[HPMo][OTAC]2/SiO2的制备及其催化柴油氧化脱硫的研究

采用溶胶-凝胶法制备不同负载量的[HPMo][OTAC]2/SiO2,通过红外光谱、比表面积和孔结构分析对[HPMo][OTAC]2/SiO2进行表征,考察负载量、催化剂用量、氧化剂用量、反应温度和反应时间对模拟柴油脱硫效果的影响。结果表明,掺杂后的催化剂保持了Keggin结构,[HPMo][OTAC]2/SiO2在最佳反应条件下,苯并噻吩的脱除率达到48.3%,二苯并噻吩的脱除率达到67.2%。     

富勒烯甘氨酸铜盐的制备及表征

以富勒烯和甘氨酸为原料合成富勒烯甘氨酸,再与硝酸铜反应得到富勒烯甘氨酸铜盐。通过单因素方法探讨了反应温度、反应时间、反应物物料比对目标物富勒烯甘氨酸铜盐中铜质量分数的影响。获得最佳工艺条件为:富勒烯甘氨酸和硝酸铜的摩尔比1∶5,反应时间2.0 h,反应温度35℃。此时富勒烯甘氨酸铜盐中铜质量分数为17.8%。同时用FT-IR、MS、元素分析及原子吸收等方法表征了产物的结构。用差热仪测试了富勒烯甘氨酸铜盐的热稳定性,表明产物具有良好的热稳定性。     

稻田土菌群驯化对稻秆两步发酵产甲烷效果的影响

为提高稻秆的降解率及其厌氧发酵甲烷产量,采用高氨氮畜禽废水作为氮源以驯化稻田土壤微生物,优化其降解稻秆的初始pH值,并评估水解产物液体发酵产甲烷性能.结果表明,混合组驯化的微生物产纤维素酶活性及对稻秆木质素的降解率高于其它组及先前文献报道,分别达到4.01 IU和51.96%,且后期水解液中总有机碳（Total organic carbon, TOC）及还原糖含量最高.随着初始pH值的提高,稻秆中纤维素、半纤维素和木质素的降解率显著增加,稻秆水解液中的挥发性脂肪酸（Volatile fatty acids, VFAs）和TOC含量均显著增加,并在第7 d达到最高值.将水解稻秆7 d的水解液进行厌氧发酵显示,在初始pH=9.0条件下累积甲烷产量达到最大,为37.60 mL·mL^-1水解液.本实验结果表明, 驯化的稻田土微生物在碱性条件下可以更有效地降解稻秆,提高水解液中TOC及VFAs含量,从而提高厌氧发酵的甲烷产量.     

产酸脱硫反应器中碳硫比对群落生态特征的影响

通过产酸脱硫反应器处理高浓度含硫酸盐废水的连续流试验,从群落动态的角度研究碳硫比(COD/SO₄^2-)从4.2降低到2.0的过程中,pH值、氧化还原电位(ORP)、碱度(ALK)和末端产物(VFAs)组成、优势种群分布等群落生态特征的变化规律试验证明,在此过程中ORP和ALK提高,而pH值和VFAs中乙酸的分布比例降低,群落类型由高碳硫比稳定型转化为低碳硫比亚稳定型,但仍未改变乙酸型顶极群落的典型特征.     

Recovery of Ni(II) from real electroplating wastewater using fixed-bed resin adsorption and subsequent electrodeposition

Resin adsorption and subsequent electrodeposition were used for nickel recovery. Treated wastewater can meet the Electroplating Pollutant Discharge Standard. The spent resin is completely regenerated by 3 BV of 4% HCl solution. 95.6% of nickel in concentrated eluent was recovered by electrodeposition. Effective recovery of high-value heavy metals from electroplating wastewater is of great significance, but recovering nickel ions from real electroplating wastewater as nickel sheet has not been reported. In this study, the pilot-scale fixed-bed resin adsorption was conducted to recover Ni(II) ions from real nickel plating wastewater, and then the concentrated Ni(II) ions in the regenerated solution were reduced to nickel sheet via electrodeposition. A commercial cation-exchange resin was selected and the optimal resin adsorption and regeneration conditions were investigated. The resin exhibited an adsorption capacity of 63 mg/g for Ni(II) ions, and the average amount of treated water was 84.6 bed volumes (BV) in the pilot-scale experiments. After the adsorption by two ion-exchange resin columns in series and one chelating resin column, the concentrations of Ni(II) in the treated wastewater were below 0.1 mg/L. After the regeneration of the spent resin using 3 BV of 4% (w/w) HCl solution, 1.5 BV of concentrated neutral nickel solution (>30 g/L) was obtained and used in the subsequent electrodeposition process. Using the aeration method, alkali and water required in resin activation process were greatly reduced to 2 BV and 3 BV, respectively. Under the optimal electrodeposition conditions, 95.6% of Ni(II) in desorption eluent could be recovered as the elemental nickel on the cathode. The total treatment cost for the resin adsorption and regeneration as well as the electrodeposition was calculated.     

