Degradation of 2,4-dichlorophenoxyacetic acid in water by ozone-hydrogen peroxide process

IntroductionAt present, several types of organic pollutantsreferred to as environmental endocrine disruptors(ED) have been suggested to be associated withabnormal sexual development (Hu, 2000). It wasreported that the ED led to the decline of reproductive…     

石油化工企业含苯胺消防污水处理技术研究

针对石油化工企业含苯胺的消防污水,利用基于过氧化氢和氯化铁为氧化剂的深度氧化技术,通过氧化、絮凝、过滤和吸附对消防污水进行处理。实验确定氧化剂的投加量为理论投加量,氧化时间1.0h,消防污水pH值为6.86时,絮凝剂最佳使用浓度约为2%,消防污水中苯胺和COD去除率达到99.5%以上,达到了消防污水处理效果。     

Effect of pyrolysis and oxidation characteristics on lauric acid and stearic acid dust explosion hazards

The effect of pyrolysis and oxidation characteristics on the explosion sensitivity and severity parameters, including the minimum ignition energy MIE, minimum ignition temperature MIT, minimum explosion concentration MEC, maximum explosion pressure P_max, maximum rate of pressure rise (dP/dt)_max and deflagration index K_st, of lauric acid and stearic acid dust clouds was experimentally investigated. A synchronous thermal analyser was used to test the particle thermal characteristics. The functional test apparatuses including the 1.2 L Hartmann-tube apparatus, modified Godbert-Greenwald furnace, and 20 L explosion apparatus were used to test the explosion parameters. The results indicated that the rapid and slow weight loss processes of lauric acid dust followed a one-dimensional diffusion model (D1 model) and a 1.5 order chemical reaction model (F1.5 model), respectively. In addition, the rapid and slow weight loss processes of stearic acid followed a 1.5 order chemical reaction model (F1.5 model) and a three-dimensional diffusion model (D3 model), respectively, and the corresponding average apparent activation energy E and pre-exponential factor A were larger than those of lauric acid. The stearic acid dust explosion had higher values of MIE and MIT, which were mainly dependent on the higher pyrolysis and oxidation temperatures and the larger apparent activation energy E determining the slower rate of chemical bond breakage during pyrolysis and oxidation. In contrast, the lauric acid dust explosion had a higher MEC related to a smaller pre-exponential factor A with a lower amount of released reaction heat and a lower heat release rate during pyrolysis and oxidation. Additionally, due to the competition regime of the higher oxidation reaction heat release and greater consumption of oxygen during explosion, the explosion pressure P_m of the stearic acid dust was larger in low concentration ranges and decayed to an even smaller pressure than with lauric acid when the concentration exceeded 500 g/m³. The rate of explosion pressure rise (dP/dt)_m of the stearic acid dust was always larger in the experimental concentration range. The stearic acid dust explosion possessed a higher P_max, (dP/dt)_max and K_st mainly because of a larger pre-exponential factor A related to more active sites participating in the pyrolysis and oxidation reaction. Consequently, the active chemical reaction occurred more violently, and the temperature and overpressure rose faster, indicating a higher explosion hazard class for stearic acid dust.     

Enhanced triallyl isocyanurate (TAIC) degradation through application of an O3/UV process: Performance optimization and degradation pathways

• UV/O₃ process had higher TAIC mineralization rate than O₃ process. • Four possible degradation pathways were proposed during TAIC degradation. • pH impacted oxidation processes with pH of 9 achieving maximum efficiency. • CO₃^2– negatively impacted TAIC degradation while HCO₃^– not. • Cl^– can be radicals scavenger only at high concentration (over 500 mg/L Cl^–). Triallyl isocyanurate (TAIC, C₁₂H₁₅N₃O₃) has featured in wastewater treatment as a refractory organic compound due to the significant production capability and negative environmental impact. TAIC degradation was enhanced when an ozone(O₃)/ultraviolet(UV) process was applied compared with the application of an independent O₃ process. Although 99% of TAIC could be degraded in 5 min during both processes, the O₃/UV process had a 70%mineralization rate that was much higher than that of the independent O₃ process (9%) in 30 min. Four possible degradation pathways were proposed based on the organic compounds of intermediate products identified during TAIC degradation through the application of independent O₃ and O₃/UV processes. pH impacted both the direct and indirect oxidation processes. Acidic and alkaline conditions preferred direct and indirect reactions respectively, with a pH of 9 achieving maximum Total Organic Carbon (TOC) removal. Both CO₃^2– and HCO₃^– decreased TOC removal, however only CO₃^2– negatively impacted TAIC degradation. Effects of Cl^– as a radical scavenger became more marked only at high concentrations (over 500 mg/L Cl^–). Particulate and suspended matter could hinder the transmission of ultraviolet light and reduce the production of HO· accordingly.     

