纳米TiO2添加剂对DMDF发动机大负荷燃烧及PM排放影响的试验研究

在一台电控增压中冷四缸柴油机的进气道上加装一套电控喷射装置,使其运行柴油/甲醇双燃料(DMDF)模式.研究了甲醇中Ti O_2添加剂的添加量及同一添加剂添加量在不同甲醇分散系喷射量时对发动机大负荷工况的燃烧和颗粒物(PM)排放的影响.结果表明,在甲醇中添加适量(30和100 mg·kg~(-1))的纳米Ti O_2能够使爆发压力升高,对燃烧有一定的促进作用,但添加过量(100 mg·kg~(-1))会对燃烧产生不利影响.加入纳米Ti O_2后,干炭烟烟度排放和积聚态颗粒数明显降低,在添加剂添加量为1000 mg·kg~(-1)时,最大降幅分别达到26.8%和29.4%,而核态颗粒物排放变化不大.在相同添加剂添加量下,增加甲醇分散系替代率R_m会使放热始点后移,放热更加集中,爆发压力增大,干炭烟烟度和颗粒物排放均大幅度降低.在添加剂添加量为100 mg·kg~(-1)时,与R_m=10%相比,R_m=40%时爆发压力增加0.94 MPa,放热率峰值增加53.5%,烟度、核态颗粒数、积聚态颗粒数和颗粒物总数的降幅分别达66.9%、42.3%、67.0%和58.0%.     

基于静态特征和动态行为的火灾检测模型

为实时准确地检测视频监控的火灾信号,减少火灾误报,提出1种基于静态特征和动态行为的火灾检测方法.利用改进的Faster RCNN检测模型,根据可疑火灾区域的颜色特征和空间特征对其进行目标检测和特征降维,与传统的Faster RCNN相比平均检测精度提升5％;利用ILSTM对连续帧中的特征进行累加,对短期内是否发生过火灾...     

北京地区PM10与秸秆燃烧排放单颗粒对比分析

采用场发射带能谱扫描电镜(FESEM/EDS)法分析北京怀柔地区PM10与秸秆燃烧排放颗粒的形貌特征和成分差异.结果显示:秸秆燃烧后排放颗粒物多为大粒径颗粒,成分上都含S、Cl和K元素.含有生物质燃烧标志元素K的PM10颗粒物多为含Si、Al和Na元素的燃煤飞灰和矿物颗粒,与秸秆燃烧排放颗粒组成化学元素差异明显.据此推...     

锌精炼铅塔燃烧系统烟气温度模糊控制研究

针对锌精馏铅塔动态过程中的非线性、非最小相位特征、不稳定性、时滞和负荷干扰,基于模糊控制策略下给出了锌精馏铅塔燃烧系统新的控制方法.运用模糊控制系统对锌精馏铅塔的烟气温度进行仿真研究和实时控制结果表明,该研究所设计的模糊控制器能够克服许多干扰因素,产生了良好的控制效果.     

岩体开挖卸荷过程力学特性分析

基于岩体开挖卸荷过程中力学参数变化理论的分析研究,建立卸荷岩体有限元分析模型,运用ADINA有限元分析软件对岩体进行一维卸荷数值仿真研究。根据有限元数值分析计算成果得到岩体力学参数与主卸荷方向累计开挖卸荷量间的变化关系曲线。结果表明:岩体开挖卸荷过程中,岩体力学参数变形模量、泊松比、粘聚力和内摩擦角等呈现出随开挖卸荷量的变化而发生变化的特征,随卸荷量的增大有减小的趋势,但它们不是从初始值一直减小到零,而是随卸荷量的增大减小到一定的量值后,岩体的裂隙张开、结构面的扩展到一定的程度,岩体的力学参数保持一定的量级不再减小。     

Comparative on Causes and Accumulation of Selenium in the Tree-rings Ambient High-selenium Coal Combustion Area from Yutangba, Hubei, China

Toxic trace elements emitted during coal combustion are the main sources of air pollution. They are released into the atmosphere mainly in the forms of fine ash, smoke and flue, and thus adversely affect plant, animal and human health. Selenium is one of toxic and the most volatile in coal. Large amount of atmospheric emission of selenium, as well as selenium present and scrubber stockpiles in ash may create serious environmental problems. In the paper, on the basis of investigating the abundance and distribution of selenium in plant-rings during recent 20 years, the bioaccumulation of selenium is explained that selenium in plant, which were collected from the village of selenium-rich coal combustion, is much higher than that in plants collected away from the village of selenium-rich coal combustion. The main origins of selenium are selenium-rich coal combustion and high-selenium rock weathered. The selenium recycle by food chain and selenium will accumulate and redistribute in environments.     

