染料废水电催化氧化及降解动力学研究

以新型钛基二氧化铅电极为阳极、石墨为阴极、活性炭-纳米二氧化钛为催化粒子电极降解染料模拟废水酸性红B溶液,考察了槽电压、pH值、催化剂量等对处理效果的影响。实验结果表明:纳米二氧化钛催化剂的催化效果显著,该反应器能够有效的降解酸性红B,降解机制主要是电致H2O2、.OH对有机物的氧化、降解。同时用一级反应拟合了酸性红B溶液COD去除反应,由实验数据确定了反应动力学方程。     

剩余污泥的电化学稳定实验研究

研究了电化学法对城市剩余污泥稳定化的影响。结果表明,以钛涂钌电极为阳极、不锈钢板为阴极,在极板间距为2cm,电压为20V,曝气量为3L/h的条件下,电解20min,其挥发性悬浮物质(VSS)去除效率可达39%,加酸调节pH值至4左右时,其电解效率则可达40%以上,同时,污泥病原体达到未检出水平。     

含有机物铁泥的超临界水氧化法资源化

氨基染料生产过程中产生大量含有机物的铁泥,对环境造成严重污染并造成资源的极大浪费.利用超临界水氧化法对含有机物铁泥进行资源化处理研究,并对产物进行了X射线衍射分析(XRD)、色差实验与电子探针分析.研究结果显示,用超临界水氧化法处理铁泥可以将铁泥中所含的有机物完全氧化,真正实现环境友好;超临界水首先将铁泥氧化成α-Fe2O3与γ-Fe2O3,再经过800℃煅烧后可以作为氧化铁红颜料使用;超临界反应压力对样品的晶型与颜色影响不大.     

改良型Carrousel氧化沟工艺生物脱氮除磷效果研究

为了提高改良型Carrousel氧化沟工艺污水处理厂的脱氮除磷效果,结合某污水处理厂3年的运行实践,讨论了该工艺的处理效果,生物脱氮除磷原理及影响出水效果的因素.分析表明将DO控制在0.3～0.7 mg/L范围内,能够使出水中的TN浓度低于20 mg/L;在氧化沟中发生的同步硝化反硝化反应(SND)对总氮的去除的贡献占总系统脱氮的66%;该系统剩余污泥的含磷率为3.0%,生物细胞中平均含磷量可达细胞干重的4.2%;总磷去除率与污泥龄具有很好的线性关系,加大污泥排放量可以提高除磷效果.     

无过氧化氢添加Fenton氧化法降解有机物的可行性研究

Fenton反应可以氧化分解有机物,在反应中的关键氧化剂羟基自由基(HO·)是通过亚铁离子与过氧化氢作用生成的,因此,传统的Fenton氧化必须由外部添加过氧化氢.研究了一种新的方法,即采用Nafion膜固定化亚铁离子,并通过光催化反应提供Fenton氧化所需的过氧化氢,使得Fenton反应在不添加过氧化氢的条件下也能够连续进行.结果表明,以甲酸为代表有机物,该方法可以在不添加过氧化氢的条件下起到分解甲酸的作用.而且,通过对负载亚铁离子Nafion膜的再生,可以使该方法的降解能力保持在稳定的范围.     

Degradation of 2,4-dichlorophenoxyacetic acid in water by ozone-hydrogen peroxide process

IntroductionAt present, several types of organic pollutantsreferred to as environmental endocrine disruptors(ED) have been suggested to be associated withabnormal sexual development (Hu, 2000). It wasreported that the ED led to the decline of reproductive…     

响应面法优化预氧化强化混凝处理铁锰地下水

以KMnO_4为氧化剂,Al_2(SO_4)_3·18H_2O为混凝剂,含铁锰离子地下水为模拟用水,考察预氧化强化混凝法的效果。利用响应面设计试验,分析氧化剂投加量、混凝剂投加量和pH值对铁锰去除的交互作用。模型优化结果显示,在氧化剂投加量4.16 mg/L,混凝剂投加量263.68 mg/L,pH值为7.54的最佳工艺参数下,铁锰去除率分别可达98.22%和97.49%。     

Effect of pyrolysis and oxidation characteristics on lauric acid and stearic acid dust explosion hazards

