重金属Cr(Ⅵ)、Pb及Cu胁迫对双齿围沙蚕体腔细胞的DNA损伤

为探讨重金属Cr(Ⅵ)、Pb以及Cu对沙蚕体腔细胞DNA的毒性效应,以双齿围沙蚕为受试动物,重金属按不同剂量水平,Cr(Ⅵ):10、100和200 mg· L-1,Pb:5、50和100 mg·L-1,Cu:1、10和20 mg· L-1,分别胁迫沙蚕24 h,以不加任何重金属离子的海水为对照,采用单细胞凝胶电泳技术,检测其体腔细胞DNA损伤程度.结果表明,与空白对照组相比,3种重金属离子的各浓度组都能引起沙蚕体腔细胞DNA损伤,且3种重金属胁迫浓度与细胞DNA损伤程度之间存在显著的剂量-效应关系.双齿围沙蚕可以作为单细胞凝胶电泳的实验材料用于重金属所致环境污染的生物监测指示生物.     

The impact of pesticides on oxidative stress level in human organism and their activity as an endocrine disruptor

Pesticides cause serious environmental and health problems both to humans and animals. The aim of this review is to discuss selected herbicides and fungicides regarding their mode of action and their influence on basic oxidative stress parameters and endocrine disruption properties tested in selected cell cultures in vitro. Because of numerous difficulties which animal studies are subject to, cell cultures are an excellent experimental model reflecting human exposure to different pesticides through all relevant routes. This experimental model can be used to monitor aggregate and cumulative pesticide exposures.     

Improving photostability and efficiency of polymeric luminescent solar concentrators by PMMA/MgO nanohybrid coatings

MgO nanocrystals were synthesized and doped with different concentrations in poly(methylmethacrylate) (PMMA) to prepare hybrid organic-inorganic coatings based on polymer nanohybrid thin films. The nanoparticles were found to be spherical with 62 nm diameter as determined by X-ray diffraction (XRD) and atomic force microscope (AFM). The coatings were characterized by spectroscopic tools such as optical absorption, transmission and fluorescence spectroscopy. The prepared nanohybrid films were spin-coated on cost-effective luminescent PMMA substrates doped with highly efficient luminescent dyes luminescent solar concentrators (LSCs). The outdoor photostability tests demonstrated enhanced protection against UVA radiation for coated LSCs compared to bare LSC substrates. The current–voltage characteristics of commercially produced LSC prototypes showed that the poor UV response of monocrystalline silicon solar cell can be improved by for LSCs coated by PMMA/MgO nanohybrid films which act as luminescent down shifting layer (LDSL).     

Investigation of titanium liquid/gas diffusion layers in proton exchange membrane electrolyzer cells

In a proton exchange membrane electrolyzer cell (PEMEC), liquid/gas diffusion layer (LGDL) is expected to transport electrons, heat, and reactants/products to and from the catalyst layer with minimum voltage, current, thermal, interfacial, and fluidic losses. In addition, carbon materials, which are typically used in PEM fuel cells (PEMFCs), are unsuitable in PEMECs due to the high ohmic potential and highly oxidative environment of the oxygen electrode. In this study, a set of titanium gas diffusion layers with different thicknesses and porosities are designed and examined coupled with the development of a robust titanium bipolar plate. It has been found that the performance of electrolyzer improves along with a decrease in thickness or porosity of the anode LGDL of titanium woven meshes. The ohmic resistance of anode LGDL and contact resistance between anode LGDL and the anode catalyst play dominant roles in electrolyzer performance, and better performance can be obtained by reducing ohmic resistance. Thin titanium LGDLs with straight-through pores and optimal pore morphologies are recommended for the future developments of low-cost LGDLs with minimum ohmic/transport losses.     

Direct methanol fuel cell bubble removal mechanism using magnetic actuation

This article develops a direct methanol fuel cell (DMFC) with a magnet-actuated bubble removal mechanism. A micro-DC motor is used to control the bubble removal mechanism. The lower magnetic device is operated to extrude a Polydimethylsiloxane (PDMS) runner to compress the liquid fuel in the anode flow channel, forcing the CO₂ bubbles in the runner to flow toward the outlet end. The bubble retention in the anode flow channel is thereby improved, enhancing the cell performance. The proposed mechanism stability and performance and Polymethylmethacrylate (PMMA) runner are also discussed.     

