紫外辐照-催化湿式过氧化氢氧化技术处理酸性大红GR染料废水

采用自制的负载型CuO-ZnO-CeO2/γ-Al2O3催化剂,常温常压下通过紫外辐照-催化湿式氧化技术处理酸性大红GR模拟染料废水。考察了催化剂加入量、H2O2加入量、废水pH、反应时间、初始酸性大红GR质量浓度等对废水脱色率的影响。实验得到最佳工艺条件为初始酸性大红GR质量浓度200mg/L,催化剂加入量10.0g/L,H2O2加入量2.0mL/L,废水pH4,反应时间2h。最佳工艺条件下废水脱色率达99.33%。     

Elimination of diclofenac from water using irradiation technology

The effluents of wastewater treatment plants, usually directly emitted to the environment, often contain the anti-inflammatory drug diclofenac (DCF). The paper investigates DCF elimination using irradiation technology. Hydroxyl radical and hydrated electron reactive intermediates resulting from water radiolysis effectively degrade DCF and strongly reduce the toxicity of the solutions. OH attaches to one of the rings of DCF, and hydroxylated molecules, 2,6-dichloroaniline and quinoid type compounds are the products. Hydrated electron adds to the chlorine atom containing ring, in the reaction quinoid type compounds and 4-chloroacridine form. At a 0.1 mM DCF concentration, a ∼1 kGy absorbed dose is needed for the degradation of DCF molecules, but for mineralization of the products (in presence of O₂) an order of magnitude higher dose is required.For irradiation of wastewater after biological treatment a ∼1 kGy dose is suggested. At this dose DCF and other drugs or metabolites present at μg L⁻¹ level are eliminated together with microorganism deactivation.     

钛基IrO2-SnO2电极在烟气海水脱硫恢复系统中的应用

采用浸渍-热分解法制备了含IrOx-TiO2中间层的IrO2-SnO2电极,得到的电极具有较高的析氯电催化活性和较强的稳定性,并通过电化学氧化法对Na2SO3海水脱硫模拟液进行处理,考察了电流密度、温度、pH值和电解时间等电解工艺参数对Na2SO3去除率和化学需氧量COD的影响.结果表明,在电流密度为200 mA/cm...     

烟气NO氧化催化剂Cu-V/Ti-PILCs的制备及其硫水稳定性

采用等体积浸渍法制备了以钛交联粘土为载体,Cu与V氧化物为活性组分的烟气NO氧化催化剂(Cu-v/Ti-PILCs),并考察了各种制备条件下催化剂的活性及稳定性.结果显示,当V水/V丙酮 =1∶2,负载4%CuO和2%V2O5,并在500℃煅烧时制得的Cu-V/Ti-PILCs催化剂,在NO浓度为350 mg/m3,O...     

对氯苯酚废水的电化学降解研究

实验利用电沉积法制备的不锈钢基PbO2电极,以对氯苯酚溶液为模型废水,通过静态实验研究外加电压、电解质浓度、曝气量及初始pH值对电化学氧化降解对氯苯酚效果的影响。结果表明,实验制备的PbO2电极具有较高的电催化活性,能够有效降解对氯苯酚;较低的操作电压有助于降低处理成本;随着电解质浓度和曝气量的增加,对氯苯酚去除率均呈...     

Performance of photocatalytic lamps on reduction of culturable airborne microorganism concentration

Reduction of viable airborne Staphylococcus epidermidis and Aspergillus niger spore concentrations using two types of photocatalytic fluorescent lamps under controlled environmental conditions (25 vs. 35 °C and 55 vs. 75% relative humidity) were investigated. Visible white-light and UVA black light were in-house spray-coated with TiO₂ and then compared with a commercially coated visible white-light for microbial concentration reduction. The white-light photocatalytic lamps reduced the concentration of culturable S. epidermidis up to 92% independent of temperature or humidity change, while the black light photocatalytic lamps completely inactivated the culturable bacteria at 25 °C, 55% relative humidity. Humidity seemed to alleviate UVA damage since better bacteria survival was found. For A. niger spores, rising humidity or temperature could lower their concentration or drop their culturabilities so that a difference between the natural decay and photocatalytic disinfection could not be distinguished. Reductions of total bacteria and total fungi concentrations using these lamps were also examined under uncontrolled environmental conditions in an office and a waste-storage room. It was found that photocatalytic lamps could reduce total culturable bacteria concentration from 9 to 97% and total culturable fungi concentration from 3 to 95% within irradiation time of 30-480 min, respectively. Insignificant difference in concentration reduction among these photocatalytic lamps was pronounced.     

钛基IrO2-SnO2电极在烟气海水脱硫恢复系统中的应用

采用浸渍-热分解法制备了含IrOx-TiO2中间层的IrO2-SnO2电极,得到的电极具有较高的析氯电催化活性和较强的稳定性,并通过电化学氧化法对Na2SO3海水脱硫模拟液进行处理,考察了电流密度、温度、pH值和电解时间等电解工艺参数对Na2SO3去除率和化学需氧量COD的影响。结果表明,在电流密度为200 mA/cm^2,pH值为3.5,电解440 mg/L的Na2SO3海水脱硫模拟液,15 min时Na2SO3去除率可达96.5%,COD去除率可达82.6%。     

电化学工艺处理有机废水的研究进展

综述了目前国内外学者在二维电极和三维电极的开发和改进方面的研究成果,指出了电化学氧化技术和电极材料的主要研究方向和发展趋势.提出为解决电化学水处理技术中提高电催化效率和延长电极寿命的问题,当前研究的主要方向应集中在阳极材料、反应器结构和处理工艺方面.     

催化湿式氧化预处理造纸黑液

采用连续式固定床反应器,利用自制稀土类复合金属氧化物催化剂对草浆造纸黑液进行了催化湿式氧化(CWAO)预处理研究.通过正交实验确定了最佳工艺条件为:进水COD 40 800 mg/L,空速0.8h-1,反应温度260℃,反应压力6.5 MPa.在此最佳条件下进行实验,COD去除率达90％.经CWAO工艺处理后,草浆造纸...     

蒽醌修饰石墨毡电极预处理头孢合成废水

以钛涂钌电极为阳极、自制蒽醌修饰石墨毡电极为阴极,对头孢合成废水(COD=25 000~30 000 mg/L、ρ(NH3-N)=850~1 300 mg/L、色度为2 300~2 680度)进行了电化学氧化预处理,优化了电解条件,并对电化学体系的动力学和稳定性进行了分析。实验结果表明:蒽醌的存在可改善电化学氧化降解效果;在电解时间50 min、电流密度0.14 A/cm2、Na2SO4浓度0.1 mol/L、极板间距2 cm、初始废水p H 7.0的条件下,废水的COD、色度、NH3-N的去除率分别可达45.3%,66.9%,33.6%;BOD5/COD由处理前的0.27增至0.40,可生化性得到改善;COD、色度、NH3-N的电化学氧化降解过程均近似符合一级动力学方程;且该电化学体系的应用稳定性良好。