Optimum conditions for the formation of Al13 polymer and active chlorine in electrolysis process with Ti/RuO2-TiO2 anodes

A polyaluminum containing a high concentration of Al₁₃ polymer and active chlorine (PACC) was successfully synthesized by a new electrochemical reactor using Ti/RuO₂-TiO₂ anodes. PACC can potentially be used as a dual-function chemical reagent for water treatment. The obtained results indicated that the formation of Al₁₃ polymer and active chlorine, were the most active components in PACC responsible for coagulation and disinfection respectively. These components were significantly influenced by electrolyte temperature, current density, and stirring rate. It was observed that high electrolyte temperature favored the formation of Al₁₃. Increasing current density and stirring rate resulted in high current efficiency of chlorine evolution, thus favoring the generation of Al₁₃ and active chlorine in PACC. When the PACC (Al_T = 0.5 mol/L, basicity = 2.3) was prepared at the optimum conditions by electrolysis process, the Al₁₃ polymer and active chlorine in product reached above 70% of Al_T and 4000 mg/L, respectively. In the pilot scale experiment with raw polyaluminum chloride used as an electrolyte, PACC was successfully prepared and produced a high content of Al₁₃ and active chlorine products. The pilot scale experiment demonstrated a potential industrial approach of PACC preparation.     

高锰酸盐复合剂强化饮用水除污染生产性研究

采用依时间序列进行对比的方法,考察了高锰酸盐复合剂(PPC)对饮用水源的强化除污染效能。生产性实验结果表明,PPC具有优良的强化混凝和强化过滤效能,能显著降低水厂沉后水和滤后水的浊度、COD_Mn、UV₂₅₄等水质指标。与未投加时相比较,水厂投加PPC后沉后水和滤后水浊度分别降低了25%和33.3%,沉后水和滤后水COD_Mn去除率分别提高了15.3%和11.5%,UV₂₅₄去除率分别提高了16.3%和9.5%。同时,GC/MS分析表明PPC能有效去除水源水中的多种微量有机污染物,显著提高饮用水的化学安全性。PPC通过高锰酸钾的氧化作用,水合二氧化锰的吸附作用,以及各组分间的协同强化作用,显著提高了对水中污染物质的去除效率。     

混凝-生物接触氧化处理合成橡胶碱洗废水

对化学合成橡胶碱洗废水进行了有机组分和可生化性分析,废水主要含有氯甲烷、六甲苯、异丁醇、甲醇等污染物质,生化降解实验中废水TOC可在6d内从60．9mg／L下降至0．0mg／L,可生化降解性好,适于生化处理。选择混凝．生物接触氧化组合工艺对废水进行处理,采用优化条件（pH=8、PAC=40mg／L、PAM=8mg／L）进行混凝,碱洗废水COD去除率为9．95％～72．94％（平均31．51％）;混凝后的碱洗废水与冲洗废水1：5混合进行接触氧化处理,在HRT为36h的情况下,COD去除率为65．6％-72．6％（平均70．4％）,出水COD为134～331mg／L,满足企业废水排放市政管网的要求;同时,实验发现COD去除率与COD容积负荷存在指数函数变化关系。     

饮用水除砷技术研究进展

饮用水中的砷对人体健康危害很大。介绍了从饮用水中去除砷的各种方法,总结了目前除砷技术存在的不足,指出混凝微滤工艺具有除砷效率高、能耗低、操作简单等优点,应成为今后饮用水除砷技术的发展方向。     

Fenton-混凝法处理焦化废水的试验研究

对Fenton预氧化-混凝法联用技术处理焦化废水进行了研究，探讨了Fenton氧化阶段H2O2投加量、混凝阶段pH值以及混凝剂投加量等因素对焦化废水COD去除率的影响，确定了最佳处理条件。结果表明，Fenton预氧化一混凝法处理焦化废水取得了良好效果，COD去除率达97．5％，为该工艺实际处理焦化废水提供了实验依据。     

