Rubber sheet strewn with TiO2 particles:Photocatalytic activity and recyclability

A new method for the preparation of rubber sheet strewn with titanium dioxide particles (TiO₂-strewn sheet) is presented. This simple and low cost method is based on the use of TiO₂ powder (Degussa P25) being strewn onto the sheet made from rubber latex (60% HA) through a steel sieve. The characteristic of the TiO₂-strewn sheet was studied by using scanning electron microscopy/energy dispersive X-ray spectrometer (SEM/EDS) and X-ray diffractometer (XRD) techniques. The photocatalytic activity of TiO₂-strewn rubber sheet was evaluated using Indigo Carmine (IC) dye as a model for organic dye pollutant in water. The results showed that the TiO₂-strewn sheet could degrade IC dye solution under UV light irradiation. The effects of pH, initial concentration, and the intensity of UV light on the photodegradation were also investigated. Kinetics of the photocatalytic degradation was of the first-order reaction. The used TiO₂-strewn sheet can be recovered and reused. The recycling uses did not require any cleaning between successive uses and no decline in the photodegradation efficiency was observed compared with freshly prepared TiO₂-strewn sheet.     

水合氧化铁对含磷废水的吸附特性研究

以Fe(NO3)3为前驱物,制备了水合氧化铁吸附剂样品,以NaOH为解吸剂,研究了样品对模拟废水中磷酸根的吸附和解吸性能。结果表明,水合氧化铁对磷酸根有较好的吸附效果;随着pH的降低,水合氧化铁对磷酸根的吸附能力增强,在pH为2时吸附达92.5%;吸附前15 min吸附速率较快,约150 min达到平衡,吸附动力学曲线符合二级动力学模型;用水合氧化铁对初始浓度为50~100 mg/L模拟含磷废水吸附,随着初始浓度的增大,磷的去除率下降;水合氧化铁对磷酸根的吸附等温线较符合Langmuir吸附模型;用NaOH对水合氧化铁行解吸,浓度为40 g/L有最好的解吸率,60 min时达到解吸平衡。     

污水处理厂升级改造中氨氮控制工艺的研究

文章研究"生物膜+活性污泥"复合工艺,将生物膜法与传统的A2/O污水处理脱氮工艺结合起来,形成了"生物膜+A2/O"复合工艺。2种工艺有机地融合于一个反应系统中,既节省用地又延长污泥龄,使脱氮除磷的效果大大提高。用该工艺处理城市污水,其出水水质符合《城镇污水处理厂污染物排放标准》(GB18918-2002)一级A标准,用作景观用水和一般回用水,可广泛地应用于污水处理厂的升级改造。     

Electrochemical oxidation of polyethylene glycol in electroplating solution using paraffin composite copper hexacyanoferrate modified (PCCHM) anode

Electrochemical oxidation of polyethylene glycol (PEG) in an acidic(pH 0.18 to 0.42) and high ionic strength electroplating solution was investigated. The electroplating solution is a major source of wastewater in the printing wiring board industry. A paraffin composite copper hexacyanoferrate modified(PCCHM) electrode was used as the anode and a bare graphite electrode was used as the cathode. The changes in PEG and total organic carbon (TOC) concentrations during the course of the reaction were monitored. The efficiency of the PCCHM anode was compared with bare graphite anode and it was found that the former showed significant electrocatalytic property for PEG and TOC removal. Chlorides present in the solution were found to contribute significantly in the overall organic removal process. Short chain organic compounds like acetic acid, oxalic acid, formic acid and ethylene glycol formed during electrolysis were identified by HPLC method. Anode surface area and applied current density were found to influence the electro-oxidation process, in which the former was found to be dominating. Investigations of the kinetics for the present electrochemical reaction suggested that the two stage first-order kinetic model provides a much better representation of the overall mechanism of the process if compared to the generalized kinetic model.     

Fe_3O_4@SiO_2复合气凝胶的制备及其对刚果红的吸附

以Fe Cl_3·6H_2O和正硅酸四乙酯为原料,通过溶胶-凝胶法结合醇溶剂热法制备了Fe_3O_4@Si O_2复合气凝胶。采用XRD,FTIR,SEM,EDS等技术对Fe_3O_4@Si O_2的结构进行了表征。考察了Fe_3O_4@Si O_2对刚果红溶液的吸附性能。表征结果显示,Fe_3O_4@Si O_2复合气凝胶是由直径为10~20 nm的近球形颗粒组装而成的具有三维网络结构的纳米材料,比表面积为457.93 m~2/g,平均孔径为10.7 nm。在溶液p H为5、吸附时间为35 min的最佳工艺条件下,采用Fe_3O_4@Si O_2吸附处理质量浓度为10 mg/L的刚果红溶液,刚果红去除率为99.39%,此时溶液中刚果红的质量浓度仅为0.052 mg/L。Fe_3O_4@Si O_2复合气凝胶吸附刚果红后具有较好的解吸和再生能力。     

