纤维增强气凝胶复合材料高温结构转变及热稳定性研究

目的研究高温受热条件下纳米复合隔热材料的结构转变特征及热稳定性。方法采用扫描电镜、X射线衍射仪、红外光谱仪及热重仪等检测方法。结果纤维增强气凝胶材料从室温到650℃存在连续的质量损失,从室温到放热前,质量损失为1.66%;365℃开始出现放热,温度升至398℃时达到峰值,整个放热过程对应质量损失约为1.3%;从435℃放热结束开始到650℃的质量损失为1.46%。经过400℃热处理后,试样比表面积从268m~2/g增加到437m~2/g;当试样热处理温度达到600℃时,试样的比表面积明显随之降低至198m~2/g。结论 SiO_2气凝胶复合材料以无定形结构为主,存在少量的二氧化钛晶体。在400℃左右,SiO_2气凝胶结构中硅甲基Si—CH_3发生氧化,产生明显的放热峰,之后硅羟基Si—OH之间发生缩聚反应,使600℃热处理后气凝胶中Si—O—Si网络骨架强度有所提高。未处理的纤维增强气凝胶材料试样上气凝胶纳米颗粒构成的块体较为良好地包裹在玻璃纤维表面,而经过600℃的高温热处理1 h后,块体气凝胶脱离了光滑的纤维表面,气凝胶纳米粒子发生收缩,致使材料比表面积下降。     

油气田在役管道高后果区识别与完整性评价方法

根据油气管道建设与管理的相关标准与规范或导则,针对目前油气田在役管道,明确了其高后果区识别的划分及其在不同标准中的差异以及识别的原则和时间间隔,分别介绍了在管道的相关数据采集的基础上开展地质灾害和第三方破坏造成的管道风险评价方法,管道内外腐蚀的直接评价以及包括剩余强度、剩余寿命和材料在内的管道适用性评价方法,同时给出了这些评价工作所涉及到的相关内容项,对油田管道的完整性管理具有重要的指导作用和应用价值。     

大气自净能力指数的气候特征与应用研究

为了定量地评估污染气象条件对空气污染的作用并实现对空气污染潜势的预报,本文在城市大气污染数值预报系统（CAPPS）预报原理的基础上,定义了大气自净能力指数,并分别给出了采用气象站观测资料和通过数值模拟计算大气自净能力指数的方法.基于气象站观测资料的全国大气自净能力指数分析计算表明,全国大气自净能力最差的地区分布在四川盆地和新疆塔里木盆地,大气自净能力最强的地区分布在青藏高原、蒙古高原、云贵高原、以及东北平原和三江平原、山东半岛和海南岛;1961~2017年,京津冀、长三角和珠三角地区的大气自净能力指数呈下降的变化趋势,全年低自净能力日数呈上升的变化趋势.采用大气自净能力指数评估2014年北京APEC会议期间大气污染防控效果,表明在11月8~10日极端不利扩散气象条件发生时,减排措施使北京市空气质量AQI平均降低77%,使京津冀平原地区11个城市的空气质量AQI平均降低37%.基于国家气候中心月动力延伸气候预测模式（DERF2.0）的预报产品和中尺度模式（WRF）,建立了可以预测全国未来40d逐日大气自净能力指数的延伸期-月尺度大气污染潜势预测系统,回报实验表明,在大多数情况下可以提前15d预报出大气重污染过程;月尺度的大气重污染过程预报效果更大程度上取决于月动力延伸气候预测模式（DERF2.0）的预报准确率.     

京津冀及周边地区水泥工业大气污染控制分析

以京津冀及周边地区水泥工业为研究对象,基于产排污系数法,建立了水泥工业主要大气污染物排放计算方法,对2016年该地区水泥工业主要大气污染物排放控制水平进行了分析.结果表明：京津冀及周边地区2016年水泥工业SO₂、NO_x、PM（有组织）排放量分别达到3.2×10⁴t、23.9×10⁴t、9.7×10⁴t,较2015年分别减少24.1%、18.2%、27.2%,各项污染物大幅下降.水泥工业PM无组织排放量占PM总排放量的45.4%,仍需要采取集中收集的方式加强治理.山东、河南是水泥工业SO₂、NO_x、PM、PM₁₀、PM_2.5重点排放来源,应通过化解过剩产能降低污染排放.从各工艺来看,新型干法工艺应考虑采用高效脱氮脱硫技术、协同处置技术、高效大型袋式除尘技术等新技术,进一步降低各项污染物的排放量;粉磨站也需进一步提高污染治理水平.     