The effect of pyrolysis and oxidation characteristics on the explosion sensitivity and severity parameters, including the minimum ignition energy MIE, minimum ignition temperature MIT, minimum explosion concentration MEC, maximum explosion pressure P_max, maximum rate of pressure rise (dP/dt)_max and deflagration index K_st, of lauric acid and stearic acid dust clouds was experimentally investigated. A synchronous thermal analyser was used to test the particle thermal characteristics. The functional test apparatuses including the 1.2 L Hartmann-tube apparatus, modified Godbert-Greenwald furnace, and 20 L explosion apparatus were used to test the explosion parameters. The results indicated that the rapid and slow weight loss processes of lauric acid dust followed a one-dimensional diffusion model (D1 model) and a 1.5 order chemical reaction model (F1.5 model), respectively. In addition, the rapid and slow weight loss processes of stearic acid followed a 1.5 order chemical reaction model (F1.5 model) and a three-dimensional diffusion model (D3 model), respectively, and the corresponding average apparent activation energy E and pre-exponential factor A were larger than those of lauric acid. The stearic acid dust explosion had higher values of MIE and MIT, which were mainly dependent on the higher pyrolysis and oxidation temperatures and the larger apparent activation energy E determining the slower rate of chemical bond breakage during pyrolysis and oxidation. In contrast, the lauric acid dust explosion had a higher MEC related to a smaller pre-exponential factor A with a lower amount of released reaction heat and a lower heat release rate during pyrolysis and oxidation. Additionally, due to the competition regime of the higher oxidation reaction heat release and greater consumption of oxygen during explosion, the explosion pressure P_m of the stearic acid dust was larger in low concentration ranges and decayed to an even smaller pressure than with lauric acid when the concentration exceeded 500 g/m³. The rate of explosion pressure rise (dP/dt)_m of the stearic acid dust was always larger in the experimental concentration range. The stearic acid dust explosion possessed a higher P_max, (dP/dt)_max and K_st mainly because of a larger pre-exponential factor A related to more active sites participating in the pyrolysis and oxidation reaction. Consequently, the active chemical reaction occurred more violently, and the temperature and overpressure rose faster, indicating a higher explosion hazard class for stearic acid dust.     

石油化工企业含苯胺消防污水处理技术研究

针对石油化工企业含苯胺的消防污水,利用基于过氧化氢和氯化铁为氧化剂的深度氧化技术,通过氧化、絮凝、过滤和吸附对消防污水进行处理。实验确定氧化剂的投加量为理论投加量,氧化时间1.0h,消防污水pH值为6.86时,絮凝剂最佳使用浓度约为2%,消防污水中苯胺和COD去除率达到99.5%以上,达到了消防污水处理效果。     

Enhanced triallyl isocyanurate (TAIC) degradation through application of an O3/UV process: Performance optimization and degradation pathways

• UV/O₃ process had higher TAIC mineralization rate than O₃ process. • Four possible degradation pathways were proposed during TAIC degradation. • pH impacted oxidation processes with pH of 9 achieving maximum efficiency. • CO₃^2– negatively impacted TAIC degradation while HCO₃^– not. • Cl^– can be radicals scavenger only at high concentration (over 500 mg/L Cl^–). Triallyl isocyanurate (TAIC, C₁₂H₁₅N₃O₃) has featured in wastewater treatment as a refractory organic compound due to the significant production capability and negative environmental impact. TAIC degradation was enhanced when an ozone(O₃)/ultraviolet(UV) process was applied compared with the application of an independent O₃ process. Although 99% of TAIC could be degraded in 5 min during both processes, the O₃/UV process had a 70%mineralization rate that was much higher than that of the independent O₃ process (9%) in 30 min. Four possible degradation pathways were proposed based on the organic compounds of intermediate products identified during TAIC degradation through the application of independent O₃ and O₃/UV processes. pH impacted both the direct and indirect oxidation processes. Acidic and alkaline conditions preferred direct and indirect reactions respectively, with a pH of 9 achieving maximum Total Organic Carbon (TOC) removal. Both CO₃^2– and HCO₃^– decreased TOC removal, however only CO₃^2– negatively impacted TAIC degradation. Effects of Cl^– as a radical scavenger became more marked only at high concentrations (over 500 mg/L Cl^–). Particulate and suspended matter could hinder the transmission of ultraviolet light and reduce the production of HO· accordingly.