混凝-超滤处理径流雨水效果——以华南地区为例

采用超滤膜(UF)为核心,以混凝作为预处理措施,对混凝-超滤工艺处理径流雨水的特性和膜通量变化与污染现象进行了研究,并对聚合硫酸铁(PFS)单独混凝、UF、PFS-UF组合工艺进行了对比;在优化混凝基础上,考察了混凝-UF对常规水质指标及总磷、生物可同化有机碳(AOC)、可生物降解溶解性有机碳(BDOC)等生物稳定性指标的去除效果.结果表明,混凝可有效去除TOC、UV254和总磷,混凝剂投加量与污染物去除近似呈线性关系.各混凝剂除浊效能均良好.综合考虑混凝处理效率与经济性,实验采用混凝方案为10 mg·L-1的PFS.PFS、UF、PFS-UF工艺除浊率均在95%以上,PFS和UF对TOC和UV254的去除较为接近,采用PFS-UF可提高去除率13%—15%;PFS-UF处理后雨水的AOC、BDOC分别降低至61.8μg·L-1、0.19 mg·L-1,残余总磷可降至3.8μg·L-1,雨水生物稳定性明显提高.PFS、UF和PFS-UF对颗粒物的去除率分别达80.5%、99.6%和99.9%.膜通量的变化和SEM图分析表明,混凝在一定程度上减轻了UF膜污染;形成的凝胶层具有一定整体强度,水力清洗时易于清除,膜通量恢复较好;但同时凝胶层的产生也增大了透膜阻力,PFS-UF工艺的周期内膜通量衰减有增加的趋势.     

钢铁企业废水污染物形态分析及混凝深度处理试验研究

利用过滤试验与粒径分布试验分析了钢铁工业达标外排废水的各类污染物特征,结合正交试验对混凝处理效果及混凝工艺中各主要影响因素的影响情况进行研究。结果表明,废水中颗粒物主要以粗分散胶体和悬浮态物质为主,PAC／PAM联用对钢铁废水具有较好的处理效果,可有效降低主要影响废水回用的铁锰类污染物,还去除了大部分的有机物及磷类等污染物,各项出水水质指标均达到《城市污水再生利用工业用水水质》（GB／T19923—2005）所规定的循环冷却水回用水质标准。     

大功率中短波广播天线电磁辐射的预测与防护

随着城镇密集度越来越高,大功率电磁辐射设备如大功率中短波天线不可避免的与建筑越来越近,因而对室内的电磁环境污染逐步加剧。电磁辐射造成的危害通常包括对人体健康的危害(健康效应)和干扰其他电磁设备而造成严重后果(电磁干扰)。针对大功率中短波天线造成的电磁环境污染问题,提出一套远场条件下电磁辐射的预测方法并成功预测了一个典型大功率中短波天线群附近的拟建项目区域的电磁环境,在此基础上,提出有效的针对拟建项目的电磁防护方案。     

“混凝沉淀+纳米零价铁”处理印刷电路板生产废水中试研究

提出一种新纳米零价铁反应器(Nanoscale Zero-Valent Iron Reactor,简称NIR)及"混凝沉淀+纳米零价铁"处理工艺,通过实际生产废水进行中试,考察和研究该工艺和NIR技术处理江苏省某市印刷电路板(Printed Circuit Board,简称PCB)工业园区废水的效果。结果表明,此工艺对PCB生产废水中Cu、TP及COD Cr去除率分别可达到97.3%、73.7%、26%,其中Cu处理效果最佳;XRD结果表明,纳米零价铁(Nanoscale Zero-Valent Iron,nZVI)与PCB生产废水反应后含有γ-Fe2O3、Fe3O4、γ-FeOOH、CuO、Cu2O、Cu0等产物。"混凝沉淀+纳米零价铁"工艺处理废水时具有处理效果好、工艺耐冲击性能好、产泥量小、不易造成二次污染等优点。     

Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.     

Study on evaluation and optimization of ecological service efficiency of urban greenbelt system： A case study of Huai＇an ecological new town

通过运用生态服务效能指数的概念,选择5种指标因子（吸收二氧化硫量、吸收热量、蒸腾水量、涵养水源量、滞尘降尘量）构建了淮安生态新城绿地系统生态服务效能评估模型,并运用全排列多边形图示指标法,针对“现状条件”、“概念规划”、“控制性详细规划”、“理想状态”4种情景下的绿地系统进行了生态服务效能评价与预测．结果表明,4种不同的土地利用方式下,绿地系统生态服务效能综合指数分别为0．24、0．56、0．70和0．89,生态服务效能逐步改善．研究结果进一步表明,在“概念规划”和“控制性详细规划”两种情景下,应使城市绿地系统面积大于1200hm^2,采用复合式绿地结构并调整林地与草地面积的比例达到7：3,同时应保证本地植物指数大于70％,研究结果可为生态城市建设提供一定的参考．     

