磁选柱在矿山磁选尾矿和硫铁矿烧渣处理中的应用

介绍了磁选柱的结构、分选原理、分选过程及其在处理矿山磁选尾矿和硫铁矿烧渣方面的应用。用磁选柱精选磁铁矿尾矿，得到的精矿品位大于66％；用磁选柱精选硫铁矿烧渣，得到的精矿品位大于65％。硫的质量分数降至0．84％。     

散射光下铁(III)-丙酮酸盐配合物还原铬(VI)的研究

研究了在散射光下铁(III)-丙酮酸盐配合物对铬(V I)的光还原反应;考察了溶液pH、铁(III)、丙酮酸钠、铬(V I)浓度对反应的影响;分析了铬(V I)光还原反应的动力学。实验结果表明:铁(III)-丙酮酸盐配合物体系能在较弱的散射光下还原铬(V I)。在铬(V I)浓度为19.2μm o l/L、铁(III)浓度为10.0μm o l/L、丙酮酸钠浓度为240μm o l/L、pH为3.0、光照240m in的条件下,铬(V I)的还原率达到99.7%。从表观动力学方程的反应级数看,铁(III)的级数(0.83)最高,铁(III)浓度是影响铬(V I)光还原反应速率的主要因素,铁(II)是铬(V I)光还原的主要还原剂。     

PLC控制系统在钢渣热焖工艺中的应用

利用PLC控制系统,实现在钢渣热焖工艺中的恒压供水和钢渣热焖定时定量喷水的自动控制要求,具有国际先进水平,取得了良好的经济效益、社会效益和环境效益.     

碱性高炉矿渣制备多孔混凝土掺合料及其净化酸性水的试验研究

碱性高炉矿渣和多孔混凝土都有良好的净水性能,将碱性高炉矿渣作为掺合料制成掺高炉矿渣多孔混凝土(BSPC),对其处理模拟酸性水的效果进行研究。结果表明:经BSPC处理后,进水p H由2~3变成8.5~9.1。与普通多孔混凝土相比,添加高炉矿渣的混凝土对酸性水浊度、CODcr、TP和Cd的平均去除率依次提高了6.2%,8.8%,5.2%和4.5%,分别达到74.3%,74.5%,91.7%和86.5%。同时,BSPC孔隙率在处理酸性水前后有所下降,下降幅度较小,为6.2%,不影响BSPC对酸性水的处理。实验最后对混凝土表面白色絮状物进行了红外和XRD表征,初步分析其中含有CaCO_3、SiO_2和水化硅酸钙(C-S-H)等无机物,初步判定来源于BSPC的溶出物。     

钢渣湿法捕获CO_2反应机制研究

以炼钢过程中排放的固体废弃物钢渣为碳捕获剂,进行了钢渣湿法捕获烟气CO2工艺的实验研究。通过分析钢渣的组成成份及反应机理,研究液固比、反应温度、反应时间、pH值及反应产物等主要参数对钢渣湿法碳捕获状况的影响。实验证明,通过合理的设计和适当的操作,可使钢渣湿法碳捕获效率达60%以上,具有一定的应用价值。     

刮油刮渣机的结构设计与应用选择

介绍了刮油刮渣机的工作原理和基本结构组成及应用结构方式,并从工艺环境及应用选择的性价比方面,提出实际工作时选择刮油刮渣机的注意事项,达到设备的最大合理化应用。     

潜流人工湿地去除大庆地区湖泊水体中石油类化合物的研究

针对大庆地区石油类化合物污染湖泊水质特点和气候条件,采用包含砾石床、砾石芦苇床、炉渣芦苇床和炉渣床单元的现场试验系统,考察启动期、投加微生物、投加缓释碳源、水温低于5℃和常规运行期等工况下各单元对石油类化合物的去除效果及其去除机理.在整个试验期内4个单元石油类化合物的平均去除率分别为24.7％、28.4％、45.9％和42.9％;投加微生物和缓释碳源都可提高石油类化合物污染物的去除效果;以炉渣为填料的单元污染物去除效果显著优于以砾石为填料的单元.2005年常规运行期间,湿地床和对照床石油类化合物去除率存在显著性差异（p<0.05）,植物对石油类化合物的去除起到显著的促进作用.系统运行期内通过截留去除的石油类化合物占总去除量70％左右,各单元该比例没有显著性差异（p<0.05）.     

Antimony smelting process generating solid wastes and dust：Characterization and leaching behaviors

A large amount of solid waste has been produced by the antimony smelting process in the＂World Capital of Antimony＂, Xikuangshan area in China. This study comprehensively investigated the physical and chemical characteristics of the various solid wastes, as well as the leaching behavior of the solid wastes, which included water-quenched slag,arsenic-alkali residue, desulfurized slag and blast furnace dust. These four types of waste were enriched in a variety of heavy metals and metalloids and more specifically with As and Sb levels up to 8.6 × 104 and 3.16 × 105mg/kg, respectively, in arsenic-alkali residue. For desulfurized slag and water-quenched slag, the leaching concentration of Sb significantly exceeded the acceptable limits during the leaching tests using the toxicity characteristic leaching procedure and the synthetic precipitation leaching procedure. In addition, As leaching in arsenic-alkali residue was extraordinarily hazardous, being three orders of magnitude higher than the regulatory level of As. According to the results of the extraction tests, all the tested wastes were classified as hazardous waste.     

Synthesis of hydrogarnet from molten slag and its hydrogen chloride fixation performance at high temperature

Hydrogarnet was synthesized hydrothermally below 200°C using molten slag obtained from municipal solid waste. For comparison, it was also synthesized using pure-phase CaO–Al₂O₃–SiO₂–H₂O, as reported previously. The structural and textural properties of this material were investigated using various analytical and spectroscopic techniques such as X-ray diffraction, X-ray fluorescence spectrometry, atomic absorption spectrometry (AAS), thermogravimetry/differential thermal analysis, Fourier transform infrared spectroscopy, and scanning electron microscopy. The Cl⁻ fixation ability of hydrogarnet was investigated in the temperature range 500–800°C in a fixed-bed flow reactor using a HCl concentration (1000 p.p.m.v.) similar to that of incinerator exhaust gas. Under these experimental conditions, the hydrogarnet was capable of reducing the HCl gas level to less than 1 p.p.m.v. Analysis of the spent catalyst revealed that the hydrogarnet was being transformed into wadalite and CaCl₂ at high temperatures. The elution test for chromium ions in hydrogarnet obtained from slag was also used, and it was found that chromium ions were not eluted from hydrogarnet. Received: January 27, 2001 / Accepted: October 11, 2001     

天然黏土材料附着纳米TiO2对 电解锰渣中锰的吸附固定

采用机械球磨法对膨润土、硅藻土、高岭土3种天然黏土材料进行预处理,通过超声法将纳米TiO_2附着于其上制得复合材料,考察了不同复合材料加入量及养护时间条件下复合材料对电解锰渣中Mn的吸附固定效果。3种天然黏土材料中,硅藻土的平均粒径最小,比表面积和总孔隙度最大,对水中Mn的吸附量也最大。黏土材料附着纳米TiO_2后对电解锰渣中Mn的吸附固定效果较单纯黏土材料有明显改善。在养护时间为12 d、硅藻土附着纳米Ti O_2复合材料加入量为10%(w)的最佳条件下,Mn的TCLP浸出量较原电解锰渣下降了83.04%。