪红细胞微核细胞率及核异常率2d后就呈现统计上的显著增加,并随暴露时间的延长而增高,第8天达到最大值。在不同浓度混合污水暴露实验中,蝌蚪红细胞微核细胞率和核异常率呈现明显的剂量依赖性增加。实验结果表明:城镇生活污水具有较强的诱变活性,一级和二级处理工艺出水也具有一定的诱变活性。现有污水处理工艺有待于进一步改进。     

单细胞凝胶电泳技术在环境污染物检测中的应用

主要介绍了单细胞凝胶电泳技术(SCGE),包括SCGE的原理、方法及其在环境污染物检测中的应用,该技术可用多种污染物的检测且灵敏度高,具有广阔的应用前景。即SCGE对大气污染物、重金属、醛类及辐射污染的检测,具有高度敏感性,是具有广阔应用前景的新技术。     

喷射浮选处理含油污水的研究

重点对喷射浮选处理含油污水进行了试验研究，结果表明浮选室内射流泵的没水深度对喷射选除油效果有较大的影响，并且只有在气泡量大并充满浮选室及表面相对平静的状态下，才儿得较好效果，为此，我们在浮选室内加入自制的增料，使兼并的气海重新得到分散，消耗了一部分动能，减缓了浮选室的扰动，使除在大提高，从而为研制新型高效的喷射浮选设备提供了一条新途径。     

Reduction of sera requirements in amniotic fluid cell culture

Reduction in serum requirement for culture of primary human amniotic fluid cells can be achieved by the addition of 10 growth-promoting factors to the nutrient medium. This supplemented medium preserves cell types normally found in amniotic fluid cell cultures supplemented with 20–30 per cent fetal bovine serum. The volume of amniotic fluid required to initiate culture can be as little as 1 ml. Amniotic fluid samples contaminated with red blood cells with no visible clot also grow well in the low serum medium. Cell-free amniotic fluid combined with equal parts of supplemented medium is useful in initiating cell culture.     

The effect of oxygen tension on colony formation and cell proliferation of amniotic fluid cellsin vitro

The effects of reduced oxygen concentrations in the gas phase over the culture medium on colony formation and cell proliferation were investigated in high and low cell density primary and secondary cultures of amniotic fluid cells. Using two standard culture methods (25 cm² plastic flasks and Leighton type tubes) a significantly reduced culture time was observed at high cell density for mass cultures by incubation within a low oxygen tension gas phase (2.5 per cent to 7.5 per cent O₂) instead of conventional air (18 per cent O₂). At low cell density colony formation was significantly enhanced in cultures grown at reduced oxygen tension. Using gas permeable membranes as support, lowering the oxygen tension from 7.5 per cent to 2.5 per cent yielded an increase in plating efficiency of cells from approximately 5 per cent to 25 per cent, whereas plating efficiency was less than 2 per cent for cells grown at ambient 18 per cent O₂. It is suggested that low oxygen tension in the gas phase is an effective means of enhancing clonal growth in amniotic fluid cell cultures, thereby reducing both culture time and risk of culture failure.     

固定化酵母菌对活性艳蓝KN-R的脱色研究

采用海藻酸钙加活性碳的方法对酵母菌进行固定化。正交试验结果表明，三者合适配比为海藻酸钠3％，活性碳10％，氯化钙4％。此方法制得的凝胶颗粒机械强度好、经久耐用。固定化酵母菌凝胶小球最适条件为：培养时间为48h，培养温度为37℃，培养基pH为3．0，凝胶量为10g。固定化细胞经多次脱色后能重复使用，4次脱色后其脱色率还达79．2％。     