Relationship between PM10 and PM2.5 levels in high-traffic area determined using path analysis and linear regression

The objective of this study was to determine the relationship between PM_(10) and PM_(2.5) levels as related to meteorological conditions and traffic flow using both a linear regression analysis and a path analysis. The Particulate matter(PM) samples were collected from Sukhumvit road, Bangkok, Thailand, at both open(104 samples) and covered(92 samples)areas along the road. Fifteen percent of all samples were separated before the statistical models were run and used for model validation. The results from the path analysis were more elaborate than those from the linear regression, thus indicating that meteorological conditions had a direct effect on the particulate levels and that the effects of traffic flow were more variable in open areas. The model also indicated that meteorological conditions had an indirect effect and that traffic flow had a direct effect on particulate levels in covered areas. The model validation results indicated that for open areas, the R~2 values were not very different between the path analysis and the linear regression model, but that the path analysis was more accurate than the linear regression model at very low PM concentrations. At high PM concentrations, the path analysis model also had a better fit than did the linear regression, so the predictions from the path analysis model were more accurate than those from the linear regression.     

空间站控制力矩陀螺微振动测试技术

目的分析控制力矩陀螺的微振动扰动特性。方法通过获取陀螺连接点对结构的扰振力输出、关键部位的微振动响应来获取产品的微振动扰动特性,通过隔振的方式对外部环境的干扰进行隔离,进而降低测试的背景噪声,通过运用高精度测试传感器来实现微小扰动力信号、加速度信号的测量,利用结构有限元法及单点激励多点响应的模态分析方法校核系统刚度,进而确定测试频率范围是否满足需求。结果可同时获得空间站控制力矩陀螺连接点处的输出扰振力、质心处的输出扰振力合力、合力矩以及关键部位的微振动响应,可有效隔离外部干扰,扰振力背景噪声的时域信号最大值可控制在0.07 N以内,RMS值在0.02 N以内,加速度信号的时域背景噪声最大值可控制在1.5 mg以内,RMS值在0.1 mg以内。可识别微小扰振信号,加速度传感器分辨率为5×10-5 grms,力传感器的测量分辨率为1×10-2 N,力矩测量分辨率小于1×10-2 N·m。测试频带在320 Hz以内。结论满足型号需求,并投入型号使用。     

典型铅锌矿化区不同土地利用类型土壤重金属污染特征与评价

选取云南者海典型铅锌矿区周边冶炼区（A）、粮食主产区（B）、保护区（C）三个区域土壤为研究对象,分析三个区域内林地（LD）和耕地（GD）土壤pH、总碳（TC）、总氮（TN）、总磷（TP）和5种重金属（Hg、Cd、Pb、Zn、Cu）含量,利用典范对应分析（CCA）研究不同土地利用类型下它们之间的关系,基于系统熵值与重金属生物毒性改进灰色聚类评价法对研究区重金属污染程度进行评价。结果表明,A、B、C三区土壤的5种重金属均超过云南省土壤背景值,且含量A区 > B区 > C区,所有土壤样品Hg、Cd、Pb、Zn、Cu平均含量分别为7.24、1.53、1 794、2 892、210 mg/kg;LD土壤重金属含量普遍高于GD。研究区土壤pH总体呈弱酸性,但A区土壤受矿业活动影响呈弱碱性。TC、TN含量和C/N值均表现出LD大于GD,但TP含量表现为GD显著大于LD （P<0.05）。CCA分析表明LD和GD土壤pH与Cd和Cu呈负相关,与Zn和Pb呈正相关,且pH对重金属含量的影响最大;TC、TP与重金属Cd和Cu在LD土壤中呈正相关,在GD土壤中呈负相关。改进灰色聚类评价结果表明重金属污染程度均表现为LD大于GD;A区污染最严重且均呈重度污染,B区次之,C区污染程度最轻。经比较本文改进的灰色聚类评价法在准确性和灵敏度方面优于传统方法。     

用EXCEL进行精密度-偏性分析质控数据处理

利用EXCEL强大的数据处理功能，可以方便地对精密度—偏性分析质控数据进行处理，具有较高的推广价值。     

Assessing protected area effectiveness using surrounding (buffer) areas environmentally similar to the target area

Many studies are based on the assumption that an area and its surrounding (buffer) area present similar environmental conditions and can be compared. For example, in order to assess the effectiveness of a protected area, the land use/cover changes are compared inside the park with its surroundings. However, the heterogeneity in spatial variables can bias this assessment: we have shown that most of the protected areas in Mexico present significant environmental differences between their interior and their surroundings. Therefore, a comparison that aims at assessing the effectiveness of conservation strategies, must be cautioned. In this paper, a simple method which allows the generation of a buffer area that presents similar conditions with respect to a set of environmental variables is presented. The method was used in order to assess the effectiveness of the Calakmul Biosphere Reserve, a protected area located in the south-eastern part of Mexico. The annual rate of deforestation inside the protected area, the standard buffer area (based upon distance from the protected area only) and the similar buffer area (taking into account distance along with some environmental variables) were 0.3, 1.3 and 0.6%, respectively. These results showed that the protected area was effective in preventing land clearing, but that the comparison with the standard buffer area gave an over-optimistic vision of its effectiveness.     

乌鲁木齐市汽车尾气排污现状及防治对策探讨

对乌鲁木齐市在用车辆进行了路抽检调查，通过大量数据分析，得出乌鲁木齐市目前汽车尾气排放情况仍令人担忧，治理工作不容忽视。