拜耳法赤泥粒径分级预处理的研究

赤泥是从铝土矿中提取氧化铝的过程中产生的工业废渣.分析了拜耳法赤泥的粒径分布,以及主要化学组成和矿物组成在不同粒径赤泥中的变化规律.在此基础上,提出先将赤泥粒径分级预处理,然后根据粗细粒径赤泥的差异分别进行回收利用的思路.研究结果表明,赤泥中粒径大于0.075 mm的粗颗粒以铁、硅、钙为主,实践证明可以通过磁选或重选工...     

高压脉冲放电等离子体处理活性红X-3B染料废水

采用高压脉冲放电等离子体技术对活性红X-3B染料废水进行处理,考察了废水电导率、脉冲电压、脉冲频率、针板间距以及曝气量对处理效果的影响。实验结果表明,当废水电导率为200μS/cm、脉冲电压为34kV、脉冲频率为60Hz、针板间距为15mm、曝气量为12L/h、处理时间为60m in时,活性红X-3B染料废水脱色率能达到98.6%。     

防风抑尘网设计要点及参数的确定

介绍了堆场起尘、防风抑尘网抑尘的机理和国内外防风抑尘网研究结果,结合实际工程设计的经验,分析了防风抑尘网设计要点和主要参数,提出防风抑尘网设计的意见和建议。     

赤泥制备含钛聚硅酸铝铁及亚甲基蓝溶液的混凝脱色

以拜耳法赤泥为原料、Na Cl为助溶剂,采用酸浸法溶出赤泥中的铁、铝元素,再与硅酸钠、硫酸氧钛反应制备出高效混凝剂含钛聚硅酸铝铁(T-PSAF),并将其用于模拟亚甲基蓝印染废水的脱色。实验结果表明:在硫酸浓度为8 mol/L、液固比(硫酸体积与干赤泥质量之比)为14 m L/g、酸浸温度为80℃、酸浸时间为80 min、Na Cl加入量为0.10 g/g(以干赤泥计)的优化酸浸条件下,铁、铝的浸出率分别为88.25%和73.21%;在n(Fe+Al)∶n(Ti)∶n(Si)=0.3∶0.3∶1、熟化p H为4~5、熟化时间为2 h、混凝剂加入量为25 m L/L的优化混凝条件下,初始亚甲基蓝质量浓度为10 mg/L的废水的脱色率可达87.1%,而当初始亚甲基蓝质量浓度增至150~200 mg/L时废水脱色率可达99%以上。     

Preparation and performance of arsenate (V) adsorbents derived from concrete wastes

Solid adsorbent materials, prepared from waste cement powder and concrete sludge were assessed for removal of arsenic in the form of arsenic (As(V)) from water. All the materials exhibited arsenic removal capacity when added to distilled water containing 10–700 mg/L arsenic. The arsenic removal isotherms were expressed by the Langmuir type equations, and the highest removal capacity was observed for the adsorbent prepared from concrete sludge with heat treatment at 105 °C, the maximum removal capacity being 175 mg-As(V)/g. Based on changes in arsenic and calcium ion concentrations, and solution pH, the removal mechanism for arsenic was considered to involve the precipitation of calcium arsenate, Ca₃(AsO₄)₂. The enhanced removal of arsenic for the adsorbent prepared from concrete sludge with heat treatment was thought to reflect ion exchange by ettringite. The prepared adsorbents, derived from waste cement and concrete using simple procedures, may offer a cost effective approach for arsenic removal and clean-up of contaminated waters, especially in developing countries.     

Experimental evaluation of emission factors of cement kilns burning hazardous wastes

Cement industry is an interesting way to eliminate combustible wastes. Thermal valorization is maximal, conditions of combustion are especially favorable to the destruction and the trapping of pollutants, and there are neither ultimate residues (slag) nor aqueous rejects. Moreover the properties of the cement are not modified. Nevertheless the increased use of substitution fuel may lead to deal with unusual amounts of heavy metals. Tests were realized on several rotary cement kilns with varying substitution ratios of fossil fuels by wastes. Mass balances were fitted over the whole plant, and emission factors were explained.     

A comparative assessment of waste incinerators in the UK

The uptake in Europe of Energy from Waste (EfW) incinerator plants has increased rapidly in recent years. In the UK, 25 municipal waste incinerators with energy recovery are now in operation; however, their waste supply chains and business practices vary significantly. With over a hundred more plant developments being considered it is important to establish best business practices for ensuring efficient environmental and operational performance. By reviewing the 25 plants we identify four suitable case study plants to compare technologies (moving grate, fluidised bed and rotary kiln), plant economics and operations. Using data collected from annual reports and through interviews and site visits we provide recommendations for improving the supply chain for waste incinerators and highlight the current issues and challenges faced by the industry. We find that plants using moving grate have a high availability of 87–92%. However, compared to the fluidised bed and rotary kiln, quantities of bottom ash and emissions of hydrogen chloride and carbon monoxide are high. The uptake of integrated recycling practices, combined heat and power, and post incineration non-ferrous metal collections needs to be increased among EfW incinerators in the UK. We conclude that one of the major difficulties encountered by waste facilities is the appropriate selection of technology, capacity, site, waste suppliers and heat consumers. This study will be of particular value to EfW plant developers, government authorities and researchers working within the sector of waste management.     

废弃钻井泥浆的固化处理

废弃钻井泥浆的处理是油气勘探与开发工业中人们极为关注的。文章在分析废弃钻井泥浆性质的基础上，通过化学稳定与固化处理试验研究得出以水泥为主，烟炭，石灰等为添加剂的固化剂配方，实验结果表明，经固化处理的废弃泥浆，其固化产物重金属浸出率低，稳定性好，具有一定的抗氧强度，从而能有效地降低废弃泥浆对环境的污染危害，文中还对各种辅加剂对固化效果的影响进行了分析。     

炼厂隔油后污水的有机构成及混凝处理

采用GC/MS技术分析了炼厂隔油后污水的有机组成,并研究了不同混凝剂处理污水的效果,以及对有机构成的影响。结果表明,隔油后污水中的有机物质主要是C6–C8,其中酚类物质的含量最高;PAM和PAC混凝处理隔油后污水,可使污水中的有机物质总浓度及各物质的相对比例均发生变化,PAM降低烃类物质的效果好于PAC,而后者降低酚类物质的效果好于前者;在PAC处理污水时,同时投加少量活性炭可有效改变PAC脱除COD的性能。     

氧化铝赤泥堆场渗滤液污染的评价与防治

提出了氧化铝生产赤泥堆场的环境影响评价构架及生产阶段尽量减少下渗量的措施，有效地保护堆场区域地下水水环境。