纳米材料对环境中微生物活性的影响研究

研究纳米材料对环境中微生物细胞活性的影响可为纳米材料的生物安全性评价提供一定的理论基础.以大肠杆菌和枯草芽孢杆菌为受试生物,采用电导率仪测定细菌培养液电导率变化,分别研究了纳米TiO2、纳米ZnO、纳米Fe3O4、纳米SiO2、纳米二氧化钛载银、纳米磷酸锆载银、纳米棕色银对细菌细胞膜通透性的影响.结果表明,纳米材料对革兰氏阳性枯草芽孢杆菌细胞活性影响更大;同种纳米材料,粒径越小,对细菌的细胞活性影响越强;对细菌细胞活性影响最大的是纳米棕色银,对细菌细胞活性影响最小的是纳米SiO2和Fe3O4.     

滤膜法测定悬浮物出现负误差原因研究

为了对滤膜法测定水中悬浮物出现负误差的情况进行研究,从滤膜的前处理到滤膜的选择进行了一系列实验,发现主要原因是滤膜在实验的过程中产生失重。对几种微孔滤膜进行了空白实验,得出有机滤膜的空白校正值为0.0000～0.0004g,低于或等于悬浮物的称量误差,此类滤膜用于水中悬浮物的测定,能减少恒重次数,缩短实验时间,提高测定结果的科学性和准确性。     

膜-生物反应器处理高盐废水膜面污染物特性研究

研究MBR在低有机负荷条件下处理高盐废水的膜面污染物特征.结果表明,稳定运行121 d后,MBR对有机物和NH+4-N去除率稳定,出水效果良好;污泥性质发生较大变化,挥发性固体含量(VSS)/固体含量(SS)的下降,污泥体积指数(SVI)下降,表明污泥中无机成分含量增加,絮体更为紧密,沉降性能变好;污泥溶解性微生物产物(SMP)和胞外聚合物(EPS)成分发生较大变化,蛋白质所占比例降低,腐殖酸所占比例增加;扫描电子显微镜-X射线能谱仪(SEM-EDX)结果表明膜面存在无机污染物,其主要组成元素为Na、Al、Mg、Ca、K、Fe、Ti、Cr、W、Si和Cl;凝胶过滤色谱(GFC)分析表明,SMP中的大分子有机物被膜截留并累积是形成膜污染的原因之一;傅立叶红外(FTIR)光谱和三维荧光光谱(EEM)分析表明,膜面有机污染物的主要成分为糖类、蛋白质和腐殖酸;膜污染物组分质量分析说明在处理高盐废水时无机膜污染不可忽略.     

纳米Ag粒子原位杂化PVDF超滤膜的抗污染性能

以AgNO3为前驱体,聚偏氟乙烯(PVDF)为聚合物基体,聚乙烯吡咯烷酮(PVP)为分散剂和成孔剂,N,N-二甲基甲酰胺(DMF)为还原剂和溶剂,利用相转化法制备了纳米Ag粒子原位杂化PVDF超滤膜.采用扫描电镜、透射电镜、原子力显微镜及接触角测定仪对杂化膜的结构和性能进行了表征.结果表明:原位形成的纳米Ag粒子均匀地分散在聚合物基体中,纳米Ag粒子的添加改善了PVDF膜的亲水性能.以腐殖酸和牛血清蛋白作为污染物的代表,考察了Ag/PVDF膜的抗有机污染性能.以大肠杆菌、耐甲氧西林金黄色葡萄球菌及活性污泥作为微生物的代表,考察了杂化膜的抗生物污染性能.结果证实了与纯PVDF膜相比,Ag/PVDF膜通量衰减较慢,可有效抑制微生物的生长,表面受活性污泥污染程度小,具有显著的抗有机污染和抗生物污染性能.     

铁镧复合氧化物纳米吸附剂的制备、表征及As（Ⅲ）吸附性能研究

本研究采用共沉淀法制备了一种新型铁镧复合氧化物吸附剂(Fe-La),并对其表面特性及As(Ⅲ)吸附行为进行了系统研究.扫描电镜(SEM)和透射电镜(TEM)结果表明,铁镧复合氧化物具有纳米结构,初级粒子粒径范围为20~200 nm.X-射线衍射仪(XRD)表征结果表明,铁镧复合氧化物具有类似氢氧化镧的晶型结构.N2吸附BET法结果表明,铁镧复合氧化物的比表面积为99.3 m2·g-1.盐加入法测得吸附剂的等电点为7.8.As(Ⅲ)吸附实验结果分析表明,铁镧复合氧化物对As(Ⅲ)具有良好的吸附效果,最大吸附量(pH 7.0)为58.2 mg·g-1,Langmuir吸附等温线可较好地拟合铁镧复合氧化物对溶液中As(Ⅲ)的吸附(R2=0.95);吸附速率较快,240 min内可完成吸附容量的80%,Elovich模型能较好地描述吸附过程(R2=0.97);溶液pH对铁镧复合氧化物吸附As(Ⅲ)的影响较为明显;共存阴离子对吸附影响的大小顺序为SO2-4相似文献   