Optimum conditions for the formation of Al13 polymer and active chlorine in electrolysis process with Ti/RuO2-TiO2 anodes

A polyaluminum containing a high concentration of Al₁₃ polymer and active chlorine (PACC) was successfully synthesized by a new electrochemical reactor using Ti/RuO₂-TiO₂ anodes. PACC can potentially be used as a dual-function chemical reagent for water treatment. The obtained results indicated that the formation of Al₁₃ polymer and active chlorine, were the most active components in PACC responsible for coagulation and disinfection respectively. These components were significantly influenced by electrolyte temperature, current density, and stirring rate. It was observed that high electrolyte temperature favored the formation of Al₁₃. Increasing current density and stirring rate resulted in high current efficiency of chlorine evolution, thus favoring the generation of Al₁₃ and active chlorine in PACC. When the PACC (Al_T = 0.5 mol/L, basicity = 2.3) was prepared at the optimum conditions by electrolysis process, the Al₁₃ polymer and active chlorine in product reached above 70% of Al_T and 4000 mg/L, respectively. In the pilot scale experiment with raw polyaluminum chloride used as an electrolyte, PACC was successfully prepared and produced a high content of Al₁₃ and active chlorine products. The pilot scale experiment demonstrated a potential industrial approach of PACC preparation.     

舟山高浊度海水混凝除浊研究

测定了舟山高浊度海水悬浮物的粒度分布,分析了高浊度海水自由沉降特性,选用氯化铁(FeCl)3、聚合氯化铁(PFC)、聚合硫酸铁(PFS)3种混凝剂,利用正交试验方法对高浊度海水进行混凝沉淀对比试验,采用极差分析方法研究了影响混凝效果的因素。试验结果表明:舟山海域悬浮物组成以粉砂为主,用自然沉降的方法是很难去除;各因素对浊度去除率影响的主次顺序均为:慢搅时间>慢搅速度>快搅时间>快搅速度;对于高浊度海水混凝除浊最佳水力条件为:快搅时间为2 min,快搅速度为300 r/min,慢搅时间为15 min,慢搅速度为60 r/min;聚合硫酸铁是较理想的絮凝剂,最佳投药量范围在15～25 mg/L,对浊度去除率高达99%以上。     

紫外辐射对小球藻混凝效果作用途径探讨

针对藻类在常规水处理过程中难以被有效去除的现状,采用紫外辐射对藻类混凝过程进行强化处理.结果表明,随着紫外照射时间的增加,混凝后对藻细胞和浊度的去除均呈先上升后下降的趋势,并在照射50 min时达到最大值.PAC(聚合氯化铝)投加量为5 mg·L~(-1)时,照射样的除藻率和去浊率达到最大,分别比空白样高20.1%和18%左右.pH值在6~9范围内,紫外辐射强化混凝效果的变化较小.溶液pH=8、紫外照射50 min,混凝后的除藻率和去浊率分别达到了93.5%和90.6%.此时,藻细胞Zeta电位最大,同时释放出藻黏液,有利于混凝沉降.而当紫外照射超过60 min后,出现细胞膜破裂,胞内有机物渗出,使得溶液中的有机物浓度急剧上升,Zeta电位开始下降,不利于后续混凝的进行.     

原水性质对新型含Ca2+复合混凝剂混凝过程的影响

为了提高水处理效率,保证出水水质,需要开发新型高效混凝剂.本实验采用经过Ca2+改性的混凝剂针对不同水样进行混凝实验,考察了浊度、有机物去除、余铝和形成絮体性质.结果表明在纯颗粒物体系中,PACl(聚合氯化铝)和Al Cl3中加入的Ca2+对于浊度去除率无明显影响,在低投加量下能够有效降低沉后水中余铝浓度,Al Cl3做混凝剂,投加量0.10mmol·L~(-1)时,沉后水余铝浓度从0.15 mg·L~(-1)降低到0.10 mg·L~(-1).在腐殖酸体系中,混凝剂中的钙离子可明显降低腐殖酸分子的负电荷,降低沉后水余铝浓度以及增大絮体粒径.对于腐殖酸与蛋白质体系,当投加量为0.16 mmol·L~(-1)时,使用含有Ca2+的PACl做混凝剂时,钙离子的存在使得平衡时絮体粒径增加了大约50μm,可明显改善絮体的沉降性.碱性条件(pH=8.5)下改性混凝剂沉后水中DOC浓度降低0.2~0.6 mg·L~(-1),余铝降低0.4~0.7 mg·L~(-1).酸性条件(pH=5.5)下改性混凝剂沉后水DOC、余铝浓度无明显变化.