聚合铝混凝过程研究:不同形态硅酸的影响作用

研究了不同形态硅酸对聚合铝混凝过程的影响作用 .实验结果表明经预制形成的具有不同形态分布组成的硅酸与聚合铝 ,在投加后相互间发生了十分复杂的物理化学作用 ,并受溶液pH值的影响 ,从而最终决定了混凝效果 .反应过程中所生成的形态产物及其物化特征 ,很大程度上取决于聚合铝碱化度以及所投加的Si Al比 .其中碱化度越高 ,最终产物所带电荷越高 .而不同硅酸所起影响作用分别取决于聚合程度 ,在与聚合铝反应过程中表现出一定的规律性 .单体硅酸与单体铝迅速发生较强的络合作用 ,抑制了多聚水解铝阳离子的形成 .聚合硅酸则倾向于与聚合铝形态相互作用形成一定的胶状化合物 ,从而在溶液中稳定存在 .对于胶体硅酸 ,在聚合铝作用下迅速凝聚形成更大的聚集体 ,在颗粒物间架桥形成粗大的絮体 .所得结果对混凝机理的解释与复合混凝剂的发展提供了一定的参考作用     

碳氮结构空心管材料及其对钍离子的吸附性能研究

目的合成碳氮结构空心管材料,用于稀土矿山开采中放射性钍离子的吸附去除,方法通过三聚氰胺和三聚氰酸超分子自组装,经水热碳化及高温热解,制备碳氮结构空心管材料.采用SEM、XRD等对材料进行表征.在不同热解温度和pH值下进行钍离子吸附实验,比较不同钍离子的初始浓度和吸附时间下吸附容量的差异.结果600℃时,材料形貌为均匀的中空管状结构;pH=3.5,热解温度为800℃时,材料最大吸附容量达到133.87 mg/g,吸附过程符合Langmuir等温吸附模型且遵从准二级动力学规律.结论碳氮结构空心管材料对钍离子具有良好的吸附效果,有望用于稀土开采过程中产生的放射性废钍离子的去除.     

离子选择电极法与离子色谱法测量低浓度氟化物比较

用离子选择电极法、离子色谱法两种方法对氟化物国家标准样品进行测量,通过比较发现两种方法测量国家标样低浓度样品时有显著差异.     

气单胞菌SH10吸附银离子机制的研究

以气单胞菌SH10为生物吸附材料,从静电吸附作用、离子交换作用、络合作用、沉淀作用几方面研究了SH10吸附Ag 过程可能存在的作用机制.结果表明,气单胞菌SH10吸附银离子依赖于静电吸附作用;吸附Ag 前后溶液中Na 、K 、Mg2 浓度的变化较小,说明吸附过程中离子交换不明显;SH10表面的羧基、氨基和脂类基团经化学屏蔽后,对Ag 的吸附量明显下降,结合红外光谱分析结果,确定酰胺基CO-NH为SH10与银离子发生络合作用的主要官能团;电镜扫描结果表明,SH10在吸附过程中可以和Ag 形成沉淀沉积在细胞表面.     

岳麓山空气负离子及空气质量变化研究

采用空气离子测量仪,于2003年10月～2004年9月对岳麓山及其周围地区的空气正、负离子浓度进行了测量,并用相应的方法对其空气质量作了评价.结果表明,岳麓山正、负离子之比的单极系数q值较小,空气离子评价系数CI值均大于0.7,空气质量良好;空气负离子浓度的垂直变化明显,山体中部明显高于山顶和山麓地带,且非核心景区高于核心景区;空气负离子浓度和空气质量1月最低,9月最高,夏、秋两季相当,春季好于冬季;空气负离子浓度的日变化规律(6:00～19:00)为清晨和中午低,上午和傍晚高,一天中存在2个峰值;下雨后空气负离子浓度和空气质量要好于下雨前,两者差异显著.而晴天空气负离子和空气质量要略好于阴天,但两者差别不明显;不同功能区空气负离子浓度和空气质量差异显著,其大小依次为:风景区＞大公园＞小公园＞商业区＞一般交通线＞交通干线＞汽车站.     