Gas separation using porous cement membrane

Gas separation is a key issue in various industrial fields. Hydrogen has the potential for application in clean fuel technologies. Therefore, the separation and purification of hydrogen is an important research subject. CO2 capture and storage have important roles in ＂green chemistry＂. As an effective clean technology, gas separation using inorganic membranes has attracted much attention in the last several decades. Membrane processes have many applications in the field of gas separation. Cement is one type of inorganic material, with the advantages of a lower cost and a longer lifespan. An experimental setup has been created and improved to measure twenty different cement membranes. The purpose of this work was to investigate the influence of gas molecule properties on the material transport and to explore the influence of operating conditions and membrane composition on separation efficiency. The influences of the above parameters are determined, the best conditions and membrane type are found, it is shown that cementitious material has the ability to separate gas mixtures, and the gas transport mechanism is studied.     

Effect of ozone on the performance of a hybrid ceramic membrane-biological activated carbon process

Two hybrid processes including ozonation-ceramic membrane-biological activated carbon （BAC） （Process A） and ceramic membrane-BAC （Process B） were compared to treat polluted raw water. The performance of hybrid processes was evaluated with the removal efficiencies of turbidity, ammonia and organic matter. The results indicated that more than 99% of particle count was removed by both hybrid processes and ozonation had no significant effect on its removal. BAC filtration greatly improved the removal of ammonia. Increasing the dissolved oxygen to 30.0 mg/L could lead to a removal of ammonia with concentrations as high as 7.80 mg/L and 8.69 mg/L for Processes A and B, respectively. The average removal efficiencies of total organic carbon and ultraviolet absorbance at 254 nm （UV254, a parameter indicating organic matter with aromatic structure） were 49% and 52% for Process A, 51% and 48% for Process B, respectively. Some organic matter was oxidized by ozone and this resulted in reduced membrane fouling and increased membrane flux by 25%-30%. However, pre-ozonation altered the components of the raw water and affected the microorganisms in the BAC, which may impact the removals of organic matter and nitrite negatively.     

Anoxic gas recirculation system for fouling control in anoxic membrane reactor

Anoxic gas recirculation system was applied to control the membrane fouling in pilot-scale 4-stage anoxic membrane bioreactor(MBR). In the anaerobic-anoxic-anoxic-aerobic flow scheme,hydrophilic polytetrafluoroethylene(PTFE) membrane(0.2 μm, 7.2 m2/module) was submerged in the second anoxic zone. During 8 months operation, the average flux of the membrane was 21.3L/(m2·hr). Chemical cleaning of the membrane was conducted only once with sodium hydroxide and sodium hypochlorite. Dissolved oxygen(DO) concentration in the second anoxic zone was maintained with an average of 0.19 ± 0.05 mg/L. Gas chromatography analysis showed that the headspace gas in the second anoxic reactor was mainly consisted of N2(93.0% ± 2.5%), O2(3.8% ± 0.6%), and CO2(3.0% ± 0.5%), where the saturation DO concentration in liquid phase was 1.57 mg/L. Atmospheric O2 content(20.5% ± 0.8%) was significantly reduced in the anoxic gas. The average pH in the reactor was 7.2 ± 0.4. As a result, the recirculation of the anoxic gas was successfully applied to control the membrane fouling in the anoxic MBR.     

ABR-MBR一体化工艺节能降耗措施优化研究

能耗高和膜污染是限制膜生物反应器(MBR)广泛应用的重要因素.为降低工艺运行能耗和延缓膜污染,以厌氧折流板反应器(ABR)-MBR工艺处理生活污水为例,对工艺结构和脱氮除磷运行条件进行优化.结果表明,通过优化ABR-MBR工艺结构,可降低43%的运行能耗,同时可保持较高的COD、NH+4-N、TN和TP去除效果,平均去除率分别为91%、85%、76%和86%.另外,添加颗粒填料可有效延缓膜污染,不过也改变了膜污染的形成过程,膜内部污染物含量显著增多,碳水化合物含量增加,而蛋白质含量减少,碳水化合物/蛋白质比明显增大.最终,增强了MBR反应器的实际应用性能.     

膜生物反应器中膜过滤特征及膜污染机理的研究

以膜生物反应器处理市政污水,通过对活性污泥进行终端过滤来反映膜污染机理,实验表明,最初很短时间内膜污染受膜孔堵塞模型控制,之后受沉积层阻力模型控制,后一阶段是膜污染的主要控制阶段;膜的相对通量随过滤时间呈指数衰减趋势,压力越大,通量衰减越快;污泥沉积层存在压密过程,这一过程中的污泥比阻随压力增大而增大,并得到处理市政污水的污泥压密指数为0.807 8;阻力分布实验表明沉积层阻力占总阻力的90%以上,是膜过滤污染阻力的主要组成部分;活性污泥各组分对膜污染均有贡献,其中悬浮固体、胶体颗粒和溶质产生的阻力分别占87.98%、6.20%和5.82%;根据实验和计算结果,探讨了MBR处理市政污水过程中可能的膜污染机理.