生物阴极式碳纸隔膜微生物燃料电池的反硝化和产电性能

为了探讨生物阴极式廉价隔膜微生物燃料电池(microbial fuel cell,MFC)的基本性能,首先以生物反硝化作用为基础构建了生物阴极MFC,并进一步以涂布聚四氟乙烯(PTFE)的廉价碳纸代替昂贵的质子交换膜(PEM)构建碳纸隔膜生物阴极式MFC。研究结果显示,对于生物阴极式MFC,阴极室中最适宜反硝化细菌生长的NO-3-N浓度为99.2 mg/L,此时输出电压最高可达0.11 V,1 h内NO-3-N的去除率达到80.0%,COD去除率为62.8%;以涂PTFE的碳纸代替PEM的生物阴极式MFC与有PEM的MFC最高输出电压基本一致(均达到0.22 V,外阻500Ω),但碳纸隔膜MFC的产电更稳定。结果验证了廉价隔膜生物阴极式MFC的可行性,并为其应用于污水脱氮奠定基础。     

Telomere length in workers was effected by omethoate exposure and interaction between smoking and p21 polymorphisms

Abstract

Omethoate is an organophosphorus pesticide that poses a major health hazard, especially DNA damage. The purpose of this study was to investigate the factors affecting telomere length in workers exposed to omethoate by analyzing the interaction between cell cycle gene polymorphism and environmental factors. The exposure group consisted of 118 workers exposed to omethoate for 8–10?years, the control group comprised 115 healthy people without occupational toxicant exposure history. The telomere length of genomic DNA from peripheral blood leucocyte was determined with real-time PCR. Polymerase chain reaction and restriction fragment length polymorphism was used to detect the polymorphisms in p53, p21 and MDM2 gene. The telomere length in the (CA?+?AA) genotypes for p21 rs1801270 polymorphism was longer than that in the CC genotype in control group (P?=?0.015). The generalized linear model analysis indicated the interaction of the p21 rs1801270 polymorphic (CA?+?AA) genotypes and smoking has a significant effect on telomere length (β = ?0.258, P?=?0.085). The prolongation of telomere length in omethoate-exposed workers was associated with genotypes (CA?+?AA) of p21 rs1801270, and interactions of (CA?+?AA) genotypes and smoking factor.     

阴极液及底物浓度对AFB-MFC同步废水处理及产电性能影响

为了提高厌氧流化床微生物燃料电池（AFB-MFC）的性能,并为双室MFC寻找价廉、易得、无污染的阴极液,在曝气量16～24 L/h、温度（35±2）℃、回流量10.2 L/h、阴极底边距阴极室内底部17.3 cm、外电阻250 Ω、水力停留时间（HRT）14.0～14.9 h以及进水pH 7.81～8.37下,研究了阴极液及底物浓度对系统产电及废水处理性能的影响。结果表明,使用缓冲溶液、阳极室出水和自来水作阴极液时,自来水的产电性能最佳,阴极液种类不影响系统有机基质的去除。以自来水为阴极液时,阴极液pH及电导率随运行时间增加而增加,COD去除率为80.11%～89.29%,输出电压及功率密度开始随运行时间增加而增加,之后稳定在440～452 mV和48.40～51.08 mW/m²之间。增加底物浓度对COD去除率影响不大,而输出电压及功率密度随底物浓度增加而下降;底物COD浓度由3 307.09 mg/L增至9 520 mg/L时,COD去除率在85.77%～94.44%之间,输出电压及功率密度则分别由449 mV和50.40 mW/m²下降至406 mV和41.21 mW/m²。自来水作阴极液可避免二次污染及阴极液对阳极室微生物的影响,并得到高的产电能力。     

河北省祖山风景区崩塌灾害特征与防治对策研究

以祖山为例,阐述了崩塌地质灾害的机理、特征和现状,并利用传递系数法对崩塌稳定性进行了计算和评价,采用削方卸载、修建抗崩塌挡土墙、构筑排水沟与格构等工程设施的防治对策及工程措施,取得了预期的效果。     

厌氧折流板式微生物燃料电池堆影响因素研究

微生物燃料电池(MFC)中输出电压/电流的提升,以及反应器体积的扩展放大是其工程化应用的关键。本文构建了一个总体积为6.4 L的新型厌氧折流板式微生物燃料电池堆(ABSMFC)。以葡萄糖作为底物,探讨了阳极材料、液面高程差和水力停留时间(HRT)等因素对ABSMFC性能的影响。结果表明,碳纤维毡作为阳极时,电池单体外电路平均分压(R_(ex)=1 000Ω)为210 mV,填充石墨颗粒后增加到319.8 mV。格室间存在液面高程差时,电池单体、串联和并联的功率密度分别为207.1、181.1和215.7 mW/m~2,当无液面高程差(即水力相连)时为205.8、69.5和151.5 mW/m~2。4个电池单体串联和并联连接时,HRT对ABSMFC的产电稳定性无影响,溶解性COD的去除率和库仑效率均随HRT的增加而升高,且并联效果优于串联。