嗅觉实验配气方法的改进及影响因素研究

配制气体样品是异味测试及相关研究的基础工作,配气稳定性直接影响测试结果准确度。三点比较式臭袋法使用微量进样针量取并转移液体标准物质到3L无臭气袋的传统配气方法。对于异味阈值较小物质或样品浓度处于较低范围时,为了降低取样体积波动对配气精度和稳定性的影响。提出先将标准注入100mL玻璃注射器,充分挥发混匀后再转移部分气体到无臭气袋的两步式配气方法。结果表明,2种配气方法的准确度不存在显著差异,但两步式配气法的配气稳定性明显优于传统方法。此外,研究还发现,常见异味物质在被注人气袋后3min内便能完全挥发并混合均匀。除一些挥发性和吸附性极强的物质外,气袋内的异味物质气体浓度能在配好后20min内基本保持不变。     

Use of sensitive methods for detection of DNA damage on human lymphocytes exposed to p,p′-DDT: Comet assay and new criteria for scoring micronucleus test

Wide distribution, stability and long persistence in the environment of dichlorodiphenyltrichloroethane (DDT), probably the best-known and most useful insecticide in the world, imposes the need for further examination of the effect of this chemical on human health and especially on the human genome. In this study, peripheral blood human lymphocytes from a healthy donor were exposed to 0.025 mg/L concentration of p,p′-DDT at different time periods (1, 2, 24 and 48 h). For the assessment of genotoxic effect, the new criteria for scoring micronucleus test and alkaline comet assay were used. Both methods showed that p,p′-DDT induces DNA damage in low concentration used in this research. Results of micronucleus test showed a statistically significant (p < 0.05) genotoxic effect of p,p′-DDT on human lymphocytes compared with corresponding control and a different exposure time. A comet assay also showed increased DNA damage caused in p,p′-DDT-exposed human lymphocytes than in corresponding control cells for the tail length. Results obtained by measuring the level of DNA migration and incidence of micronuclei (MN), nucleoplasmic bridges (NPBs) and nuclear buds (NBUDs) indicate the sensitivity of these tests and their application in detection of primary genome damage after long-term exposure to establish the effect of p,p′-DDT on human genome.     

Behavior of bensulfuron-methyl in an agricultural alkaline soil

A field experiment to determine the available bensulfuron-methyl (BSM) in the upper soil layer was conducted in an agricultural area in the South of Spain. To facilitate herbicide analysis, two application rates were employed, 200 g ha^?1 and 5 kg ha^?1. Samples of upper soil and soil solution were collected. Soil solution was sampled by means of metallic samplers, placed at a depth of 35 cm. In the plots receiving the lower dose ceramic suction, porous cups were also installed. Results from soil solution samples showed that the maximum BSM concentration was found after 8-10 days for the high irrigation supply (945 mm) and after 18-25 days for the lower irrigation regime (405 mm). The mathematical model FOCUSPELMO 1.1.1 was applied to interpret the data obtained in the field experiments. In general, there was a reasonable agreement between experimental and simulated data for soil samples, although the model did not acceptably predict herbicide concentrations in water soil samples. Ceramic cups sampled a higher soil water volume and more frequently than did the metallic samplers. However some variable results were attributed to preferential flow.     

The effects of soil and Trifolium repens (white clover) on the fate of estrogen

In this study, we investigated the behavior of estrogens in the rhizosphere of white clover (Trifolium repens, clover hereafter) with two different pot tests, using soil and agar as growth media. In a pot test using agar spiked with estrogen, the estrogen concentration in the agar with clover decreased to non-detectable levels within one month, while in the agar without clover, 60% of initially added estrogen remained after one month. The half-lives of estrone (E1) and 17β -estradiol (E2) in the agar with clover were 2.4–3.8 and 13.2 d, respectively. The dissipation of E1 followed first-order rate law, while that of E2 fitted a zero-order reaction, indicating that they had different mechanisms of dissipation from agar. In the soil pot test, the behavior of E1 and E2 was not influenced by clover. An initial rapid decrease in the amount of estrogen extracted by methanol/acetic acid was followed by persistence for 1–3 months, regardless of presence of clover. Moreover, in three weeks E1 and E2 were only partly degraded by microbes extracted from the soil used in the pot test. In this study, abiotic degradation of estrogens and sorption of estrogen to soil, rather than the effects of soil microbes and clover, contributed to the initial rapid dissipation of estrogens in the soil. However, the results of the agar pot test suggested that vegetation such as clover may significantly contribute to removal of estrogens when estrogens in aqueous phase are discharged with surface runoff and preferential flow after heavy rain in agricultural fields, or when present in soils with low estrogen sorptivity.     