响应曲面法优化絮凝处理木薯淀粉废水

采用中心复合实验设计和响应面分析法研究复合絮凝剂聚合氯化铝锌(PAZC)和聚合氯化铝(PAC)混凝处理木薯淀粉废水,进行设计和分析,以溶液pH值和絮凝剂用量为考察因素,分别以COD、浊度去除率为考察指标,选用最佳优化数学模型描述考察指标和考察因素之间的数学关系,并以设定PAZC和PAC对COD去除率(65%),浊度去除率(90%)和SS去除率(90%)的目标值,通过等高线叠加图预测最优实验条件,得到PAZC投量为6.5 mg/L,pH为7.7时,COD去除率和浊度去除率分别达到最大为76.6%和99.9%;PAC投量为19.2 mg/L,pH为7.8时,COD去除率和浊度去除率最大值分别为64.4%和97.1%。经对最优条件进行验证,预测值与验证实验平均值接近。     

不同混凝剂处理松花江低温水

东北松花江地区冬季有将近6个月的冰封期,低温季节水源水处理难度大。为了保证东北地区冬季饮用水供应,研究几种混凝剂在处理冬季松花江低温水时的混凝效果。实验结果表明,NPAC1和NPAC2水解产物中具有较高的Alb和Alc成分,拥有较高的电中和、吸附和网捕卷扫性能,高效聚铝铁(PAF)水解产物Fe(OH)3具有比表面积大、吸附架桥作用较强的优点。这3种混凝剂无论是在控制出水浊度还是在对水体有机物去除能力方面均优于目前水厂所使用的PAC和聚合氯化铝铁(水厂PAF);NPAC2的投加量达到50 mg/L时,出水浊度达到最优;当混凝剂投加量达到50 mg/L时,NPAC1的浊度去除率逐渐超过NPAC2,剩余浊度低于3.0 NTU;NPAC1、NPAC2和PAF 3种混凝剂对有机物的去除能力大致相当,当混凝剂投加量为50 mg/L时,这3种混凝剂处理后的水的UV254的值均低于0.06,而水厂使用的2种混凝剂处理后的水的UV254仍高于0.1;结合其对浊度去除的情况,可以判断55 mg/L的投药量为NPAC1的最优投药点,PAF的最佳投药量为65 mg/L;投加适量的粉末活性碳可以有效地提高氨氮的去除率,当粉末活性炭的投加量为30 mg/L时,氨氮的去除率基本达到最大(51.27%)。表面负荷对混凝效果具有重要的影响,合理降低沉淀池的表面负荷对于提高出水水质具有重要作用。     

舟山高浊度海水混凝除浊研究

测定了舟山高浊度海水悬浮物的粒度分布,分析了高浊度海水自由沉降特性,选用氯化铁(FeCl)3、聚合氯化铁(PFC)、聚合硫酸铁(PFS)3种混凝剂,利用正交试验方法对高浊度海水进行混凝沉淀对比试验,采用极差分析方法研究了影响混凝效果的因素。试验结果表明:舟山海域悬浮物组成以粉砂为主,用自然沉降的方法是很难去除;各因素对浊度去除率影响的主次顺序均为:慢搅时间>慢搅速度>快搅时间>快搅速度;对于高浊度海水混凝除浊最佳水力条件为:快搅时间为2 min,快搅速度为300 r/min,慢搅时间为15 min,慢搅速度为60 r/min;聚合硫酸铁是较理想的絮凝剂,最佳投药量范围在15～25 mg/L,对浊度去除率高达99%以上。     

Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.     

壳聚糖复合粘土矿凝聚铜绿微囊藻的研究

对壳聚糖与天然粘土矿物海泡石复配凝聚水体中铜绿微囊藻进行了研究 ,结果表明 :在壳聚糖用量为0 5 6mg L、海泡石用量为 32mg L的情况下 ,藻个数由 1 94 4× 10 6 个 mL降为 1 38× 10 3个 mL ,去除率达到 99 93% ;浊度由 6 5NTU降到 0 1NTU ,去除率达 99 6 % ;叶绿素a去除率达 10 0 % (用常规方法无法检测到 )。实验还确定了最佳pH值范围是 4～ 8;并且探讨了壳聚糖的絮凝机理。