生态补偿机制及模式研究进展

详细综述了生态补偿机制概念、理论基础、补偿标准、补偿模式及国内外生态补偿实践经验等方面的研究进展。发现外部性的内部化是生态补偿的关键和环境经济学基础,其核心问题包括：谁补偿谁,补偿多少以及如何补偿。通过回顾美国、欧洲发达国家与中国、拉丁美洲发展中国家在实施生态补偿过程中采取的各种措施,发现生态学与经济学理论已经逐渐融入生态补偿的研究之中。在此基础上,指出了国内生态补偿的科研和实践中有待解决的问题,最后提出了包括补偿的法律机制、补偿经济标准、政策制定等方面的建议。     

Effectiveness of fluidized pellet bed for removing soluble contaminants

Fluidized pellet bed (FPB) has been successfully applied in water and wastewater treatment. However, the removal mechanism of contaminants especially the soluble ones, is still unclear. This study aimed to evaluate the e ectiveness of FPB reactor for removing soluble contaminants from synthetic wastewater. By only coagulation through jar test operation with addition of polyaluminium chloride (PACl) as primary coagulant and polyacryamide (PAM) as coagulant-aid, the removals of soluble chemical oxygen demand (COD), total phosphorus (TP), and NH4 +-N were found to be only 2.2%–7.5%, 5.7%–25.5%, and 9.9%–18.5%, respectively. However, by FPB operation under the same dosage of coagulants, these values increased to 82.7%, 37.2%, and 50%, indicating that the formation of pellets in the FPB e ectively enhanced the removal of soluble contaminants. By careful comparison of the settleablility and filterability of the pollutants after coagulation, the originally soluble contaminants could be divided into three groups, namely: (1) coagulated-andsettleable, (2) coagulated-but-nonsettleable, and (3) uncoagulable. It was found that not only the first two groups but also a large part of the third group could be e ectively removed by FPB operation. However, the mechanism for the removal of the uncoagulable pollutants by FPB operation still needs further investigation.     

分形理论在混凝研究中的应用

针对絮凝体的形成具有自相似性和标度不变性分形特征,将分形理论应用于混凝领域,从絮凝体结构模型、分形结构模式以及分维的研究方法三个方面对混凝研究进行了论述,从而为混凝的研究提供了新的工具.     

高锰酸钾预氧化混凝去除水中颤藻的试验研究

采用KMnO4对颤藻氧化,再接种到培养液中进行培养,根据达到对数生长期的时间,考察KMnO4预氧化对颤藻生长活性的影响,并通过显微镜观察藻细胞的破裂情况,同时采用聚合氯化铝(PAC)对KMnO4预氧化水体进行混凝处理,结果表明:KMnO4对颤藻有很好的氧化效果,不同浓度KMnO4对颤藻生长活性的抑制时间不同;在投加量为2 mg/L以下时,预氧化没有破坏颤藻的细胞结构;模拟含藻水在KMnO4预氧化后采用PAC混凝优于单加PAC的除藻效果.     

Assessment of the effect of technical and management characteristics on the frequency of release from piping: An application to a gas storage facility

The assessment of the frequencies of release from piping due to losses of containment is an essential step in the preparing Safety Reports, drawn up as required by the so-called “Seveso” Directive. These are usually calculated starting from the frequencies of random rupture included in international databases and are not plant-specific, furthermore, the quantification of the effect of the safety management system of the facility is not easy. A simple and flexible approach quantifying technical and management characteristics of the plant has been proposed by Milazzo and co-workers in 2010; it is based on the modification of the frequency taken from literature, through the use of the percentages of failure causes actually possible in that plant, and the judgment about their management. The data about the failure causes are taken from the literature and modified by using corrective factors to adapt them to the industrial context. To make possible the application of the method to a large number of major-hazard industry types, some aspects of the approach needed to be improved; these have been identified during a development project coordinated by RINA Consulting, on behalf of Saipem, with the collaboration of the University of Messina. The improvement of the approach focused on two main points, the development of a method to calculate the corrective factors for the failure causes associated with corrosion and erosion phenomena and the strengthening of the methodology for the formulation of the judgment about the safety management. This paper illustrates the fully improved method, as well as an application to a typical gas storage plant.     