Comparison of CNT-PVA membrane and commercial polymeric membranes in treatment of emulsified oily wastewater

CNT-PVA membrane was fabricated and compared with polymeric membranes. The separation performance was evaluated by homemade and cutting fluid emulsions. The three membranes show similar oil retention rates. CNT-PVA membranes have higher permeation fluxes compared with polymeric membranes. CNT-PVA membrane shows higher fouling resistance. Membrane separation is an attractive technique for removal of emulsified oily wastewater. However, polymeric membranes which dominate the current market usually suffer from severe membrane fouling. Therefore, membranes with high fouling resistance are imperative to treat emulsified oily wastewater. In this study, carbon nanotube-polyvinyl alcohol (CNT-PVA) membrane was fabricated. And its separation performance for emulsified oily wastewater was compared with two commercial polymeric membranes (PVDF membrane and PES membrane) by filtration of two homemade emulsions and one cutting fluid emulsion. The results show that these membranes have similar oil retention efficiencies for the three emulsions. Whereas, the permeation flux of CNT-PVA membrane is 1.60 to 3.09 times of PVDF membrane and 1.41 to 11.4 times of PES membrane, respectively. Moreover, after five consecutive operation circles of filtration process and back flush, CNT-PVA membrane can recover 62.3% to 72.9% of its initial pure water flux. However, the pure water flux recovery rates are only 24.1% to 35.3% for PVDF membrane and 6.0% to 26.3% for PES membrane, respectively. Therefore, CNT-PVA membrane are more resistant to oil fouling compared with the two polymeric membranes, showing superior potential in treatment of emulsified oily wastewater.     

榆林市某园区兰炭企业存在问题及解决对策

兰炭是榆林市的重要产业之一,但由于兰炭"粗放"的生产方式,对区域环境产生一定影响。为推进兰炭绿色健康发展,本文针对榆林市某园区内兰炭企业进行调研,了解该企业存在的主要问题,并提出相关建议。     

丛枝菌根对盐胁迫的响应及其与宿主植物的互作

丛枝菌根真菌(Arbuscular Mycorrhizae Fungi,AMF)作为陆地生态系统的组成部分之一,在促进宿主植物对土壤养分和水分的吸收、提高植物生物量生产、调节种群和群落的结构、维持生态系统的稳定性等方面发挥了重要作用。其中,盐渍化是自然生态系统中广泛存在的一种胁迫生境条件,全球盐渍化土地约占耕地总面积的10%,因而探讨AM菌根在此胁迫生境下对宿主植物生长的影响具有重要意义。从以下几个方面,围绕盐胁迫条件、AM菌根和宿主植物三者之间的关系对当前国际上相关领域的研究进展进行了综述:1)AM真菌对盐胁迫的响应,包括菌根共生体形成、菌根侵染率、AM真菌的分布、菌丝体生长发育、孢子的形成和分布等;2)盐胁迫条件下AM菌根对宿主植物的效应,包括AM菌根促进宿主植物对P、N等元素的吸收、降低植物体内Na 的含量、提高光合作用能力,进而提高植物的生物量和对植物的群落结构产生影响等;3)AM菌根提高宿主植物耐盐性的机理,分别从植物根系形态的改变、水分吸收能力的加强、细胞内营养物质的平衡,以及细胞生理代谢的调节等方面对AM菌根促进植物抗盐性的机理进行了剖析。     

金属负载活性炭催化氧化法处理ZPT生产废水

研究了金属负载活性炭催化剂在常温常压下催化氧化处理吡啶硫酮锌(ZPT)废水的技术，在探讨影响催化氧化效果诸因素的基础上，确定出中和预处理、后接两级催化氧化处理该废水的工艺流程，该流程的COD的去除率最高可达92％，处理出水达到国家污水综合排放标准二级指标。     

酿酒废水培养钝顶螺旋藻(S.platensis)与营养物质去除的研究

经前处理后的酿酒厂废水用清水稀释用来培养钝顶螺旋藻 ,可以获得高生物量的钝顶螺旋藻。同时 ,废水中的营养物质也可以被去除。在连续培养条件下 ,使用改进的开放式通道装置培养获得螺旋藻的蛋白质、水分、灰化成份分别为 6 2 .7%、6 .2 1 %和 5 .2 6 % ,重金属含量也符合标准 (GB 1 991 9-1 997)。T -N ,NH4 + -N ,T -P和PO4 3 --P的去除效率分别可达到 72 %、97.9%、4 1 .3%、4 3.1 %。