Study of Trace Elements and Soot in Aerosols from a Coal-Fired Power Plant in Northern Vietnam

Two measurement campaigns were conducted in two sampling sites, An Thinh and Duy Minh, in northern Vietnam during the months of November–December 2000 and November 2001–February 2002 in order to investigate the extend of the particulate air pollution from the Pha Lai coal fired power plant. Fine particle samples were analyzed by Energy Dispersive X-Ray Fluorescence spectrometry and soot samples were analyzed by reflectometer. The result showed that high concentration of soot and elements mostly coincided with the air masses originating from the power plant. Sea spray aerosol was found to be the major source of chlorine at both sites. Ratios of specific elements and principal component analysis (PCA) revealed that coal combustion was the main contributor to the air pollution at both sites. PCA also indicated that there were other sources responsible for the elements emission, probably the influence of long distance transport and Asian Brown Cloud.     

Results of An Indoor Size Fractionated PM School Sampling Program in Libby, Montana

Libby, Montana is the only PM_2.5 nonattainment area in the western United States with the exceptions of parts of southern California. During January through March 2005, a particulate matter (PM) sampling program was conducted within Libby’s elementary and middle schools to establish baseline indoor PM concentrations before a wood stove change-out program is implemented over the next several years. As part of this program, indoor concentrations of PM mass, organic carbon (OC), and elemental carbon (EC) in five different size fractions (>2.5, 1.0–2.5, 0.5–1.0, 0.25–0.5, and <0.25 μm) were measured. Total measured PM mass concentrations were much higher inside the elementary school, with particle size fraction (>2.5, 0.5–1.0, 0.25–0.5, and <0.25 μm) concentrations between 2 and 5 times higher when compared to the middle school. The 1.0–2.5 μm fraction had the largest difference between the two sites, with elementary school concentrations nearly 10 times higher than the middle school values. The carbon component for the schools’ indoor PM was found to be predominantly composed of OC. Measured total OC and EC concentrations, as well as concentrations within individual size fractions, were an average of two to five times higher at the elementary school when compared to the middle school. For the ultrafine fraction (<0.25), EC concentrations were similar between each of the schools. Despite the differences in concentrations between the schools at the various fraction levels, the OC/EC ratio was determined to be similar.     

水平管内不同煤质煤尘爆炸火焰传播特性实验研究

为研究水平管道空间不同煤质煤尘爆炸火焰传播特性,选取褐煤、长焰煤、不粘煤、气煤4种煤尘,对爆炸火焰焰峰特性、火焰加速传播特性、火焰传播距离与持续时间展开研究。研究结果表明:褐煤在500 ms内焰峰的形状由尖锐向平滑再向钝化不断演变,长焰煤与不粘煤在375 ms时焰峰前端出现明显焰体分离现象,分析认为这与管体冷壁效应、空间尺度效应及空间氧气消耗直接相关;气煤在375 ms时焰峰出现大面积火焰碎纹,说明气煤爆炸火焰猛烈传播的持续时间相对较短,整体爆炸强度相对较弱;褐煤与长焰煤爆炸火焰存在2次间断性加速,分析认为这与管体空间受限、常温管壁散热、局部助燃氧气瞬间不足等因素有关;褐煤在爆炸后400～600 ms内火焰2次加速完全,火焰传播距离达740 mm,明显大于长焰煤、不粘煤与气煤,说明低变质褐煤爆炸火焰持续时间更长,火焰传播距离更远且传播更剧烈;虽然气煤火焰最远传播距离比长焰煤大30 mm,但由于气煤火焰在375 ms左右出现大片火焰碎纹,因此气煤整体的爆炸强度小于长焰煤。     

炼油厂厂界恶臭强度分级评估

石油炼制是产生恶臭污染的重点行业之一,恶臭强度是评估恶臭污染程度的重要参数。以炼油厂厂界大气特征污染物为研究对象,综合考虑检出率、嗅阈值和物质浓度3项指标,采用指标评分法筛选出厂界主要恶臭污染物硫化氢、氨、甲苯和二甲苯。基于韦伯-费希纳定律构建了恶臭强度分级评估方法,以某炼油厂为例进行了厂界恶臭强度评估,结果表明,厂界恶臭强度值为0.63,属于Ⅱ级(轻污染),硫化氢是恶臭强度的主要贡献源。应用感官测定法验证了该评估方法的可靠性。从恶臭管理的角度看,炼油厂在厂界达标排放的基础上应进一步实施恶臭污染综合治理措施,以改善周边的环境质量。