柠檬酸浸出土壤中铜、锌的优化设计

以某工业废弃地土壤为供试材料,采用批次实验方法,研究了柠檬酸对重金属Cu、Zn的浸出效果。并在单因素实验基础上,探讨不同pH值、柠檬酸浓度、固液比和浸提时间等对浸出效果的影响,进而对实验条件进行正交优化组合,确定优化工艺参数为：pH值为3.2,柠檬酸浓度为0.4 mol/L,壤土固液比为1/10,土壤中Cu、Zn接近平衡的时间分别为1 h和1.5 h。结果表明,在此条件下,对这2种金属来说,Cu较Zn易释放,Cu、Zn的最大浸出率分别为74.8%和65.3%。柠檬酸浸提前后,土壤中有机质含量下降范围为0.61%~3.16%。单从土壤有机质含量来看,柠檬酸对土壤质量影响较小,具有较好的应用前景。     

膨化预处理玉米秸秆的还原糖酶解工艺

应用膨化技术对玉米秸秆进行预处理.在单因素实验基础上,以还原糖转化率为影响值设计正交实验,研究温度、pH、液固比、酶浓度及酶解时间五因素对纤维素酶解过程的影响.得出玉米秸秆糖化酶解最佳工艺条件为:温度48℃,pH 4.5,液固比8:1,酶浓度36.0 U/g,酶解时间25 h;在此工艺条件下还原糖转化率达到28.98％.扫描电镜表征对比观察可看出,膨化后玉米秸秆纤维素酶解充分;结合红外光谱对各组分特征基团分析表明,膨化后的玉米秸秆酶解的纤维素基团特征峰变化更为明显.     

国产脱硝催化剂在国电长源荆州电厂2×300MW机组上的应用

随着新火电厂大气污染物排放标准的出台,NOx排放标准提高,现有的脱硝技术难以满足要求,需要增加后端烟气脱硝处理技术.选择性催化还原法是较成熟的烟气脱硝技术,催化剂是SCR技术的核心.针对国内某催化剂在国电长源荆州电厂的应用情况,详细描述了催化剂的设计选型过程.运行结果表明,该催化剂完全可以满足长源荆州电厂的性能要求,说明国产脱硝催化剂的设计选型、生产以及运行等技术能力已达到要求.     

经济发展与农业面源污染关系的协整检验——基于三峡库区重庆段1992-2009年数据的分析

运用协整检验和Granger因果检验方法,考察了三峡库区重庆段1992-2009年经济发展与农业面源污染之间的相互关系。研究结果表明:①经济增长是影响三峡库区重庆段农业面源污染的主要原因,且种植业、养殖业和农村生活三大类污染源排放量与农村经济发展之间都具有协整关系;②短期内农业生产总值的变化引起三类农业污染源排放量的同方向变动,长期来看,农村经济发展对农业面源污染有减缓作用,这与传统的环境—经济增长库兹涅茨倒U型曲线所揭示的一般规律相同;③农业经济的发展和种植业、养殖业的污染排放量具有双向的因果关系,但是经济发展是农村生活污染排放量增长的原因,农村生活污染排放量不是经济增长的原因,它们之间是单向因果关系。因此,我们要密切关注库区经济增长对环境质量带来的负面效应,必须依赖科学技术进步,提高种植业中化肥、农药、农膜和秸秆等的利用率,根据当地农业发展的特点以及与河流的远近,规划好农业、林业、畜牧业的结构,大力发展环保型、生态型农业,以减轻农业面源污染,实现农业经济增长与保持环境质量之间的相互协调。     

超高斯（分布）随机振动HALT试验剖面建立要点解析

本文介绍了超高斯（分布）随机振动HALT技术,对超高斯（分布）随机振动HALT试验剖面的建立提出了方法和建议,主要包括试验顺序的选择、应力强度的确定、步进量级的选择、驻留时间确定和试验停止原则等五方面,并总结了现场试验的要求和注意事项。     

振动试验中常见问题的分析

振动试验是装备环境试验不可缺少的部分,本文分析了试验条件的制定、试验夹具的设计和试验样品安装等振动试验中比较重要的环节,提出了振动试验实施过程中常见的几个问题,并结合实际操作经验给出了解决方案。