垃圾炉一次风量对炉床燃烧影响的仿真研究

针对垃圾焚烧炉床层内垃圾燃烧过程复杂性及影响垃圾燃烧效率因素多的问题,运用数值仿真方法对某垃圾焚烧炉床层垃圾燃烧进行了模拟,获得了垃圾质量流失速率、水分蒸发速率、挥发分释放速率、焦炭燃烧速率和烟气的温度;并在50~1 000 Nm3/min范围内改变一次风流量,获得了床层质量流失比值、过剩空气系数和烟气中各组分的质量百分比含量。仿真结果显示,一次风流量取值517.47~6`32.09 Nm3/min时燃烧效率较高;炉排两端区域的一次风流量在50~75 Nm3/min时,可以使垃圾床表面平均温度明显提高,而且还可以提高燃烧效率,同时减少供风总量,节约能源与动力资源。本研究对优化设计垃圾焚烧炉,提高床层内垃圾的燃烧效率有一定参考价值。     

固硫灰渣深度处理焦化废水的实验研究

选用同硫灰渣深度处理经生化处理后焦化废水,采用分光光度计法评价焦化废水的处理效果,采用XRD、XRF、SEM和IR等分析材料的成分、结构和微观形貌等.结果表明,固硫灰渣用量60 g/L、吸附时间15 min,焦化废水的脱色率可达94.22%,COD从原水的76.01 mg/L降低到处理后的5.76 mg/L,NH+4-...     

污水污泥在富氧环境下燃烧特性的实验研究

采用综合热分析仪研究了空气气氛和富氧气氛下污水污泥和煤的燃烧曲线,分析比较氧浓度对污泥燃烧特性参数的影响,并计算得到各工况下的动力学参数。结果表明：随着氧浓度增加,污泥燃烧DTG曲线向低温区移动,着火温度和燃尽温度均降低,综合燃烧指数大大提高,污泥燃烧特性得到改善。可用两段一级反应动力学模型来较好的描述污泥的主要燃烧过...     

Fuel efficiency improvement of a dual-fuel engine fuelled with Honge oil methyl ester (HOME)–bioethanol and producer gas

Renewable and alternative fuels have numerous advantages compared with fossil fuels as they are renewable and biodegradable and provide food and energy security and foreign exchange savings besides addressing environmental concerns and socio-economic issues (Yaliwal et al. 2013. International Journal of Sustainable Engineering, doi:10.1080/19397038.2013.801530. Zhu et al. 2011a, Applied Thermal Engineering 31 (14–15): 2271–2278; Zhu et al. 2011b, Fuel 90: 1743-1750; Banapurmath, Tewari, and Hosmath 2008, Renewable Energy 33: 2007-2018; Banapurmath 2009, “Performance, Combustion and Emission Characteristics of a Single Cylinder Direct Injection CI Engine Operated on Dual Fuel Mode Using Honge Oil and Producer Gas.” PhD thesis, 1–195; Banapurmath et al. 2011, Waste and Biomass Valorization 2: 1–11). In this context, the main objective of the present work is to study methods of biofuel production such as Honge oil methyl ester (HOME) using a conventional transesterification process and bioethanol from the Calliandra calothyrsus shrub using a new pretreatment method known as hydrothermal explosion. Further, experimental investigations were carried out on a single-cylinder, four-stroke, direct-injection stationary diesel engine operating in a dual-fuel mode using HOME, bioethanol and producer gas combinations to determine its performance, combustion and emission characteristics. The performance of the dual-fuel engine was analyzed at optimized engine conditions. HOME-Bioethanol (BE) blends such as HOME+ 5% bioethanol (BE5), HOME+ 10% bioethanol (BE10) and HOME+ 15% bioethanol (BE15) were prepared by adding bioethanol to HOME (on volume basis) in different proportions ranging from 5 to 15% with an increment of 5%. In this present work, the effect of different BE blends on the performance of producer gas fuelled dual fuel engine was studied. Experimental investigation on dual fuel engine using BE5-Producer gas operation resulted in up to 4–9% increased brake thermal efficiency with decreased hydrocarbon (HC), carbon monoxide (CO) and marginally increased nitric oxide (NOx) emission levels compared to HOME-Producer gas, BE10-producer gas and BE15-producer gas mode of operation. However, it was observed that, the overall performance of BE-producer gas operation was found to be lower compared to diesel-producer gas operation.     

北京地区PM10与秸秆燃烧排放单颗粒对比分析

采用场发射带能谱扫描电镜(FESEM/EDS)法分析北京怀柔地区PM10与秸秆燃烧排放颗粒的形貌特征和成分差异.结果显示:秸秆燃烧后排放颗粒物多为大粒径颗粒,成分上都含S、Cl和K元素.含有生物质燃烧标志元素K的PM10颗粒物多为含Si、Al和Na元素的燃煤飞灰和矿物颗粒,与秸秆燃烧排放颗粒组成化学元素差异明显.据此推...     

基于物元模型的煤自燃危险性分析

为探索判断煤自燃的危险性新方法,在煤低温氧化试验的基础上,基于可拓理论构建了煤自燃危险性熵权和经验权的物元综合分析模型。采用该方法对4个不同煤样低温氧化试验数据进行自燃危险性分析,得出各煤样自燃危险性的等级及差异程度,并提出相应的防范对策。结果表明:4号煤样比其他煤样更具自燃危险性,需要重点防范。该方法的预测结果与实际情况相吻合。     

C6H12N4+Mg+KClO4+SrSO4系统的振荡控制和安全分析

从实验和数值分析两方面研究了C6Hl2N 4+Mg+KClO4+SrSO4反应系统的振荡燃烧现象,并对反应机理进行了深层次的分析.结果表明,振荡燃烧是由化学动力学的非线性反馈引起的,即:反应系统中镁的三相与氧气的相互竞争反应造成系统的非线性化学振荡燃烧.氧化剂和可燃剂的比值,以及频率调节剂等吸热物质可调节气相镁的生成速率,能有效地控制药剂的振荡频率.选取适当的控制参数,可以使反应按照预定的、安全的过程进行,避免爆燃的产生.本文的研究结果对化工、军事等领域的安全控制具有重要意义.     

石脑油罐硫铁化合物自燃原因分析

对一起石脑油罐硫化铁化合物自燃事故的经过和原因进行了分析 ,推断出发生在石脑油罐硫铁化合物自燃并非为FeS自燃 ,并提出了预防同类事故的防范措施。     

印铁涂装烘房有机废气的直接燃烧法处理实践

本文通过采用催化法和直燃法两种工艺处理印铁涂装生产的有机废气的工业实践,对设计和运行中的一些要点进行分析和探讨。     

均压防灭火定量分析技术研究及其应用

均压是防治煤矿自然发火的主要措施之一。针对均压应用中的定性分析方法及两点式均压方法的不足,提出了均压防灭火定量分析技术并开发了与采空区相连两个工作面间均压的计算机摸拟计算程序。阐述了程序均压原理、内容及应用实例。这项技术具有创新性和应用推广价值,可以提高均压防灭火技术应用的经济性和安全性