酸碱改性对活性焦烧结烟气脱硫性能的影响

选取一定目数范围的活性焦,用3种酸(HCl、H2SO4和HNO3)、3种碱(KOH、NaOH和NH3·H2O)和酸碱两步(HNO3和KOH)对其进行改性处理,对比这几种方法改性的活性焦对烧结烟气的脱硫性能,实验结果表明,20~40目范围的活性焦脱硫性能最好;HCl改性活性焦的脱硫性能基本无变化,HNO3改性后有促进作用但作用不大,H2SO4改性反而降低了活性焦的脱硫活性;KOH和NaOH溶液改性活性焦对其脱硫性能有很大的提升作用,其中KOH改性效果更好,NH3·H2O改性基本无影响;先KOH后HNO3两步改性的活性焦效果最佳,并且能维持一定时间100%的脱硫效率。     

中国工业水污染及其成因的de Bruyn模型分析

选取废水、挥发酚、氰化物、COD、石油类和氨氮为中国工业水污染指标,利用分解分析方法将2004—2010年间的污染变化分解为规模效应、结构效应、污染治理效应、清洁技术效应和广义技术效应。结果显示,这5类效应的平均作用强度分别为2.08%、3.04%、15.61%、17.37%和32.88%,其中规模效应和广义技术效应是影响工业水污染的主导效应。各类效应对不同污染物的作用方向并不完全一致,规模效应促进污染物排放量的增加;结构效应以加重污染为主,污染治理效应和清洁技术效应以减轻污染为主;广义技术效应的平均作用强度和负向作用概率均最大,是现阶段中国工业水污染控制最为有效的手段。     

不同混凝剂处理松花江低温水

东北松花江地区冬季有将近6个月的冰封期,低温季节水源水处理难度大。为了保证东北地区冬季饮用水供应,研究几种混凝剂在处理冬季松花江低温水时的混凝效果。实验结果表明,NPAC1和NPAC2水解产物中具有较高的Alb和Alc成分,拥有较高的电中和、吸附和网捕卷扫性能,高效聚铝铁(PAF)水解产物Fe(OH)3具有比表面积大、吸附架桥作用较强的优点。这3种混凝剂无论是在控制出水浊度还是在对水体有机物去除能力方面均优于目前水厂所使用的PAC和聚合氯化铝铁(水厂PAF);NPAC2的投加量达到50 mg/L时,出水浊度达到最优;当混凝剂投加量达到50 mg/L时,NPAC1的浊度去除率逐渐超过NPAC2,剩余浊度低于3.0 NTU;NPAC1、NPAC2和PAF 3种混凝剂对有机物的去除能力大致相当,当混凝剂投加量为50 mg/L时,这3种混凝剂处理后的水的UV254的值均低于0.06,而水厂使用的2种混凝剂处理后的水的UV254仍高于0.1;结合其对浊度去除的情况,可以判断55 mg/L的投药量为NPAC1的最优投药点,PAF的最佳投药量为65 mg/L;投加适量的粉末活性碳可以有效地提高氨氮的去除率,当粉末活性炭的投加量为30 mg/L时,氨氮的去除率基本达到最大(51.27%)。表面负荷对混凝效果具有重要的影响,合理降低沉淀池的表面负荷对于提高出水水质具有重要作用。     

取芯过程中煤芯温度分布特征模拟研究*

针对取芯过程瓦斯解吸受煤芯的温度影响不明,造成煤层瓦斯含量测不准的问题,开展对取芯过程煤芯温度分布特征研究。采用自主研制的取芯管自动测温装置在赵固二矿原生结构煤层（f=1.71）进行深度20 m的取芯试验,获得取芯管管壁温升变化规律,变化曲线分为4个阶段:缓慢上升、加速上升、减速上升、缓慢下降阶段;应用COMSOL建立含瓦斯煤传热模型,将管壁的温度变化设置为边界条件,模拟取芯过程煤芯与管壁之间的热交换。结果表明:在取芯时间30 min内,煤芯平均温度快速上升,之后上升速度趋于平稳;在煤芯内,相同时刻,等间距的轴向与径向距离,径向较轴向的温度梯度较大,径向传导快于轴向传导;取芯过程煤芯径向温度Ta与径向距离d、时间t满足指数函数关系。研究结果可为测定取芯过程煤芯的瓦斯损失量提供参考依据。     

基于无人机建模的尾矿库溃坝事故推演*

为诠释尾矿库溃坝后水砂演进过程,提升尾矿库事故灾害应急处置能力,采用无人机倾斜摄影技术获取尾矿库全息影像,建立尾矿库三维数字高程模型,导入三维流体计算软件对尾矿库进行溃坝事故推演。结果表明:尾矿库实景三维模型能高精度还原尾矿库实际情况,尾矿库溃坝将淹没库区临时厂房建筑及下游村落;其中,上游沟谷临时厂房建筑水位高程最大达8 m,尾砂淤积厚度最高达10.5 m,下游沟谷村落水位高程最大达10 m,尾砂淤积厚度最高达2.5 m;通过对库区下游布设监测点,得出各监测点处水位高程和尾砂淤积厚度变化规律,分析溃坝主要影响区域。研究结果可为尾矿库风险防控、应急响应工作提供借鉴。     

1种抑制巷道信号NLOS的矿井RSSI高精度定位算法

在RSSI(Received Signal Strength Indication)测距定位技术中,为抑制巷道信号NLOS(Non Line of Sight)传输对定位结果的影响,提出信号指纹定位和几何优化算法.在离线阶段利用高斯滤波最大值加权法和最小二乘法建立符合矿井巷道环境的无线信号测距模型,设计改进卡尔曼滤波器...     