TEMPORAL AND GEOMORPHIC VARIATIONS OF STREAM STABILITY AND MORPHOLOGY: MAHOGANY CREEK,NEVADA1

ABSTRACT: Detailed studies of long-term management impacts on rangeland streams are few because of the cost of obtaining detailed data replicated in time. This study uses government agency aquatic habitat, stream morphologic, and ocular stability data to assess land management impacts over four years on three stream reaches of an important rangeland watershed in northwestern Nevada. Aquatic habitat improved as riparian vegetation reestablished itself with decreased and better controlled livestock grazing. However, sediment from livestock disturbances and road crossings and very low stream flows limited the rate of change. Stream type limited the change of pool variables and width/depth ratio, which are linked to gradient and entrenchment. Coarse woody debris removal due to previous management limited pool recovery. Various critical-element ocular stability estimates represented changes with time and differences among reaches very well. Ocular stability variables tracked the quantitative habitat and morphologic variables well enough to recommend that ocular surveys be used to monitor changes with time between more intensive aquatic surveys.     

A Parallel Study of SAR Levels in Head Tissues for Three Antennas Used in Cellular Telephones: Monopole, Helix and Patch

Summary This paper is a comparative study of several antennas commonly used in cellular telephones. These include a monopole, a helix-monopole and a patch antenna. Each one of these structures is modeled and numerically tested using finite-difference time-domain simulation and human models based on magnetic-resonance images, which allow for inclusion of details of the human body in the simulation. The testing procedure involves antenna simulation in the proximity of the human head. The behavior of each antenna is evaluated for variable distances from the head geometry (0, 1, 2, 4, 8 and 16 mm). Continuous waveform, representative of the sources used in mobile telephones, (250 mW, 1.8 GHz) is used as the form of the antenna excitation. The simulation outputs used as measures for this comparative study include transmitting and receiving antenna characteristics and the specific absorption rate (SAR). The SAR levels for the head tissues are calculated for and with accordance to the two currently accepted standards: Federal Communications Commission (FCC) and International Commission on Non-Ionizing Radiation Protection (ICNIRP). The computed SAR levels within each of the considered tissues vary for the three antennas under investigation and are within the determined health safety standards. Results suggest that the patch antenna may be the structure of choice when considering safety standards, as its radiation yields the lowest local SAR in the head tissues.     

Improving the Urban Stream Restoration Effort: Identifying Critical Form and Processes Relationships

Stream restoration projects are often based on morphological form or stream type and, as a result, there needs to be a clear tie established between form and function of the stream. An examination of the literature identifies numerous relationships in naturally forming streams that link morphologic form and stream processes. Urban stream restoration designs often work around infrastructure and incorporate bank stabilization and grade control structures. Because of these imposed constraints and highly altered hydrologic and sediment discharge regimens, the design of urban channel projects is rather unclear. In this paper, we examine the state of the art in relationships between form and processes, the strengths and weaknesses of these existing relationships, and the current lack of understanding in applying these relationships in the urban environment. In particular, we identify relationships that are critical to urban stream restoration projects and provide recommendations for future research into how this information can be used to improve urban stream restoration design. It is also suggested that improving the success of urban restoration projects requires further investigation into incorporating process-based methodologies, which can potentially reduce ambiguity in the design and the necessity of using an abundant amount of in-stream structures.     

Performance evaluation of reverse logistics enterprise – an agent-based simulation approach

Reverse logistics (RL) has been applied in many industries and sectors since its conception. Unlike forward logistics, retracing consumer goods from the point of consumption to the point of inception is not a well-studied process. It involves many uncertainties such as time, quality and quantity of returns. The returned products can be remanufactured, have parts harvested, or be disposed safely. It is important to implement these activities in a cost-effective manner. The aim of this research is to measure the performance of the RL enterprise with the help of an agent-based simulation model. The major entities in the RL network are considered as Agents that can act independently. There are several different agents: collector agent, sorting-cum-reuse agent, remanufacturing agent, recycler agent, supplier agent and distributor agent. The individual performances of the agents are measured and recommendations are given to improve their performance, leading to the enhancement of the total performance of the RL enterprise. The approach is applied to a case study involving cell phone remanufacturing.