SGO改性复合纳滤膜的制备及分盐性能

近年来,水资源短缺,水源污染严重,国家对水处理末端的资源化利用提出了更高的要求,分盐过程也受到越来越多的关注.纳滤膜表面通常带有电荷,可以选择性地透过不同价态的离子.基于纳滤膜表面电荷特性不同,为很好地实现盐的分离,将制备的带有磺酸基团的氧化石墨烯引入到纳滤膜材料中,采用界面聚合法,制备了SGO改性复合纳滤膜. Zeta电位分析表明所制备的复合纳滤膜表面的电荷比不添加SGO的纳滤膜更负;红外光谱分析中酯基基团特征峰的出现表明磺酸基团参与了聚合反应; SEM结构表面,膜表面出现了明显的图灵结构,在0. 2 MPa压力下,纯水通量可达45. 85 L·(m~2·h)-1,对Na2SO4截留率为98. 23%,对Na Cl截留率为24. 93%,10 h运行可以很好地实现对SO_4~(2-)、Cl~-的有效分离,可实现盐的资源化回收.     

La-M-Co-O/堇青石催化剂的制备及催化氧化氯苯

采用柠檬酸络合法制备La-M-Co-O（M=Mn,Cr,Fe,Ni和Cu）/堇青石催化剂,运用BET,XRD,SEM,H₂-TPR和XPS技术对催化剂性能及微观结构进行表征分析,研究考察过渡金属掺杂,掺杂量以及焙烧温度等对催化剂催化氧化性能的影响.结果表明,随着催化剂焙烧温度升高至650℃时,催化剂表面所负载的活性氧化物颗粒最为分散,其氧化活性最佳,且当反应温度为350℃时,催化剂催化氧化氯苯转化率可达96.4%,究其原因是高温焙烧致使催化剂形成LaCoO₃钙钛矿型复合氧化物,其复合氧化物的晶体结构有利于催化剂催化氧化氯苯性能的提高.     

过硫酸钠缓释胶囊反应带修复苯胺污染地下水

针对有机污染地下水原位化学氧化修复中普遍存在的氧化剂过量使用、污染物反弹和二次污染问题,以苯胺（AN）为特征污染物,以活化过硫酸盐为氧化剂,采用硬脂酸为胶结剂,制备过硫酸钠（PS）和硫酸亚铁（FeSO₄）缓释胶囊,构建基于PS和FeSO₄缓释胶囊的可渗透反应屏障（PS-FeSO₄-PRB）,考查了缓释胶囊组分、地下水流速对PRB中活性物质释放和AN去除的影响.结果表明,当缓释胶囊中活性物质/硬脂酸为1/2,地下水流速为0.1mL/min时,48h后PRB中PS和Fe²⁺累计释放率分别为43.18%和14.98%.当PRB中FeSO₄/PS为1/9时,AN累计去除率达到95.37%,TOC累计去除率为57.07%.采用砂柱模拟AN污染地下水,比较了直接注射PS和FeSO₄与PS-FeSO₄-PRB两种处理方式的修复性能,4d内两者的AN累计去除率分别为35.22%和69.74%,TOC累计去除率分别为15.83%与14.88%.PS-FeSO₄-PRB修复效果明显高于直接注射处理.GC/MS分析表明,处理后产生了对苯醌、偶氮苯以及长链烷烃等产物,导致AN矿化率不高.pH值和Eh连续记录结果表明,PS-FeSO₄-PRB处理能够保持反应体系氧化还原电位和酸碱性的相对稳定.相比直接注射氧化剂,基于PS和FeSO₄-缓释胶囊的PRB处理中地下水的急性毒性更低,二次污染风险更小.     

MWNTs/TiO2对典型氯苯类化合物的光催化降解研究

研究复合光催化剂MWNTs/TiO2对典型氯苯类有机化合物光催化降解动力学及主要光降解路径.结果表明,同一初始浓度和相同光催化降解实验条件下,60min时典型氯苯类有机化合物的光降解率均达到90%以上.其中六氯苯和五氯苯的光催化降解速率常数分别为0.0664h-1和0.0670h-1,其大小明显高于其它氯苯类化合物.1,二氯苯的光催化降解反应速率常数仅为0.0430h4--1,在典型氯苯类化合物中最小.三氯苯的3种同分异构体——1,3-三氯苯、24-三氯苯和1,5-三氯苯的光催化降解速率常数分别为0.0547h2,1,,3,-1、0445h0.-1和0.0439h-1.六氯苯的主要光催化降解路径为:HCB→PeCB→1,2,3,5-TeCB→1,2,4-TCB→1,4-DCB.     