Biological conversion pathways of sulfate reduction ammonium oxidation in anammox consortia

• The SRAO phenomena tended to occur only under certain conditions. • High amount of biomass and non-anaerobic condition is requirement for SRAO. • Anammox bacteria cannot oxidize ammonium with sulfate as electron acceptor. • AOB and AnAOB are mainly responsible for ammonium conversion. • Heterotrophic sulfate reduction mainly contributed to sulfate conversion. For over two decades, sulfate reduction with ammonium oxidation (SRAO) had been reported from laboratory experiments. SRAO was considered an autotrophic process mediated by anammox bacteria, in which ammonium as electron donor was oxidized by the electron acceptor sulfate. This process had been attributed to observed transformations of nitrogenous and sulfurous compounds in natural environments. Results obtained differed largely for the conversion mole ratios (ammonium/sulfate), and even the intermediate and final products of sulfate reduction. Thus, the hypothesis of biological conversion pathways of ammonium and sulfate in anammox consortia is implausible. In this study, continuous reactor experiments (with working volume of 3.8L) and batch tests were conducted under normal anaerobic (0.2≤DO<0.5 mg/L) / strict anaerobic (DO<0.2 mg/L) conditions with different biomass proportions to verify the SRAO phenomena and identify possible pathways behind substrate conversion. Key findings were that SRAO occurred only in cases of high amounts of inoculant biomass under normal anaerobic condition, while absent under strict anaerobic conditions for same anammox consortia. Mass balance and stoichiometry were checked based on experimental results and the thermodynamics proposed by previous studies were critically discussed. Thus anammox bacteria do not possess the ability to oxidize ammonium with sulfate as electron acceptor and the assumed SRAO could, in fact, be a combination of aerobic ammonium oxidation, anammox and heterotrophic sulfate reduction processes.     

响应面法优化预氧化强化混凝处理铁锰地下水

以KMnO_4为氧化剂,Al_2(SO_4)_3·18H_2O为混凝剂,含铁锰离子地下水为模拟用水,考察预氧化强化混凝法的效果。利用响应面设计试验,分析氧化剂投加量、混凝剂投加量和pH值对铁锰去除的交互作用。模型优化结果显示,在氧化剂投加量4.16 mg/L,混凝剂投加量263.68 mg/L,pH值为7.54的最佳工艺参数下,铁锰去除率分别可达98.22%和97.49%。     

用次氯酸钠法处理选矿废水

采用次氯酸钠法处理铅锌硫化矿选矿废水,考察了废水初始pH、NaClO加入量及反应时间对选矿废水COD去除率的影响。在废水pH为4、NaClO加入量为100g/L、反应时间为30min的条件下,选矿废水的COD去除率可达到98．3％;当pH为11、反应时间为10min、NaClO加入量为1g/L时,选矿废水的COD去除率为39．4％。     

用环己烷氧化副产物制备浮选剂

在固体酸催化剂作用下,用环己烷氧化制备环己酮的副产物——酸性油和轻质油进行酯化反应,制备了羧酸混合酯,酯化反应的最佳工艺条件：n（C4-C5醇）：n（有机羧酸）=1．2：1,催化剂质量分数为1．5％,反应温度为110-160℃,反应时间为5h。经应用评价结果表明,该羧酸混合酯是一种性能优异的选煤浮选剂。     

圆筒形电化学反应器中有机物电催化的传递特性研究

研究了圆筒形电化学反应器内有机物在电化学降解过程中的传递特性.假设废水以平推流方式通过圆筒形反应器,由电催化过程的质量守恒和法拉第定律导出浓度、电流强度随废水停留时间的变化规律.根据废水中有机物的电化学降解和有机物氧化分解的关系将浓度分布转换成COD分布,并考察了扩散对COD、电流强度分布的影响理论模型和实验数据表明,在传质控制条件下忽略与不忽略扩散的影响,COD、电流强度的分布遵循不同的指数关系.理论模型与实验数据的平均误差为8.6%;极限电流随电解质流量的变化而改变.     

改良型Carrousel氧化沟工艺生物脱氮除磷效果研究

为了提高改良型Carrousel氧化沟工艺污水处理厂的脱氮除磷效果,结合某污水处理厂3年的运行实践,讨论了该工艺的处理效果,生物脱氮除磷原理及影响出水效果的因素.分析表明将DO控制在0.3～0.7 mg/L范围内,能够使出水中的TN浓度低于20 mg/L;在氧化沟中发生的同步硝化反硝化反应(SND)对总氮的去除的贡献占总系统脱氮的66%;该系统剩余污泥的含磷率为3.0%,生物细胞中平均含磷量可达细胞干重的4.2%;总磷去除率与污泥龄具有很好的线性关系,加大污泥排放量可以提高除磷效果.