粉煤灰表面改性的研究

本文利用H-NA,H-R等六种不同的表面活化剂,采用干法和湿法的活化工艺,对粉煤灰的表面进行改性研究。试验表明,活化粉煤灰表面的羟基数目减少,增加了活化剂的相应基团,它在有机介质中的分散性明显好转。用活化粉煤灰作聚氯乙烯和橡胶的填料,制成试样,测试结果表明,与未活化的粉煤灰相比,各种性能均明显改善,除橡胶磨耗减量质量有待进一步提高外,其余各项指标均达到和超过有关标准。因此,这是利用再生资源,降低复合材料成本,保护环境的一种新途径。     

Improved utilization of active sites for phosphorus adsorption in FeOOH/anion exchanger nanocomposites via a glycol-solvothermal synthesis strategy

Metal oxide/hydroxide-based nanocomposite adsorbents with porous supporting matrices have been recognized as efficient adsorbents for phosphorus recovery. Aiming at satisfying increasingly restrictive environmental requirements involving improving metal site utilization and lowering metal leakage risk, a glycol-solvothermal confined-space synthesis strategy was proposed for the fabrication of Fe OOH/anion exchanger nanocomposites（Fe/900s）with enhanced metal site utilization and reduced metal lea...     

Tailor-made FAU zeolite composite membrane for wastewater treatment

In this work, a novel multipurpose Faujasite (FAU) zeolite composite membrane was fabricated by in-situ hydrothermal method to separate different solute molecules such as vanillic acid, phenol, and brilliant green from the aqueous solution. The coal fly ash based ceramic substrate was synthesized and used as substrate for preparing the zeolite composite membrane. The X-ray diffraction (XRD) pattern confirmed the crystalline nature of membranes and the presence of Quartz and hematite in the composite membrane. The presence of Si-O and Al-O in zeolite coated composite membrane was confirmed by Fourier Transform infrared spectroscopy (FTIR) analysis. Scanning electron microscope (SEM) analysis showed the porous structure and 8.34 μm thickness of zeolite coating on membrane. The isoelectric point of composite membrane was observed at pH 2.07 through zeta potential analysis. Brunauer-Emmett-Teller (BET) surface area, average pore volume and pore diameter of zeolite composite membrane were estimated as 6.406 m²/gm, 0.0070 cm³/gm, and 4.371 nm, respectively. The hydraulic pore radius and porosity of composite membranes were 27.7 nm and 20.1%. The maximum separation efficiency of FAU zeolite composite membrane towards vanillic acid, phenol and brilliant green was estimated as 78.67%, 89.13%, and 94.28%, respectively, for 200 mg/L feed concentration at 276 kPa applied pressure. The results obtained in this study reveals that the multipurpose FAU zeolite composite membrane fabricated in this study can be effectively used for separation of various solutes molecules present in the wastewater.     

甲烷氯化物废水治理工艺的技术应用

在氯碱工业加工过程中会产生大量的甲烷氯化物废水,废水中含有大量的甲烷氯化物,该类废水不易处理,极大地影响了后续废水处理工作的开展。本文以某司甲烷氯化物具体试验为例,探讨高分子吸附剂在甲烷氯化物废水处理过程中的应用,在利用高分子吸附剂进行吸附的同时通过蒸汽吹脱使树脂中富集下来的甲烷氯化物得到分离回收,从而实现了废水的资源化,达到治废与资源利用的双重效果。     

复合载体对选择性催化还原催化剂低温脱硝性能的影响

采用浆液浸涂法在堇青石蜂窝陶瓷载体上涂覆Al2O_3-TiO_2-ZSM-5分子筛复合载体,并通过浸渍法负载活性组分Mn-Fe-Ce,制备了M/ATZ-CC选择性催化还原催化剂。考察了催化剂的低温脱硝活性和抗水性能,表征了催化剂的物性参数和氨-程序升温脱附性能。实验结果表明,M/ATZ-CC催化剂具有优异的脱硝活性和抗水性能,在反应温度为160℃、水蒸气加入量为10%(φ)、NO体积分数为0.1%、n(NH_3)∶n(NO)=1、O_2体积分数为3.0%、体积空速为3 000~10 000 h~(-1)的条件下,NO去除率在80%以上。表征结果显示,该催化剂的比表面积、孔径、弱酸酸量、中强酸酸量和总酸量得到了显著提高。