Cr(Ⅵ)污染土壤的热解还原无害化处理

提出了用热解还原法对含铬土壤进行无害化处理的新技术,研究了热解温度、热解时间及土壤有机质对铬无害化处理的影响,分析了热解前后土壤中铬的元素形态的变化.同时还探讨了热解还原过程中Cr(Ⅵ)的无害化机制.结果表明,土壤中的有机质在热解还原过程中产生的挥发分对Cr(Ⅵ)的无害化起核心作用;在200～600℃范围内,Cr(Ⅵ)的还原量随着热解温度升高而增大,500.0℃最适合于经济有效地实现Cr(Ⅵ)的热解还原处理;Cr(Ⅵ)的热解还原过程较快.铬的形态分析结果表明,热解后可交换态和碳酸盐结合态铬量大大降低,大部分铬转化成了活性低的残渣态,极大地降低了铬的危害.     

板栗壳对重金属Cr（Ⅵ）吸附性能的研究

从废弃的植物材料中筛选出一种Cr(Ⅵ)高效吸附剂——板栗壳。研究了pH、接触时间、板栗壳用量、温度和Cr (Ⅵ)初始浓度对Cr(Ⅵ)吸附活性的影响。结果表明, 板栗壳的最佳pH为2～3。在pH 2时,Cr(Ⅵ)的去除率达99.7%。在15～35℃的温度范围内,板栗壳对Cr(Ⅵ)的去除率随温度的升高而增加。30℃时,Cr(Ⅵ)的去除率可达99%。板栗壳用量对Cr(Ⅵ)的去除有明显影响。由0.2 g增加到0.4 g时, Cr(Ⅵ)的去除率从90.6%提高到99%。在较宽的铬初始浓度范围内,板栗壳对Cr (Ⅵ)有明显的去除作用。     

污水污泥裂解及其性能的研究

以碘吸附值为裂解残渣吸附性能的指标,通过单因素实验和正交实验,确定了制备裂解残渣的最佳工艺条件,并对残渣的表面元素组成、孔结构组成、晶相组成和吸附性能等性质进行了表征。结果显示：以浓度均为5 mol/L的ZnCl₂和H₂SO₄作活化剂、复配比2∶1、活化温度600℃、活化时间1 h、固液比1∶2.5,制得的裂解残渣酸洗后碘值平均值可达892.8 mg/g;用制备的裂解残渣对苯酚废水进行处理,室温下振荡5 min,苯酚去除率即可达到87.9%,且符合Langmuir吸附等温线方程和Freundlich吸附等温线方程。     

Batch sorption dynamics and equilibrium for the removal of lead ions from aqueous phase using activated carbon developed from coffee residue activated with zinc chloride

Lignocellulosic materials are good precursors for the production of activated carbon. In this work, coffee residue has been used as raw material in the preparation of powder activated carbon by the method of chemical activation with zinc chloride for the sorption of Pb(II) from dilute aqueous solutions.The influence of impregnation ratio (ZnCl₂/coffee residue) on the physical and chemical properties of the prepared carbons was studied in order to optimize this parameter. The optimum experimental condition for preparing predominantly microporous activated carbons with high pore surface area (890 m²/g) and micropore volume (0.772 cm³/g) is an impregnation ratio of 100%. The developed activated carbon shows substantial capability to sorb lead(II) ions from aqueous solutions and for relative impregnation ratios of 75 and 100%, the maximum uptake is practically the same. Thus, 75% represents the optimal impregnation ratio.Batch experiments were conducted to study the effects of the main parameters such as contact time, initial concentration of Pb(II), solution pH, ionic strength and temperature. The maximum uptake of lead(II) at 25 °C was about 63 mg/g of adsorbent at pH 5.8, initial Pb(II) concentration of 10 mg/L, agitation speed of 200 rpm and ionic strength of 0.005 M. The kinetic data were fitted to the models of pseudo-first order and pseudo-second order, and follow closely the pseudo-second order model. Equilibrium sorption isotherms of Pb(II) were analyzed by the Langmuir, Freundlich and Temkin isotherm models. The Freundlich model gives a better fit than the others.Results from this study suggest that activated carbon produced from coffee residue is an effective adsorbent for the removal of lead from aqueous solutions and that ZnCl₂ is a suitable activating agent for the preparation of high-porosity carbons.     

利用含铬废水和含铅废水制备铬黄

利用净化后的含铬废水和含铅废水制备铬黄.采用沉淀法对废水进行净化预处理,最佳工艺条件:100mL含铬废水中加入20 g Na_2CO_3,及10 mL H_2O_2,用NaOH调节含铬废水pH为10.00;用NaOH调节含铅废水pH为2.65.将净化后的10 mL含铬废水和25 mL含铅废水混合,在55-60℃条件下反应10 min,合成的铬黄达到GB/T 3184-2008<铬酸铅颜料和钼铬酸铅颜料>的质量标准.经重金属吸附剂处理Pb~(2+)后铬黄合成滤液中的Cr~(6+)和Pb~(2+)质量浓度均达到GB8978-1996<污水综合排放标准>的指标.     

