The dissipation rates of trichlorfon and its degradation product dichlorvos in cabbage and soil

The residual levels and dissipation rate of trichlorfon, and its degradation product, dichlorvos, in cabbage crops and the soil in which these were grown, were determined by gas chromatography at two geographically distant experimental sites, one in Kunming and one in Beijing, China. Trichlorfon was applied at two dosages (900 g ai ha⁻¹ and 1350 g ai ha⁻¹). Maximum final residues of trichlorfon in soil and cabbage were 1.23 mg kg⁻¹ and 1.81 mg kg⁻¹ respectively at Kunming, and 0.35 mg kg⁻¹ and 0.70 mg kg⁻¹ respectively at Beijing. However, the final residues of dichlorvos in both cabbage and soil was only 0.04 mg kg⁻¹ at Kunming, and only 0.03 mg kg⁻¹, or “not detectable”, at Beijing. The mean half-life of trichlorfon in cabbage was 1.80 d with a dissipation rate of 90% over 5 d, while that in soil was 3.05 d with a dissipation rate of 90% over 14 d at one experimental site. The dissipation rates of trichlorfon and its degradation product dichlorvos at the two experimental sites were different, suggesting that degradation of these pesticides was affected by local soil characteristics and climate. When applied at both the recommended dosage and at 1.5 times this, no detectable residues of either trichlorfon or dichlorvos were found in soil or cabbage at harvest. Although trichlorfon can easily degrade into dichlorvos, which is highly toxic to humans and other animals, the observed low residual levels of dichlorvos suggest that trichlorfon is safe when applied at the recommended dosage.     

不同来源废水COD、TOC与Cl-的关系

通过对含盐化工废水(A)、受潮汐影响的河流水(B)、城市生活污水处理厂排水(C)、采油废水(D)4种不同来源废水进行为期15 d的采样监测,测定了其COD、TOC和Cl-浓度,分析比较了3种废水指标之间的关系,其中COD分别使用重铬酸钾法、氯气校正法和碘化钾碱性高锰酸钾法3种方法进行测定.实验结果表明,4种废水Cl-浓...     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

Assessment of organochlorine pesticide residues in Atlantic Rain Forest fragments, Rio de Janeiro, Brazil

A superficial water quality survey in a watershed of the Paraíba do Sul River, the main water supply for the most populated cities of southeastern Brazil, was held in order to assess the impact of the expansion of agricultural activity in the near border of the Atlantic Rain Forest. The aim of this study was to investigate the presence of priority organochlorine pollutants in soils and superficial waters of Atlantic rainforest fragments in Teresópolis, Rio de Janeiro State. Soil sample preparations were compared by using ultrasound, microwave assisted extraction and Soxhlet extraction. Recoveries of matrix spiked samples ranged from 70 to 130%. Analysis of a certified soil material showed recoveries ranging from 71 to 234%. Although low concentrations of organochlorine residues were found in water and soil samples, this area is of environmental importance and concern, thus demanding a monitoring program of its compartments.     

ZnO/LixNi1-xO光催化降解甲基橙的研究

采用溶胶凝胶法制备LixNi1-xO和ZnO粉体,利用球磨法制备ZnO/LixNi1-xO复合粉体,以紫外光为光源,通过降解甲基橙,研究了锂掺杂及n-p复合对氧化镍的光催化性能影响。结果表明：当投放量为0.1 g/L,x≤0.075（摩尔分数）的锂掺杂氧化镍均比未掺杂氧化镍的光催化活性高。当锂掺杂摩尔分数为0.025,投放量为0.4 g/L时锂掺杂氧化镍的光催化活性最佳,甲基橙最高降解率达到93.1%。当ZnO/Li0.025Ni0.975O在质量比为1∶1,投放量为0.2 g/L时光催化活性最佳,甲基橙最高降解率达到98.1%。     

制药废水有机污染物特性分析与处理

分析了某制药企业废水生物处理站进出水中有机污染物的相对分子质量分布和气相色谱—质谱图谱,提出了根据废水水质特性有针对性地确定制药废水处理工艺的新思路.实验结果表明:进出水中的有机污染物主要是相对分子质量小于1 000的物质,且主要来源于车间5排放的COD比重大、水量小的工段废水;采用旋转蒸馏预处理法处理车间5废水,可使...     

火电厂CO2捕集与封存技术探讨

火电厂CO2减排技术主要包括燃烧前处理、燃烧中减排及燃烧后捕集三类。介绍了IGCC、富氧燃烧、胺吸收法、生物法等CO2捕集与封存技术,分析其存在问题及应用前景。     

中型污水处理厂中药物和个人护理品的分布与去除

为了解15种药物及个人护理用品(PPCPs)在中小型污水处理厂中的分布及其去除效果,采用液相色谱-串联质谱(LC-MS/MS)技术对3座A2/O工艺的污水处理厂水样进行分析研究。结果显示,除普萘洛尔、吉非罗平和吲哚美辛在3座中小型污水处理厂各个工艺单元中均未被检出外,其余12种目标化合物的检出频率在90%~100%之间。进水水样中PPCPs的平均检出浓度为2 285.4 ng/L,其中咖啡因(CF)的平均检出浓度最高为973.3 ng/L,酮洛芬(KP)的平均检出浓度次之为844.7 ng/L,两者之和占进水水样中PPCPs平均含量的79.5%,表明污水处理厂的主要污染物为CF和KP。3座污水处理厂对CF的去除效果最为显著,平均去除率为95.3%,对15种PPCPs总去除效率在39.3%~82.8%之间。     

高效液相色谱-串联质谱法同时检测地表水中13种药物及个人护理品

采用高效液相色谱-串联质谱(HPLC-MS/MS)检测,建立了地表水中13种药物及个人护理品的测定方法。水样用盐酸与氢氧化钠溶液调p H值至7.0左右,过固相萃取小柱进行富集,用14 m L甲醇洗脱。以C18柱为分离柱,0.01%甲酸的甲醇-0.01%甲酸水溶液为流动相,目标物在10 min内分离,在0.50~250μg/L范围内,13种化合物峰面积与内标物质峰面积之比与质量浓度的线性关系良好(0.99),检出限在0.05~0.5 ng/L范围内。基质加标实验结果表明,13种化合物在水中的回收率分别在56.2%~123.2%之间(加标水平5 ng/m L)和58.0%~107.8%(加标水平50 ng/m L),相对标准偏差在1.60%~19.9%(n=6)之间。应用该方法测定了从2条纳污河流采集的10份水样,结果表明,除美托诺尔和普洛萘尔未被检出外,其余11药物的检出频率在30%~100%之间。在13种目标物质中,咖啡因的检测浓度最高达287.5ng/L,舒必利次之,为277.5 ng/L。本方法快速、准确,适用于地表水中PPCPs类的快速测定。     

水下公路隧道纵向疏散通道加压送风系统研究

为研究水下公路隧道纵向疏散通道加压送风系统的关键设计参数,结合纵向疏散通道的特点,借鉴一般建筑加压送风系统的设计要求,提出了纵向疏散通道内加压送风量的计算方法,并通过数值模拟方法对纵向疏散通道加压送风系统进行了研究。结果表明,利用风速法计算得到的送风量比压差法计算得到的结果大20倍左右,并且压差法计算送风量时受疏散口缝隙宽度影响较大,工程适用性差。通过数值模拟可知,疏散通道内的送风风速达到1.5m/s时即能够满足人员安全疏散要求,这与风速法计算的结果一致。研究结果可供采用纵向疏散模式的隧道疏散通道加压送风系统设计参考。