Simulated and experimental evaluation of factors affecting the rate and extent of reductive dehalogenation of chloroethenes with glucose

Carbohydrates such as molasses are being added to aquifers to serve as electron donors for reductive dehalogenation of chloroethenes. Glucose, as a model carbohydrate, was studied to better understand the processes involved and to evaluate the effectiveness for dehalogenation of different approaches for carbohydrate addition. A simulation model was developed and calibrated with experimental data for the reductive dehalogenation of tetrachloroethene to ethene via cis-1,2-dichloroethene. The model included fermentors that convert the primary donor (glucose) into butyrate, acetate and hydrogen, methanogens, and two separate dehalogenator groups. The dehalogenation groups use the hydrogen intermediate as an electron donor and the different haloethenes as electron acceptors through competitive inhibition. Model simulations suggest first that the initial relative population size of dehalogenators and H(2)-utilizing methanogens greatly affects the degree of dehalogenation achieved. Second, the growth and decay of biomass from soluble carbohydrate plays a significant role in reductive dehalogenation. Finally, the carbohydrate delivery strategies used (periodic versus batch addition and the time interval between periodic addition) greatly affect the degree of dehalogenation that can be obtained with a given amount of added carbohydrate.     

钛白副产硫酸亚铁的综合利用研究

以钛白副产硫酸亚铁、氯化钾和氨水为原料，采用硫酸钾铵法制取硫酸钾。实验结果表明，该工艺生产的产品，其质量达到ZBG-21006-89国家标准，且此工艺流程简单、操作方便、条件易控制，无二次污染。     

等度洗脱快速分离SO4^2-、PO4^3-的新方法和

多聚磷酸盐在分离柱上保留能力强，不易洗脱，因此采用离子色谱分析测定多聚磷酸盐时大多采用梯度淋洗的方法，实现多聚磷酸盐、硫酸盐的分离。具体方法为采用美国戴安ICS-1000型离子色谱仪，METROSEP A Supp 5 100型分离柱，36mmol LiOH＋2％乙腈的淋洗液等度淋洗；进样20μL，流速0．7mL／min，8min内实现SO4^2-：PO4^3-和P2O7^4-的完全分离，保留时间分别为3．9，4．9和6．4min；检出限分别为4、11和17ng／L；加标回收率分别为96．88％，96．41％和98．48％。     

Chlorination of dibenzofuran and dibenzo-p-dioxin vapor by copper (II) chloride

Dibenzofuran (DF) is formed from phenol and benzene in combustion gas exhaust streams prior to particle collection equipment. Subsequent chlorination at lower temperatures on particle surfaces is a potential source of chlorinated dibenzofuran (CDF). Gas streams containing 8% O₂ and approximately 0.1% DF vapor were passed through particle beds containing copper (II) chloride (0.5% Cu, mass) at temperatures ranging from 200 to 400 °C to investigate the potential for CDF formation during particle collection. Experiment duration was sufficient to provide an excess amount of DF (DF/Cu=3). The efficiency of DF chlorination by CuCl₂ and the distribution of CDF products were measured, with effects of temperature, gas velocity, and experiment duration assessed. Results of a more limited investigation of dibenzo-p-dioxin (DD) chlorination by CuCl₂ to form chlorinated DD (CDD) products are also presented.

The efficiency of DF/DD chlorination by CuCl₂ was high, both in terms of CuCl₂ utilization and DF/DD conversion. Total yields of Cl on CDF/CDD products of up to 0.5 mole Cl per mole CuCl₂ were observed between 200 and 300 °C; this suggests that nearly 100% CuCl₂ was utilized, assuming a conversion of two moles of CuCl₂ to CuCl per mole Cl added to DD/DF. In a short duration experiment (DF/Cu=0.3), nearly 100% DF adsorption and conversion to CDF was achieved. The degree of CDF chlorination was strongly dependent on gas velocity. At high gas velocity, corresponding to a gas–particle contact time of 0.3 s, mono-CDF (MCDF) yield was largest, with yields decreasing with increasing CDF chlorination. At low gas velocity, corresponding to a gas–particle contact time of 5 s, octa-CDF yield was largest. DF/DD chlorination was strongly favored at lateral sites, with the predominant CDF/CDD isomers within each homologue group those containing Cl substituents at only the 2,3,7,8 positions. At the higher temperatures and lower gas velocities studied, however, broader isomer distributions, particularly of the less CDD/CDF products, were observed, likely due to preferential destruction of the 2,3,7,8 congeners.     

高铁铝矾土制备聚合氯化铝铁及其在污水处理中的应用研究

利用含铁的低品位铝矾土为主要原料,添加适量铝酸钙粉,制备出絮凝剂聚合氯化铝铁.制备方法为酸溶两步法.对影响聚合铝铁制备的因素,如盐酸浓度、盐酸用量、温度和铝酸钙粉用量等进行了系统研究,得到了制备聚合铝铁的优化条件,同时将该絮凝剂用于实际工业污水的处理.研究结果表明：制备的絮凝剂絮凝效果明显优于一些传统的絮凝剂;不仅具有去浊性能好、沉降快的优点,而且具有原料易得,制备成本低的优势.