飞机蒙皮用含氟聚氨酯涂层老化原因分析

选用飞机蒙皮常用的含氟聚氨酯涂层体系为研究对象,结合飞机服役环境的主要特点,开展了实验室模拟加速老化试验研究,并利用电化学阻抗谱对老化试验后的涂层进行了表征.结果表明,紫外线仅对涂层的表面结构产生影响,紫外试验后的涂层电阻下降较慢.在紫外-盐雾循环试验中,紫外线引起涂层表面结构发生变化,涂层的耐水性变差,水更快地进入涂...     

太阳跟踪反射聚光户外加速试验研究

太阳辐射是引起有机材料老化的最主要原因.由于拉萨高原地区的太阳辐射年总量比内地同纬度高出约1倍,在拉萨进行有机涂层样品的户外暴露试验,其老化速度可大大提高.通过在拉萨试验站对4种常用的有机防护涂层开展太阳跟踪反射聚光户外加速试验和自然暴露试验对比研究,优选出了环境适应性好的材料,并验证了其加速性.     

雷达吸波涂层海洋大气环境适用性试验研究

目的 分析一种雷达吸波隐身涂层在海洋大气自然环境下性能的变化规律。方法 对12个月不同阶段涂层的常规物理性能和电性能进行检测,其中常规物理性能包括宏观形貌、金相形貌、微观性能、附着力、抗冲击强度和红外光谱。结果 从宏观形貌看,涂层明度和色差值呈上升趋势,12个月明度增加1.22,色差值增加2.91,颜色向绿色和蓝色发展,失光率先增大、后减小,最大失光率为9个月时的34%。涂层附着力和试验时间呈现非线性关系,6个月时,附着力降低了18%,12个月时增大了24%。涂层在2～18GHz的频率范围内,吸波曲线大体呈“U”形,最低反射率随时间向低频方向偏移。涂层金相形貌、微观性能、抗冲击强度和红外光谱特征总体变化不明显。结论 在1a内,自然海洋大气环境对雷达吸波隐身涂层常规物理性能和电性能产生了一定影响,但在试验时间相对较短情况下,海洋大气环境对涂层老化的影响作用尚未充分显示,需要结合更长周期的试验数据进一步分析。     

包膜材料对土壤酶活性的影响

以自然资源＂水冬瓜果油＂为包膜材料,利用盆栽试验,共设5个处理,研究在有菊花吸收养分的情况下,水冬瓜（Idesia polycarpa maxim.var.vestita dies）油包膜材料在土壤中的降解性能及对土壤酶活性的影响。结果表明：水冬瓜油包膜材料随土壤含水量的增加,降解速率加快。种植菊花的土壤过氧化氢酶、蔗糖酶、脲酶活性也呈现先上升、后下降的趋势。在土壤含水量为30%时,包膜材料半衰期只有62 d;在处理3（果油85%＋调理剂15%）中,土壤过氧化氢酶、土壤蔗糖酶和脲酶数量增加最多。因此,水冬瓜果油85%＋调理剂15%和土壤含水量30%,有利于土壤酶活性的提高,从而加快包膜材料的降解速度。     

广东省家具行业基于涂料类型的VOCs排放特征及其环境影响

为掌握不同涂料类型废气之间的排放差异,基于溶剂型、水性、溶剂型辐射固化（ultra-violet,UV）、水性UV和粉末等不同涂料类型,选取典型家具制造企业进行废气采样,对比研究不同涂料类型废气挥发性有机物（volatile organic compounds,VOCs）排放浓度和组分差异,并对不同涂料类型废气的臭氧生成潜势（ozone formation potential,OFP）和二次有机气溶胶生成潜势（secondary organic aerosol formation potential,SOAFP）进行分析.结果表明,溶剂型涂料废气的总挥发性有机化合物（total volatile organic compound,TVOC）浓度、OFP和SOAFP均高于水性、溶剂型UV、水性UV和粉末涂料废气.不同涂料类型有组织废气VOCs浓度水平和组成差异较大.溶剂型涂料和溶剂型UV涂料废气以芳香烃和含氧挥发性有机物（oxygenated volatile organic compounds,OVOCs）为主,芳香烃的占比分别为41.91%~60.67%和42.51%~43.00%,OVOCs的占比分别为24.75%~41.29%和41.34%~43.21%.水性涂料、水性UV涂料和粉末涂料废气中VOCs占比最高的是OVOCs,占比分别为54.02%~62.10%、55.23%~64.81%和42.98%~46.45%.溶剂型涂料废气的主要组分为苯乙烯（14.68%）,水性涂料废气的主要组分为甲缩醛（14.61%）,溶剂型UV涂料和水性UV涂料废气的主要组分均为乙酸丁酯（15.36%和20.56%）,粉末涂料废气的主要组分是3-乙氧基丙酸乙酯（20.19%）.芳香烃对溶剂型涂料和溶剂型UV涂料废气的OFP贡献最大,分别为79.84%和80.32%.水性涂料和水性UV涂料废气OFP的主要贡献者是芳香烃（51.48%和36.71%）和OVOCs（42.30%和41.03%）.芳香烃（43.46%）、OVOCs（28.06%）和烯烃（25.24%）是粉末涂料OFP的主要贡献者.芳香烃是溶剂型涂料、水性涂料、溶剂型UV涂料、水性UV涂料和粉末涂料废气SOAFP的绝对贡献者,占比均超过99%.     