深埋水平岩层隧道开挖稳定性分析及控制*

针对深埋高地应力水平岩层掌子面开挖稳定性及支护结构失效问题,以大峡谷隧道为工程背景,通过现场测试、室内试验、数值模拟等方法,探究深埋高地应力水平岩层失稳机理及控制措施。研究结果表明:坚硬岩体被节理面切割后,在高地应力作用下容易发生挤压破碎,破碎岩体遇水发生软化,导致掌子面发生大范围塌方,初支和超前支护失效;隧道开挖后岩层发生不均匀沉降,浅部岩层最先发生弯折破坏,层内块体错动滑移,继而向上方岩层发展,并伴随层间分离和层内裂隙发育,最终形成宏观破裂面;提出的台阶法、2 m开挖进尺、砼喷层、双层小导管、提高初支强度的整体优化控制措施,可有效提高现场支护效果。     

Dynamic risk assessment for underground gas storage facilities based on Bayesian network

Loss of the underground gas storage process can have significant effects, and risk analysis is critical for maintaining the integrity of the underground gas storage process and reducing potential accidents. This paper focuses on the dynamic risk assessment method for the underground gas storage process. First, the underground gas storage process data is combined to create a database, and the fault tree of the underground gas storage facility is built by identifying the risk factors of the underground gas storage facility and mapping them into a Bayesian network. To eliminate the subjectivity in the process of determining the failure probability level of basic events, fuzzy numbers are introduced to determine the prior probability of the Bayesian network. Then, causal and diagnostic reasoning is performed on the Bayesian network to determine the failure level of the underground gas storage facilities. Based on the rate of change of prior and posterior probabilities, sensitivity and impact analysis are combined to determine the significant risk factors and possible failure paths. In addition, the time factor is introduced to build a dynamic Bayesian network to perform dynamic assessment and analysis of underground gas storage facilities. Finally, the dynamic risk assessment method is applied to underground gas storage facilities in depleted oil and gas reservoirs. A dynamic risk evaluation model for underground gas storage facilities is built to simulate and validate the dynamic risk evaluation method based on the Bayesian network. The results show that the proposed method has practical value for improving underground gas storage process safety.     

上、下悬窗阻风能力对比研究

环境风会改变排烟窗附近的烟气流向和速度,影响建筑内烟气流动,进而导致建筑自然排烟效率受到影响。采用数值模拟方法,对比研究了排烟窗开启角度和环境风对上、下悬窗阻风能力的影响,分析了不同开窗角度下,悬窗进风量和进风区域随开窗角度和风速的变化规律。结果表明:上、下悬窗相对进风量与开窗角度均成指数关系,但上悬窗阻风能力弱于下悬窗,上悬窗开窗角度大于45°后即失去阻风能力,而下悬窗开窗角度大于75°后才逐渐失去阻风能力,且开窗角度小于30°时,下悬窗至少能比上悬窗多减少50%空气进入室内。上悬窗开窗角度小于56°时,主要进风区域为近窗下侧水平区域;下悬窗开窗角度小于30°时,主要进风区域为窗体两侧及远窗下侧竖直区域,随着开窗角度增大,上、下悬窗主要进风区域均过渡到远窗下侧竖直区域。窗体用于日常通风时建议优选上悬窗。若要用于排烟,则应首选下悬窗,开窗角度15°即可满足阻风要求,若选用上悬窗,开窗角度不宜大于45°。     

The acceptance of personal protective equipment among Hong Kong construction workers: An integration of technology acceptance model and theory of planned behavior with risk perception and safety climate

Introduction: The phenomenon that construction workers do not use personal protective equipment (PPE) is a major reason for the high occurrence frequency of accidents in the construction industry. However, little efforts have been made to quantitatively examine the factors influencing construction workers’ acceptance of PPE. Method: In the current study, a PPE acceptance model for construction workers (PAMCW) was proposed to address the noted need. The PAMCW incorporates the technology acceptance model, theory of planned behavior, risk perception, and safety climate for explaining construction worker acceptance of PPE. 413 construction workers participated in this study to fill out a structured questionnaire. The PAMCW was analyzed using structural equation modeling. Results: Results provide evidence of the applicability of the technology acceptance model and theory of planned behavior to the PPE acceptance among construction workers. The positive influence of safety climate and risk perception-severity on attitude toward using PPE was significant. Safety climate positively influences perceived usefulness. Risk perception-worry and unsafe was found to positively affect intention to use PPE. Practical Applications: Practical suggestions for increasing construction workers’ use of PPE are also discussed.