Removal of Cr(VI) from simulative contaminated groundwater by iron metal

The Cr(VI) removal from simulative contaminated groundwater using zero-valent iron (Fe⁰) filings, Fe⁰ powder and nanoscale Fe⁰ in batch experimental mode was studied. Cr(VI) is a primary pollutant of some soils and groundwater. Zero-valent iron, an important natural reductant, could transform Cr(VI) to Cr(III) which is much less toxic and immobile. The Cr(VI) removal percentage was 87% at a metal to solution ratio of 6 g l⁻¹ for commercial iron powder (200 mesh) in 120 min, and 100% Cr(VI) was removed when the metal to solution ratio was 10 g l⁻¹. The results demonstrates that the Cr(VI) removal percentage was affected apparently by pH, the amount of Fe powder and the reaction temperature. The Cr(VI) removal percentage with nanoscale Fe⁰ was much higher than those with Fe⁰ filings or Fe⁰ powder at the same reaction time. Electrochemical analysis of the reaction process led to the conclusion that the Cr(VI) trended to form Cr(III) hydroxide under the reaction conditions. The kinetics analysis showed that Cr(VI) reduction by Fe⁰ could be described as a pseudo-first-order kinetics model.     

Use of whole-body and subcellular Cu residues of Lumbriculus variegatus to predict waterborne Cu toxicity to both L. variegatus and Chironomus riparius in fresh water

We tested the use of whole-body and subcellular Cu residues (biologically-active (BAM) and inactive compartments (BIM)), of the oligochaete Lumbriculus variegatus to predict Cu toxicity in fresh water. The critical whole-body residue associated with 50% mortality (CBR₅₀) was constant (38.2-55.6 μg g⁻¹ fresh wt.) across water hardness (38-117 mg L⁻¹ as CaCO₃) and exposure times during the chronic exposure. The critical subcellular residue (CSR₅₀) in metal-rich granules (part of BIM) associated with 50% mortality was approximately 5 μg g⁻¹ fresh wt., indicating that Cu bioavailability is correlated with toxicity:subcellular residue is a better predictor of Cu toxicity than whole-body residue. There was a strong correlation between the whole-body residue of L. variegatus (biomonitor) and survival of Chironomus riparius (relatively sensitive species) in a hard water Cu co-exposure. The CBR₅₀ in L. variegatus for predicting mortality of C. riparius was 29.1-45.7 μg g⁻¹ fresh wt., which was consistent within the experimental period; therefore use of Cu residue in an accumulator species to predict bioavailability of Cu to a sensitive species is a promising approach.     

聚环氧琥珀酸萃取锰泥残渣中铬的研究

聚环氧琥珀酸(PESA)是一种具有无磷及非氮结构、环境友好型水溶性聚合物,且具有螯合多价金属阳离子的性能和可生物降解性的特征,选取其作为锰泥残渣中铬的螯合萃取剂,研究了不同pH、螯合萃取剂剂量、搅拌时间下PESA对铬的萃取率。结果表明:(1)最佳萃取条件为pH=4、PESA剂量30mg/g、搅拌时间60min;在最佳萃取条件下,铬的萃取率可达95%。(2)从结构上看,PESA是由醚基和羧基基团组成的高分子聚合物,羧基基团是与金属离子作用的主要官能团,它对Ca2+、Mg2+、Zn2+、Cr(Ⅲ)、Cr(Ⅵ)和Pb2+等有较强的螯合能力;从溶液的配位角度看,PESA与金属有较强的结合能力。因此,PESA对锰泥残渣中的铬有萃取作用。     

高分子量高纯度阳离子聚丙烯酰胺的合成

以丙烯酰胺与丙烯酰氧乙基三甲基氯化铵为单体,在复合引发剂的作用下,选择水溶液共聚法合成高分子量与高纯度阳离子型聚丙烯酰胺(CPAM)。实验表明,有机偶氮引发剂A用量0.5‰、氧化还原引发剂用量0.45‰、还原剂与氧化剂摩尔比2∶1、反应体系pH为4与反应时间5 h条件下,CPAM分子量为1 042万,且溶解性好。通过对聚合物残单含量影响因素添加剂用量、反应时间的研究,结果表明,添加剂EDTA和增溶剂D对残留AM含量影响小,而苯甲酸钠对聚合物残留AM的含量影响显著;延长反应时间至7 h,残单含量可降低至0.27%,CPAM的纯度高。通过与国内外3种同类型产品进行对比,结果表明,自制产品的分子量明显高于其他产品,且残单含量比国内产品降低了50%～75%。     

微量元素对牛粪低温厌氧发酵的影响

为考察较低温度(<17℃)条件下添加微量金属元素对厌氧发酵产气量的影响,在发酵底物TS(含固率)为10%下采用10 L玻璃瓶作反应器,以牛粪为原料,向厌氧生物反应器中分别添加MnSO4、FeSO4·7H2O、电解锰渣,分析了厌氧消化系统运行过程中的产气量、COD(化学需氧量)和pH的变化。结果表明,锰元素能促进低温下牛粪的厌氧发酵,加速反应启动。当添加6 g MnSO4、100 g电解锰渣时,单位质量VS产气率分别为0.26 mL/g和0.64 mL/g,添加6 g FeSO4·7H2O与空白对照组均未见明显产气。