悬浮种衣剂生产中对环境影响的研究

通过对悬浮种衣剂不同程度毒性的原药和各种助剂的筛选、生产中废水处理和周围土壤有效保护等方面的研究,提出采用物理、化学和生物等方法,进行预防和消除悬浮种衣剂生产中存在对环境不利的安全隐患和危害人们生活和健康的因素。但操作不当和预防意识弱,会给接触者带来身体健康的危害,采取相应的预防措施,能消除危害隐患,使接触者的身体健康得到保障。指出有效助剂不仅能稳定悬浮种衣剂的悬浮度,还能起到增加剂型药效和环境保护的作用,研究表明悬浮种衣剂是环境友好型农药制剂。     

Effect of bioethanol and thermal barrier coating on the performance of dual fuel engine operating on Honge oil methyl ester (HOME) and producer gas induction

Alternative fuels have numerous advantages compared to fossil fuels as they are renewable, biodegradable; provide energy security and foreign exchange saving besides addressing environmental concerns and socio-economic issues as well. Renewable fuels can be used predominantly as fuel for both transportation and power generation applications. Improved engine performance with reduced engine exhaust emissions is a major research objective in engine development. Today, the use of biomass derived producer gas is more relevant for addressing rural power generation and is a promising technique for controlling both nitric oxide (NO_x) and soot emission levels. In view of this, exhaustive experiments on the use of Honge oil methyl ester (HOME)–Producer gas in a dual fuel engine have been carried out with an intension of improving its fuel efficiency. This paper mainly presents results on a single cylinder four stroke direct injection diesel engine operated in dual fuel mode using HOME–Producer gas combination with and without bio-ethanol addition and thermal barrier coating (TBC). Further, the results were compared with diesel–producer gas mode of operation. Experimental investigation on dual fuel operation using HOME+5% bioethanol (BE5)–Producer gas operation with TBC showed 12.35% increased brake thermal efficiency with decreased hydrocarbon and carbon monoxide emissions and increased NO_x emission levels compared to HOME–Producer gas mode of operation.     

NdFeB磁体表面环保型Zn-Al涂层的盐雾腐蚀行为

目的 研究NdFeB磁体表面环保型Zn-Al涂层在盐雾环境中的腐蚀行为。方法 采用SEM、XRD、EDS、拉曼光谱、傅里叶变换红外光谱等对Zn-Al涂层的形貌、物相、成分结构进行分析。通过电化学曲线探究Zn-Al涂层在盐雾环境中的腐蚀机理。结果 在NdFeB磁体表面制备的环保型Zn-Al涂层的耐盐雾腐蚀时间不少于1 000 h。在盐雾腐蚀环境中,Zn-Al涂层表面逐渐被白锈覆盖,失去金属光泽,腐蚀至1 126 h时,Zn-Al涂层表面出现红色锈点,涂层微观组织呈蜂窝状结构,并出现微裂纹。腐蚀产物由Zn_(5)(OH)_(8)Cl_(2)·H_(2)O、Al_(9)SiAl_(12)(OH)_(18)(AlO_(4))(Si_(5)O_(16))Cl、Fe_(2)O_(3)和极少量的Zn、Al组成。腐蚀前期,Zn-Al涂层表面的钝化膜、硅烷膜起保护作用;随腐蚀进行,膜层破坏暴露出片状金属粉,金属粉活化,涂层发挥牺牲阳极保护作用;腐蚀后期,腐蚀介质通过涂层微裂纹穿透涂层至磁体,涂层牺牲阳极的保护作用和物理屏蔽保护作用显著减弱,直至失效。结论 环保型Zn-Al涂层可显著提高NdFeB磁体的耐中性盐雾腐蚀性能。     

Functional flax fiber with UV-induced switchable wettability for multipurpose oil-water separation

● A PAA-ZnO-HDTMS flax fiber with UV-induced switchable wettability was developed. ● The property of flax fiber could be switched from hydrophobicity to hydrophilicity. ● The mechanism of the acquired UV-induced switchable wettability was discussed. ● The developed flax fiber was successfully used for multipurpose oil-water separation. The large number of oily wastewater discharges and oil spills are bringing about severe threats to environment and human health. Corresponding to this challenge, a functional PAA-ZnO-HDTMS flax fiber with UV-induced switchable wettability was developed for efficient oil-water separation in this study. The developed flax fiber was obtained through PAA grafted polymerization and then ZnO-HDTMS nanocomposite immobilization. The as-prepared PAA-ZnO-HDTMS flax fiber was hydrophobic initially and could be switched to hydrophilic through UV irradiation. Its hydrophobicity could be easily recovered through being stored in dark environment for several days. To optimize the performance of the PAA-ZnO-HDTMS flax fiber, the effects of ZnO and HDTMS concentrations on its switchable wettability were investigated. The optimized PAA-ZnO-HDTMS flax fiber had a large water contact angle (~130°) in air and an extremely small oil contact angle (~0°) underwater initially. After UV treatment, the water contact angle was decreased to 30°, while the underwater oil contact angle was increased to more than 150°. Based on this UV-induced switchable wettability, the developed PAA-ZnO-HDTMS flax fiber was applied to remove oil from immiscible oil-water mixtures and oil-in-water emulsion with great reusability for multiple cycles. Thus, the developed flax fiber could be further fabricated into oil barrier or oil sorbent for oil-water separation, which could be an environmentally-friendly alternative in oil spill response and oily wastewater treatment.     

高性能防腐蚀涂料GFT—1及在环保装备中的应用

本文概述了环保装备中严重的腐蚀问题 ,高性能防腐蚀涂料的发展及应用前景。介绍了高性能防腐蚀涂料GFT -1的特性及其在环保行业中的应用范例。