碱矿渣胶凝材料固化重金属污泥的研究

主要原材料为高炉矿渣的碱矿渣胶凝材料(HAS)、掺3%沸石的HAS、掺5%沸石的HAS、水泥等4种固化材料被用来固化人工合成含铅、镉、铬等重金属的污泥。污泥固化体中污泥与固化材的掺和比例为4:1。实验结果表明,HAS固化剂对重金属污泥的固化效果要好于水泥,其污泥固化体的无侧限抗压强度高于水泥固化体,同时其固化体的重金属浸出量明显低于水泥。沸石的掺入使HAS固化体的重金属浸出量减小,且随着沸石掺加量的增大,HAS固化体的重金属浸出量相应的减少。     

煤渣填料固定化菌膜处理餐厅污水

以煤渣为填料,采用人工筛选优势菌挂膜固定化技术和直流式供水送风形式,对酒家、宾馆的餐厅污水进行生物接触氧化处理,COD和BOD的去除率可>90％,处理后排放水质可稳定达到COD≤100mg·1~(-1),BOD≤30mg·1~(-1),SS≤30mg·1~(-1),NH_3—N≤15mg·1~(-1)。推广应用结果表明,具有显著的经济效益和环境效益。     

铬渣的固化/稳定化研究

探讨了用水泥粘结剂对铬渣进行稳定化的方法。结果表明，把高炉矿渣和粉煤灰加入水泥基材中对铬渣进行固化，固化体抗压强度达到30MPa以上，浸出毒性大大降低，浸了同液中六价铬浓度在容许范围内，建议可以综合利用。     

焦炭和废铁屑微电解预处理垃圾渗滤液的研究

研究表明,废铁屑和焦炭微电解是预处理垃圾渗滤液的一种有效方法,可去除垃圾渗滤液COD、色度和腐殖酸等污染物质,改善其可生化性、降低负荷,为后续生化处理创造良好的条件.通过静态正交实验确定废铁屑和焦炭最佳投加体积比为1∶3;最佳反应pH值为4;动态实验中,反应时间为1 h时,COD和色度去除率分别高达68%和91%;BOD/COD从0.3提高到0.5左右.     

含铬电镀废水的资源化处理

针对电镀厂产生的高浓度含铬废水,研究了硫化钠还原沉淀法回收电镀废水中的铬的可能性。讨论了pH、投药量、反应时间和搅拌速率等变量对铬回收效果的影响。结果表明:在pH1.6,工业硫化钠(60%)投加量为4.0g/L废水,搅拌速率170r/min和反应时间t=90min的条件下能够将原水中初始浓度为533.1mg/L的三价铬C(rⅢ)和530.0mg/L的六价铬[C(rⅥ)]分别降到42.9mg/L和0.01mg/L。此时铬渣中三氧化二铬(Cr2O3)含量为29.5%,满足回用要求。接下来,为了进一步去除残余的三价铬C(rⅢ),利用正交试验设计讨论了重金属捕集剂(FZ)对其去除的最佳条件。在上述条件下出水中总铬(TCr)浓度最终降到0.94mg/L。     

锰尾矿、矿渣浸出毒性及Cd、Pb溶出特性研究

锰尾矿、矿渣是锰生产过程中形成的废弃物,里面的很多物质都会在自然条件下如雨水淋溶而溶出,进入到土壤和水体中造成环境污染。通过对锰尾矿、矿渣进行浸出毒性实验;以及结合到当地的自然条件,考查浸泡体系pH值、温度、液固比的变化条件,对尾矿、矿渣中Pb、Cd溶出含量的影响,明确了锰尾矿、矿渣属于一般的工业固体废物,以及Pb、Cd的溶出特性。     

烧结烟气脱硫灰-矿渣复合粉反应性能的研究

烧结烟气脱硫灰中由于含有大量的亚硫酸钙和游离氧化钙,在将其直接用于胶凝材料时,不但延长凝结时间,降低早期强度,而且还容易导致水泥硬化体体积膨胀,恶化硬化体性能。实验研究了脱硫灰不同掺入方式和掺入量,以及氧化温度对复合粉反应性能的影响。结果表明,在将脱硫灰经过550℃氧化处理后,再采用加水预拌的方式,在脱硫灰掺入量为5%时可获得具有较好反应性能的复合粉。     

Comparative study of microbial community structure in di erent filter media of constructed wetland

Comparisons of microbial community structure, in eight filter media of zeolites, anthracite, shale, vermiculite, ceramic filter media, gravel, steel slag and bio-ceramic, were undertaken by analyzing the phospholipid fatty acid (PLFA) composition. A total of 20 fatty acids in the range of C11 to C20 were determined but only 13 PLFAs were detected in steel slag. They consist of saturated fatty acids, branched fatty acids, monounsaturated fatty acids, and polyunsaturated fatty acids. The variation of fatty acids was revealed in the relative proportions of these fatty acids in di erent media. The aerobic prokaryotes were the predominant group in all media. The PLFA composition showed significant di erences among the eight di erent media by Tukey’s honestly test. It was found that steel slag was significantly di erent in the microbial community as compared to other filter media, probably due to its alkaline e uent. Steel slag alone is probably not a good choice of substratum in constructed wetlands. The principle components analysis (PCA) showed that zeolites, bio-ceramic, shale and vermiculite had a similar microbial community structure while steel slag and ceramic filter media were distinct from other media.     

Thermal stabilization of chromium slag by sewage sludge: Effects of sludge quantity and temperature

To investigate the feasibility of detoxifying chromium slag by sewage sludge,synthetic chromium slag containing 3% of Cr(VI) was mixed with sewage sludge followed by thermal treatment in nitrogen gas for stabilizing chromium.The effects of slag to sludge ratio(0.5,1 and 2) and temperature(200,300,500,700 and 900°C) on treatment efficiency were investigated.During the mixing process before thermal treatment,59.8%-99.7% of Cr(VI) was reduced,but Cr could be easily leached from the reduction product.Increasing heating temperature and decreasing slag to sludge ratio strengthened the reduction and stabilization of Cr(VI).When the slag to sludge ratio was 0.5 and thermal treatment temperature was 300°C,the total leached Cr and Cr(VI) declined to 0.55 mg/L and 0.17 mg/L respectively,and 45.5% of Cr in the thermally treated residue existed as residual fraction.A two-stage mechanism was proposed for the reduction and stabilization of Cr.     

电炉钢渣对水中Cu2+、Cd2+和Pb2+的去除作用

以宝钢电炉钢渣为研究对象,考察了钢渣对溶液中重金属离子Cu2+、Cd2+、Pb2+的吸附动力学、吸附等温线、吸附热力学特征,借助多种分析手段(XRD、BET比表面分析、SEM/EDS等)对钢渣进行了理化性能测试和表征.结果表明,电炉钢渣对重金属离子的吸附速率较快,吸附速率顺序为Cd2+>Pb2+>Cu2+,吸附过程符合一级动力学模型(R2>0.99).吸附等温实验结果表明,Langmuir模型较为适合重金属离子在钢渣上的吸附,实验条件下对Cu2+、Cd2+、Pb2+离子的最大吸附容量分别为0.101、0.058、0.120 mmol.g-1.3种重金属离子在钢渣上的吸附是一个吸热(ΔH0<0)、熵值增大(ΔS0>0)的自发反应过程(ΔG0<0),熵效应是吸附反应自发进行的主要驱动力.SEM/EDS分析结果揭示了吸附前后钢渣表面形貌和化学成分的变化.电炉钢渣以其低价、高效性在重金属废水处理中具有广阔的应用前景.