气体二氧化氯对葡萄表面细菌杀菌规律研究

研究气体二氧化氯杀灭金黄色葡萄球菌、大肠杆菌、李斯特单增菌和腐生酵母菌4种葡萄表面的危险致病菌的杀菌规律。在实验范围内,随着气体二氧化氯浓度的增加和杀菌时间的延长,杀菌效果明显增加。当杀菌时间超过12min,杀菌量级几乎不再增加。杀菌效率随温度的增加而减小,在实验温度条件下,只有大肠杆菌的杀菌效果减少了5.38～6.09log量级,其他3种菌均减少了6log量级以上,杀菌作用温度在实验条件下对杀菌效果影响不大。研究表明,当气体二氧化氯的杀菌浓度为25mgl-1、杀菌时间12min、杀菌温度25℃的条件下,金黄色葡萄球菌、李斯特单增菌和腐生酵母菌均减少了6.4log量级以上,而大肠杆菌达到5.76log量级;同时表明二氧化氯气体的杀菌保鲜功能也是食品安全技术非热杀菌手段。     

二氧化氯对有机染料脱色效果的研究

本文对二氧化氯二两种直接染料和两种活性染料脱色效果的影响因素－ClO2的投加量、染料的初始浓度、pH值、温度以及反应时间等进行了研究。结果表明,在适当的条件下,二氧化氯对这几种有机染料均具有很好的脱色效果。     

高氯低COD值水样的无汞快速测定法

以硝酸银和硫酸铬钾代替硫酸汞来消除 COD 测定中的氯离子干扰,同时将重铬酸钾溶液的浓度降低为0.100 mol／L,并用硫磷混酸代替硫酸,该方法经过对标准样品和实际样品的测定,表现出对于测定氯离子含量低于25000 mg／L的高氯低 COD 值水样具有较好的准确度和精密度,同时可以实现银盐的回收再利用。     

无汞开管法快速测定工业废水中的COD

文章对化学需氧量的几种测定方法进行对比,研究了无汞开管法快速测定方法的实验条件与干扰因素,并与标准方法进行对照,总结出炼油废水应用无汞开管法监测COD的适用范围与注意事项,可供同类企业应用该方法时借鉴。     

氯消毒新工艺对大肠杆菌灭活作用的研究

研究了短时游离氯后转氯胺的联合消毒方法对大肠杆菌的灭活作用,并对其协同作用以及pH值和温度对协同作用的影响进行了探讨。结果表明：pH值在6．5～8范围内,温度不超过30℃时,短时游离氯后转氯胺的消毒方法对大肠杆菌的灭活具有协同作用,且随pH值的降低而加强,在低温下该方法的协同效果更加明显。     

Facilitating substance phase‐out through material information systems and improving environmental impacts in the recycling stage of a product

The amount of electrical and electronic products is increasing rapidly, and this inevitably leads to the generation of large quantities of waste from these goods. Some of the generated e‐waste ends up in regions with sub‐standard recycling systems and may be processed under poor conditions. During uncontrolled incineration, halogenated dioxins and furans can be generated from brominated and chlorinated compounds in the products. In order to reduce the health and environmental risks involved in the recycling stage of the life cycle of electronics, an effective design‐for‐environment process must be established during the product development phase. Knowledge of the chemical substances in the product is crucial to being able to make informed decisions. Through full knowledge of the material content of procured components, phase‐outs of unwanted substances, such as halogenated substances, can be performed in an effective manner. Therefore, information is the key to success in phasing‐out substances; facilitating compliance of legal provisions for manufacturers of electrical and electronic devices; and improving the environmental footprint of products as they reach the end of the life cycle. After an introduction to the challenges of electronics waste management, this paper describes supply chain information systems and how they are used to facilitate substance phase‐outs in the electronics industry. Sony Ericsson has been working with phase‐outs of unwanted substances since it was founded in 2001. Through the introduction of a material declaration system that keeps track of all substances in the components used in the company's products, Sony Ericsson has been able to replace unwanted substances to improve environmental impacts at the recycling stage of a product.     

混凝辅助电化学法处理橙黄G染料废水

以石墨板为阳极,研究了电化学氧化法对橙黄G染料废水的降解效果。比较了在NaCl、Na2 SO4以及NaCl与FeSO4·7H2O组合的支持电解质体系中的处理效果,同时考察了电压、初始pH、电解质浓度、电极间距和电解时间等因素对废水中橙黄G脱色率及COD去除率的影响。研究结果表明,橙黄G的脱色主要是活性氯的氧化作用,橙黄G分子的矿化可能主要是电解过程中产生的·OH的作用,FeSO4·7H2O的加入增加了混凝作用,使得处理效果进一步提高。最佳脱色条件下橙黄G脱色率和COD的去除率分别为97．6％和56．3％,B／C（BOD／COD）由0．09提高至0．41,可生化性有较大改善,并且随着降解时间的增加,COD去除率逐渐升高。此结果表明,橙黄G废水COD的去除相对于脱色存在滞后性。     

ClO2氧化法预处理联苯胺类染料中间体废水

采用ClO₂氧化法预处理联苯胺类染料中间体生产废水,探讨了影响COD和联苯胺去除率的主要因素,并采用GC/MS技术对ClO₂氧化前后废水中的有机组分进行了分析。实验确定了较佳的工艺参数：ClO₂加入量为45~55 mg/L,ClO₂与联苯胺的化学计量比控制在（3.0~3.5）∶1,反应时间为 30~35 min。在此条件下,ClO₂氧化后出水中联苯胺去除率达到80%以上,联苯胺类污染物含量得到有效降低,废水BOD₅/COD由原水的0.18提高到0.40。该方法能提高废水的可生化性,是一种较好的生化预处理技术。     

Salting-out phenomenon and 1-octanol/water partition coefficient of metalaxyl pesticide

In this paper, we present the effect of inorganic cations such as Na⁺, K⁺, Ca²⁺, Mg²⁺ on the salting-out phenomenon of metalaxyl from pure water to aqueous salt solutions. Moreover the 1-octanol/water partition coefficient in pure water is presented. To accomplish this, aqueous solubility of metalaxyl was determined in pure water, in different salt solution (NaCl, KCl, CaCl₂ and MgCl₂), and at different concentration level ranging from 0.01 to 1.5 M. The 1-octanol/water partition coefficient was determined using the static shake-flask method. Solubility was determined using dynamic saturation method for pure water in the range of 298.15-325.15 K and at 298.15 K for different salt solutions. The solubility value in pure water for studied interval was found constant (m = 3.118 × 10⁻² mol kg⁻¹).Solubility values were used to calculate the standard molar Gibbs free energy of dissolution (Δ_solG°) and transfer (Δ_trG°) at 298.15 K. The values of Δ_trG° from pure to all studied aqueous salt solutions did not exceed 2 kJ mol⁻¹, the value of Δ_solG° of dissolution is 18.5 ±0.72 kJ mol⁻¹. The 1-octanol/water partition coefficient in pure water log K_o/w is equal to 1.69. The obtained results confirm the classification of the neutral metalaxyl as a slightly hydrophobic molecule.     

不同来源废水COD、TOC与Cl-的关系

通过对含盐化工废水(A)、受潮汐影响的河流水(B)、城市生活污水处理厂排水(C)、采油废水(D)4种不同来源废水进行为期15 d的采样监测,测定了其COD、TOC和Cl-浓度,分析比较了3种废水指标之间的关系,其中COD分别使用重铬酸钾法、氯气校正法和碘化钾碱性高锰酸钾法3种方法进行测定.实验结果表明,4种废水Cl-浓...