离子液体对废旧印刷线路板中铜、锌、铅的浸出规律

以离子液体1-丁基磺酸-3-甲基咪唑三氟甲烷磺酸盐([BSO_3HMIm]OTf)为浸出剂,初步研究了WPCBs浸铜过程中锌和铅浸出率的影响因素。实验结果表明:铜、锌的浸出率随着WPCBs粒径的减小、H_2O_2溶液加入量的增大而增大,铜的浸出率随浸出温度的升高先增大后减小,锌的浸出率受浸出温度影响不大;铅的浸出率受5种因素影响不大,且总体处于较低水平。在WPCBs粒径为0.100~0.250 mm、离子液体加入量为60.0%(φ)、H_2O_2溶液加入量为7.5%(φ)、固液比为1∶15、浸出温度为50℃的条件下,铜、锌、铅的浸出率分别为99.84%,93.25%,22.46%。     

羟基乙叉二膦酸镀铜废液的处理及Cu~(2+)的高附加值资源化回收

采用Na BH4还原法将羟基乙叉二膦酸(HEDP)镀铜废液中的Cu~(2+)制备成纳米铜粉,并采用聚丙烯酰胺(PAM)对还原反应后的废液进行絮凝处理。研究了n(Cu~(2+))∶n(Na BH4)、还原反应温度、还原反应时间及PAM添加量对废液中剩余Cu~(2+)质量浓度的影响,并对回收的纳米铜粉进行了XRD和TEM表征。实验结果表明:当n(Cu~(2+))∶n(Na BH4)=4∶6、还原反应温度为50℃、还原反应时间为2 h时,废液中剩余Cu~(2+)质量浓度降低至1.1 mg/L,Cu~(2+)还原率达99.99%;可获得粒径为20~45 nm的近球型、高纯度、由多晶组成的纳米铜粉;当PAM添加量为10 mg/L时,废液中剩余Cu~(2+)质量浓度降至0.35 mg/L以下,达到GB 21900—2008《电镀污染物排放标准》(小于0.5 mg/L)的要求。     

金属冶炼进口物料的固体废物鉴别方法

建立了金属冶炼进口物料的固体废物鉴别方法,并利用该方法对海关查扣的3种金属冶炼进口物料进行了固体废物鉴别。鉴别结果显示:物料1、2和3的自然属性分别为砷含量超标铜精矿、锰阳极泥、回转窑氧化锌,产生来源分别为有害物质超标的产品、污染控制设施产生的物质、有意识加工的目标产物;物料1和2属于我国禁止进口的固体废物,物料3不属于固体废物。本文建立的固体废物鉴别方法可行,可为金属冶炼进口物料的固体废物鉴别和监管提供参考。     

Toxicity of nanoparticulate and bulk ZnO, Al2O3 and TiO2 to the nematode Caenorhabditis elegans

Limited information is available on the environmental behavior and associated potential risk of manufactured oxide nanoparticles (NPs). In this research, toxicity of nanoparticulate and bulk ZnO, Al₂O₃ and TiO₂ were examined to the nematode Caenorhabditis elegans with Escherichia coli as a food source. Parallel experiments with dissolved metal ions from NPs were also conducted. The 24-h median lethal concentration (LC₅₀) and sublethal endpoints were assessed. Both NPs and their bulk counterparts were toxic, inhibiting growth and especially the reproductive capability of the nematode. The 24-h LC₅₀ for ZnO NPs (2.3 mg L⁻¹) and bulk ZnO was not significantly different, but significantly different between Al₂O₃ NPs (82 mg L⁻¹) and bulk Al₂O₃ (153 mg L⁻¹), and between TiO₂ NPs (80 mg L⁻¹) and bulk TiO₂ (136 mg L⁻¹). Oxide solubility influenced the toxicity of ZnO and Al₂O₃ NPs, but nanoparticle-dependent toxicity was indeed observed for the investigated NPs.     

