用电絮凝法处理乳品污水的实验研究

利用电凝聚法处理乳品污水 ,通过中试设备进行条件实验得出最佳的实验条件为 :电压 :1 5 .2 V;电流 :1 1 .2 A;p H值 :7.0 ;流量 :1 0 0 /L·h- 1 ;PAM:5 ppm。CODCr去除率可达 92 %     

化学法处理含酚废水的组合工艺系统和条件研究

采用化学法组合的三种工艺系统,对含酚废水进行了工艺条件的研究。结果表明,对于浓度<30mg/l含酚废水,采用氧化凝聚处理是有效的;而对于30～80mg/l含酚废水,选用氧化凝聚和吸附组合的工艺系统处理,能使排放水中酚和COD达标。     

Graphical strategies for design of evaporation crystallization networks for environmental wastewater applications

This paper introduces graphical strategies for the design of an evaporation/crystallization network for ternary wastewater environmental applications. Sources, sinks and other streams are located on a ternary composition diagram. While a source is any wastewater stream that has the potential to be recycled, a sink is any unit in the process that can accept sources. The proposed methodology is extremely simple to understand and implement, as it only requires basic solid-liquid phase equilibria data and uses lever arm principles to generate alternative process designs. Geometric constructions are carried out on the ternary composition diagram and the respective lever arms are used to determine intermediate flow rates in the evaporation/crystallization network. The relative locations and flow rates of the sources and sinks under consideration, as well as the unique shape of the solid-liquid equilibrium, drive the design of the separation (via evaporation/crystallization) network. Some generic structures are proposed for a typical evaporation and crystallization network. Once the general problem statement has been defined, special cases consisting of a single source-single sink, single source-two sinks and two sources-single sink are described. These special cases are representative of commonly occurring industrial wastewater design problems. Several graphical insights are listed that allow one to represent evaporation and crystallization operations on a ternary triangular composition diagram and avoid mathematical complexity. The possibility of bypassing a part of the initial feed streams is also considered. Certain feasible composition regions are identified on the ternary composition diagram for cases dealing with multiple sources and sinks. The methodology is useful in pre-screening and eliminating certain sources/sinks and is readily applicable to cases with lower number of sources and sinks. A case study involving the ammonium nitrate manufacturing process is included to demonstrate the broad applicability and value of the proposed approach.     

粉煤灰、硫铁矿渣制备聚铁铝硅混凝剂及应用研究

采用粉煤灰、硫铁矿渣为原料 ,设计出一条新的工艺流程制备新型无机高分子絮凝剂聚铁铝硅盐 (PAFCSi)。通过其形态分布的研究和对模拟水样的处理得到了产品的最优性能指标。对两种废水的处理结果表明产品的混凝效果明显优于市售混凝剂聚铝 (PAC)和聚铁 (PFC)。     

印刷线路板厂含铜污泥固化处理工艺研究

研究采用水泥作固化基材固化处理某印刷线路板厂酸性废水用石灰混凝所产生的含铜、锡、金的污泥 ,对固化块在不同 pH的水中重金属Cu2 +的浸出实验结果表明 :水泥固化处理该混凝污泥效果良好 ,控制合适的条件 ,可得到混合性能好、初凝时间适当、抗压强度较好的固化块。Cu2 +的浸出率低于允许浸出浓度。混凝过程中加入硫脲硅酸钠等助剂 ,可提高固化效果。研究还对几种不同配比的固化块抗压强度进行了探讨。     

染料废水处理的工艺实验研究

采用中和 -电解 -臭氧氧化工艺首先对高浓度染料生产工艺废水进行预处理 ,再与低浓度废水混合混凝、吸附处理。经电解正交实验设计及工艺实验确定本研究工艺实验为 :废水pH中性、电解条件为电解时间 2h ,电解电压10V ,电流密度 0 0 18A cm2 、O3氧化时间 2h、混凝剂 1#、3#浓度均为 2 5 0mg L、炉渣吸附时间 30min。总脱色率与CODCr总去除率均达 99% ,可以达标排放     

对硝基氯苯废气治理研究

冷却凝固法处理含对硝基氯苯废气 ,用水作冷却剂直接冷却、冷凝、凝固、凝华废气中对硝基氯苯蒸气 ,废气中的升华物、粉尘和水蒸汽同时被分离 ,处理后的废气达到很高的净化程度。在此根据实验结果 ,得到在水蒸汽存在时对硝基氯苯蒸气分压和温度之间的关系     

聚合铝的凝聚絮凝特征及作用机理

采用不同碱化度B(OH/Al)值的聚合铝和AlCl_3对高岭土悬浊液进行凝聚絮凝实验,同时测定电泳度及表面吸附特征,结合不同铝盐的化学形态分布,探讨聚合铝的高效凝聚作用原理.并求得表面吸附覆盖率,电位变化与形态分布间的定量关系,绘出聚合铝的凝聚区域图,对阐明聚合铝的作用机理提供了实验依据.     

皮革和毛皮加工废水处理技术

采用混凝沉淀-酸化水解-悬挂链曝气-生物接触氧化组合工艺处理皮革和毛皮加工生产废水。实验结果表明;进水COD为2400mg/L,处理后出水COD≤100mg/L,去除率≥95.8%。各项水质指标均稳定地达到了GB8978-96污水综合排放一级标准。     

PASS混凝去除给水腐植酸的研究

用所研制的聚硅硫酸铝对含腐植酸原水进行了混凝处理 ,研究了投加量、pH值等对腐植酸去除效果的影响 ,探讨了PASS对腐植酸的混凝去除机理 ,并作了经济分析