铁屑还原－鼓风氧化－石灰凝沉法脱除硫酸生产废水中的砷

比较了硫酸生产废水的几种除砷方法，认为铁屑还原－鼓风氧化－石灰凝沉工艺是可行的，此法具有处理量大、处理效果好、运行费用低等优点。     

含氯苯和对邻硝基氯苯农药废水的混凝—氧化预处理

采用混凝沉淀 -芬顿试剂氧化对含氯苯和对邻硝基氯苯农药废水进行预处理 ,探讨了不同条件下农药废水的处理效果。结果表明 ,废水经混凝处理后可去除 46 .2 %的COD ,BOD5/COD值有一定程度的提高 ;废水经芬顿试剂氧化处理后可去除 5 0 .9%的COD ,BOD5/COD值可从 0 .0 4提高到 0 .1     

炼厂隔油后污水的有机构成及混凝处理

采用GC/MS技术分析了炼厂隔油后污水的有机组成,并研究了不同混凝剂处理污水的效果,以及对有机构成的影响。结果表明,隔油后污水中的有机物质主要是C6–C8,其中酚类物质的含量最高;PAM和PAC混凝处理隔油后污水,可使污水中的有机物质总浓度及各物质的相对比例均发生变化,PAM降低烃类物质的效果好于PAC,而后者降低酚类物质的效果好于前者;在PAC处理污水时,同时投加少量活性炭可有效改变PAC脱除COD的性能。     

混凝沉淀-二氧化氯氧化法处理印染废水

介绍了混凝沉淀－ＣｌＯ２氧化法处理印染废水的反应机理,工艺流程,处理效果及经济效益分析。在２个工厂的实际应用表明,该法工艺简单,操作方便,投资少,效果好。     

石灰-聚铁法处理硫酸厂废水的研究

对各种处理硫酸厂废水的方法者了探讨,选择了以百石灰和聚合硫酸铁为药剂去除废水中砷,硫等污染物的方法。该法工艺简单,混凝剂投加量少,运行费用低,处理后的废水可达到排放标准。     

混凝工艺去除重金属-腐殖酸有效性研究

考查了混凝剂对腐殖酸(HA)和重金属镉的络合体的去除效果。通过与混凝剂分别对腐殖酸和镉的单一去除比较发现:混凝剂对络合体的去除提高了HA和镉的去除率。通过调节不同环境因素发现:增加混凝剂用量,HA的去除率会在达到峰值后不再增加,而镉的去除率会在达到峰值后有所下降;提高p H值会加快HA的去除达到峰值且提高镉的去除率;腐殖酸溶液初始浓度越高,腐殖酸和镉的最终去除率越高;离子强度越高,HA和镉的最终去除率越低。     

水质安全的动态超声波强化混凝除藻水处理试验研究

超声波辐射能够破坏蓝藻气囊,在水处理工艺中达到强化蓝藻混凝沉淀的效果.然而不适当的超声处理会进一步破坏蓝藻细胞,导致胞内毒素大量释放,加重水质污染负荷.本研究为获得水质安全的超声波强化混凝沉淀蓝藻水处理方法,采用频率40~120 k Hz的超声波辐射蓝藻水,考察处理后蓝藻混凝沉淀去除效果及藻毒素释放情况.结果表明,频率68~120 k Hz、能量密度59.1~186.4 W·L-1的静态超声波作用10~15 s后进行混凝沉淀,藻类去除率达98%以上,且频率越高效果越好;然而各频率静态超声波作用5 s以上均会导致藻细胞内藻毒素释放.采用内衬吸声棉及动态超声方式,频率120 k Hz、能量密度38.5~196.6 W·L-1超声波作用7.5~30 s后,可避免胞内藻毒素释放,且能去除水中溶解性藻毒素18.7%~30.7%,混凝沉淀后藻类去除率97.0%以上,其它有机物也降低.     

Effect of AlCl3 concentration on nanoparticle removal by coagulation

In recent years, engineered nanoparticles, as a new group of contaminants emerging in natural water, have been given more attention. In order to understand the behavior of nanoparticles in the conventional water treatment process, three kinds of nanoparticle suspensions, namely multi-walled carbon nanotube-humic acid (MWCNT-HA), multi-walled carbon nanotube-N,N-dimethylformamide (MWCNT-DMF) and nanoTiO₂-humic acid (TiO₂-HA) were employed to investigate their coagulation removal efficiencies with varying aluminum chloride (AlCl₃) concentrations. Results showed that nanoparticle removal rate curves had a reverse “U” shape with increasing concentration of aluminum ion (Al^3 +). More than 90% of nanoparticles could be effectively removed by an appropriate Al^3 + concentration. At higher Al^3 + concentration, nanoparticles would be restabilized. The hydrodynamic particle size of nanoparticles was found to be the crucial factor influencing the effective concentration range (ECR) of Al^3 + for nanoparticle removal. The ECR of Al^3 + followed the order MWCNT-DMF > MWCNT-HA > TiO₂-HA, which is the reverse of the nanoparticle size trend. At a given concentration, smaller nanoparticles carry more surface charges, and thus consume more coagulants for neutralization. Therefore, over-saturation occurred at relatively higher Al^3 + concentration and a wider ECR was obtained. The ECR became broader with increasing pH because of the smaller hydrodynamic particle size of nanoparticles at higher pH values. A high ionic strength of NaCl can also widen the ECR due to its strong potential to compress the electric double layer. It was concluded that it is important to adjust the dose of Al^3 + in the ECR for nanoparticle removal in water treatment.     

臭氧+曝气生物滤池深度处理工艺试验研究

针对某污水厂出水不达标的情况,本研究采用臭氧(O3)和曝气生物滤池(BAF)组合工艺对其进行深度处理.结果表明,当采用两级臭氧+曝气生物滤池工艺时,出水COD在31～46 mg/L,色度在13～29倍,均达到一级A排放标准.在最佳运行条件下,臭氧氧化使相对分子质量大于50 000的有机物含量减少10％,小于1 000的有机物含量增加14％.曝气生物滤池工艺使相对分子质量小于1 000的有机物含量降低了24％.