铜氰溶液的电子束辐照降解

研究了铜氰溶液中总氰初始浓度、pH、铜浓度等对总氰降解效率的影响,比较了KCN溶液和铜氰溶液的总氰降解率,初步推断了铜氰溶液在辐照过程中的降解机制.实验结果表明,在同样的辐照剂量下,随着总氰初始浓度的增加,总氰降解率降低,相应的总氰降解G值增大;铜浓度越低,总氰降解率越高;pH越小的铜氰溶液总氰降解率越高.电子束辐照KCN溶液和铜氰溶液的总氰降解反应属于表观一级反应.在相同的辐照剂量下,KCN溶液的总氰降解率比铜氰溶液要高得多.铜氰溶液的电子束辐照降解过程非常复杂,主要是铜氰络合离子逐步离解出的CN-与·OH的反应.     

氧化亚铁硫杆菌浸出废弃线路板中铜的研究

对废弃线路板中的铜进行了细菌浸出、只有硫酸亚铁环境下的浸出及酸浸出实验,研究了不同条件对比浸出效果,研究结果表明,细菌浸出比只有硫酸亚铁存在的浸出和酸浸要快得多。研究了在线路板粉末浓度12、24、40、60和120 g/L下浸出速率的变化,结果表明, 在考察范围内,浸出速度随着加入的废弃线路板粉末浓度的升高而降低,当线路板粉末的浓度＞60 g/L时,浸出速度维持在较低水平,选取24 g/L作为浸出的线路板粉末的浓度。分别在细菌培养0、24、48和72 h时加入线路板粉末24 g/L进行浸出实验,结果表明,细菌培养时间长,使得浸出过程进行得也更快。     

Seven thousand years in the service of humanity—the history of copper, the red metal

Measured by weight, copper is the third most important metal used by man. The annual value of its 2007 output was on a par with the GDP of e.g. Ukraine. Copper is also one of the oldest metals, its employment going back 7000 years. For millennia, it was predominantly employed for decorative purposes, coinage and in warfare. Technical breakthroughs in antiquity, like smelting and alloying, expanded its production and enhanced its utility. Copper's true heyday occurred after 1850, with the usage of electricity. In the period since then, volumes increased 300-fold, while costs and prices declined. With impressive progress in the technology of its production and consumption, the red metal has been able to hold its own, despite the emergence over history of formidable substitutes like iron, aluminum, plastics and optic fiber.     

Conceptual issues in designing a policy to phase out metal-based antifouling paints on recreational boats in San Diego Bay

In marine areas throughout the world where recreational boats are densely located, concentrations of copper in the water are being found to be in excess of government standards, due to the hull coatings used on these boats. Copper-based hull coatings are intended to be antifouling in that they retard the growth of algae, barnacles and tubeworms; but alternatives exist that can eliminate the harm that copper contamination does to marine organisms. A variety of policy options are available to mandate or provide economic incentives to switch to these less harmful alternatives. This paper puts forth a conceptual framework for thinking about how to design and evaluate alternative policies to transition to nontoxic boat hulls, drawing from the authors' experience designing a policy for use in San Diego Bay. Many of the issues raised are broadly applicable to environmental problems where the solution involves a large-scale replacement of durable consumer goods.     

废水中环氧丙烷降解菌株的培育及降解效果研究

本文通过对污泥的驯化筛选得到4株降解环氧丙烷废水的优势茵A、B、C、D,并对降解效果最好的一个菌株A进行研究,得到其最佳降解条件是温度为30℃、pH为5、废水浓度为20％、反应时间为9h,其COD去除率可达到63．24％左右。     

Comparison of manufactured and black carbon nanoparticle concentrations in aquatic sediments

In this paper, we show that concentrations of manufactured carbon-based nanoparticles (MCNPs) in aquatic sediments will be negligible compared to levels of black carbon nanoparticles (BCNPs). This is concluded from model calculations accounting for MCNP sedimentation fluxes, removal rates due to aggregation or degradation, and MCNP burial in deeper sediment layers. The resultant steady state MCNP levels are compared with BCNP levels calculated from soot levels in sediments and weight fractions of nanosized fractions of these soot particles. MCNP/BCNP ratios range from 10⁻⁷ to 10⁻⁴ (w:w). This suggests that the often acclaimed effect of MCNPs on organic pollutant binding and bioavailability will likely be below the level of detection if natural BCNPs are present, even if binding to MCNP is one to two orders of magnitude stronger than to BCNPs. Furthermore, exposure and toxic effects of MCNPs in sediments and soils will be negligible compared to that of BCNPs.