Experimental study on detonation flame penetrating through flame arrester

In-line detonation flame arresters are important safety apparatus to prevent group tank fires caused by the spreading of fire through vapor connection lines. In this study, a DN50 experimental apparatus aimed at the detonation flame penetration characteristics and failure mechanisms in a flame arrester was set up, and a series of experiments were carried out with 6.6% C2H4 and air mixture. Pressure, and velocity of flame penetrating through flame arrester housing and filters were analyzed. Experimental results showed that the attenuation of pressure and velocity was proportional to the thickness of the filters. Two failure modes of the fire-extinguishing process in the flame arrester were captured directly with a high-speed camera. In Mode I, the detonation flame could go straight through the flame arrester filters when the filters were too thin. In Mode II, when the filters were not sufficiently thick, the remained shock wave pressure of detonation flame was still several times of the initial pressure and could rise sharply at the downstream contraction section, resulting in that the flammable gas at the downstream transition section could be compressed and reignited even the flame had been extinguished by filters. These conclusions are helpful to reveal the nature of failure modes of fire-extinguishing process and design flame arresters with high fire-resisting performance by structure improved.     

PAN dust explosion inhibition mechanisms of NaHCO3 and Al(OH)3

We investigate the PAN dust explosion inhibition behaviors of NaHCO₃ and Al(OH)₃ in a 20 L spherical explosion system and a transparent pipe explosion propagation test system. The results show that, in the standard 20 L spherical explosion system, the highest PAN dust explosion concentration is 500 g/m³, the maximum explosion pressure is 0.661 MPa, and the maximum explosion pressure increase rate is 31.64 MPa/s; adding 50% NaHCO₃ and 60% Al(OH)₃ can totally inhibit PAN dust explosion. In the DN0.15 m transparent pipe explosion propagation test system, for 500 g/m³ PAN dust, the initial explosion flame velocity is 102 m/s, the initial pressure is 0.46 MPa, and the initial temperature is 967 °C; adding 60% NaHCO₃ and 70% Al(OH)₃ can totally inhibit PAN dust explosion flames. Through FTIR and TG analyses, we obtain the explosion products and pyrolysis patterns of the explosion products of PAN dust, NaHCO₃, and Al(OH)₃. On this basis, we also summarize the PAN dust explosion inhibition mechanisms of NaHCO₃ and Al(OH)₃.     

强化混凝组合工艺处理微污染水源水研究

采用静态烧杯实验考察了强化混凝组合工艺解决某水厂出水COD_(Mn)、色度及铝含量超标的问题。结果表明,高锰酸盐与次氯酸钠联合预氧化,配合使用少量黏土、粉末活性炭混合物强化混凝,可以在氯化物不超标的情况下,使出水COD_(Mn)、色度及铝含量得到有效控制。     

吉非罗齐在热活化过硫酸盐体系中的降解机制研究

以降血脂药物吉非罗齐(GEM)为目标污染物,研究其在热活化过硫酸盐体系中的降解机制.结果表明,GEM的降解过程符合准一级反应动力学规律,增加过硫酸盐初始浓度或升高反应溶液温度都可以显著提高GEM的降解速率常数(kobs),其反应的表观活化能Ea为133.14k J·mol~(-1).酸性和中性条件下GEM的降解效果要好于碱性条件.自然水体中的腐植酸(HA)和HCO_3~-对GEM的降解有明显的抑制作用.自由基清除实验表明,在酸性和中性条件下,SO_4~(·-)对GEM的降解起主导作用,而在碱性条件下,HO·成为体系主要的氧化物种.利用HPLC-MS/MS技术共检测到11种中间产物,推测GEM的降解路径涉及苯环的羟基化和醛基化反应、苯环侧链的环化作用和脱羧反应以及醚支链的断裂.     

Enterobacter sp.CV-v对孔雀石绿的脱色特性及机理研究

采用单因素实验研究了各种操作因素对菌株Enterobacter sp.CV-v降解孔雀石绿的影响.结果表明,在供试碳源中,葡萄糖对脱色的促进效果最为显著,而供试氮源中,酵母粉对脱色的促进效果最优;同时,供试金属离子中,锰离子对脱色的促进效果最优.在p H=3.0~10.0、温度20~50℃之间时,菌株CV-v对孔雀石绿的12 h脱色率在90%以上.此外,该菌株可在6 h内完全脱色浓度低于500 mg·L-1的孔雀石绿.动力学实验结果表明,该菌株对孔雀石绿脱色的动力学数据与一级动力学模型拟合度最好(R2=0.9755).酶分析实验结果表明,锰过氧化物酶和孔雀石绿还原酶可能与菌株CV-v降解孔雀石绿相关.此外,代谢产物分析实验结果表明,菌株CV-v降解孔雀石绿的主要产物为二甲氨基二苯甲酮和4-羟基-N,N-二甲基苯铵.