有证标准样品的应用及其管理方法探讨

介绍了有证标准样品的定义和主要作用,详细阐述了有证标准样品在检测实验室的7个主要应用领域、正确使用指南和科学管理方法,以保证检测实验室检测结果的准确和量值溯源性。     

An antibiotic composite electrode for improving the sensitivity of electrochemically active biofilm biosensor

• Antibiotic azithromycin employed in graphite electrode for EAB biosensor. • Azithromycin at 0.5% dosage increased the sensitivity for toxic formaldehyde. • Azithromycin increased the relative abundance of Geobacter. • Azithromycin regulated thickness of electroactive biofilm. Extensive research has been carried out for improved sensitivity of electroactive biofilm-based sensor (EAB-sensor), which is recognized as a useful tool in water quality early-warning. Antibiotic that is employed widely to treat infection has been proved feasible in this study to regulate the EAB and to increase the EAB-biosensor’s sensitivity. A novel composite electrode was prepared using azithromycin (AZM) and graphite powder (GP), namely AZM@GP electrode, and was employed as the anode in EAB-biosensor. Different dosages of AZM, i.e., 2 mg, 4 mg, and 8 mg, referred to as 0.25%, 0.5% and 1% AZM@GP were under examination. Results showed that EAB-biosensor was greatly benefited from appropriate dosage of AZM (0.5% AZM@GP) with reduced start-up time period, comparatively higher voltage output, more readable electrical signal and increased inhibition rate (30%-65% higher than control sensor with GP electrode) when exposing to toxic formaldehyde. This may be attributed to the fact that AZM inhibited the growth of non-EAM without much influence on the physiologic or metabolism activities of EAM under proper dosage. Further investigation of the biofilm morphology and microbial community analysis suggested that the biofilm formation was optimized with reduced thickness and enriched Geobacter with 0.5% AZM@GP dosage. This novel electrode is easily fabricated and equipped, and therefore would be a promising way to facilitate the practical application of EAB-sensors.     

High performance of multi-layered alternating Ni–Fe–P and Co–P films for hydrogen evolution

Judiciously engineering the electrocatalysts is attractive and challenging to exploit materials with high electrocatalytic performance for hydrogen evolution reaction. Herein, we successfully perform the interface engineering by alternately depositing Co–P and Ni–Fe–P films on nickel foam, via facile electroless plating and de-alloying process. This work shows that there is a significant effect of de-alloying process on alloy growth. The electronic structure of layered alloys is improved by interface engineering. The multilayer strategy significantly promotes the charge transfer. Importantly, the Co–P/Ni–Fe–P/NF electrode fabricated by interface engineering exhibits excellent electrocatalytic hydrogen evolution activity with an overpotential of 43.4 mV at 10 mA cm-2 and long-term durability for 72 h in alkaline medium (1 mol L-1 KOH). The innovative strategy of this work may aid further development of commercial electrocatalysts.     

一种新型废旧轮胎组合拦石结构的试验研究

提出了一种由废旧轮胎组成的拦石结构,该结构用钢丝绳将废旧轮胎进行合理的绑扎,使轮胎与轮胎之间紧密连接,然后将该结构绑扎在用废旧钢轨或钢筋混凝土制作而成的柱子上面.当拦石结构受到落石冲击时,利用废旧轮胎的弹塑性变形吸收冲击能量.为了考察这种由废旧轮胎组成的拦石结构的防护效果,设计了试验模型,采用20 kg的砝码模拟落石,...     

磁絮凝高效处理高浊度废水的性能及机理研究

自来水供水厂在运行过程会产生大量高浊度废水,其中富集了许多微生物、有机物及无机杂质,若直接排放会严重污染河流水体及周边土壤.采用磁絮凝工艺处理自来水厂供水过程中产生的高浊度废水,通过单因素和正交试验考察了聚合氯化铝(PAC)投加量、磁种(Fe3O4)投加量、废水初始pH值和沉降时间对废水中浊度、COD和UV254去除效...     

一种新型旋风气幕式排风罩数值模拟研究

利用Fluent计算流体力学软件对新型旋风气幕式排风罩工作流场及有害物分布进行了数值模拟,并与传统排风罩进行了对比。结果表明:旋转射流屏蔽作用下的抽吸流场具有中部压力较低和提高抽吸能力的作用;新型旋风气幕式排风罩不仅能有效地控制有害物扩散,而且可以实现远距离捕集有害物及以较小的排风速度排放有害物。